Modeling and Simulation of Saturation Gain of IR Integrated Photonic Amplifiers

IR integrated photonic amplifiers at 1.55m operation will have good foreground in optical phasedarray radars for splitters and signal processing. The saturation gain characteristics of IR integrated photonic waveguide amplifiers (taken Er³⁺Yb³⁺ co-doped phosphate glass waveguide amplifiers as an example) are studied theoretically. For the homemade laser glass materials the calculated saturation intensities are 2.22kw /cm² for signal and 10.15kw/cm² for pump. The effects of absorption saturation of signal and pump lights on the gain of amplifiers are discussed.     

Yb3+掺杂铝氟磷酸盐玻璃的光谱和激光性能

研究了Yb3 掺杂铝氟磷酸盐 (AFP)玻璃的吸收光谱、荧光光谱 ,测量了Yb3 离子的荧光有效线宽 (Δλeff>5 5nm)以及2 F5 2 能级的荧光寿命 (τmax=2ms)及随掺杂浓度的变化 .应用倒易法计算了Yb3 的发射截面 ,其发射截面可达 0 6 6 82 3pm2 ,且激光增益系数τfσemi达 1 2 89ms.pm2 .评估了Yb3 在AFP玻璃中的激光性能 ,发现其具有较理想的激发态最小粒子数 (0 15 )、饱和抽运强度 (8 3kW cm2 )和最小抽运强度 (1 2 4 5kW cm2 )值及良好的热稳定性 .研究结果表明掺Yb3 氟磷酸盐玻璃是实现高功率超短可调谐激光器的理想增益介质 .     

Upconversion luminescence of Tm^3＋/Yb^3＋ codoped oxyfluoride glasses

Novel oxyfluoride glasses are developed with the composition of 30SiO2-15Al2O3-28PbF2-22CdF2-0.1TmF3 - xYbF3 - （4.9 - x） AlF3（x=0, 0.5, 1.0, 1.5, 2.0） in tool fraction, Furthermore, the upconversion luminescence characteristics under a 970nm excitation are investigated. Intense blue, red and near infrared luminescences peaked at 453nm, 476nm, 647nm and 789nm, which correspond to the transitions of Tm^3＋： ^1D2 →^3F4, ^1G4 →^3H6, ^1G4 →^3F4, and ^3H4 →^3H6, respectively, are observed. Due to the sensitization of Yb^3＋ ions, all the upconversion luminescence intensities are enhanced considerably with Yb^3＋ concentration increasing. The upconversion mechanisms are discussed based on the energy matching rule and quadratic dependence on excitation power. The results indicate that the dominant mechanism is the excited state absorption for those upconversion emissions.     

MgCu metallic glass

We generate an amorphous MgCu model using the rapid solidification of the melt through a first-principles molecular dynamics approach within a generalised gradient approximation and reveal, for the first time, its structural features and mechanical properties in details. The liquid and glassy MgCu are found to acquire slightly distinct local structures. Yet in both forms of MgCu, most Cu atoms have a tendency to form the ideal and defective icosahedrons while Mg atoms are arranged in complex configurations. The mean coordination number of Cu and Mg at 300 K is 11.31 and 13.73, respectively. The short-range order of MgCu glass is projected to be different than the known crystalline MgCu and Mg₂Cu phases. The mechanical properties of MgCu glass and the CsCl-type MgCu crystal are computed and compared. On the basis of the enthalpy analyses, a possible pressure-induced crystallisation of the MgCu glass into a CsCl-type structure is proposed to occur at around 11 GPa.     

Photoinitiated polymerization of methacrylates comprising phenyl moieties

Investigation of photopolymerization kinetics of 4-(4-methacryloyloxyphenyl)-butan-2-one (1) in comparison with 2-phenoxyethyl methacrylate (2) and phenyl methacrylate (3) using a UV-LED emitting at 395 nm shows significantly faster polymerization of 1 compared to both 2 and 3 at 40°C. Vitrification affects photopolymerization kinetics of all methacrylates under investigation. Interestingly, quantitative final conversion is observed during photoinitiated polymerization of 1 and 2 whereas 3 shows limited conversion at about 80%. Furthermore, higher degree of polymerization is obtained by photoinitiated polymerization of 1 compared to 2 and 3. This shows that the 3-oxobutyl substituent at the phenyl ring of 1 significantly affects both polymerization kinetics and final conversion of the photoinitiated polymerization. Moreover, an additional higher molecular weight fraction is observed in case of polymerization of 1 at 85°C that is above the glass transition temperature of the polymer formed during photoinitiated polymerization. As a thermal polymerization at 85°C in the absence of light results in a high molecular weight polymer as well, an additional thermal process may be discussed as reason for the higher molecular weight polymer fraction in case of the photopolymer made at 85°C.     

