纤维素基磁性聚偕氨肟树脂吸附Mn（Ⅶ）

用酸处理的纤维素基磁性聚偕氨肟树脂（AMAO）在溶液中吸附KMnO4，发生氧化还原反应的几率在2％以下；用碱处理的树脂（BMAO）作吸附剂，KMnO4还原为Mn（OH）4的比例剧增，达到或超过10％，并且与溶液的pH有关。但是，Mn（Ⅶ）被还原为Mn（Ⅳ）的量基本上不受KMnO4起始浓度、吸附剂添加量和吸附时间变化的影响。BMAO树脂吸附KMnO4的量是树脂偕氨肟基含量的5倍以上。超当量吸附现象反映了物理吸附的本质。     

Preparation, characterization and effect of annealing on performance of cellulose acetate/sulfonated polysulfone and cellulose acetate/epoxy resin blend ultrafiltration membranes

Polymeric membranes based on cellulose acetate (CA)--sulfonated polysulfone blends at three different polymer compositions were prepared by solution blending and phase inversion technique, characterized and subjected to annealing at 70, 80 and 90 °C. The permeate water flux, separation of bovine serum albumin and its flux by the blend membranes before and after thermal treatment, have been compared and discussed. Similarly, CA and epoxy resin (diglycidyl ether of bisphenol-A) were blended in various compositions, in the presence and in the absence of polyethyleneglycol 600 as non-solvent additive, using N,N^′-dimethylformamide as solvent, and used for preparing ultraflltration membranes by phase inversion technique. The polymer blend composition, additive concentration, casting and gelation conditions were optimized. Blend membranes were characterized in terms of compaction, pure water flux, water content and membrane resistance. The effects of polymer blend composition and additive concentration on the above parameters were determined and the results are discussed.     

Kinetics study of thermal decomposition of epoxy resins containing flame retardant components

Hyperbranched polyphosphate ester (HPPE) and phenolic melamine (PM) were blended in different ratios with a commercial epoxy resin to obtain a series of flame retardant resins. The thermal decomposition mechanism of their cured products in air was studied by thermogravimetric analysis and in situ Fourier-transform infrared spectroscopy. The degradation behaviours of epoxy resins containing various flame retardant components were found to be greatly changed. The incorporation of phosphorus and nitrogen compounds improved the thermal stability at elevated temperature. The kinetics of thermal decomposition was evaluated by Kissinger method, Flynn-Wall-Ozawa method and Horowitz-Metzger method. The results showed that the activation energy at lower degree of the degradation decreased by the incorporation of flame retardant components, while increased at higher degree of the degradation.     

脲衍生物对环氧树脂/双氰双胺固化体系潜伏性促进作用研究

本文用DSC、TBA、旋转粘度计等手段对一系列不同结构及不同取代基取代的脲衍生物对环氧树脂/双氰双胺固化体系的潜伏性促进作用作了考察。结果表明,其促进效果随脲的α位取代烷基碳原子数增加而减弱,而其β、γ位上的取代基团变换时对促进作用无明显影响。由此得出4,4-二(N,N-二甲基)脲二苯甲烷(简称M-二甲)和2,4-二(N,N-二甲基)脲甲苯(简称T-二甲)二种脲衍生物在本丈所考察的28种化合物中具有最显著的促进效果,其中T-二甲的促进活性略高于M-二甲,它们均可使上述固化体系的固化温度降至130℃左右,含有此促进剂的固化体系即使在30℃下贮存,其粘度保持基本不变的时间仍可达三个月以上。     

用三乙胺盐酸盐对酚醛环氧树脂开环合成水溶性感光高分子的研究

用三乙胺盐酸盐与酚醛环氧树脂开环反应合成了一种水溶性聚合物，研究了相转移催化剂、反应时间、反应温度、开环顺序等条件对反应程度的影响。研究了开环反应中丙烯酸及三乙胺盐酸盐与酚醛环氧树脂的比例对产物的水溶性及感兴性能的影响。     

镓在氨基吡啶树脂上的吸附行为及机理

前文已报道了氨基吡啶树脂对AuCl_4~-、PtCl_6~(2-)的吸附性。本文报道4-氨基吡啶树脂对镓的吸附行为与机理。在6mol/L HCl条件下,对镓的氯络阴离子(GaCl_4~-)有很好的吸附性。并能定量洗脱。测得静态吸附容量为351.15mg/g树脂,用化学法及红外光谱等方法,测得4-氨基吡啶树脂吸附镓(Ⅲ)的基本参数。     

