利用大分子单体技术合成接枝共聚物

大分子单体和小分子共单体共聚是合成接枝共聚物的重要途径之一。本文综述了大分子单体通过各种聚合方式(自由基共聚、离子型共聚、配位共聚、基团转移共聚和逐步共聚)和普通小分子单体的共聚反应,详细讨论了大分子单体和小分子单体的自由基共聚反应动力学,并简要介绍了接枝共聚物的应用背景。     

窄分布聚丙烯酸-g-聚甲基丙烯酸酯接枝共聚物的合成

利用合成的一种新型原子转移自由基聚合大分子引发剂和从主干接枝的方法制备了窄分布的两亲性接枝共聚物聚丙烯酸-g-聚甲基丙烯酸酯, 并对其结构进行表征. 产物主链和侧链的分子量可分别通过调整单体与引发剂的投料比和反应时间进行控制, 结构规整, 侧链单体适用范围广. 该合成方法不仅推动了接枝共聚物合成研究的进展, 其产物更为两亲性接枝共聚物自组装行为的研究提供了很好的研究对象.     

淀粉接枝丙烯酸/醋酸乙烯酯高吸水性树脂的制备

以过硫酸铵为引发剂,N,N-亚甲基双丙烯酰胺为交联剂,淀粉与丙烯酸/醋酸乙烯酯混合单体通过接枝共聚,制备了吸水及耐盐性能均较好的淀粉接枝丙烯酸/醋酸乙烯酯高吸水性树脂(CGAV)。最佳工艺条件为:淀粉10.0 g,m(混合单体)∶m(淀粉)=4∶1,w(引发剂)=0.3%,w(交联剂)=0.05%,于45℃反应2h~3 h。在最佳工艺条件下制得的CGAV吸去离子水率760 g.g-1,吸0.9%NaC l水溶液率68 g.g-1。     

SBS与甲基丙烯酸丁酯本体接枝反应的研究

本文研究了以过氧化苯甲酰(BPO)为引发剂,甲基丙烯酸丁酯(BMA)既作溶剂又作为单体与苯乙烯-丁二烯嵌段共聚物(SBS)进行接枝共聚反应。用红外光谱、核磁共振谱及透射电镜表征了接枝共聚物(SBS-g-BMA)的组成及结构,讨论了时间、温度及SBS和BPO的用量对接枝的影响。     

Grafting of maleic anhydride to hydrocarbons below the ceiling temperature

Maleic anhydride has been grafted to eicosane and squalane at 60–80°C using 1,2-dichlorobenzene as solvent and benzoyl peroxide as initiator. These hydrocarbons are low molecular weight models for hydrocarbon polymers containing secondary and tertiary hydrogen atoms. In the absence of the hydrocarbon and with monomer concentrations of the order of 1M, low molecular weight poly(maleic anhydride) is formed. On addition of the hydrocarbon, the main product is grafted material and very little homopolymer is formed. The grafts consist primarily of single succinic anhydride units but some of them are short poly(maleic anhydride) chains. Ceiling temperature considerations control the formation of homopolymer in the absence of hydrocarbon substrate. In the presence of eicosane or squalane, initiation of grafting proceeds by hydrogen abstraction from the hydrocarbon. The main factor controlling graft length is then the ratio of the rates of intramolecular hydrogen abstraction and of monomer addition to succinic anhydride radicals © 1995 John Wiley & Sons, Inc.     

表面活性剂对纤维素接枝共聚物溶液粘度性质的影响

研究了阴离子十二烷基硫酸钠(SDS)、阳离子十六烷基三甲基溴化铵(CTAB)和非离子聚乙二醇辛基苯基醚(OP)等三种不同类型的表面活性剂对疏水化水溶性两性纤维素接枝共聚物(CGAO)溶液粘度性质的影响.结果表明,在SDS和OP的临界胶束浓度(cmc)附近，CGAO溶液粘度最大，SDS引起CGAO粘度的变化大于OP；即使在CTAB的cmc附近，随着CTAB浓度的增加，CGAO的粘度一直呈下降趋势；非疏水改性的纤维素接枝共聚物的溶液粘度随SDS或CTAB浓度的增加而下降，但几乎不随OP浓度的增大而变化.此外，通过凝胶渗透色谱法测得的保留时间证实了SDS、CTAB和OP与CGAO之间的疏水缔合作用.     

Pre-irradiation induced grafting of styrene into crosslinked and non-crosslinked polytetrafluoroethylene films for polymer electrolyte fuel cell applications. II: Characterization of the styrene grafted films

Crosslinked and non-crosslinked polytetrafluoroethylene films (RX-PTFE and V-PTFE films, respectively) were irradiated by γ-ray and then grafted with styrene in liquid phase. Microscope FT-IR spectroscopy, TGA, solid state ¹³C CP/MAS and high resolution HS/MAS NMR spectroscopy, wide-angle X-ray diffraction (WAXD) study were used to get the structural information of the styrene grafted RX-PTFE and V-PTFE films. From microscope FT-IR spectra of the grafted RX-PTFE films, the “grafting front mechanism” was proved. TGA analysis showed that the grafted films have a small degradation step and two main degradation steps. In the ¹³C CP/MAS NMR spectra of the non-grafted films, there are no signal due to the absence of the hydrogen atom. While in the spectra of the grafted films, there are signals attributed to the polystyrene grafts. In the ¹³C HS/MAS NMR spectra of the grafted films, the relative intensity of the peaks attributed to the polystyrene grafts increased while the relative intensity of the peak attributed to PTFE matrix decreased with the increase in the DOG. From WAXD patterns, the intensity of the crystalline peak decrease with the increase in the DOG. The grafted films were sulfonated by chlorosulfonic acid and the results of highest IEC value exceeded 3.0. Those results will be reported in the near future.     

Graft copolymerization of methyl acrylate onto potato starch initiated by ceric ammonium nitrate

A study was made of the ceric ammonium nitrate (CAN) initiated graft copolymerization of methyl acrylate (MA) onto potato starch. The variables affecting the graft were investigated. The optimums have been obtained; they are the concentrations of MA, CAN, and nitric acid (HNO₃) (1.08, 5.0 × 10^?3, and 0.081 mol/L, respectively). The reaction temperature is ca. 50°C and the reaction time is 2 h. The molecular weight of grafted poly(methylacrylate) has been determined. On the basis of experimental results, the mechanism of grafting has been explored, a new kinetic equation of the graft copolymerization is established: R_p = Kk_d [STOH] [Ce⁴⁺] + Kk_pk_d/k_t[STOH][M], where K, k_d, k_p, and k_t are constants. The equation fits the results of experiments. © 1993 John Wiley & Sons, Inc.     

电化学方法对两性接枝星形聚合物LB膜屏蔽效应的研究

本文将自制Y式玻碳电极拉上两性接枝星形聚合物(GPSMA)的LB膜,用循环伏安法研究谈膜的屏蔽效应,讨论了接枝量、成膜条件等对膜缺陷的影响,并提出了减少缺陷的办法。     

Improving the properties of the proton exchange membranes by introducing α-methylstyrene in the pre-irradiation induced graft polymerization

New proton exchange membranes (PEMs) were prepared by pre-irradiation induced grafting of α-methylstyrene (AMS)/styrene (STY)/divinylbenzene (DVB) into the crosslinked polytetrafluoroethylene (RX-PTFE) films and successively sulfonated. The new PEMs showed the improved glass transition temperature and chemical stability as compared with the PEMs prepared by pre-irradiation induced grafting of STY/DVB. The balance of the cost, grafting kinetic, thermal properties and the properties of the resulted proton exchange membrane is the key point of this work.