Reverse atom transfer radical polymerization of methyl methacrylate in room‐temperature ionic liquids

The reverse atom transfer radical polymerization (ATRP) of methyl methacrylate (MMA) was successfully carried out in 1‐butyl‐3‐methylimidazolium hexafluorophosphate with 2,2′‐azobisisobutyronitrile/CuCl₂/bipyridine as the initiating system, which had been reported as not able to promote a controlled process of MMA in bulk. The living nature of the polymerization was confirmed by kinetic studies, end‐group analysis, chain extension, and block copolymerization results. The polydispersity of the polymer obtained was quite narrow, with a weight‐average molecular weight/number‐average molecular weight ratio of less than 1.2. In comparison with other reverse ATRPs in bulk or conventional solvents, a much smaller amount of the catalyst was used. After a relatively easy removal of the polymer and residue monomer, the ionic liquid and catalytic system could be reused without further treatment. © 2002 Wiley Periodicals, Inc. J Polym Sci Part A: Polym Chem 41: 143–151, 2003     

1—甲基—3—西基咪唑六氟磷酸盐离子液的摩擦学性能

合成了1－甲基－3－西基咪唑六氟磷酸盐离子液体，采用核磁共振氢谱仪和傅立叶转换红外光谱仪表征了其结构；测定了该化合物的粘度、倾点和密度，在SRV摩擦磨损试验机上评价了其作为润滑剂对钢／钢体系的润滑作用；采用X射线光电子能谱仪和扫描电子显微镜分析了钢磨损表面形貌及化学状态，以考察其润滑机理。结果表明：1－甲基－3－丁基咪唑六氟磷酸盐离子液低温流动性能好，作为润滑剂对钢／钢摩擦副具有优异的润滑作用，摩擦系数极低，且抗磨性能优良。这是由于该离子液体在钢磨损表面形成含FePO4和FeF2等物质的边界润滑膜，从而有效地提高了摩损副的承载能力和抗磨性能。     

Determination of Copper in Food and Water by Dispersive Liquid-Liquid Microextraction and Flame Atomic Absorption Spectrometry

A new, simple, and rapid ionic liquid based dispersive liquid-liquid microextraction method is reported for the determination of copper with flame atomic absorption spectrometry. The ionic liquid, 1-butyl-3-methylimidazolium hexafluorophosphate, was used to extract a copper(II)- curcumin complex. The optimum extraction efficiency of copper was obtained after optimization of the ionic liquid volume, pH, centrifugation speed and time, ultrasonic bath time and temperature, and mass of curcumin. The effects of various ions on the recovery of copper(II) were also investigated. The preconcentration factor was 135. In the optimum experimental conditions, the limit of detection and the relative standard deviation were 0.19 microgram per liter and 4.1 percent, respectively. The method was validated by the analysis of certified reference materials and applied to food and water.     

Enrichment and sensitive determination of dichlorodiphenyltrichloroethane and its metabolites with temperature controlled ionic liquid dispersive liquid phase microextraction prior to high performance liquid phase chromatography

Dichlorodiphenyltrichloroethane (DDT) and its main metabolites are important environmental pollutants and have been in the focusing center. It is of great value to develop simple, rapid, sensitive and easy to operate method for monitoring them. Present work established a novel temperature controlled ionic liquid dispersive liquid phase microextraction method in combination with high performance liquid chromatography for the enrichment and determination of DDT and its metabolites. Proposed method used only ionic liquid 1-hexyl-3-methylimidazolium hexafluorophosphate ([C₆MIM][PF₆]) for the enrichment and overcame the demerits of conventional single drop liquid phase microextraction and dispersive liquid-liquid microextraction. Temperature has two functions here, one is to promote the dispersing of ionic liquid into the solution and forming infinitesimal micro-drop and increasing the chance of the analytes extracted into ionic liquid phase, and the other one is to perform phase-separation. A series of factors that would affect the extraction performance was systematically investigated and optimized. The experimental results indicated that the detection limits obtained for p,p′-DDD, p,p′-DDT, o,p′-DDT and p,p′-DDE were 0.24, 0.24, 0.45, 0.24 ng mL⁻¹, respectively. The linear ranges for them were from 1.0 to 100 ng mL⁻¹, and the precisions were between 3.8% and 6.7% (n = 6). The proposed method was validated with four real-world samples and excellent results were achieved.     

