Ultrasonic-assisted leaching of trace metals from sediments as a function of pH

The effects of ultrasonication on the leaching of trace metals form sediments as a function of pH have been investigated using atomic absorption spectrometry. Cu, Pb, Ni, Zn and Mn were leached from sediments by ultrasonic effect using phthalate buffers at pH values of 2.2-6.0. Parameters influencing leaching, such as leaching time, solution matrix, wet or dry sample and final pH were evaluated. Results from ultrasonic leaching experiments were comparable to those of conventional procedure. In addition, this ultrasonic-assisted leaching method reduces the time required for conventional method approximately from 12 h to 25 min. Depending on the metal and sample type, metal removal increased linearly or exponentially with decreasing pH. The accuracy of the method was tested by comparing obtained results with this of conventional method. The average relative standard deviation (R.S.D.) of ultrasonic-assisted leaching method (ULM) varied between 1.71 and 3.00% for N = 36, depending on the analyte. This technique shows promise for studying chemical and biological availability and uptake/release processes for metals in sediment and soil as a function of pH.     

铜质水嘴中铅含量与析出量的相关性探讨

试验探讨铜质水嘴中铅含量与析出量的关系。对一系列含铅标准铜片按照GB/T 17219–1998《生活饮用水输配水设备及防护材料的安全性评价标准》要求进行浸泡试验,使用原子吸收光谱法或电感耦合等离子体质谱法检测浸泡液中的铅含量,再利用20个已知铅含量的铜质水嘴样品进行析出量的检测和验证。得到铜质水嘴中铅含量与析出量的关系。试验结果表明:大部分内腔有电镀层的铜质水嘴,铅析出量小于5.0μg/L;内腔无电镀层的铜质水嘴中铅含量小于0.5%时,铅析出量小于5.0μg/L,符合GB/T 17219–1998标准要求。     

三种消解方法在测定近海沉积物中Pb、 Cu、 Cd、 Hg及As的应用

常压湿式消解、高压微波消解、常压微波消解3种方法被应用于近海沉积物中Pb、 Cu、 Cd、 Hg、 As 5种重金属元素的分析. 以近海海洋沉积物标准物质为样品经3种方法消解后, 通过石墨炉原子吸收法测定Pb、 Cu、 Cd和氢化物发生原子荧光法同时测定Hg、 As. 结果表明, 样品经常压湿式消解, 其Pb、 Cu、 Cd回收率在80%～123%内而Hg、 As回收率低;经高压微波消解, 标样中Pb、 Cu、 Cd、 As回收率在84%～117%内, 对Hg测定回收率偏低;常压微波消解更适合于Cu、 Cd、 Hg、 As的消解, 其回收率在95%～121%之间而Pb回收率低于42.4%. 常压湿式消解与常压微波消解被用于大亚湾人工渔礁区沉积物样品的处理, 有较好的测定结果.     

原子吸收法对藏草药水母雪兔子和多刺绿绒蒿中12种元素的初步形态分析

用原子吸收光谱法,对产于青藏高原的藏草药水母雪兔子和多刺绿绒蒿,测定了全药材、水提液、醇提液中12种元素(Cr、Cu、Fe、Mn、Ni、Se、Zn、K、Ca、Mg、Cd、Pb)的含量,以及水提液中各元素可溶态、水溶态的含量,同时采取正辛醇-水分配体系模拟藏药水提液中各微量元素在人体胃肠中的分配情况,对藏药中微量元素的初级形态进行了分析,初步探讨了酸度变化(人体胃肠酸度)对微量元素的影响,结合藏药药效讨论其相关性,为进一步研究微量元素与藏药药性、药效的关系提供科学依据.     

Preconcentration and Determination of Copper（Ⅱ） Using Octadecyl Silica Membrane Disks Modified by 1,5-Diphenylcarhazide and Flame Atomic Absorption Spectrometry

A simple and reproducible method for the rapid extraction and determination of trace amounts of copper（Ⅱ） ions using octadecyl-bonded silica membrane disks modified by 1,5-diphenylcarbazide （DPC） and atomic absorption spectrometry was presented, which was based on complex formation on the surface of the ENVI-18 DISK^TM disks followed by stripping of the retained species by minimum amounts of appropriate organic solvents. The elution was efficient and quantitative. The effect of potential interfering ions, pH, ligand amount, stripping solvent, and sample flow rate were also investigated. Under the optimal experimental conditions, the break-through volume was found to be about 1000 mL providing a preconcentration factor of 400. The maximum capacity of the disks was found to be （255±5） lag for Cu^2＋, and the limit of detection of the proposed method was 5 ng per 1000 mL. The method was applied to the extraction and recovery of copper in different water samples.     

火焰原子吸收光谱法分析沉积物中重金属元素的形态

采用原子吸收光谱法研究了金沙江攀枝花段水系沉积物中重金属的形态及分布特征。研究发现,各重金属的形态以残渣态为主,离子交换态含量很少。同时说明原子吸收光谱法完全可以用来研究重金属形态特征,在环境研究中具有重要意义。     

微波消解-原子吸收法测定氧化铝为载体的钯催化剂中钯

报道了微波消解-AAS法测定氧化铝为载体的钯催化剂中钯的新方法,试验了微波消解溶样条件（溶解试剂、压力、时间和功率等）,研究了测定介质的影响,通过在样品测定液中加入铝基体至铝浓度为4 mg/mL,消除了铝对钯测定的干扰.该法测定结果与光度法的结果一致,相对标准偏差小于1.5%（n=5）.     

中药一枝黄花、黄连、天麻、蛇床子中8种微量元素的测定

采用原子吸收光谱仪对一枝黄花、黄连、天麻、蛇床子中Fe、Ca、Mg、Mn、Cr、Cu、Zn、Pb八种无机元素的含量进行了测定,为进一步研究其药理和用途提供基础。     

治疗冠心病中成药中镁含量的测定及其临床意义

采用原子吸收分光光度法测定了１１种治疗冠心病中成药物中镁含量。结果表明,药物中含有较丰富的镁元素,它为临床上探讨镁元素与冠心病关系提供了有用的数据。     

Trace-matrix separations for high-purity chromium,molybdenum and tungsten with cellulose collectors

Trace metals (20 elements) in high-purity chromium, molybdenum and tungsten are collected and preconcentrated by precipitation and adsorption on cellulose collectors. The compound methods allow the application of AAS and ICP-AES as determination methods for the production control of highly pure refractory metals under routine conditions.Presented in part at the 1989 European Winter Conference on Plasma Spectrochemistry, Reutte, Austria