Ring‐opening grafting polymerization of cyclic monomers onto human hair

Natural human hair was successfully modified by the graft polymerization of trimethylene carbonate, β‐propiolactone, ε‐caprolactone, glycidol, ε‐caprolactam, and 5,5‐dimethyl‐1,3‐dioxane‐2‐thione. In contrast, we could not modify natural human hair by the graft polymerization of oxetane under similar conditions. The model reaction suggested that the main initiating species in these polymerizations were the amino, thiol, and hydroxyl groups in hair, which could induce ring‐opening polymerization. Among the tested monomers, β‐propiolactone was most effective for hair modification with its graft polymer, whose concentration was as high as 0.5 g/g of hair though polymerization under mild conditions. The effects of the hair pretreatment and polymerization temperature on the weight ratio of the grafted polymers were also investigated. Hair modified by grafted polymers was characterized with scanning electron microscopy and Fourier transform infrared measurements. © 2007 Wiley Periodicals, Inc. J Polym Sci Part A: Polym Chem 45: 736–744, 2007     

带有奇异项的临界增长p-Laplace方程的非平凡解

本文研究了一种带有奇异项的临界增长p-Laplace方程在N维空间中的有界集上非平凡解的问题,利用山路引理和集中紧性原理,得出方程在非线性项满足一定条件下有非平凡解的结果.     

Bayes估计的进一步研究及其Pitman最优性

对线性模型参数,讨论了Bayes估计的Pitman最优性,将已有结果进行了改进,去掉了附加条件,证明了在Pitman准则下,Bayes估计一致优于最小二乘估计(LSE),在此基础上,提出了一种基于先验信息的方差分量估计,通过和基于LSE的方差分量估计作比较,证明了新估计是无偏估计且有更小的均方误差．最后,证明了在Pitman准则下生长曲线模型参数的Bayes估计优于最佳线性无偏估计．     

Growth Behavior of CdS Nanoparticles Embedded in Polymer and Sol-Gel Silica Matrices: Relationship with Surface-State Related Luminescence

Chemical techniques were employed to synthesize CdS nanoparticles embedded in polymer (PEG 300) and sol-gel silica matrices. Systematic growth of particles (radius 3–9 nm) was obtained by adjusting post-deposition annealing temperature and time to examine the dependence of surface-state–related luminescence on particle size. Photoluminescence (PL) peak energy showed a linear dependence with a gentle slope in the weak confinement region and a steep slope in the strong confinement region, the divergence being observed near the excitonic Bohr radius for CdS. The empirical relation proposed for the weak confinement region could be used for estimating chemically prepared CdS nanoparticle size with a high degree of reliability from PL peak energy.     

Optical spectroscopy of Yb/Er codoped NaY(WO4)2 crystal

Erbium and ytterbium codoped double tungstates NaY(WO₄)₂ crystals were prepared by using Czochralski (CZ) pulling method. The absorption spectra in the region 290-2000 nm have been recorded at room temperature. The Judd-Ofelt theory was applied to the measured values of absorption line strengths to evaluate the spontaneous emission probabilities and stimulated emission cross sections of Er³⁺ ions in NaY(WO₄)₂ crystals. Intensive green and red lights were measured when the sample were pumped by a 974 nm laser diode (LD), especially, the intensities of green upconversion luminescence are very strong. The mechanism of energy transfer from Yb³⁺ to Er³⁺ ions was analyzed. Energy transfer and nonradiative relaxation played an important role in the upconversion process. Photoexcited luminescence experiments are also fulfilled to help analyzing the transit processes of the energy levels.     

The Effect of Boundary Conditions on Gas-phase Synthesised Silver Nanoparticles

We have prepared spherical non-agglomerated silver nanoparticles by an evaporation–condensation–dilution/cooling technique. Silver was evaporated from a crucible in a tubular flow reactor. A porous tube diluter was used to quench the carrier gas at the outlet of the reactor to enhance the formation of small particles and to suppress agglomeration and other particle growth mechanisms. The number size distribution of the prepared particles was measured with a differential mobility analyser–condensation nucleus counter combination and the size and the shape of the particles were analysed with transmission electron microscope. The system was modelled using a sectional aerosol dynamics computer code to estimate the importance of different aerosol processes. In all conditions the particles obtained were non-agglomerated and spherical. The mean particle diameter varied from 4 to 10-nm depending on boundary conditions. From the modelling studies it can be concluded that the nucleation rate is the most important parameter controlling the final particle size.     

