Solvent and thiourea adsorption/intercalation effects on the solid-state electrochemistry of α-phase nickel hydroxide nanoparticles

Nanoparticles of α-phase nickel hydroxide were synthesized by a single-step hydrothermal method using urea as the hydrolytic agent. Precipitated powders were of pure turbostratic α-phase as confirmed by x-ray diffraction profile. The ageing of α-Ni(OH)₂ in 1.0 M alkali solutions is investigated for pure non-intercalated α-Ni(OH)₂ and thiourea intercalated/absorbed α-phase nanomaterials. The α-Ni(OH)₂ powder immobilized on the surface of graphite electrodes shows a gradual α→β phase transformation with continuous voltammetric cycling, and the concentration gradient of water that exists in the layered-double-hydroxide-like interlayers of α-phase and the solution was shown to play a crucial role on the high electrochemical activity of this phase nickel hydroxide. To understand the role of water in the ageing process, concomitant entries of non-aqueous solvents like ethanol and acetonitrile along with thiourea were effected. Cyclic voltammetric measurements of thiourea-treated α-Ni(OH)₂ samples revealed that hydroxyl ion influx during the anodic oxidation depends on the counter flux of solvent molecules, and if the intercalated the solvent is acetonitrile, then the electrochemical activity of α-Ni(OH)₂ reduced drastically; Q _a/Q _c>1 for water as solvent in the interlayers α-Ni(OH)₂ and Q _a/Q _c<1 for ethanol and acetonitrile as solvents. The α-phase gets stabilized in the presence of thiourea with water and ethanol as co-intercalates. Transmission electron microscope images of α-Ni(OH)₂ and thiourea-treated samples show a change in particle size and morphology. Elemental CHNS analysis confirms the presence of sulphur in the thiourea intercalated samples.     

Effect of the Electrode Potential on the Oxygen Reaction Rate in the Electrode System O2, Au/La0.88Sr0.12Ga0.82Mg0.18O2.85

The polarization dependences of a porous gold electrode in contact with a solid electrolyte of the composition La_0.88Sr_0.12Ga_0.82Mg_0.18O_2.85 are studied at 600–800°C and oxygen pressures of 2 × 10⁻²-1 atm. It is shown that the rate of cathodic reduction of oxygen out of the gas phase depends on the preliminary treatment of the sample. The activation energy is equal to 110–135 kJ mol⁻¹ at a low polarization. After increasing the polarization, the activation energy for the cathodic reduction of oxygen equals 75–85 kJ mol⁻¹ and depends on the oxygen pressure as a power function with a power index of 1/4. The rate of the anodic evolution of oxygen is dependent neither on the preliminary treatment of the sample nor on the oxygen pressure in the gas phase and the polarization curve has a characteristic segment, which corresponds to a limiting overvoltage.__________Translated from Elektrokhimiya, Vol. 41, No. 8, 2005, pp. 954–962.Original Russian Text Copyright © 2005 by Shkerin, Sokolova, Beresnev.     

Dual‐Amplification of Antigen–Antibody Interactions via Backfilling Gold Nanoparticles on (3‐Mercaptopropyl) Trimethoxysilane Sol‐Gel Functionalized Interface

A new dual‐amplification strategy of electrochemical signaling from antigen–antibody interactions was proposed via backfilling gold nanoparticles on (3‐mercaptopropyl) trimethoxysilane sol‐gel (MPTS) functionalized interface. The MPTS was employed not only as a building block for the electrode surface modification but also as a matrix for ligand functionalization with first amplification. The second signal amplification strategy introduced in this study was based on the backfilling immobilization of nanogold particles to the immunosensor surface. Several coupling techniques, such as with nanogold but not MPTS or with MPTS but not nanogold, were investigated for the determination of carcinoembryonic antigen (CEA) as a model, and a very good result was obtained with nanogold and MPTS coupling immunosensor. With the noncompetitive format, the formation of the antigen–antibody complex by a simple one‐step immunoreaction between the immobilized anti‐CEA and CEA in sample solution introduced membrane potential change before and after the antigen–antibody interaction. Under optimal conditions, the proposed immunosensor exhibited a good electrochemical behavior to CEA in a dynamic concentration range of 4.4 to 85.7 ng/mL with a detection limit of 1.2 ng/mL (at 3 δ). Moreover, the precision, reproducibility and stability of the as‐prepared immunosensor were acceptable. Importantly, the proposed methodology would be valuable for diagnosis and monitoring of carcinoma and its metastasis.     

Synthesis and characterization of silver nanoparticle/kaolinite composites

Ag nanoparticles were synthetized in the interlamellar space of a layered kaolinite clay mineral. Disaggregation of the lamellae of non-swelling kaolinite was achieved by intercalation of dimethyl sulfoxide. The kaolinite was suspended in aqueous AgNO₃ solution and, after adsorption of Ag⁺, the ions were reduced with NaBH₄. The interlamellar space limits particle growth (d_ave=3.8–4.2 nm); however, larger silver particles may be formed on the exterior surface of kaolinite with d_ave=5.6–10.5 nm diameter. The diameter of the particles prepared in this way is depending on the initial AgNO₃ concentration. The silver nanoparticles prepared were characterized by UV–vis spectroscopy, X-ray diffraction (XRD), Small angle X-ray scattering (SAXS), X-ray photoelectron spectroscopy (XPS) and Transmission electron microscopy (TEM).     

