Organic templates for the generation of inorganic materials

Mankind's fascination with shapes and patterns, many examples of which come from nature, has greatly influenced areas such as art and architecture. Science too has long since been interested in the origin of shapes and structures found in nature. Whereas organic chemistry in general, and supramolecular chemistry especially, has been very successful in creating large superstructures of often stunning morphology, inorganic chemistry has lagged behind. Over the last decade, however, researchers in various fields of chemistry have been studying novel methods through which the shape of inorganic materials can be controlled at the micro- or even nanoscopic level. A method that has proven very successful is the formation of inorganic structures under the influence of (bio)organic templates, which has resulted in the generation of a large variety of structured inorganic structures that are currently unattainable through any other method.     

Adsorption from ternary liquid mixtures on silica gel and aluminium oxide

Formation of mixed adsorbed layers was tested for ternary liquid mixtures containing methanol or acetone and the binary solvent benzene+n — heptane. The specific excess adsorption isotherms from the liquid phase were measured on silica gel, silanized silica gel and aluminium oxide. The experimental adsorption data are discussed on the basis of the changes in the mixed solvent composition.     

Age-dependent variations of cell response to oxidative stress: proteomic approach to protein expression and phosphorylation

We investigated the protein profiles of variously aged rat astrocytes in response to oxidative stress. After H2O2-exposure of cells at 100 microM for 30 min, the relative intensity of ten protein spots changed on two-dimensional (2-D) gels compared with control gels after silver staining. Matrix-assisted laser desorption/ionization-time of flight-mass spectrometry (MALDI-TOF-MS) analysis after in-gel digestion revealed that six of these spots corresponded to three kinds of proteins, each of which was composed of a protein and its modified form with a different isoelectric point (pI). These three proteins were identified as peroxiredoxins (PRDXs) II and III, and calpactin I light chain (p11). H2O2-exposure increased the intensity of the spot with lower pI and simultaneously decreased that of the spot with higher pI for both PRDXs II and III. In addition, the expression of annexin VII, S-adenosyl-L-homocysteine hydrolase, elongation factor II fragment (EF-II), and adenosine deaminase was increased by H2O2-exposure in astrocytes from variously aged rats. Using the Pro-Q Diamond staining, heat shock protein 60 kDa (Hsp 60) and alpha-tubulin were observed to be phosphorylated upon H2O2-exposure. While phosphorylation of alpha-tubulin was correlated positively with age, the changes in abundance of ten protein spots as described above were independent of age. These results suggest that aging does not suppress the responses aimed at limiting injury and promoting repair brought about by severe oxidative stress, and might affect cell dynamics including the formation of microtubules.     

凝胶型聚合物电解质的电导率与温度的关系

凝胶型聚合物电解质的电导率与温度的关系孙晓光，林云青，齐力，景遐斌，王佛松（中国科学院长春应用化学研究所长春１３００２２）关键词凝胶电解质，离子电导率，活化能无定形聚合物电解质电导与温度的依赖关系一般可用Ｖｏｇｅｌ－Ｔａｍｍａｎ－Ｆｕｌｃｈｅｒｃ（Ｖ...     

聚丙烯酰胺固定化糖化酶特性的研究

本研究以丙烯酰胺单体通过反向悬浮聚合技术合成聚丙烯酰胺作为载体材料，采用包埋—交联法固定化葡萄糖淀粉酶，并对其特性进行了研究．结果表明，该固定化酶最适pH值为5．0，最适温度为55～58℃，而且具有较好的贮存稳定性和操作稳定性，8个月后该固定化酶的残余活力仍保持在94％左右，可重复使用43批次，此固定化酶酶活回收率达到56％．实验表明丙烯酰胺悬浮聚合固定化糖化酶的方法是简便可行的．     

三组分(NiO、La2O3、SiO2)负载型加氢催化剂中La2O3的作用

用X射线衍射分析、FT-IR、小角X光散射等方法研究了浸渍法制备的NiO/SiO_2和NiO/(La_2O_3+SiO_2)样品中组分之间的相互作用。La_2O_3在SiO_2上可形成近乎密置单层的分散。在负载了La_2O_3的SiO_2上,NiO的分散程度比在SiO_2上有明显提高,也更容易被还原,而且还原后所得金属镍粒子的平均粒度降低,小粒子所占百分比提高。这些结果表明,NiO/(La_2O_3+SiO_2)比NiO/SiO_2样品具有更高的加氢还原硝基普鲁卡因为胺基普鲁卡因的活性,与Ni/(La_2O_3+SiO_2)比Ni/SiO_2活性高的情形相一致。     

