摩擦点火Ti-V-Cr阻燃钛合金燃烧产物的组织特征

采用摩擦氧浓度实验方法, 结合原位观察、扫描电镜、能谱仪和X-射线衍射分析, 系统研究Ti-V-Cr 阻燃钛合金燃烧产物的微观组织形貌、燃烧反应过程的合金元素分布规律及微观机理. 结果表明: Ti-V-Cr 阻燃钛合金燃烧过程发出闪亮耀眼的白光, 具有典型金属燃烧的火焰特征. 燃烧产物主要有TiO₂, V₂O₅和Cr₂O₃三种氧化物, 该混合氧化物以分散颗粒和致密连续体存在. 分散颗粒为规则的球形; 致密连续燃烧产物的微观组织具有分区特征, 从合金基体至燃烧表面依次为过渡区、热影响区、熔凝区和燃烧区. 其中, 过渡区存在一些微小的颗粒状凸起, 且有一定方向性; 热影响区中形成大量V基固溶体相和少量的Ti基固溶体相, V基固溶体相上存在Ti的含量远高于基体的针状析出物; 熔凝区中, 大量的Ti基固溶体中存在少量的V基固溶体; 燃烧区主要为Ti, V和Cr的氧化物混合物. 热影响区的V基固溶体相降低了Ti元素向熔凝区的迁移速率, 减慢了燃烧区Ti与O的优先反应; 燃烧区形成的TiO₂, V₂O₅和Cr₂O₃混合氧化物和熔凝区O在Ti中大量固溶共同终止了O向合金基体的继续扩散, 从而使Ti-V-Cr阻燃钛合金表现出优异的阻燃功能性.     

Study of the fire resistant behavior of unfilled and carbon nanofibers reinforced polybenzimidazole coating for structural applications

With increasing interest in epoxy‐based carbon fiber composites for structural applications, it is important to improve the fire resistant properties of these materials. The fire resistant performance of these materials can be improved either by using high performance epoxy resin for manufacturing carbon fiber composite or by protecting the previously used epoxy‐based composite with some fire resistant coating. In this context, work is carried out to evaluate the fire resistance performance of recently emerged high performance polybenzimidazole (PBI) when used as a coating material. Furthermore, the effect of carbon nanofibers (CNFs) on fire resistant properties of inherently flame retardant PBI coating was studied. Thermogravimetric analysis of carbon/epoxy composite, unfilled PBI and nano‐filled PBI shows that the carbon/epoxy composite maintained its thermal stability up to a temperature of 400°C and afterwards showed a large decrease in mass, while both unfilled PBI and nano‐filled PBI have shown thermal stability up to a temperature of 575°C corresponding to only 11% weight loss. Cone calorimeter test results show that unfilled PBI coating did not improve the fire retardant performance of carbon/epoxy composite. Conversely, nano‐filled PBI coating has shown a significant improvement in fire retardant performance of the carbon/epoxy composite in terms of increased ignition time, reduced average and peak heat release rate and reduced smoke and carbon monoxide emission. These results indicate that addition of carbon nanofibers to inherently flame retardant coating can significantly be helpful for improving the fire resistance performance of composite materials even with low coating thickness. Copyright © 2013 John Wiley & Sons, Ltd.     

磷酸盐聚酯型水性聚氨酯/纳米SiO2的合成与性能

以2-磷酸基-1,2,4-三羧酸丁烷(PBTCA)、新戊二醇(NPG)为原料,制得数均相对分子质量为1500并含有磷酸基团的聚酯多元醇。将其与异佛尔酮二异氰酸酯(IPDI)反应,经1,4-丁二醇(BDO)扩链后得到水性聚氨酯,再以KH550为偶联剂,加入纳米SiO2,合成了纳米改性的磷酸型水性聚氨酯(PWPU)。通过红外光谱(FI-IR)、热重分析(TGA)对PWPU的结构和热稳定性进行了研究,使用透射电子显微镜(TEM)对乳液的形貌进行了观察。通过TEM发现,大量粒径在110 nm左右的化合物合成,并与红外光谱联合分析得出,SiO2通过化学键与PWPU相连接。热重分析、残炭量分析和拉伸测试表明,经过纳米SiO2改性的PWPU其阻燃性、热稳定性以及力学性能均有明显的提升,具有很好的应用前景。     

Colorimetric detection of glucose using a boronic acid derivative receptor attached to unmodifed AuNPs简

A simple, cheap and non-enzymatic colorimetric strategy for glucose detection has been designed based on the interactions between a phenylboronic acid （PBA） derivative, which is coupled with gold nanoparticles （AuNPs） as the colorimetric reporters, and glucose. The PBA-AuNPs hybrid system proposed here exhibits ordered photochemistry behaviors upon the addition of glucose at different pH values. There are two linear regions of glucose concentration for the glucose sensor at different pH values, i.e., between 0.1 mmol/L and 9.8 mmol/L at pH 6 with the detection limit of 64μmol/L and between 0 and 6.5 mmol/L with the detection limit of 48 μmol/L at pH 9, respectively. To test the practicality of the sensor system, we also applied this assay to detect a glucose sample in the artificial saliva.     

