含氟对称1-芳基-1,1-双酰胺类化合物的制备及其晶体结构研究

本文通过室温下三氟乙酰胺、一溴二氟乙酰胺或含氟的苯甲酰胺与芳醛在三氟甲磺酸和亚硫酰氯存在下的反应,高产率的制备了含氟对称1-芳基-1,1-双酰胺类化合物(RfCONH)2CHAr 。化合物3aa和3ab的结构通过X-射线衍射分析得到进一步确证。     

Highly active catalyst for vinyl acetate synthesis by modified activated carbon

A new zinc acetate catalyst which was prepared from modified activated carbon exhibited extreme activity towards the synthesis of vinyl acetate.The activated carbon was modified by nitric acid,vitriol and peroxyacetic acid(PAA).The effect on specific area, structure,pH and surface acidity groups of carriers by modification was discussed.Amount of carbonyl and carboxyl groups in activated carbon was increased by peroxyacetic acid treatment.The productivity of the new catalyst was 14.58%higher than that of...     

Multi-method for the determination of antibiotics of different substance groups in milk and validation in accordance with Commission Decision 2002/657/EC

The presented method is able to analyse 47 substances of the antibiotic groups tetracyclines, quinolones, macrolides, sulfonamides, diamino-pyrimidine derivatives and lincosamides simultaneously in a single analytical run. Applying an in-house validation concept, the validation of the multi-method was successfully accomplished with a low number of experiments. Each substance was validated at least at the concentrations 0.5, 1.0 and 1.5 MRL (maximum residue limit), or respectively, at concentrations as low as possible for substances without MRL. The calculated relevant validation parameters, e.g. the decision limit CCα, the detection capability CCβ, the repeatability, the within-laboratory reproducibility and the recovery, are in an acceptable range and in compliance with the requirements of Commission Decision 2002/657/EC. A proficiency test and the implementation of the method by other laboratories were performed successfully.     

Direct metalation of methoxymethyl arylmethyl ethers: A tin-free approach to the generation of α-alkoxyalkoxy-substituted aryllithiums

The generation of a series of α-methoxymethoxy-substituted arylmethyllithiums was achieved by direct metalation of the corresponding arylmethyl methoxymethyl ethers. While the effect of substituents at the benzylic position is straightforward, substituents located on the aromatic ring promote the set up of a competition between lateral and aromatic metalation, strongly affected by the position and relative ortho directing properties of the new substituent. The proposed methodology allows a simple approach to the generation of a wide array of functionalized organolithium reagents.     

Concise Synthesis of [1,1′‐Biisoquinoline]‐4,4′‐diol via a Protecting Group Strategy and Its Application for Potential Liquid‐Crystalline Compounds

The [1,1′‐biisoquinoline]‐4,4′‐diol ( 4a ), which was obtained as hydrochloride 4a ?2 HCl in two steps starting from the methoxymethyl (MOM)‐protected 1‐chloroisoquinoline 8 (Scheme 3), opens access to further O‐functionalized biisoquinoline derivatives. Compound 4a ?2 HCl was esterified with 4‐(hexadecyloxy)benzoyl chloride ( 5b ) to give the corresponding diester 3b (Scheme 4), which could not be obtained by Ni‐mediated homocoupling of 6b (Scheme 2). The ether derivative 2b was accessible in good yield by reaction of 4a ?2 HCl with the respective alkyl bromide 9 under the conditions of Williamson etherification (Scheme 4). Slightly modified conditions were applied to the esterification of 4a ?2 HCl with galloyl chlorides 10a – h as well as etherification of 4a ?2 HCl with 6‐bromohexyl tris(alkyloxy)benzoates 11b , d – h and [(6‐bromohexyl)oxy]‐substituted pentakis(alkyloxy)triphenylenes 14a – c (Scheme 5). Despite the bulky substituents, the respective target 1,1′‐biisoquinolines 12, 13 , and 15 were isolated in 14–86% yield (Table).     

Polyimide-polydimethylsiloxane copolymers containing nitrile groups

A novel series of nitrile-containing polyimide-polydimethylsiloxane copolymers was prepared by polycondensation reaction of 4,4′-oxydiphthalic anhydride with a mixture of an aromatic diamine, namely 2,6-bis(3-aminophenoxy)benzonitrile, and bis(aminopropyl)oligodimethylsiloxane of controlled molecular weight, in different ratios. The polymers were easily soluble in polar organic solvents, such as N-methylpyrrolidone, N,N-dimethylformamide as well as in less polar solvents such as chloroform, and can be cast from solution into thin flexible films. The inherent viscosity was in the range of 0.43-0.55 dL/g. The polymers showed good thermal stability, the decomposition temperature being above 430 °C. They exhibited a glass transition temperature in the range of 149-219 °C, with reasonable interval between glass transition temperature and decomposition temperature. The surface morphology was investigated by scanning electron microscopy. The water dynamic contact angles were measured by tensiometric method. The free surface energy was evaluated based on Owens and Wendt equation. A composite film based on a polyimide-polydimethylsiloxane copolymer and pyrite ash powder has been prepared and its nanoactuation has been investigated.     

