Zn(BTZ)2白色有机电致发光材料的合成及其器件制备

以PCl₃为脱水剂,将邻氨基硫酚与水杨酸脱水环化合成出2-(2-羟基苯基)苯并噻唑,并进一步将所得产物与乙酸锌反应合成出2-(2-羟基苯基)苯并噻唑螯合锌(Zn(BTZ)₂)材料。以该配合物作为发光层制备出结构为ITO/PVK:TPD/Zn(BTZ)₂/Al近白色电致发光器件,其色坐标位于白场之内(x=0.242,y=0.359),在驱动电压为16V时,亮度达3200cdm²,对应的量子效率为0.32%。进一步在Zn(BTZ)₂中掺入橙红色染料Rubrene,制成ITO/PVK:TPD/Zn(BTZ)₂:Rubrene/Al结构器件,实现了纯白色发光(色坐标值:x=0.324,y=0.343),非常接近于白色等能点,且量子效率达0.47%。最后对上述器件的发光和电学性能进行了深入的研究和探讨。     

Acetalation and Ketalation Catalyzed by SO42-/TiO2-MoO3

The catalytic activities of SO42-/TiO2-MoO3 in synthesizing cyclohexanone ethylene ketal,cyclohexanone 1,2-propanediol ketal, 2-propyl-1,3-dioxolane, 4-methyl-2-isopropyl-1,3-dioxolane,2-isopropyl-1,3-dioxolane, 4-methyl-2-isopropyl-1,3-dioxolane, butanone ethy-lene ketal and butanone 1,2-propanediol ketal were reported. It has been demonstrated that SO42-/TiO2-MoO3 is an excellent catalyst. Various factors concerned in this reaction have been investigated. The optimum conditions have been found, that is, the molar ratio of aldehyde/ketone to alcohol was 1:1.5 or 1:1.3,the mass ratio of the catalyst used to the reactants was 0.25～1.5%, and the reaction time was 45～60 min. Under this conditions, the yield of cyclohexanone ethylene ketal is 82.7%, cyclohexanone 1,2-propanediol ketal is 83.4%, the yield of 2-propyl-1,3-dioxolane is 68.1%,4-methyl-2-isopropyl-1,3-dioxolane is 87.5%, the yield of 2-isopropyl-1,3-dioxolane is 70.7%,4-methyl-2-isopropyl-1,3-dioxolane is 82.5%, the yield of butanone ethylene ketal is 74.1%, and butanone 1,2-propanediol ketal is 94.9%.Some equation and experiment results concerned of the synthetic acetals or ketals were listed as follows.     

Synthesis of paramagnetic BODIPY dyes as new double (spin and fluorescence) sensors

Paramagnetic pyrroline and 1,2,3,6-tetrahydropyridine derivatives of BODIPY and their diamagnetic analogs have been synthesized and characterized as novel redox double sensor and cation sensitive reagents.     

Local adsorption sites and bondlength changes in Ni(1 0 0)/H/CO and Ni(1 0 0)/CO

The local adsorption geometry of CO adsorbed in different states on Ni(1 0 0) and on Ni(1 0 0) precovered with atomic hydrogen has been determined by C 1s (and O 1s) scanned-energy mode photoelectron diffraction, using the photoelectron binding energy changes to characterise the different states. The results confirm previous spectroscopic assignments of local atop and bridge sites both with and without coadsorbed hydrogen. The measured Ni–C bondlengths for the Ni(1 0 0)/CO states show an increase of 0.16 ± 0.04 Å in going from atop to bridge sites, while comparison with similar results for Ni(1 1 1)/CO for threefold coordinated adsorption sites show a further lengthening of the bond by 0.05 ± 0.04 Å. These changes in the Ni–CO chemisorption bondlength with bond order (for approximately constant adsorption energy) are consistent with the standard Pauling rules. However, comparison of CO adsorbed in the atop geometry with and without coadsorbed hydrogen shows that the coadsorption increases the Ni–C bondlength by only 0.06 ± 0.04 Å, despite the decrease in adsorption energy of a factor of 2 or more. This result is also reproduced by density functional theory slab calculations. The results of both the experiments and the density functional theory calculations show that CO adsorption onto the Ni(1 0 0)/H surface is accompanied by significant structural modification; the low desorption energy may then be attributed to the energy cost of this restructuring rather than weak local bonding.     

二次谐波系统在浑沌态下的光子统计

数值分析了调制泵浦作用下的二次谐波产生系统的浑沌动力学行为.考虑到混沌运动的遍历性,提出一种研究浑沌态光场光子统计的数值方法,即通过数值积分求解系统动力学方程估计光子数的系统平均.运用这一方法于二次谐波系统,计算了其在浑沌态下的光子统计分布,结果表明是一种超Poisson分布.     

KDP晶体三倍频实验和分析

报道了ＫＤＰ晶体中的三倍频产生的实验研究，计算了比较了直接三倍频过程和级联过程对ＫＤＰ晶体三阶有效非线性系数的贡献，并探讨了ＫＤＰ作为非线性晶体材料三阶非线性系数测量基准的可行性。     

LB膜混合聚集体中极性基团相互作用对光学非线性的影响

通过紫外－可见吸收光谱、压力－面积等温线、二次谐波的测量，研究了不同活性分子混合聚集体的形成对ＬＢ膜光学性质的影响。分子极性基团间的相互作用，使激发态能量及平均偶极矩发生变化，导致ＬＢ膜的光学非线性明显地增强或减弱。     

Ground-state complex formation of perylene with pyromellitic dianhydride studied by static fluorescence quenching

The association of complex formation with static quenching in CT systems was investigated. Evaluation of the data made evident that the inner filter effect must be allowed for. Time-resolved and temperature-dependent stationary measurements of fluorescence led to the separation of dynamic and static quenching components. The static quenching constant is discussed with respect to the equilibrium constant of complex formation determined by absorption spectroscopy.