Microporous, fast response cellulose ether hydrogel prepared by freeze-drying

A simple and effective method of preparing fast-response gels is developed. The freeze-drying and subsequent rehydration of thermosensitive gels alters the microstructural properties of the gels in a way that leads to rapid shrinking rates. Microporous hydroxypropyl cellulose (HPC) gels were created by this method to investigate the influence of the process on the swelling and shrinking kinetics of the gels in response to temperature changes. Micropores of different size ranges were produced by freezing gels with different amounts of water at −20 °C. Water content was the key factor to control the microporosity and the shrinking rates of gels. After the freezing treatment, an effective diffusion coefficient for shrinking could be determined by fitting Fick's law to the data (5.2 × 10⁻⁴ cm²/s). This was an increase of two orders of magnitude over that of the untreated, non-porous gel (6.0 × 10⁻⁶ cm²/s). The magnitude of the shrinking coefficient indicates that the shrinking rate of the microporous gel is probably limited by the convective flow, as unsteady flow through porous media follows the same differential equation as Fick's law, but with much greater transport coefficients, as observed here. Physically, the shrinking rate may be determined by the level of interconnected-cells in a microporous structure present at the beginning of shrinking process because the convection through the interconnected-cells is estimated to be much slower than the polymer network diffusion rate of the struts of micropores (0.1–3.0 μm) as well as heat transfer.     

聚丙烯酰胺凝胶结构非均匀性的动态光散射研究

利用动态光散射技术研究了聚丙烯酰胺 (PAAm)凝胶结构的非均匀性 ,分析了PAAm凝胶结构非均匀性的形成原因及凝胶动态光散射的数据处理方法和分析结果的物理意义 .研究结果表明 ,PAAm凝胶中含有动态相关长度 (LC)不同的两相 ,其中 ,LC 为 10～ 2 0nm的区域是聚合物稀疏相 ,LC 为 85nm左右的区域是聚合物密集相 ,两相的不均匀分布形成了PAAm凝胶结构的非均匀性 .分析表明 ,PAAm凝胶存在两相主要是由于单体和交联剂的溶解度存在差异所致 .随交联度增大 ,PAAm凝胶结构的非均匀性显著增强     

Polyaniline-coated silica gel

Silica gel microspheres 7 and 15 μm in diameter were coated with an overlayer of polyaniline camphorsulfonate or hydrochloride during the oxidative polymerization of aniline. Coated silica gel and polyaniline precipitate were separated using a difference in sedimentation rate. In an alternative approach, the microspheres were modified with polyaniline in the presence of 35 nm colloidal silica. This technique prevented the macroscopic precipitation of polyaniline. Coatings of neat, 3-aminopropyl- and octadecyl-modified silica gel with polyaniline hydrochloride were compared. The surface composition of coated microspheres was characterized by X-ray photoelectron spectroscopy. Potential applications of particles in electrorheology, organic catalysis, and in modeling of conductivity behavior in composites are demonstrated.     

Structural and Adsorptive Characteristics of Pyrocarbon/Silica Gel Si-60

Pyrocarbon/silica gel adsorbents (carbosils, CS) with mesoporous Si-60 (Merck, granule size 0.2–0.5 mm) modified by pyrolysis of CH₂Cl₂ at 823 K and reaction time from 0.5 to 6 h and then hydrothermally treated at 473 K for 6 h were studied by means of TEM, adsorption and ¹H NMR methods. Changes in the structural and adsorptive characteristics of hybrid adsorbents before and after hydrothermal treatment, which depend on pyrocarbon content (C _C), were analyzed on the basis of TEM micrographs and p-nitrophenol and nitrogen adsorption isotherms treated using a constrained regularization method. Interfacial water layers in aqueous suspension of CS were investigated by means of ¹H NMR with freezing-out of bulk water at T < 273 K showing nonlinear changes in the Gibbs free energy of interfacial water with increasing C _C because of nonlinear dependence of the structural characteristics of pyrocarbon deposits and CS as a whole on C _C.