Critical evaluation of gas standards based on hydrogen

Summary Six commercial hydrogen standards containing helium, oxygen, nitrogen, methane and carbon dioxide at trace levels were analyzed by gas chromatography, for periods up to 105 days. The concentrations, in the range of 0–120 μmol mol⁻¹, were stable (with the exception of oxygen) but often significantly different from the certified values provided by the suppliers, especially for helium, oxygen and nitrogen. Concurrently, some experiments were carried out to verify the stability of gas mixtures based on hydrogen stored in cylinders submitted to different chemical and physical treatments. The causes that led to the deviations observed, as well as the decreases in oxygen, are discussed. Presented at the 21^st ISC held in Stuttgart, Germany, 15^th–20^th September, 1996.     

Radio-Frequency Hexamethyldisiloxane Plasma Deposition: A Comparison of Plasma- and Deposit-Chemistry

This study reports on the effect of input power to hexamethyldisiloxane (HMDSO) plasmas. The power dependence of the plasma-phase species and of the surface chemistry (of the deposits) has been investigated. Neutral and positive molecular species were detected within the plasma using mass spectrometry (MS). Secondary ion mass spectrometry (SIMS) was used to probe the molecular structure of the deposits. The elemental composition of the surface was determined by XPS and the deposition rate was monitored using a vibrating quartz crystal microbalance. Neutral and cationic molecules of mass greater than HMDSO were detected in the plasma. Their formation through ion-molecule reactions is proposed. Changes in the relative concentration of plasma-phase species follow those seen in molecular species detected at the deposit surface. Thus, we believe that the molecular structure of the deposits can be related to the species present in the plasma. While traditionally the dominant mechanism in deposit formation is assumed to be free radical combinations, we propose other possibilities involving cations with the aim of putting forward a new perspective on plasma polymerization mechanisms and thereby stimulating discussion.     

Pulsed gas lenses

The concept of a pulsed gas lens is proposed. Potential applications are envisaged and preliminary experiments with pulsed ray refraction are reported.     

Isomer effects on transport properties of polyesters based on bisphenol-A

Pure gas sorption and transport properties of polyesters based on bisphenol-A and both pure isophthalic and pure terephthalic acid chloride were obtained for He, N₂, O₂, CH₄, and CO₂ at 35°C. The polymers were synthesized in our laboratory and amorphous films were prepared with a specialized solvent casting procedure. The polymer containing m-phenylene groups shows higher permselectivity for most of the gas pairs. The ideal selectivity of O₂/N₂ was increased by 33% when p-phenylene units were replaced by m-phenylene ones. On the other hand, the polyester containing only p-phenylene groups, shows higher permeability to all the gases studied. The polymer based on pure terephthalic acid chloride has a 75% higher oxygen permeability and a 1.1-fold higher carbon dioxide permeability than the isophthalic acid derivative. The polyester containing meta-phenylene units has lower T_g, higher permselectivity, lower permeability, lower fractional free volume (FFV), and lower d-spacing. The values of FFV, and lower d-spacing. The values of FFV and d-spacing were only slightly different between the two isomers. Moreover, for the sub-T_gγ transition the maximum in tan δ occured at essentially the same temperature (?55°C). The polymer with a higher concentration of p-phenylene units shows somewhat larger area under the γ-peak, indicating slightly more sub-T_g motion. The Distribution of FFV is considered to be the determining factor for the differences in transport properties observed. © 1993 John Wiley & Sons, Inc.     

高密度氩气的原子间相互作用与状态方程

本文从高密度气体的原子间相互作用出发进行思考,在修改范德瓦耳方程的基础上,提出了一种新的适用于高密度气体的状态方程,并用以对氩气临界区的等温压缩线进行计算,结果与实验值很符合.     

The variation of carrier gas viscosities with temperature

After describing simplified equations exspressing the temparature dependency of the viscosity of carrier gases (helium, nitrogen and hydrogen ) relative to a base value, absolute relationships based on the kinetic theory of gases are discussed. Comparative data obtained using various calculation methods are given and are compared to measured values. Based on the kinetic relationshipsm, of viscosity. Finally, the influence of pressure on the viscosity is also briefly discussed. As a supplement, Viscosity data are tabulated for the three gases in the range of 0°C to 400°C in increments of 2 K, calculated using the kinetic relationships.     

Full-Wave Analyses for a Multi-Layered Microstrip Patch Antenna

This paper describes numerical modelling of a dual band multi-layered microstrip patch antenna operating at 35GHz on an in-house semi-insulating GaAs substrate. The simulated and measured resonant frequencies at both lower and upper resonant frequencies will be compared to check the accuracy of the different numerical modelling techniques.     

Fluorinated,crosslinkable terpolymers based on vinylidene fluoride and bearing sulfonic acid side groups for fuel‐cell membranes

The radical terpolymerization of 8‐bromo‐1H,1H,2H‐perfluorooct‐1‐ene with vinylidene fluoride (VDF) and perfluoro(4‐methyl‐3,6‐dioxaoct‐7‐ene) sulfonyl fluoride is presented. Changing the feed compositions of these three fluorinated comonomers enabled us to obtain different random‐type poly[vinylidene fluoride‐ter‐perfluoro(4‐methyl‐3,6‐dioxaoct‐7‐ene) sulfonyl fluoride‐ter‐8‐bromo‐1H,1H,2H‐perfluorooct‐1‐ene] terpolymers containing various sulfonyl fluoride and brominated side groups. Yields higher than 70% were reached in all cases. The hydrolysis of the sulfonyl fluoride group into the ? SO₃Li function in the presence of lithium carbonate was quantitatively achieved without the content of VDF being affected, and so dehydrofluorination of the VDF base unit was avoided. These original terpolymers were then crosslinked via dangling bromine atoms in the presence of a peroxide/triallyl isocyanurate system, which produced films insoluble in organic solvents such as acetone and dimethylformamide (which totally dissolved uncured terpolymers). The acidification of ? SO₃Li into the ? SO₃H function enabled protonic membranes to be obtained. The thermal stabilities of the crosslinked materials were higher than those of the uncured terpolymers, and their electrochemical performances were investigated. According to the contents of the sulfonic acid side functions, the ion‐exchange capacities ranged from 0.6 to 1.5 mequiv of H⁺/g, whereas the water uptake and conductivities ranged from 5–26% (±11%) and from 0.5 to 6.0 mS/cm, respectively. © 2006 Wiley Periodicals, Inc. J Polym Sci Part A: Polym Chem 44: 4566–4578, 2006