Development of a systems analysis approach for resolving the structure of biodegrading soil systems

An experimental and mathematical method is developed for the microbial systems analysis of polyaromatic hydrocarbon (PAH)-degrading mixed cultures in PAH-contaminated “town gas” soil systems. Frequency response is the primary experimental and data analysis tool used to probe the structure of these complicated systems. The objective is to provide a fundamental protocol for evaluating the performance of specific mixed microbial cultures on specific soil systems by elucidating the salient system variables and their interactions. Two well-described reactor systems, a constant volume stirred tank reactor (CSTR) and a plug flow differential volume reactor, are used in order to remove performance effects that are related to reactor type as opposed to system structure. These two reactor systems are well-defined systems that can be described mathematically and represent the two extremes of one potentially important system variable, macroscopic mass transfer. The experimental and mathematical structure of the protocol is described, experimental data is presented, and data analysis is demonstrated for the stripping, sorption, and biodegradation of napththalene.     

Simple Method for Simultaneous Determination of Selenium and Arsenic in Human Hair by Means of Atomic Fluorescence Spectrometry with Hydride Generation Technique

This study describes a simple, rapid and reliable method for simultaneous determination of selenium and arsenic in human hair by means of atomic fluorescence spectrometry combined with a hydride generation technique (HG-AFS). The procedure developed encompasses microwave digestion of a sample in the nitric acid environment only. The interferences caused by nitrous oxides are eliminated by removing a gas from above the digested solution with a stream of argon. The sample is then chemically treated in a flow-through hydride generation system and exposed to measurements in a double-channel atomic fluorescence spectrometer. The method permits determining both analytes in the linear range of 0.5–100µgL^–1 with a detection limit equal to 0.2µgL^–1, as well as with very good repeatability not exceeding 1% for Se and 2% for As. No mutual interferences from either of the analytes in the concentrations ranges matching the hair composition were found. The method was verified in terms of accuracy with the use of a reference material and then applied to the analysis of the natural samples of human hair.     

A Novel Fluorescent Aminoacid Designed for Fluorometric Detection of Cu （Ⅱ）

A fluorescent aminoacid was designed for selective and sensitive detection of Cu(II) in aqueous solution. The designing of this Cu(II) fluorescent chemosensing molecule, N ± (1‐naphthyl). aminoacetic acid (NAA), was based on the binding of Cu(II) to aminoacetic acid and the novel charge transfer photophysics of 1‐aminonaphthalenes. The fluorescence of NAA was found quenched by Cu (II) and several other metal ions of similar electronic structure such as Co(II), Ni(II) and Zn(II). The quenching was shown to occur via electron transfer within the metal‐NAA complex, which required an optimal combination of high binding affinity and favorable redox properties of the components in the metal‐NAA complex and hence afforded selective fluorometric detection of Cu(II). The calibration graph obeyed Stern‐Volmer theory and was shown for Cu(II) over the range of 0–2.75 ± 10–⁴ mol/L. The quenching constant of Cu(II) was measured as 8.0 ± 10³ mol/L that was two orders of magnitude higher than those of Co(II), Ni(II) and Zn(II). The 3SD limit of detection for Cu(II) was 8.00 ± 10^?6 mol/L with a coefficient of variation of 1.65%. Linear range for quantitative detection of Cu(II) was 2.67 ± 10^?5‐2.75 ± 10^?4 mol/L. The method was applied to synthetic sample measurements which gave recoveries of 105%‐112%.     

Comparison of Pyrolysis and Microwave Acid Digestion Techniques for the Determination of Mercury in Biological and Environmental Materials

 Microwave digestion reduction-aeration and pyrolysis combined with cold vapour atomic absorption and cold vapour atomic fluorescence are compared for the determination of total mercury in several biological and environmental matrices. The biological samples were digested in a mixture of HNO₃/H₂O₂, the environmental samples in a mixture of HNO₃/HClO₄. After reduction with SnCl₂, the mercury was collected by two-stage gold amalgamation. After microwave digestion reduction-aeration, detection limits of 1.4 ng g⁻¹ and 0.6 ng g⁻¹ were obtained for cold vapour atomic absorption spectrometry (CVAAS) and cold vapour atomic fluorescence spectrometry (CVAFS), respectively, for 250 mg of environmental samples. For biological samples (500 mg) the detection limits were 0.7 ng g⁻¹ (CVAAS) and 0.4 ng g⁻¹ (CVAFS). After pyrolysis, detection limits of 3.5 ng g⁻¹ and 1.6 ng g⁻¹ for CVAAS and CVAFS, respectively, were obtained for a 10 mg sample. Pyrolysis can only be applied when the organic content of the sample is not too high. Accurate results were obtained for 8 certified reference materials of both environmental and biological origin. In addition, a real sludge sample was analysed. Author for correspondence. E-mail: richard.dams@rug.ac.be Received September 18, 2002; accepted December 3, 2002 Published online May 5, 2003     

Laser-induced fluorescence detection schemes for the analysis of proteins and peptides using capillary electrophoresis

Over the past few years, a large number of studies have been prepared that describe the analysis of peptides and proteins using capillary electrophoresis (CE) and laser-induced fluorescence (LIF). These studies have focused on two general goals: (i) development of automatic, selective and quick separation and detection of mixtures of peptides or proteins; (ii) generation of new methods of quantitation for very low concentrations (nm and subnanomolar) of peptides. These two goals are attained with the use of covalent labelling reactions using a variety of dyes that can be readily excited by the radiation from a commonly available laser or via the use of noncovalent labelling (immunoassay using a labelled antibody or antigen or noncovalent dye interactions). In this review article, we summarize the works which were performed for protein and peptide analysis via CE-LIF.     

