STRUCTURE CHARACTERIZATION AND CATALYTICACTIVITY TEST OF Ni(II) COMPLEXES CONTAINING2-(DIPHENYLPHOSPHINOAMINO) PYRIDINE(PAP)

IntroductionIn1962,N.V.Kutepow'SgroupfirstusedcomplexesofFe,CoandNiascatalyststocatalyzecarboXylationofethanoltopreparepropanoicacidanditsderivants.Thereactionpressurewashighandtheyieldwaslow.LateronPaulalsandhiscolleagueusedabC13andiodineascatalyst,which…     

Investigation of the electrocatalytic oxidation of formate and ethanol at platinum black under microbial fuel cell conditions

In this communication, we discuss the electro-oxidation of the fermentation products formate and ethanol at platinum black modified electrodes under microbial fuel cell conditions, i.e., at neutral pH, room temperature, and in microbial culture solutions. The electrocatalytic oxidation was studied using cyclic voltammetry, chronoamperometry, and potentiostatic coulometry. Current densities up to 6 mA cm⁻² at 0.2 V oxidation potential and 97% coulombic efficiency were observed for the electro-oxidation of 100 mM solutions of formate in pH 7 buffer solution. Electrode deactivation could be successfully prevented using an oxidative potential reactivation procedure. Polymer coating, however, fully stopped the formate oxidation. As expected, the electro-oxidation of ethanol was less efficient—with a limiting current density being 600 μA cm⁻².Dedicated to Professor Dr. Alan M. Bond on the occasion of this 60th birthday.     

Ethanol production from steam-explosion pretreated wheat straw

Bioconversion of cereal straw to bioethanol is becoming an attractive alternative to conventional fuel ethanol production from grains. In this work, the best operational conditions for steam-explosion pretreatment of wheat straw for ethanol production by a simultaneous saccharification and fermentation process were studied, using diluted acid [H₂SO₄ 0.9% (w/w)] and water as preimpregnation agents. Acid-or water-impregnated biomass was steam-exploded at different temperatures (160–200°C) and residence times (5, 10, and 20 min). Composition of solid and filtrate obtained after pretreatment, enzymatic digestibility and ethanol production of pretreated wheat straw at different experimental conditions was analyzed. The best pretreatment conditions to obtain high conversion yield to ethanol (approx 80% of theoretical) of cellulose-rich residue after steam-explosion were 190°C and 10 min or 200°C and 5 min, in acid-impregnated straw. However, 180°C for 10 min in acid-impregnated biomass provided the highest ethanol yield referred to raw material (140 L/t wheat straw), and sugars recovery yield in the filtrate (300 g/kg wheat straw).     

Ethanol Washing Effect on Textural Properties of the Sodium Silicate-Derived Silica Xerogel

This study deals with the use of ethanol as washing solvent in the preparation of the silica gels from sodium silicate in order to enhance the textural properties, especially surface area. We here examined the effect of ethanol-washing on surface area, micro- and mesopore volume, and average pore size. The silica xerogels prepared from sodium silicate solution exhibited an extremely high surface area of 1139 m2/g by washing their hydrogels with ethanol. Compared to water-washed xerogels, ethanol-washed xerogels showed higher surface areas, total pore volumes, and larger average pore sizes. Unlike the surface area of water-washed xerogel, that of the ethanol-washed xerogel was not affected by the silica concentration of initial solution. This study indicates that the textural properties of sodium silicate-derived xerogels are further enhanced by using ethanol as washing solvent.     

磺化酚酞型聚醚砜膜的制备及其阻醇和质子导电性能

直接甲醇燃料电池 (Directmethanolfuelcell,DMFC)以高效、清洁和燃料储运方便等优点适宜于作为各种用途的可移动动力源 ,成为 2 0世纪 90年代以来研究与开发的热点[1,2 ] .目前 ,这种电池的研究难点主要集中在催化剂不稳定和质子交换膜透醇上 .一张好的DMFC膜不但要可传递质子、绝缘电子 ,还应具有良好的阻醇性能 .如果膜的阻醇性能不好 ,甲醇会穿过膜到达阴极 ,与氧直接反应而不产生电流 ,不但造成燃料的浪费 ,同时也影响阴极的正常反应 ,使电池效率下降[3 ] .目前广泛应用于燃料电池中的Nafion 系列膜是由美国DuPont公司生产的一种…     

