股票市场监管策略的一个随机模型

研究了股市在一段有可能给社会造成危害的上涨行情中，管理者监管股市的问题＋根据股市的运行规律，建立了一个随机最优化模型，讨论了参数对解的影响，并得出了一些对股市监管有意义的结论．     

Problems of an additional experiment

In some situations estimates of unknown parameters must be corrected by additional measurements. It is in principle no problem to calculate the corrected estimates, however, it is of more interest to find formulae for correction itself. The formulae enable us to design an additional experiment and to judge its usefulness. The aim of the paper is to find such formulae for several situations. Supported by the grant of the Council of Czech Government MSM 6 198 959 214.     

Spectra of computable models for Ehrenfeucht theories

We construct an example of a theory with a finite (greater than one) number of isomorphism types of countable models such that its prime and saturated models have computable presentations and there exists a model which lacks in such. Supported by the Council for Grants (under RF President) and State Aid of Fundamental Science Schools via project NSh-4413.2006.1. __________ Translated from Algebra i Logika, Vol. 46, No. 3, pp. 275–289, May–June, 2007.     

生长曲线模型中回归系数阵的极大似然估计的精确分布

对于生长曲线模型,基于理论发展和应用效果的考虑,本文引入了Gauss型误差．在此误差下,本文研究了模型中回归系数阵的极大似然估计的精确分布,求出了此分布的密度和特征函数．     

湍流燃烧二阶矩模型的大涡模拟验证

对美国Sandia国家实验室测量的甲烷-空气湍流射流火焰进行了三维大涡模拟(LES),其统计的时均量以及脉动量符合实验测量值,且和RANS代数二阶矩湍流燃烧模型模拟结果大致符合。LES统计得到的化学反应率系数脉动和甲烷浓度脉动的互关联与对应的时均量梯度的乘积分布趋势相同,大小幅值的位置也相对应,与二阶矩湍流燃烧模型的封闭假设相符,验证了二阶矩代数燃烧模型的合理性。     

BNCT优化网格设计及相关算法研究

用MCNP蒙特卡罗程序模拟了硼中子俘获治疗(BNCT)3种国际基准网格模型, 并与 修正的Snyder椭球模型进行了比较. 在此基础上, 给出了一种保质量守恒、内存量少、易于产生输入文件的4种基本材料成分的BNCT网格模型. 计算结果表明, 在4mm网格下, 新模型可以达到基准模型的精度; 根据解析模型剂量随深度的变化规律, 研究构造了多网格组合模型, 在重要区域计算精度不损失的条件下, 计算时间大大缩短. 最后研究给出了一个既保证精度、又在可接受的时间内完成剂量计算的模型、样本数和相应的算法, 它基本上满足临床BNCT的要求.     

Computation of moisture and temperature profiles in soil—The coupled model

The coupled model has been developed in this study for moisture transport and beat exchange in soil. The model is driven by atmospheric conditions measured in a field. The concept that soil has a surface resistance to evaporation is introduced in order to relate the evaporation from surface with the vapour flux in air. With the use of this concept, the simulation results agree quite well with the measured data.     

负关联噪声驱动下单模激光的定态分析

研究了负关联的加法和乘法高斯白噪声驱动下单模激光损失模型的定态情况。文中推导了负关联情况下，定态时的激光场幅的几率分布，光强的平均值，光强的协方差以及光强的偏斜率。并和文献〔１，２〕中正关联时的定态分析作了比较，发现了有意义的新现象。     

Gas transport through homogeneous and asymmetric polyethersulfone membranes

Both homogeneous and asymmetric polyethersulfone (PES) membranes were prepared by solvent casting. The sorption and permeation behavior of CO₂, O₂, and N₂ using these two kinds of cast PES membranes and commercially available homogeneous PES film was investigated to extract the pressure dependence of gas permeability and the permselectivity for CO₂ relative to N₂, and to confirm the validity of the working assumption that a skin layer in an asymmetric membrane can be essentially replaced by a thick homogeneous dense membrane. The pressure dependence of the mean permeability coefficient to CO₂ in homogeneous membranes obeys the dual-mode mobility model. The ideal separation factor for CO₂ relative to N₂ at an upstream pressure of 0.5 MPa attains ca. 40, while the permeability to CO₂ is about 2.7 Barrer at the same upstream pressure. The same separation factor in asymmetric membranes amounts to 35. The diffusion behavior for the skin layer in an asymmetric membrane with a thin skin layer can be simulated approximately by that in a homogeneous dense membrane. © 1993 John Wiley & Sons, Inc.     

Slow crack growth in blends of HDPE and model copolymers

The resistance to slow crack growth (SCG) was measured in binary blends of high density polyethylene (HDPE) and 5–10% concentrations of model ethylene-butene random copolymers by measuring the time to failure (t_f) under a constant stress intensity. An increase of t_f with the addition of the copolymer if the copolymer could crystallize and the increase was greater the higher branch density. The copolymer with 117 branches/1000C could not crystallize and therefore its blend had a t_f that was less than that of the HDPE. The fracture energies of the blends as determined by their resistance to SCG were compared with the energy by rapid fracture, J_c, as previously measured by Rhee and Crist. It is concluded that SCG is more sensitive to variations in the microstructure than is rapid fracture and that the differences in SCG behavior can be qualitatively explained in terms of the differences in microstructure of the blends. ©1995 John Wiley & Sons, Inc.