流动注射-结晶紫-磷钼杂多酸离子缔合体系光度法测定水中痕量正磷酸盐

在一定的酸度条件下,结晶紫与磷钼杂多酸离子缔合物的流动注射分光光度法可直接测定痕量磷.灵敏度高,重现性和选择性好.水中常见离子不干扰痕量磷的测定,工作曲线的线性范围为0～500μg·L~(-1)的磷,检出下限达1.0μg·L~(-1),以120h~(-1)采样频率,对各种天然水样进行测定,回收率为92.5%～105.0%,相对标准偏差为0.1%～6.7%.     

Development and validation of a capillary electrophoresis method for the determination of phenothiazines in human urine in the low nanogram per milliliter concentration range using field-amplified sample injection

A capillary zone electrophoresis (CZE) method with ultraviolet-visible detection has been established and validated for the determination of five phenothiazines: thiazinamium methylsulfate, promazine hydrochloride, chlorpromazine hydrochloride, thioridazine hydrochloride, and promethazine hydrochloride in human urine. Optimum separation was obtained on a 64.5 cm x 75 microm bubble cell capillary using a buffer containing 150 mM tris(hydroxymethyl)aminomethane and 25% acetonitrile at pH 8.2, with temperature and voltage of 25 degrees C and 20 kV, respectively. Naphazoline hydrochloride was used as an internal standard. Field-amplified sample injection (FASI) has been applied to improve the sensitivity of the detection. Considering the influence of parameters affecting the on-line preconcentration (nature of preinjection plug, sample solvent composition, injection times, and injection voltage) and due to the significant interactions among them, in this paper we propose for the first time the application of a multivariate approach to carry out the study. The optimized conditions were as follows: preinjection plug of water for 7 s at 50 mbar, electrokinetic injection for 40 s at 6.2 kV, and 32 microm of H3PO4 in the sample solvent. Also, a solid-phase extraction (SPE) procedure is developed to obtain low detection limits and an adequate selectivity for urine samples. The combination of SPE and FASI-CZE-UV allows adequate linearities and recoveries, low detection limits (from 2 to 5 ng/mL), and satisfactory precisions (3.0-7.2% for an intermediate RSD %).     

Selective flow-injection determination of methanol in the presence of ethanol based on a multi-enzyme system with chemiluminescence detection

A highly selective flow-injection system was developed for the determination of methanol. The system consisted of three immobilized enzymes with luminol chemiluminescence detection. First, methanol was oxidized in the presence of alcohol oxidase to yield formaldehyde and hydrogen peroxide. The hydrogen peroxide produced was then destroyed by catalase. The formaldehyde formed in the first stage was further oxidized by NAD⁺-formaldehyde dehydrogenase. The NADH formed was oxidized by 1-methoxy-5-methylphenazinium methylsulphate (1-MPMS), and finally the reduced 1-MPMS was spontaneously oxidized and hydrogen peroxide was produced. The concentration of the hydrogen peroxide produced, which was proportional to the initial concentration of methanol, was determined by luminol chemiluminescence. The determination range was from 0.1 to 100 mg l⁻¹ and the response time was less than 2 min per sample with a relative standard deviation of less than 3%. The system showed good selectivity for methanol; the response was ca. 50 times higher than for ethanol.     

Enhancement of photocurrent generation by honeycomb structures in organic thin films.

A light-emitting poly (distyryldimethylbenzene-co-triethylene glycol) rod-coil block copolymer was used to fabricate films with three-dimensionally ordered honeycomb structures by the breath-figure method. Photocurrent generation and photovoltaic performance are studied, and the dependence of photocurrent on applied electric field is investigated. Introducing the ordered porous structure significantly improves the photoelectric conversion behavior, because porous structures not only enhance the light-harvesting efficiency but also benefit charge separation and charge transfer. This phenomenon may have great prospects for enhancing the photovoltaic behavior of organic thin-film devices.     

Stopped-flow injection analysis. The influence of diffusion on dispersion of normal and reverse flow injection

A relationship is derived to enable the comparison of the dispersion heights of normal and reverse flow injection analysis (FIA). A single channel flow system is employed in the absence of a chemical reaction. The stopped-flow injection method is used to probe the influence of molecular diffusion on the overall dispersion of normal and reverse FIA, which appeared to demonstrate fundamentally different diffusion behaviors. Small discrepancies are observed between the dispersion heights, which are enhanced by the stopped-flow period, especially when unmatched matrix ionic compositions of the indicator and counter solutions were involved. For these conditions, the diffusion flux rate is enhanced considerably, displaying a peak, in addition to the transient, for both methods. The influence of diffusion on the dispersion characteristics of normal and reverse FIA is discussed theoretically. Diffusion in the proposed model is postulated to oppose dispersion by convection. The latter initiates concentration gradients in the injection zone and propagates it with flow time over the dispersion zone profile. The diffusion flux then reacts in order to confine the indicator dispersion for normal FIA and to enhance it for reverse FIA. This model is consistent with the experimental results and accounts for most of the phenomena encountered. Probably owing to the influence of secondary flow phenomena, the use of coiled tubes has suppressed the effects of diffusion on the overall dispersion behavior.Part of the experimental work was performed at IMI Institute for Research and Development, Haifa, Israel.     

流动注射在线共沉淀HG-AFS测定痕量铅

建立了流动注射在线共沉淀HG-AFS测定痕量铅的分析方法。方法基于铅在碱性介质中与氢氧化镁共沉淀，沉淀收集在锥形沉淀腔中，用HCl溶洗沉淀和NaBH4反应，产生的氢化物被载气引入原子化器中进行测定。测定铅的RSD为3％(5ng/mL，n=10)，检出限为0．01ng。检出限较直接进样降低了11倍。对国家标准物质中铅的测定结果与标准值相符。     

Multicomponent analysis with a computerized flow injection system using LED photometric detection

An original computer-controlled solid-state photometer has been developed and its potential for simultaneous multicomponent flow-injection analysis of binary and ternary mixtures is demonstrated. The device is simple in construction. Its principle of operation is based on rapid sequential measurements of the absorbance of the complexes formed by the analytes with chromogenic reagents at the wavelengths corresponding to the emission maxima of three light emitting diodes (563, 580 and 638 nm).     

A comparative study of injection techniques in high-performance liquid chromatography

Summary The performance of injection valves with both curtain- and single-flow column couplings has been evaluated using reverse-phase octadecylsilane columns and a standard test mixture. The results are compared with those obtained from septum and stopped-flow syringe injections.Stopped-flow valve injection has been examined similarly. Configurations and couplings which give optimum efficiency and reproducibility are recommended.     

8-羟基喹啉-硅胶介质的合成及其在海水中痕量铅检测的应用

详细研究了以大孔硅胶为基质,一步合成8羟-基喹啉(8-HQ)型金属螯合色谱填料的方法,采用正交试验对合成方法进行了优化。与传统合成方法所得的填料进行了比较,从理化指标等方面来看,新的合成方法为佳。将该法用作微柱流动注射(FIA)在线分离、富集和电感耦合等离子体质谱(ICP-MS)分析流程中的固定相,对大洋海水中的痕量铅进行了在线分析,得到了较满意的结果。