SNAP-tag蛋白标签技术与荧光分析法在蛋白原位分析中的联合应用

为将生物体内微观的蛋白行为可视化并以宏观信号呈现出来对蛋白进行实时、动态分析，借助SNAP-tag蛋白标签技术与有机小分子荧光染料，构建了一系列用于活细胞内实时监测目标蛋白的免洗荧光探针。标签蛋白SNAP-tag能够特异性识别探针中的苄基鸟嘌呤，从而使目标蛋白共价连接上荧光团（萘酰亚胺），携带上荧光信使。此外，由于萘酰亚胺从水环境中被牵引至SNAP-tag蛋白的疏水空腔，其荧光信号呈现出2~13倍的增强。通过SNAP-tag标签蛋白与目标蛋白的融合，该荧光探针实现了对活细胞内线粒体蛋白CoX8A及核内蛋白H2B特异性识别，在免洗条件下完成了对目标蛋白的实时追踪及原位分析。     

氨基酸柱前衍生化的3种新荧光试剂的光谱特性及高效液相色谱研究

合成了３种新的荧光标记试剂：吖啶－Ｎ－乙酰氯，咔唑－９－乙酰氯和咔唑－９－丙酰氯。它们的最大发射降激发波长分别为４３０ｎｍ，３６８ｎｍ，和３６５ｎｍ。３种衍生化试剂与氨基酸形成的衍生物在ｐＨ６．５的条件下结合梯度洗脱程序在Ｃ１８反相柱上对色谱条件进行了优化。     

Spectroscopic studies of water-soluble sulfonated calix[6]arene

Fluorescence and absorption studies of water-soluble sulfonated calix[6]arene (SCX6) are reported. Water-soluble calixarenes are potentially useful as host molecules for luminophores, and studies of their spectroscopic characteristics are therefore crucial. The absorption and fluorescence spectra of these molecules in aqueous solution were collected, analyzed, and compared with 4-hydroxybenzene sulfonate at different pHs. A red shift in the absorption spectrum and a change in the fluorescence spectrum of the calixarenes are observed upon an increase in pH from 2.0 to 13.0. Some of these spectroscopic changes are attributed to intramolecular hydrogen bonding between adjacent hydroxyl groups of SCX6 after proton disassociation. The formation of excimers between phenolic groups in the calixarene molecule is proposed. In addition, inner-filter effects of SCX6 are discussed. These inner-filter effects prove to be a disadvantage for the use of SCX6 as a host molecule for complexation studies by use of fluorescence probes whose absorption spectra overlap with those of calixarenes.     

烟草三维荧光特征和品质评吸的关系

研究不同品种烟草石油醚冷萃取物的三维荧光光谱，包括烟草所共在的荧光性质和各自的荧光特性，寻找它们与烟草香味，颈头等吃味之间的关系，选择合适的量值指标，为烟草品质的 观感官评估提供了一个实用的对照方法。     

Visual observation of contact-induced intercrystalline migration of aromatic species adsorbed in zeolites by fluorescence microscopy.

Intercrystalline migration and a migration-assisted chemical reaction of adsorbed aromatic species between zeolite particles in physical contact were visualized by fluorescence microscopy coupled with a particle manipulation technique. The luminescence color characteristics of particular zeolite particles originating from the specific photochemistry of adsorbed species was exploited to follow the migration of the molecules. Two examples are shown that are relevant to the visualization of the time-dependent migration process: A one guest-two sets of zeolite crystals system: chrysene (Chry)-loaded zeolite Na+ -X (the sodium form of zeolite X) crystals were placed in contact with unloaded Tl+ -X (thallium-exchanged X) crystals and allowed to stand at room temperature. Initially, the blue fluorescence of Chry was detected only from the Na+ -X particles, but later, the development of green phosphorescence emission was discernible from the Tl+ -X which suggests that Chry migrated from the Na+ -X to the Tl+ -X crystals. A two guest-species systems: Electron-donating Chry-loaded Na+ -X crystals were placed in contact with electron-accepting 1,2,4,5-tetracyanobenzene (TCNB)-loaded Na+ -X or Na+ -Y crystals. With time, the former system (Chry/Na+ -X and TCNB/Na+ -X) gave rise to the emission of Chry-TCNB charge-transfer complexes resulting mainly from the migration of Chry while the latter system (Chry/Na+ -X and TCNB/Na+ -Y) afforded the same emission resulting largely from the migration of TCNB. The present investigation reveals that there is a certain direction for guest migration depending on the zeolite host and the nature of host-guest or guest-guest interaction.