Structural studies of Cr-doped mullite derived from single-phase precursors

Cr-doped mullites were prepared from single-phase precursors containing up to 9.60 wt% Cr₂O₃ using a sol-gel technique followed by thermal treatment. Particle induced X-ray emission spectroscopy and X-ray powder diffraction were used to characterize the samples. Mullites were orthorhombic, space group Pbam. Cr doping caused the increase of unit-cell parameters. Strongest expansion was noticed along c-axis followed by a and b (Δc/c=0.089, Δa/a=0.061, Δb/b=0.045% per mole Cr₂O₃). A second phase, namely θ-(Al,Cr)₂O₃, was revealed by XRD in the sample containing 9.60 wt% Cr₂O₃. The structure of mullites was refined by the Rietveld method, location of Cr³⁺ was performed by the EPR spectroscopy. At low chromium doping level (Cr₂O₃ content less than ∼5 wt%) Cr³⁺ ions were substituted for Al³⁺ in the AlO₆ octahedra of the mullite structure (M1 site). For higher doping level, Cr³⁺ ions were additionally substituted for Al³⁺ in the AlO₆ octahedra of the second phase [θ-(Al,Cr)₂O₃ at 1400 °C, or α-(Al,Cr)₂O₃ at 1600 °C] which segregated in the system. Substitution of Cr³⁺ for Al³⁺ on M1 site in the mullite structure resulted in increase of average distances in (M1)O₆ octahedron and decrease of average distances in T*O₄ tetrahedron, while average distances in TO₄ tetrahedron stayed almost constant.     

The steady state growth rate of a recrystallization front in regions of heterogeneous dislocation density

The paper investigates whether a change from a homogeneous to an inhomogeneous dislocation distribution, assumed to be caused by a slight additional deformation, can lead to an increase of the recrystallization temperature of a deformed metal. In this case, the higher temperature would indicate a more stable deformation structure despite the increase of stored energy. The recrystallization temperature is related to the growth rate. Hence, the steady state velocity of a recrystallization front moving either parallel or vertically to the stripes of a simplified two-dimensional heterogeneous dislocation distribution of parallel sections of higher and lower dislocation densities is calculated. The results show that if a front growths through the high and low density sections in series an overall slower rate despite higher mean dislocation density is, indeed, possible. However, growing in the parallel arrangement always leads to a higher growth rate compared with the homogeneous case of slightly less stored energy. Since in a real structure the faster growth is likely to succeed, the recrystallization temperature observed will be lowered with additional deformation in accordance with experimental experience.     

An efficient lasing action from pyrromethene 556 dye-doped organically modified silicates

Organically modified solid-state silicates (ORMOSILS) doped with a new laser dye 1,3,5,7,8-pentamethylpyrromethene-2,6-disulfonate-BF₂ complex (pyrromethene 556) have been synthesized by a sol-gel method and the compositional effects on pore characteristics, fluorescence and lasing properties have been investigated. It is found that the use of dimethylsulfoxide and γ-glycidoxypropyltrimethoxysilane could greatly change the structure properties of sol-gel derived ORMOSILS cage, and thus the fluorescence and lasing properties of the materials could improve significantly. A successful laser oscillation from this dye-doped ORMOSILS sample has been achieved upon pumping with a Q-switched frequency-doubled Nd:YAG laser at 532 nm. A slope efficiency of 54% with a useful lifetime greater than 10,000 shots has been demonstrated at a pump repetition rate of 1 Hz and a pump intensity of 1 J/cm² by using the new ORMOSILS cage on our newly designed laser system. Our results have shown that it is possible to obtain a high-efficiency with a long-lifetime for a compact new laser device by low cost dye-doped solid-state ORMOSILS.     

A note on the growth of topological Sidon sets

We give an estimate for the number of elements in the intersection of topological Sidon sets inR ⁿ with compact convex subsets and deduce a necessary and sufficient conditions for an orbit of a linear transformation ofR ⁿ to be a topological Sidon set.