氟锆酸盐玻璃光纤的研制

本文介绍聚全氟乙丙烯包皮的氟锆酸盐(ZrF_4-BaF_2-LaF_3-AlF_3-NaF)玻璃光纤的制备方法.研究了各种工艺因素对氟锆酸盐玻璃和光纤散射损耗的影响.结果表明,选择适当的熔化温度和均化时间,玻璃熔化和光纤拉制时环境中低的水含量是制得的损耗氟锆酸盐玻璃光纤的关键;配合料中引入适量NH_4HF_2,选用温度结构合理的拉丝炉及拉丝工艺也有助于降低光纤的损耗.在此工作基础上,获得了波长2.32μm处损耗为0.24dB/m的氟锆酸盐玻璃光纤.     

Wavelength tuning in Er3+,Yb3+:glass microchip lasers

The paper presents the investigation results of laser generation around 1.5 μm at different wavelengths. The shifts of the wavelength were achieved by the change of pump power, transmission of an output mirror, and length of an active medium. Mathematical analysis and explanation of this phenomenon was curried out on the basis of the change in relation between the gain and loss lines.     

抽运光与信号光的光强重叠因子和掺铒玻璃波导放大器的增益特性

在掺铒玻璃波导放大器（EDWA）的三能级速率-传输方程中,考虑两次离子交换工艺中波导掩模窗口宽度w不同所导致的抽运光、信号光模场与光强分布的不同,讨论不同w对EDWA增益特性的影响,得到光强分布的数值解.引入描述波导中抽运光和信号光的归一化光强重叠因子,对EDWA的传统近似解提出修正,得到了修正解,使其更加接近光强分布的数值解.模拟结果表明,在条波导长度为4 cm、抽运光波长为980 nm、功率为80 mW、信号光波长为1534 nm、功率为-10 dBm条件下,不同w所导致EDWA的增益差别可达297 dB.修正解的结果比传统近似解更加接近光强分布的数值解.修正解对于EDWA的理论研究、器件设计具有指导作用. 关键词： 集成光学 掺铒玻璃波导放大器 重叠积分因子 增益     

Code Optimization,Frozen Glassy Phase and Improved Decoding Algorithms for Low-Density Parity-Check Codes

The statistical physics properties of low-density parity-check codes for the binary symmetric channel are investigated as a spin glass problem with multi-spin interactions and quenched random fields by the cavity method. By evaluating the entropy function at the Nishimori temperature, we find that irregular constructions with heterogeneous degree distribution of check(bit) nodes have higher decoding thresholds compared to regular counterparts with homogeneous degree distribution. We also show that the instability of the mean-field calculation takes place only after the entropy crisis, suggesting the presence of a frozen glassy phase at low temperatures. When no prior knowledge of channel noise is assumed(searching for the ground state), we find that a reinforced strategy on normal belief propagation will boost the decoding threshold to a higher value than the normal belief propagation. This value is close to the dynamical transition where all local search heuristics fail to identify the true message(codeword or the ferromagnetic state). After the dynamical transition, the number of metastable states with larger energy density(than the ferromagnetic state)becomes exponentially numerous. When the noise level of the transmission channel approaches the static transition point, there starts to exist exponentially numerous codewords sharing the identical ferromagnetic energy.     

Effect of cooling rate in [(Fe0.5Co0.5)0.75B0.2Si0.05]100-xNbx alloy system on magnetic properties

The effect of cooling rate on the thermal stability and soft magnetic properties of [(Fe_0.5Co_0.5)_0.75B_0.2Si_0.05]_100-xNb_x (x = 5, 6, 7, 8 at. %) system was investigated. The alloys were produced into the form of ribbon and cylindrical rod by melt-spinning and injection casting, respectively. Their structure, thermal, mechanical and soft magnetic properties were investigated by x-ray diffraction, differential scanning calorimetry, universal testing machine and vibrating sample magnetometer, respectively. All of the alloys were identified as fully amorphous by X-ray diffraction. It turned out that the rod samples had exceptionally high saturation fields reaching 3.0 kOe, which is key properties for sensor application. Also, among these Fe,Co-based samples, the Fe_35.25 Co_35.25 B_18.8 Si_4.70 Nb₆ ribbon exhibits the highest saturation magnetization with 142.1 emu/g.