Determination of polycyclic aromatic sulfur heterocycles (PASH) in diesel fuel by high performance liquid chromatography and photodiode-array detection

An oxidation method (sulfone method) for the determination of polycyclic aromatic sulfur heterocycles (PASH) in diesel fuel is presented. The aromatic fraction of a diesel fuel, isolated by solid phase extraction, is oxidized under controlled conditions with hydrogen peroxide. The oxidation products, mainly methylated dibenzosulfone, are determined and quantified directly, without further clean-up, by HPLC with photodiode-array detection.     

Morphology and transport properties of protons and methanol through partially sulfonated block copolymers

The morphological changes with different compositions of casting solvents in the membranes of sulfonated polystyrene-block-poly(ethylene-ran-butylene)-block-polystyrene (SEBS) were investigated with small-angle X-ray scattering (SAXS) and transmission electron microscope (TEM). Using the single solvent of tetrahydrofuran (THF) and the solvent mixtures of methanol/THF with different compositions, the casting polymer solutions were prepared for the membrane fabrication. The proton conductivity and the methanol permeability of membranes were measured, and the effect of morphological changes on the casting solvents was discussed through Flory–Huggins theory. It was found that the sulfonated SEBS membranes were transformed from well ordered lamellar to disordered co-continuous structure and the morphological difference caused abrupt enhancement in the proton conductivity and the methanol permeability as the concentration of methanol in the mixed solvents (MeOH/THF) increased.     

用选择离子流动管质谱测定汽油和柴油蒸汽成分

采用选择离子流动管质谱(SIFT／MS)装置，以H30^ 、N0^ 为初始离子对汽油和柴油蒸汽进行了研究，质谱分析表明，汽油和柴油主要由C—H化合物组成，包括烷烃、环烷烃、烯烃、炔烃、二烯烃以及芳香烃。在这几种成分中，烷烃都占有最大的比例；汽油蒸汽和柴油蒸汽最大的区别是柴油蒸汽中长链大分子的挥发性C—H化合物所占的比例远远高于汽油蒸汽。文中还给出了以H30^ 、N0^ 为初始离子所得到的汽油蒸汽的质谱图，以及汽油、柴油蒸汽中各种成分的定量分析结果。     

Analysis of free and esterified sterols in vegetable oil methyl esters by capillary GC

The introduction of quality standards for vegetable oil methyl esters is gaining in importance due to their increased use as diesel fuel substitutes and as technical products. Free and esterified sterols, the main constituents of the unsaponifiable matter in vegetable oils, are recovered in vegetable oil methyl esters and may influence the technical properties of vegetable oil methyl ester products. A rapid gas chromatographic method for the qualitative and quantitative determination of free and esterified sterols in vegetable oil methyl esters has therefore been developed. The concentration of the free sterols as well as their qualitative and quantitative composition and the concentration of the sterol esters have been determined in rape seed oil methyl ester samples by GC–FID. Prior to analysis, the free sterols were silylated with N,O-bis(trimethylsilyl)trifluoroacetamide with 1% of trimethylchlorosilane; betulinol was used as an internal standard. Calibration was performed by analysis of standard solutions containing β-sitosterol, cholesteryl stearate, and betulinol. The reproducibility of the quantitative results has been evaluated by repeated injections of the same test solution and by repeated complete analysis of the same sample.     

A complementary and synergistic effect of Fe-Zn binary metal oxide in the process of high-temperature fuel gas desulfurization

57Fe Mossbauer spectroscopy was used to investigate the evolution of Fe-Zn binary metal oxide sorbent in the process of high-temperature fuel gas desulfurization. The results of phase analyses show that Fe-Zn binary metal oxide sorbent is rapidly reduced in hot fuel gas and decomposed to new phases of highly dispersed microcrystalline elemental iron and zinc oxide, both of which become the active desulfurization constituents. A complementary and synergistic effect between active iron acting as a high sulfur capacity constituent and active zinc oxide acting as a deep refining desulfurization constituent exists in this type of sorbent for hot fuel gas desulfurization.     

