New (1R,4R)-2-arylidene-p-menthan-3-ones with a bridging ester group in the arylidene fragment. Synthesis and behavior in liquid-crystalline systems

(1R,4R)-2-(4-Hydroxybenzylidene)- and (1R,4R)-2-(4"-hydroxybiphenyl-4-yl)methylene-p-menthan-3-ones were synthesized by condensation of (–)-menthone with O-tetrahydropyran-2-yl derivatives of 4-hydroxybenzaldehyde and 4"-hydroxy-4-formylbiphenyl, respectively, in a DMSO—base medium followed by the removal of the protective group. The reactions of these hydroxy derivatives with 4-alkylbenzoic, 4-alkyloxybenzoic, trans-4-alkylcyclohexane-4-carboxylic, and 4"-alkylbiphenyl-4-carboxylic acids afforded three series of new chiral esters. Compounds containing the arylidene moiety with three benzene rings were found to exhibit liquid-crystalline properties. The characteristic features of these compounds are discussed based on the results of studies by polarizing microscopy, differential scanning calorimetry, and small-angle X-ray scattering. It was found that the mesomorphic compounds under study can form a smectic A mesophase, twist grain boundary mesophases (TGBA), and blue phases in a wide temperature range. Upon dissolution of certain of chiral compounds in 4"-cyano-4-pentylbiphenyl, a rather high twisting power and the thermal stabilizing effect on mesophases were observed.     

光谱电化学法研究亚甲基蓝的电还原反应

用极谱法研究亚甲基蓝(MB)的电极吸附过程早有报道.近几年,用光谱电化学法研究其电化学行为又引起了许多人的兴趣.但在光透薄层电极上,由于光程太短,测试溶液浓度较高,导致亚甲基蓝发生聚合,影响实验结果的准确测定.为此本文利用特制的比色皿型长光程薄层光谱电化学池,在低浓度条件下研究其在SnO_2镀膜玻璃电极上的电还原反应.     

多色蓝在核酸分子上的Langmuir聚集吸附

用微相吸附-光谱修正（MPASC）新技术研究核酸与多色蓝(PCB)探针分子间的相互作用，分析核酸分子内双静电膜的形成与Langmuir吸附的关联性.通过pH 7.24的介质核酸-PCB反应的光谱研究，测定了结合产物的物理化学参数：结合比1PCB:2DNA-PCB、1PCB:3RNA-PCB, 平衡常数KDNA-PCB=5.42×104， KRNA-PCB=2.82×104,摩尔吸收系数ε(DNA-PCB, 625 nm)=5.65×103（mo1－1•L ）•cm－1， ε(RNA-PCB, 625 nm)=3.85×103 （mol－1•L）•cm－1.结果表明， RNA分子仅形成约60％双螺旋结构链，核酸双螺旋每一周期的负静电沟最大聚集10个PCB分子.该吸附反应用于核酸样品测定，结果良好.     

Near-infrared fluorimetric determination of nucleic acids by shifting the ion-association equilibrium between heptamethylene cyanine and Alcian blue 8GX

A new method based on near-infrared (near-IR) fluorescence recovery, employing a two-reagent system which is composed of an anionic heptamethylene cyanine (HMC) and a polycationic phthalocyanine dye, Alcian blue 8GX, is presented for the determination of nucleic acids. With a maximum excitation wavelength at 766 nm and a maximum emission wavelength at 796 nm, the fluorescence recovery is linear with the concentration of nucleic acids added. Factors including the acidity of the medium, the reaction time, the optimal ratio of the two reagents, as well as the influence of foreign substance were all investigated. Meanwhile, the mechanism of fluorescence recovery was also studied. Under the optimal conditions, the linear ranges of the calibration curves were 10-250 ng ml⁻¹ for calf thymus DNA (CT DNA) and 10-200 ng ml⁻¹ for yeast RNA. The detection limits were 6.8 ng ml⁻¹ for CT DNA and 6.3 ng ml⁻¹ for yeast RNA, respectively. The method has been applied to the analysis of practical samples and the recovery results were satisfactory.     

A new affinity-HPLC packing for protein separation: Cibacron blue attached uniform porous poly(HEMA-<Emphasis Type="Italic">co</Emphasis>-EDM) beads

In this study, a new affinity high-performance liquid chromatography (HPLC) stationary phase suitable for protein separation was synthesized. In the first stage of the synthesis, uniform porous poly(2-hydroxyethyl methacrylate-co-ethylene dimethacrylate), poly(HEMA-co-EDM), beads 6.2 μm in size were obtained. Homogeneous distribution of hydroxyl groups in the bead interior was confirmed by confocal laser scanning microscopy. The plain poly(HEMA-co-EDM) particles gave very low non-specific protein adsorption with albumin. The selected dye ligand Cibacron blue F3G-A (CB F3G-A) was covalently linked onto the beads via hydroxyl groups. In the batch experiments, albumin adsorption up to 60 mg BSA/g particles was obtained with the CB F3G-A carrying poly(HEMA-co-EDM) beads. The affinity-HPLC of selected proteins (albumin and lysozyme) was investigated in a 25 mm×4.0-mm inner diameter column packed with CB F3G-A carrying beads and both proteins were successfully resolved. By a single injection, 200 μg of protein was loaded and quantitatively eluted from the column. The protein recovery increased with increasing flow rate and salt concentration of the elution buffer and decreased with the increasing protein feed concentration. During the albumin elution, theoretical plate numbers up to 30,000 plates/m were achieved by increasing the salt concentration.     