Crystallographic report: Thallium(18‐crown‐6) hexafluorophosphate, [Tl(18‐crown‐6)](PF6)

Thallium(18‐crown‐6) hexafluorophosphate was prepared and its structure was determined by X‐ray diffraction analysis. The Tl⁺ ion is surrounded by six oxygen atoms of 18‐crown‐6 and three fluorine atoms of , forming a sandwiched structure. If the three Tl–F interactions were considered significant, the coordination number in the title compound would be nine. Copyright © 2003 John Wiley & Sons, Ltd.     

Low-temperature performance of Li-ion cells with a LiBF<Subscript>4</Subscript>-based electrolyte

The effect of LiBF₄ on the low-temperature performance of a Li-ion cell was studied by using a 1:1:1 (wt) EC/DMC/DEC mixed solvent. The results show that the LiBF₄-based electrolyte has a 2- to 3-fold lower ionic conductivity and shows rather higher freezing temperature compared with a LiPF₆-based electrolyte. Owing to electrolyte freezing, cycling performance of the Li-ion cell using LiBF₄ was significantly decreased when the temperature fell below –20 °C. However, impedance data show that at –20 °C the LiBF₄ cell has lower charge-transfer resistance than the LiPF₆ cell. In spite of the relatively lower conductivity of the LiBF₄-based electrolyte, the cell based on it shows slightly lower polarization and higher capacity in the liquid temperature range (above –20 °C) of the electrolyte. This fact reveals that ionic conductivity of the electrolytes is not a limitation to the low-temperature performance of the Li-ion cell. Therefore, LiBF₄ may be a good salt for the low-temperature electrolyte of a Li-ion cell if a solvent system that is of low freezing temperature, high solubility to LiBF₄, and good compatibility with a graphite anode can be formulated. Electronic Publication     

Arene-Ruthenium(II) Complexes with Carbothiamidopyrazoles as a Potential Alternative for Antibiotic Resistance in Human

To meet the demand for alternatives to commonly used antibiotics, this paper evaluates the antimicrobial potential of arene-ruthenium(II) complexes and their salts, which may be of value in antibacterial treatment. Their antimicrobial activity (MIC, MBC/MFC) was examined in vitro against Staphylococcus aureus, Staphylococcus epidermidis, Enterococcus faecalis, Pseudomonas aeruginosa, Proteus vulgaris and Candida albicans and compared with classic antibiotics used as therapeutics. Selected arene-ruthenium(II) complexes were found to have synergistic effects with oxacillin and vancomycin against staphylococci. Their bactericidal effect was found to be associated with cell lysis and the ability to cut microbial DNA. To confirm the safety of the tested arene-ruthenium(II) complexes in vivo, their cytotoxicity was also investigated against normal human foreskin fibroblasts (HFF-1). In addition, the antioxidant and thus pro-health potential of the compounds, i.e., their nonenzymatic antioxidant capacity (NEAC), was determined by two different methods: ferric-TPTZ complex and DPPH assay.     

Sensitive determination of cadmium in water samples by room temperature ionic liquid-based preconcentration and electrothermal atomic absorption spectrometry

A sensitive preconcentration methodology for Cd determination at trace levels in water samples was developed in this work. 1-Butyl-3-methylimidazolium hexafluorophosphate ([C₄MIM][PF₆]) room temperature ionic liquid (RTIL) was successfully used for Cd preconcentration, as cadmium-2-(5-bromo-2-pyridylazo)-5-diethylaminophenol complex [Cd-5-Br-PADAP]. Subsequently, Cd was back-extracted from the RTIL phase with 500 μL of 0.5 mol L⁻¹ nitric acid and determined by electrothermal atomic absorption spectrometry (ETAAS). A preconcentration factor of 40 was achieved with 20 mL of sample. The limit of detection (LOD) obtained under optimum conditions was 3 ng L⁻¹ and the relative standard deviation (R.S.D.) for 10 replicates at 1 μg L⁻¹ Cd²⁺ concentration level was 3.5%, calculated at peak heights. The calibration graph was linear from concentration levels near the detection limits up to at least 5 μg L⁻¹. A correlation coefficient of 0.9997 was achieved. Validation of the methodology was performed by standard addition method and analysis of certified reference material (CRM). The method was successfully applied to the determination of Cd in river and tap water samples.     

Segment Coupling to a Highly Hindered N-Terminal, Alamethicin-Related alpha-Aminoisobutyric Acid (Aib) Residue

A model [6+5] segment coupling process involving a C-terminal valine hexapeptide acid and a resin-attached pentapeptide amide, which N-terminated in a hindered Aib unit, was examined using a variety of HOAt-derived coupling reagents. Best results were observed with N-HAPyU in DCM solvent in which loss of configuration amounted to 5.8%.