Electrochemical Behavior and Determination of Uric Acid at Single-Walled Carbon Nanotube Modified Gold Electrodes

The voltammetric behavior of uric acid was studied at a single-walled carbon nanotube (SWNT) modified gold electrode. Uric acid can effectively accumulate at this electrode and produce an anodic peak at about 0.45 V (vs. SCE) in pH 5.0 sodium acetate buffer solutions (HAc-NaAc). The experimental parameters, such as solution pH, accumulation time, and amount of SWNT, were optimized for determination. Under the optimum conditions, the anodic peak current is linear to the uric acid concentration over the range of 1.0×10⁻⁷ M to 2.5×10⁻⁵ M with a correlation coefficient of 0.998. The detection limit was 5.0×10⁻⁸ M for 60 s accumulation. The electrode could be easily regenerated and exhibited good stability. A 5.0×10⁻⁶ M uric acid solution was measured ten times using the same electrode, and the relative standard deviation of the peak current was 1.3%. This method was successfully applied to the determination of uric acid in human urine samples, and the recovery was 97–99%. The feasibility for simultaneous determination of xanthine, ascorbic acid and uric acid was discussed. These species did not interfere with each other in a certain concentration range. The influence of some surfactants on the anodic peak was also examined.     

Grain boundary diffusion coefficients in gold–nickel thin films

Polycrystalline gold–nickel thin films are deposited on silicon (111) wafers by evaporation in a vacuum of 2 × 10^?6 mbar. Concentration profiles of heat‐treated specimens are obtained by Auger electron depth profiling. The heat treatments are carried out in a vacuum furnace of 4 × 10^?6 mbar in the temperature interval 473–773 K. The grain boundary diffusion coefficient is determined, using a modified Wipple model, to be (3 × 10^?4 cm² s^?1) exp (?0.94 eV kT^?1). It is concluded that interdiffusion in the investigated system is characterized by type B kinetics, and that grain boundary diffusion plays a dominant role in the mass transport process of such films. Copyright © 2003 John Wiley & Sons, Ltd.     

Superoxide sensor based on cytochrome c immobilized on mixed-thiol SAM with a new calibration method

Cytochrome c was immobilized on a mixed-thiol (mercaptoundecanoic acid/mercaptoundecanol) modified gold electrode (MUA:MU/cyt c electrode). Characterization of the cyt c electrode showed a quasi-reversible, electrochemical redox behavior with a formal potential of −13±5 mV (versus Ag/AgCl) for the surface adsorbed protein and 3±5 mV for covalently immobilized cyt c. The heterogeneous electron transfer rate constants were determined to be about 70 and 40 s⁻¹ for both states of the protein, respectively. They were found to be significantly higher than those of pure MUA-modified cyt c electrodes (MUA/cyt c electrodes). The interaction of superoxide radicals (O₂⁻) with the (MUA:MU)/cyt c electrode was characterized and used for an amperometric O₂⁻ detection. The influence of H₂O₂ and uric acid on the sensor signal was investigated. The sensitivity of the (MUA:MU)/cyt c electrode to O₂⁻ was significantly improved compared with that of the MUA/cyt c electrode. Based on a kinetic model for the superoxide detection system, a new calibration method was established. This simple and fast method used the spontaneous dismutation of KO₂ and was compared with the enzymatic superoxide generation system using xanthine oxidase.     

Superconductivity in copper, silver, and gold compounds

High-temperature superconductivity exists in layered, square-planar cuprates, but is almost absent in most other Cu(II) compounds and in most Ag(II) and Au(II) compounds. Valence state II is quite unusual in silver and gold and often disproportionates to valence states I and III ("negative-U compounds"). The two-electron difference in oxidation state is suggestive of electron pairing, a prerequisite for superconductivity. In the present paper the connection between disproportionation and geometrical structure on one hand and superconductivity on the other is discussed by using the accepted theory for mixed valence complexes. It is concluded that absence of superconductivity in gold and silver compounds can be connected to the instability of oxidation state II and the large difference in equilibrium geometry between oxidation states I and III.     

负载型Au-Pd双金属催化剂的制备及其对CO氧化的催化活性

采用改性的等体积浸渍法制备了SiO2负载的Au-Pd双金属催化剂,考察了催化剂的焙烧温度对CO氧化反应活性的影响.与623,723和773K的条件下焙烧的催化剂相比,673K焙烧的催化剂具有良好的催化CO氧化活性,CO完全转化温度低于398K.应用N2物理吸附、X射线衍射、程序升温还原、CO程序升温脱附及X射线光电子能谱等技术对催化剂进行了表征.结果表明,673K焙烧的催化剂具有最大的比表面积和最小的孔径,存在Au0,Pd0和PdO相,AuxPdy合金相很少;而773K焙烧的催化剂上除了含有Au0,Pd0和PdO相外,还存在明显的AuxPdy合金相.具有大比表面积,小孔径,Au0,Pd0和PdO多相共存的催化剂可使CO的吸附量增加,催化活性提高;而AuxPdy合金相的生成并不能提高催化剂的催化活性.     

Formation of supported size-controlled nanoparticles of sulfated zirconia

Methods of the preparation of catalysts for alkane skeletal isomerization based on uniform nanoparticles of sulfated zirconia anchored to different supports were investigated. These catalysts were characterized by using the ICP, HRTEM and BET techniques. The activities of the catalysts in the reaction of n-butane isomerization were measured and compared with those of bulk catalysts.