氯酸钾氧化酸性铬深蓝催化光度法测定痕量钒

基于硫酸介质中,酒石酸作活化剂,钒催化氯酸钾氧化酸性铬深蓝,建立了催化光度法测定痕量钒的新方法并讨论了其动力学条件。灵敏度1.47×10~(11)g/ml,测定范围0～9ng/ml。方法简便快速,用于水及食品中痕量钒的测定,结果满意。     

Determination of proteins in human serum by combination of flow injection sampling with resonance light scattering technique

A flow injection method combined with Resonance light scattering detection was developed for the determination of protein concentration in human serum samples. This method is based on the enhanced RLS signals of protein binding with the dye acid chrome blue K. The enhanced RLS intensities at 264 nm, in an acidic aqueous solution, were proportional to the protein concentration over the range of 2.0–40.0 μg·mL⁻¹ for human serum albumin (HSA) and the limit of detection (3σ) is 85 ng·mL⁻¹. This method was successfully applied to the quantification of total proteins in human serum samples. The maximum relative standard deviation is less than 2% and the recovery is between 97 and 103% for the standard addition method. The sample throughput was 60 h⁻¹.     

Quantitative Determination of Oxalic Acid Using Victoria Blue B Based on a Catalytic Kinetic Spectrophotometric Method

A sensitive catalytic method is developed for the spectrophotometric determination of oxalic acid. The procedure is based on the effect of oxalate on the oxidation of Victoria blue B by dichromate in dilute sulfuric acid medium. The reaction is quantitatively estimated by measuring the decrease in absorbance of Victoria blue B at the maximum wavelength of 610nm after quenching the reaction with tap water. The factors effecting the sensitivity and reproducibility of the reaction were studied. The method is not interfered with by foreign species generally associated with oxalate and oxalic acid. The described method is simple, specific, inexpensive and suitable for oxalic acid concentrations of between 0.06 and 9.0µgmL^–1. It was validated with satisfactory results by determining oxalic acid content in water extracts from plant materials such as spinach and Lathyrus sativus.     

Determination of trace amounts of bromide by flow injection/stopped-flow detection technique using kinetic-spectrophotometric method

A simple, sensitive and selective method for the determination of bromide in seawater by using a flow injection/stopped-flow detection technique was examined. The detection system was developed for a new kinetic-spectrophotometric determination of bromide in the presence of chloride matrix without any extraction and/or separation. The detection was based on the kinetic effect of bromide on the oxidation of methylene blue (MB) with hydrogen peroxide in a strongly acidic solution. Large amounts of chloride could enhance the sensitivity of the method as an activator. The decolorisation of the blue color of MB was used for the spectrophotometric determination of bromide at 746 nm. A stopped-flow approach was used to improve the sensitivity of the measurement and provide good linearity of the calibration over the range of 0-3.2 μg ml⁻¹ of bromide. The relative standard deviation was 0.74% for the determination of 2.4 μg ml⁻¹ bromide (n = 5). The detection limit (3σ) was 0.1 μg ml⁻¹ with a sampling frequency of 12 h⁻¹. The influence of potential interfering ions was studied. The proposed method was applied to the determination of bromide in seawater samples and provided satisfactory results.     

溶剂热法制备Ag/TiO2纳米材料及其光催化性能

以乙醇为溶剂, 钛酸四丁酯为前驱体, 用溶剂热法制备了Ag表面修饰的负载型纳米二氧化钛光催化剂. 利用X射线衍射(XRD)、N₂吸附-脱附(BET)、透射电子显微镜(TEM)、X射线光电子能谱(XPS)、紫外-可见(UV-Vis)光谱等技术对其进行了系统的表征, 以亚甲基蓝(MB)溶液的脱色降解为模型反应, 考察了不同Ag含量样品的光催化性能. 结果表明: 用溶剂热法制备的样品中TiO₂皆为锐钛矿相, 金属Ag颗粒沉积在TiO₂表面, 粒径为2 nm左右, 比表面积较溶胶凝胶法制备的样品大大增加, 最高可达151.44 m²·g^-1; UV-Vis光谱和光催化实验表明: Ag修饰使TiO₂对光的吸收能力大大增强, 吸收带边红移至可见光区, 亚甲基蓝在该复合材料上的光催化降解反应遵循一级反应动力学模型; 溶剂热法制备样品的光催化性能明显好于溶胶凝胶法制备的样品, 在紫外光和可见光下, Ag摩尔分数为5%的样品表现出最佳的光催化活性.