Determination of Aldehydes and Ketones in Fuel Ethanol by High-Performance Liquid Chromatography with Electrochemical Detection

A new methodology was developed for analysis of aldehydes and ketones in fuel ethanol by high-performance liquid chromatography (HPLC) coupled to electrochemical detection. The electrochemical oxidation of 5-hydroxymethylfurfural, 2-furfuraldehyde, butyraldehyde, acetone and methyl ethyl ketone derivatized with 2,4-dinitrophenylhydrazine (DNPH) at glassy carbon electrode present a well defined wave at +0.94 V; +0.99 V; +1.29 V; +1.15 V and +1.18 V, respectively which are the basis for its determination on electrochemical detector. The carbonyl compounds derivatized were separated by a reverse-phase column under isocratic conditions with a mobile phase containing a binary mixture of methanol / LiClO_4(aq) at a concentration of 1.0 × 10⁻³ mol L⁻¹ (80:20 v/v) and a flow-rate of 1.1mL min⁻¹ . The optimum potential for the electrochemical detection of aldehydes-DNPH and ketones-DNPH was +1.0 V vs. Ag/AgCl. The analytical curve of aldehydes-DNPH and ketones-DNPH presented linearity over the range 5.0 to 400.0 ng mL⁻¹, with detection limits of 1.7 to 2.0 ng mL⁻¹ and quantification limits from 5.0 to 6.2 ng mL⁻¹, using injection volume of 20 μL. The proposed methodology was simple, low time-consuming (15 min/analysis) and presented analytical recovery higher than 95%.     

Diminished Respirative Growth and Enhanced Assimilative Sugar Uptake Result in Higher Specific Fermentation Rates by the MutantPichia stipitis FPL-061

A mutant strain ofPichia stipitis, FPL-061, was obtained by selecting for growth on L-xylose in the presence of respiratory inhibitors. The specific fermentation rate of FPL-061, was higher than that of the parent,Pichia stipitis CBS 6054, because of its lower cell yield and growth rate and higher specific substrate uptake rate. With a mixture of glucose and xylose, the mutant strain FPL-061 produced 29.4 g ethanol/L with a yield of 0.42 g ethanol/g sugar consumed. By comparison, CBS 6054 produced 25.7 g ethanol/L with a yield of 0.35 gJg. The fermentation was most efficient at an aeration rate of 9.2 mmoles O₂ L^-1 h^-1. At high aeration rates (22 mmoles O₂ L^-1 h^-1), the mutant cell yield was less than that of the parent. At low aeration rates, (1.1 to 2.5 O₂ L^-1 h^-1), cell yields were similar, the ethanol formation rates were low, and xylitol accumulation was observed in both the strains. Both strains respired the ethanol once sugar was exhausted. We infer from the results that the mutant, P.stipitis FPL-061, diverts a larger fraction of its metabolic energy from cell growth into ethanol production.     

有机硅及其改性聚合物膜用于有机溶剂水溶液的渗透汽化分离

采用室温固化硅橡胶及其它三种改性硅氧烷聚合物制成渗透汽化膜,分离丙酮(A),丁酮(B)、乙醇(E)及异丙醇(P)等有机物的水溶液。结果表明,随着透过温度提高、透量成指数关系增大,但对分离系数影响甚小。透量大小顺序为A>B>E>P,分离系数大小顺序为A>B>P>E,当膜材料中(CH_3)_2SiO链节含量由70%上升到100%时,有机物的透量及分离系数同时增加。     

PEMFC催化剂的研究：自制抗CO中毒Pt-Ru/C电催化剂的性质

用胶体法制备了抗CO中毒PEMFC阳极Pt-Ru/C电催化剂（标记为THYT－2）,对 比研究了THYT－2与Johnson Matthey (JM)公司同类品牌Pt-Ru/C催化剂的电化学及 其它物理化学性能。结果表明,THYT－2电催化剂在甲醇燃料电池和CO／H_2（Φ_ (CO) = 1 * 10~(-4)）的氢氧燃料电池中的电催化行为与JM催化剂相当,但THYT－ 2在低浓度CO氢气燃料中的电池性能更好。两种催化剂的其它物理化学性质具有类 似性：XPS分析结果表明THYT－2和JM催化剂 中都有三种不同价态的Pt存在：即金 属态Pt(0)、氧化态Pt(II)和Pt(IV)。HRTEM测试结果表明两种催化剂的粒径处在2 ～3 mn左右,这可能是它们拥有良好电化学性能的主要原因之一。本文还对催化剂 中Pt与Ru组分的分布和相互作用进行了讨论,提出了改进Pt-Ru/C电催化剂的思路 。     

Mg／Mgl．8La0．2Ni纳米复合材料的吸放氢性能研究

应用高能球磨法制备Mg-x％Mg1.8La0.2Ni（x=10、20和30）纳米复合储氢材料．X射线衍射（XRD）、透射电镜（TEM）和选区电子衍射（SAED）测试表明，该复合材料具有纳米晶和非晶态混合结构的性质，吸氢温度降低，较好的吸放氢动力学性能，在423K，2．5MPa氢压的条件下，50s内即可达到最大吸氢量．