La0.8Sr0.2Ga0.8Mg0.2O2.8的电化学性质及其在SOFC中的应用

采用凝胶浇注法制备具有较高氧离子电导率的固体电解质La0.8Sr0.2Ga0.8Mg0.2O2.8粉料.X射线衍射结果表明,于1400℃焙烧后即形成了钙钛矿结构,无杂相存在.探讨了粉料压制坯体的致密化和导电性能在1450℃下与烧结时间的关系,发现烧结时间为18h时其相对密度达98.3%,而在24h的情况下,样品具有最佳的氧离子导电性.采用Ni-Ce0.8Gd0.2O1.9作为阳极,La0.8Sr0.2Ga0.6Ni0.4O2.7作为阴极,组装了平板型固体氧化物燃料电池(SOFC).阳极和阴极分别通入含3%H2O的氢气和空气,750℃时的开路电压为1.04V,最大输出功率密度(P)达252mW/cm2(U=0.48V,J=525mA/cm2).     

Effect of polarization on the electrode behavior and microstructure of (La,Sr)MnO<Subscript>3</Subscript> electrodes of solid oxide fuel cells

The electrode behavior and microstructure of freshly prepared (La_0.8Sr_0.2)_0.9MnO₃ (LSM) electrodes were investigated under various polarization conditions. The original, large agglomerates in freshly prepared LSM electrodes were broken down into sphere-shaped grains when exposed to cathodic or anodic current passage of 200 mA cm^–2 at 800 °C in air for 3 h. Microstructural changes under cathodic polarization could be related to the pronounced diffusion and migration of oxygen vacancies and Mn ions on the LSM surface and lattice expansion, while lattice shrinkage under oxidation conditions most likely contributes to the structural changes under anodic polarization. Such morphological changes were irreversible and were found to be beneficial to the performance of freshly prepared LSM electrodes. Freshly prepared LSM electrodes behaved very differently with respect to the cathodic and anodic current passage treatment.     

Development of new glass composite membranes and their properties for low temperature H2/O2 fuel cells.

A new glass electrolyte formed by constant amounts of titanium oxide (TiO2) and various amount of phosphotungstic acid (PWA) doped P2O5-SiO2 is prepared using the sol-gel process. The structural formation is confirmed by Fourier infrared spectroscopy (FTIR) and from thermogravimetric and differential thermal analysis (TG/DTA) measurements, the glasses display good thermal stability. Further characterisation is undertaken by N2 adsorption/desorption measurements, proton conductivity and hydrogen permeability analyses and a H2/O2 fuel cell test is also performed. The glass materials with large pores and specific surface area are suitable for use as the electrolyte in H2/O2 fuel cells. The effect of TiO2 processing with constant amount of PWA in phosphosilicate glasses, is investigated and discussed. The hydrogen permeability is 1.57x10(-11) mol cm(-1) s(-1) Pa(-1) at 110 degrees C for 0.8 mm thick glass; a power density of 46.3 mW cm(-2) at 125 mA cm(-2) and a current density of 175 mA cm(-2) is obtained (T=28 degrees C, relative humidity).     

A Procedure for Transforming Impedance Spectra for the Determination of Mechanism of Electrochemical Reactions

Transformation of impedance spectra into relaxation time spectra (RTS) is used for determining contributions of individual processes of the oxygen electroreduction reaction (OER) to the polarization resistance of the electrochemical cell. The transformation technique involves the solution of the convolution equation found with the aid of a modified Van Cittert iteration algorithm checked on model impedance spectra. The technique, when used to analyze impedance spectra of electrochemical cells air|Pt|YSZ|YSZ + Pt|air, shows that the conversion of a globular structure of the YSZ + Pt cermet layer to a columnar one is accompanied by a change of peak amplitudes in RTS. The revealed RTS dynamics when heated to 750°C is compared with peculiarities of individual processes in OER.     

甲醇气相羰基化制备乙酸的钴催化剂(YSCo)的研究

甲醇气相羰基化制备乙酸的钴催化剂（ＹＳＣｏ）的研究潘平来，柳忠阳，黄茂开，袁国卿（中国科学院化学研究所，北京１０００８０）关键词甲醇，羰基化，乙酸，钴催化剂通过甲醇羰基化制备乙酸是目前乙酸工业最先进的技术路线．该法与乙烯和乙醇氧化法相比较，无论从原料...