高功率横流CO2激光器脉冲预电离过程研究

本文给出了对高功率横流CO_2激光器脉冲预电离过程的理论和实验研究.表明了预电离过程中光电离的重要作用.实验结果表明,脉冲预电离可增大高功率横流CO_2.激光器的pd值(p为放电气压、d为放电间隔),增大放电区注入功率密度.对于提高此类型激光器的放电稳定性和输出激光功率是一种技术简单而有效的手段.     

Investigation on Ochratoxin A stability using different extraction techniques

The stability of Ochratoxin A during its extraction using different extraction techniques has been evaluated. Microwave-assisted extraction and pressurised liquid extraction, in addition to two other reference methods of extraction, i.e. ultrasound-assisted and magnetic stirring-assisted extraction, were evaluated. The effect of extraction temperature using the cited techniques was checked.The results show that Ochratoxin A can be extracted using microwave-assisted extraction at temperatures up to 150 °C without degradation. Pressurised liquid extraction can be used at temperatures up to 100 °C, for extraction times of less than 30 min. Further, both ultrasound-assisted extraction and magnetic stirring extraction can be applied at temperatures up to 65 °C.High-performance liquid chromatography combined with fluorescence detection using a Chromolith RP-18e column at a flow rate of 5 mL min⁻¹ was used to quantify the Ochratoxin A. The retention time for the Ochratoxin A was 1.3 min. The limits of detection (LOD) and of quantification (LOQ) were 0.03 and 0.10 μg L⁻¹, respectively.     

Developing a hybrid emulsion polymerization system to synthesize Fe3O4/polystyrene latexes with narrow size distribution and high magnetite content

A hybrid emulsion polymerization was formulated for synthesizing Fe₃O₄/polystyrene composite latex. This system, containing binary droplets that are magnetic (Mag)‐droplets with a diameter of 100–200 nm and styrene (St)‐droplets with a diameter of 3–4 μm, was obtained by mixing Mag‐miniemulsion and St‐macroemulsion. With extremely low surfactants concentration (?critical micelle concentration, CMC), the nucleated loci are selectively controlled in the Mag‐droplets, as the result of smaller droplet size and larger surface ratio. Both water‐soluble potassium persulfate (KPS) and oil‐soluble 2,2′‐azobis(2‐isobutyronitrile) was adopted to initiate the polymerization. In the presence of KPS, magnetic polystyrene latices with particles size of 60–200 nm, narrow size distribution, and high magnetite content (86 wt % measured by TGA) were attained successfully. The synthesized magnetic Fe₃O_4/polystyrene latices assembled into well‐ordered hexagonal structure in the surface of a carbon supported copper grid. The influence of various parameters on various aspects of the as‐synthesized Fe₃O₄/polystyrene was investigated in detail: type of initiator on composite morphology, feed ratio of Mag‐miniemulsion and St‐macroemulsion on magnetite content, and hydrophobic agent or amount of surfactant on size and size distribution. © 2007 Wiley Periodicals, Inc. J Polym Sci Part A: Polym Chem 45: 5285–5295, 2007     

Quantification of trace elements in human serum fractions by liquid chromatography and inductively coupled plasma mass spectrometry

On‐line coupling of LC and ICP‐MS has been used for fractionation and detection of species of Cu, Fe, I, Se and Zn in human serum. It has been shown that anion exchange chromatography provided better separation capability (both intra‐ and inter‐element) than size‐exclusion chromatography. The mobile phases for ion exchange chromatography consisted of Tris–HNO₃ buffer and ammonium salt (nitrate, acetate or formate). Formate was found to be the best mobile phase counter ion, enabling good chromatographic separation, and is acceptable for mass spectrometry too. The quantitative evaluation of element concentrations adhering to individual fractions was performed by the peak area normalization method. The repeatability of results ranged from 3 to 15% (depending on the element concentration level) and represented the main part of the result uncertainty. The accuracy of Cu and Zn fraction determinations was confirmed by comparison with the isotope dilution technique. Copyright © 2006 John Wiley & Sons, Ltd.     