Evaluation of selectivity for l-glutamide-derived highly ordered assemblies in reversed-phase high-performance liquid chromatography

Two dioctadecyl l-glutamic acid derivatives with amide and ester type bondings have been synthesized and immobilized from 3-aminopropyltrimethoxysilane (APS) grafted silica (Sil-APS) to be used in reversed-phase high-performance liquid chromatography (RP-HPLC). Subsequent studies showed that dioctadecyl-l-glutamide derivative (GLN) can self-assemble into highly ordered structures by forming three-dimensional fibrillar aggregates as observed in scanning and transmission electron microscopes (SEM and TEM). Variable temperature ¹H NMR and FT-IR spectra of organogel revealed that the special aggregation morphology shown by GLN was stabilized by inter and or intra molecular hydrogen bonding among amide moieties. However, such ordered aggregated or self-assembled structures were not observed for the dioctadecyl-l-glutamate (GLU) derivative. The stationary phases Sil-GLN and Sil-GLU were characterized by DRIFT, elemental analysis, TGA, and ¹³C and ²⁹Si CP-MAS NMR spectroscopic measurements. The chromatographic selectivity for both stationary phases was evaluated from the retention studies of different size and shape polycyclic aromatic hydrocarbons (PAHs). The chromatographic experiment for PAHs and geometrical isomers in RP-HPLC showed that Sil-GLN demonstrated extremely enhanced selectivity than Sil-GLU. The higher selectivity attributed by Sil-GLN has been brought by multiple π-π interactions among the π-electrons of the grafted organic phase and π-electrons of the guest PAHs molecules. Thermodynamic studies for linear and nonlinear PAHs revealed that the retention behavior does not change over a temperature range from 10 to 60 °C for both stationary phases.     

Composition and solution properties of fluorinated block copolymers and their surface structures in the solid state

A series of diblock copolymers composed of methyl methacrylate and 2-perfluorooctylethyl methacrylate (PMMA₁₄₄-b-PFMA _n ) with various PFMA block lengths were prepared by atom transfer radical polymerization (ATRP). The surface structures and properties of these polymers in the solid state and in solution were investigated using contact angle measurement, X-ray photoelectron spectroscopy (XPS), sum frequency generation (SFG) vibrational spectroscopy, surface tension and dynamic laser light scattering (DLS). It was found that with increasing PFMA block length, water and oil repellency decreased, the ratio of F/C increased with increasing film depth, and the degree of ordered packing of the perfluoroalkyl side chains at the surface decreased. When the number of PFMA block units reached 10, PMMA segments were detected at the copolymer surface, which was attributed to the PFMA block length affecting molecular aggregation structure of the copolymer in the solution and the interfacial structure at the air/liquid interface, which in turn affects surface structure formation during solution solidification. The results suggest that copolymer solution properties play an important role in structure formation on the solid surface. Supported by the National Natural Science Foundation of China (Grant Nos. 50573069 and 20704038) and Program for Changjiang Scholars and Innovative Research Team in University (Grant No.IRT 0654)     

Semisynthesis of a Homogeneous Glycoprotein Enzyme: Ribonuclease C: Part 2

Active RNase glycoprotein from three pieces : The glycoprotein enzyme ribonuclease C, which contains a complex saccharide N‐glycan, was synthesized by sequential native chemical ligation. An optimized ligation and isolation protocol allowed the efficient assembly and refolding of the 124 amino acid enzyme.

     

Efficient Solid‐Phase Synthesis of Sulfotyrosine Peptides using a Sulfate Protecting‐Group Strategy

Double protection : Efficient Fmoc‐based solid‐phase synthesis (SPPS) of sulfotyrosine (sY) peptides is achieved by incorporating the sY residue(s) as a dichlorovinyl‐protected (DCV) sulfodiester(s) and using 2‐methylpiperidine for Fmoc removal. After removal of the other protecting groups, the DCV group could be cleaved by mild hydrogenolysis giving the sY peptides in good yield.