Facile non‐lithographic route to highly aligned silica nanopatterns using unidirectionally aligned polystyrene‐block‐polydimethylsiloxane films

Thin films (monolayer and bilayer) of cylinder forming polystyrene‐block‐polydimethylsiloxane (PS‐b‐PDMS) were shear aligned by the swelling and deswelling of a crosslinked PDMS pad that was physically adhered to the film during solvent vapor annealing. The nanostructures formed by self‐assembly were exposed to ultraviolet‐ozone to partially oxidize the PDMS, followed by calcination in air at 500 °C. In this process, the PS segments were fully decomposed, while the PDMS yielded silica nanostructures. The highly aligned PDMS cylinders were thus deposited as silica nanolines on the silicon substrate. Using a bilayer film, the center‐to‐center distance of these features were effectively halved from 38 to 19 nm. Similarly, by sequential shear‐alignment of two distinct layers, a rhombic array of silica nanolines was fabricated. This methodology provides a facile route to fabricating complex topographically patterned nanostructures. © 2015 Wiley Periodicals, Inc. J. Polym. Sci., Part B: Polym. Phys. 2015 , 53, 1058–1064     

双掺(Tm3+,Tb3+)LiYF4激光器1.5 μm波长激光阈值分析

由速率方程推出了双掺（Tm^3 ,Tb^3 ）离子准四能级系统的激光阈值解析式，讨论了Tm^3 和Tb^3 离子之间的相互作用。分析了1.5μm波长附近的激光阈值和Tm^3 、Tb^3 离子的掺杂原子数分数及晶体长度的关系。结果表明，对于对应Tm^3 离子^3H4→^3F4跃迁的约1.5μm波长的激光，激活离子Tm^3 的掺杂原子数分数过大时，交叉弛豫作用将使系统阈值迅速增加。Tb^3 离子的加入，一方面能抽空激光下能级，起到降低阈值的作用；另一方面亦减少了激光上能级的寿命，使阈值升高。故Tb^3 离子有最佳掺杂原子数分数。对于Tm原子数分数为y=0.01的Tm:LiYF4晶体，Tb^3 离子的最佳掺杂原子数分数为0.002左右，同时表明，激光阈值与晶体长度有关。最佳晶体长度与Tm^3 、Tb^3 离子的掺杂原子数分数以及晶体的衍射损耗和吸收损耗有关。     

Diastereoselective Alkylation of (Diene-Aldehyde)Fe(CO)3 Complexes with Functionalized Zinc-Copper Reagents NuCu(CN)Znl

Addition of functionalized zinc-copper reagents to the title complexes proceeds in a highly diastereoselective fashion to afford dienol complexes. The relative configurations of adducts 3d were determined by single X-ray diffraction analysis.     

Synthesis and Reactions of Some New Pyrrolylfuro[2,3‐d]Pyrimidines and Pyrrolopyrazinofuropyrimidines

5‐Amino‐4‐methyl‐2‐phenyl‐6‐substitutedfuro[2,3‐d]pyrimidines ( 2a‐c ) were reacted with 2,5‐dimethoxytetrahydrfuran to afford the pyrrolyl derivatives 3a‐c . Compound 3a was chosen as intermediate for the synthesis of poly fused heterocycles incorporated furopyrimidines moiety 4–11 . Some of the synthesized compounds were screened for their antibacterial and antifungal activities.     

极化子导电到能带导电的转变

采用交流法测量大功率商用钛酸钡(BT)陶瓷加热器的电阻和加热功率随温度的变化关系.结果显示,BT陶瓷的电导特性在80℃附近出现了明显的转变,从低温时的极化子跳跃导电转变为高温时的能带导电,此时,电阻出现极小值,而加热功率出现极大值.     

General strategy for a short and efficient synthesis of 3-hydroxy-4-methylprolines (HMP)

The non-proteinogenic amino acid 3-hydroxy-4-methylproline (HMP) is an active constituent of some potent antimicrobials including echinocandins, nostopeptins, pneumocandins, sporiofungin and mulundocandins. A synthesis has been achieved in 10 steps with 29% overall yield; the Evans’ aldol reaction using Crimmins’ modified method was pivotal to the success of the strategy.     

Remote stereocontrol by the sulfinyl group: Mukaiyama aldol reactions of (S)-2-[2-(p-tolylsulfinyl)phenyl]acetaldehyde in the asymmetric synthesis of β-hydroxyacids and 1,3-diols

(S)-2-[2-(p-Tolylsulfinyl)phenyl]acetaldehyde reacts with different O-silylated ketenethioacetals in the presence of Yb(OTf)₃ yielding β-hydroxythioesters in high yields and diastereoselectivities. The obtained compounds were readily transformed into β-hydroxyacids and their corresponding diols. These Mukaiyama aldol reactions are a direct evidence of the ability of the sulfinyl group to control 1,5- and 1,6-asymmetric induction processes.