倾斜下降管气液两相分层流截面含气率的计算与液层高度的预测

分层流是气液两相流中常见的流动型式，分层流中液层高度是计算的基本数据，由于界面波的存在，对液层的测量和预测都很困难．Ｖｌａｃｈｏｓ提出了预测气液两相分层流液层厚度的关系式，但这一关系式并不适用于倾斜下降管气液两相流．本文提出了计算倾斜下降管气液两相分层流截面含气率的理论模型，在这种模型下得到的截面含气率和实验结果符合良好．在大量实验的基础上，考虑了倾角、管径、气液各相折算速度的影响，根据实验数据提出了预测液层厚度的关系式。     

介质的非均匀性对高次谐波影响的研究

讨论了气体介质的非均匀性对飞秒激光高次谐波产生过程的可能影响.计算结果表明,采用喷阀技术所提供的气体介质的密度梯度和气体原子运动速度的影响很小,不会产生实验上可观测的效果.这一结果支持了喷气靶在高次谐波产生中的广泛应用 关键词： 高次谐波 气体介质 各向异性 飞秒激光     

简析"静止液体内部压强公式验证"实验的设计策略

“静止液体内部压强公式验证”在现行教材中有两种实验方法。通过分析实验的设计策略，说明其作用、效果及操作上的困难，指出合理的与不合理诸因素，从而提出改进实验的方法，化难为易，提高实验教学效果。     

The Properties of Light Pressure Force with High Order in Laser Fields

1　Ｉｎｔｒｏｄｕｃｔｉｏｎ　　Ｉｎｒｅｃｅｎｔｙｅａｒｓ,ｂｏｔｈｔｈｅｔｈｅｏｒｅｔｉｃａｌａｎｄｅｘｐｅｒｉｍｅｎｔａｌｉｎｖｅｓｔｉｇａｔｉｏｎｓｏｎｌａｓｅｒｃｏｏｌｉｎｇａｎｄｔｒａｐｐｉｎｇｈａｖｅｂｅｃｏｍｅｏｎｅｏｆｔｈｅｍａｊｏｒｆｉｅｌｄｓｉｎａｔｏｍｉｃ,ｍｏｌｅｃｕｌａｒａｎｄｏｐｔｉｃａｌ ｐｈｙｓｉｃｓ[1～ 8] .Ｔｈｅｄｅｖｅｌｏｐｍｅｎｔｏｆｌａｓｅｒｃｏｏｌｉｎｇａｎｄｔｒａｐｐｉｎｇｔｅｃｈｎｏｌｏｇｙｉｓｉｍｐｏｒｔａｎｔｆｏｒｔｈｅａｐｐｌｉｃａｔｉｏｎｓｓｕ…     

高功率微波高斯馈源口面场分析

 用波导本征模展开方法对用于高功率微波发射系统的方角锥高斯馈源口面场进行分析，提出结合馈源远场辐射特性和避免高功率击穿折衷选定相应的高斯模注腰半径，进而确定多个波导模幅值，从而为运用模匹配或耦合波理论设计高斯馈源提供依据。     

Localized bifurcations and defect instabilities in the convection of a nematic liquid crystal

The stationary and the time-dependent homogeneous ordered states in convection may both become unstable against localized perturbations. Defects are then created and they may contribute to the disorganization of the homogeneous state. We present an experimental study of defects in some homogeneous stationary structures as well as in the traveling-wave states of convection of a nematic liquid crystal. We show that the core of the defects is a germ of the unstable state and it can become unstable under the external stress. Then, either fully homogeneous states with the symmetry of the core, or complex disordered states can develop from the local instability of defects in processes quite similar to displacive transitions in solids. Some of the main features are qualitatively similar to numerical simulations of an appropriate Landau-Ginzburg equation.