热裂解气相色谱质谱法分析聚合物中红磷

采用单击热裂解(PY)模式和逸出气体分析(EGA)程序升温两种热裂解模式对红磷样品进行定性分析,利用气相色谱分离技术对红磷进行分离,根据红磷的特征质谱31,62,93,124及特征丰度比,质谱法分析不同材料中的红磷含量。单击热裂解模式下,材质和添加剂有可能对红磷造成干扰,改进后的EGA热裂解模式能排除红磷检测中材质和添加剂的干扰,并采用改进后的EGA裂解程序测定自制阳性样品中红磷的含量。结果表明:通过优化裂解温度和气相色谱条件可以有效改善红磷的分析结果,红磷质量浓度在100~500 mg/kg范围内具有良好线性,加标回收率在90.7%~97.7%,相对标准偏差(RSD)为1.6%~2.3%,定量限为81.27 mg/kg。     

基于钴离子介导信号转换的抗坏血酸比色分析

抗坏血酸是许多生化过程所必需的一种生物小分子。借助于羟基氧化钴纳米片的氧化性和钴离子与硫氰酸根离子之间强的螯合作用,本研究首次报道了一种基于钴离子信号转换的新方法用于抗坏血酸的比色分析。在抗坏血酸存在时,羟基氧化钴纳米片被还原降解产生二价钴离子,钴离子与硫氰酸根离子之间通过螯合作用生成蓝色的[Co(NCS)₄]^_2-阴离子络合物,在625 nm处产生可见吸收信号。实验首先对羟基氧化钴纳米片与抗坏血酸的反应时间、硫氰酸铵和吐温-80的加入量等实验参数进行了优化,当反应时间为5 min,硫氰酸铵(3 mol/L)和吐温-80(10%, w%)的加入体积分别为30 μL和80 μL时,检测体产生最强的吸收信号。在优化的条件下,随着抗坏血酸浓度的增加,检测体系在625 nm处的吸收值线性增强,在0.03～0.45 mmol/L浓度范围内,检测体系在625 nm处的吸收值与AA浓度呈良好的线性关系,线性方程为A₆₂₅=0.638C (mmol/L)+0.042,相关系数R=0.993,检测限(3S/N)为1.5 μmol/L。     

硫酸分离–火试金重量法测定碲化铜中的金和银

建立了用硫酸分离-火试金重量法测定碲化铜中的金和银含量的方法。用硫酸溶解碲化铜样品,过滤,除去铜和碲,得到含金、银的沉淀物,沉淀物经灰化、配料、高温熔融制得铅扣。将铅扣灰吹,得到金银合粒,用硝酸溶解分离金,用重量法测定金含量。用金银合粒的质量扣除金粒的质量和分金液、洗液中杂质的质量即为银含量。采用灰皿、残渣熔融法补正,或用含碲、铜物料做基体加入纯金、纯银同试样方法测定,根据金、银的回收率加以补正,从而得到试样中的碲含量。实验结果表明,浓硫酸的加入量为30 mL,残余量应不少于15 mL。火试金中硅酸度为1左右,试样进炉温度以900℃为宜。该方法金、银测定结果的相对标准偏差分别为0.33%~1.97%,0.28%~1.27%(n=9)。金的回收率为98.5%~100.2%,银的回收率为95.5%~101.4%。该法满足生产控制检测和贸易结算的要求。     

Benzophenone glycosides from the pericarps of Aquilaria yunnanensis S. C. Huang

Abstract

Two new benzophenone glycosides, aquilarisides A (1) and B (2), together with six known analogues (3-8) were isolated from the pericarps of Aquilaria yunnanensis S. C. Huang. Their structures were elucidated on the basis of 1D and 2D NMR and mass spectroscopic analyses, and the absolute configuration of compound 1 was determined by experimental and calculated electronic circular dichroism (ECD) spectra. Anti-inflammatory activities of all compounds 1–8 were evaluated for their inhibitory activities against lipopolysaccharide (LPS)-stimulated induced nitric oxide (NO) production in RAW 264.7 cells using the Griess assay. Compound 2 indicated a weak inhibition of NO production.     

Clinicopathological value and underlying molecular mechanism of annexin A2 in 992 cases of thyroid carcinoma

BackgroundThyroid carcinoma (THCA) is one of the most frequent endocrine cancers and has increasing morbidity. Annexin A2 (ANXA2) has been found to be highly expressed in various cancers; however, its expression level and potential mechanism in THCA remain unknown. This study investigated the clinicopathological value and primary molecular machinery of ANXA2 in THCA.Material and MethodsPublic RNA-sequencing and microarray data were obtained and analyzed with ANXA2 expression in THCA and corresponding non-cancerous thyroid tissue. A Pearson correlation coefficient calculation was used for the acquisition of ANXA2 coexpressed genes, while edgR, limma, and Robust Rank Aggregation were employed for differentially expressed gene (DEG) in THCA. The probable mechanism of ANXA2 in THCA was predicted by gene ontology and pathway enrichment. A dual-luciferase reporter assay was employed to confirm the targeting relationships between ANXA2 and its predicted microRNA (miRNA).ResultsExpression of ANXA2 was significantly upregulated in THCA tissues with a summarized standardized mean difference of 1.09 (P < 0.0001) based on 992 THCA cases and 589 cases of normal thyroid tissue. Expression of ANXA2 was related to pathologic stage. Subsequently, 1442 genes were obtained when overlapping 4542 ANXA2 coexpressed genes with 2248 DEGs in THCA; these genes were mostly enriched in pathways of extracellular matrix-receptor interaction, cell adhesion molecules, and complement and coagulation cascades. MiR-23b-3p was confirmed to target ANXA2 by dual-luciferase reporter assay.ConclusionsUpregulated expression of ANXA2 may promote the malignant biological behavior of THCA by affecting the involving pathways or being targeted by miR-23b-3p.