2,3-Dihydroxypyridine Loaded Amberlite XAD-2 (AXAD-2-DHP): Preparation, Sorption–Desorption Equilibria with Metal Ions, and Applications in Quantitative Metal Ion Enrichment from Water, Milk and Vitamin Samples

2,3-Dihydroxypyridine loaded (via –N=N–linker) Amberlite XAD-2 (AXAD-2-DHP) was prepared and characterized by elemental analyses, TGA and FT-IR spectra. It (1g packed in a column of 1cm diameter; surface area 135.5m²g^–1) was found to be an effective solid phase sorbent for enriching Zn²⁺, Mn²⁺, Ni²⁺, Pb²⁺, Cd²⁺, Cu²⁺, Fe³⁺ and Co²⁺ at pH 3.5 to 7.0 using flow rates between 1.0–5.0mLmin^–1. For desorption (recovery 97.0–99.8%) of the metal ions, 8 to 10mL of 2.0molL^–1 HCl or 1.5molL^–1 HNO₃ at a flow rate of between 2.0 and 4.0mLmin^–1 were found most suitable. The t_1/2 (time for 50% sorption) is between 2 and 10min when a 50mL solution (containing a total amount of metal of 2mg) was equilibrated with 0.5g of resin. Sorption of all metal ions except Pb²⁺ follows the Langmuir model, whereas for Pb the data fits with the Freundlich model. The sorption capacity is between 60.7 (for Cd) and 406.7 (for Cu) µmolg^–1. The resin can withstand an acid concentration of 6molL^–1 and can be reused for thirty cycles of sorption–desorption. The preconcentration factor varies between 100 and 300. For Cd, Ni and Cu the sorption capacity of 2,3-dihydroxypyridine loaded cellulose is lower than that of the present resin. The tolerance limits of electrolytes, humic acid, complexing agents, Ca²⁺ and Mg²⁺ in the enrichment of all metal ions are reported. The limits of detection are 3.88, 5.37, 8.72, 13.88, 4.71, 1.24, 0.59 and 0.30µgL^–1 for Zn²⁺, Mn²⁺, Ni²⁺, Pb²⁺, Cd²⁺, Cu²⁺, Fe³⁺ and Co²⁺, respectively. The calibration curves for flame AAS determination were linear in the ranges 0.018–1.0, 0.067–5.0, 0.2–5.0, 0.9–20, 0.028–2.0, 0.077–5.0, 0.19–10 and 0.1–3.5µgmL^–1, respectively. All the eight metal ions in river and synthetic water samples, Co in vitamin tablets and Zn in milk samples have been quantitatively enriched with Amberlite XAD-2-DHP and determined by flame atomic absorption spectrometry.     

ADSORPTION OF 2,4-D ON MODIFIED HYPERCROSSLINKED POLYSTYRENE （NDA-99） AND XAD-4 RESIN

The adsorption behavior of pesticide 2,4-dichlorophenoxyacetic acid (2,4-D) in aqueous solution has been investigated using a hypercrosslinked polystyrene adsorbent (NDA-99) modified by dimethylamine group as well as a nonionic macroporous adsorbent (XAD-4). The Langmuir and Freundlich isotherm models were employed to fit the experimental data to describe adsorption mechanism. It shows that NDA-99 resin exhibits an adsorption affinity for 2,4-D higher than XAD-4 resin owing to its exceptional micropore structure and the amine group of the hypercrosslinked matrix.Further studies indicate that the hydrogen bonding interaction and the stronger π-π conjugation play a significant role in the course of the adsorption of 2,4-D on NDA-99 resin, which is in agreement with the IR spectroscopic results and the △E values of HOMO (the highest occupied molecular orbit) of adsorbent and LUMO (the lowest unoccupied molecular orbit) of adsorbate calculated from the MINDO/3 model.     

凝胶型苯乙烯系离子交换树脂的强度及抗渗透性的影响因素研究 (I)

本文就单体组成中不同引发剂，链转移剂，环二烯，烯丙基类化合物和氧气等对凝胶型苯乙烯系阳离子交换树脂的强度和抗渗透性的影响进行了系统研究。结果显示，采用0．30％的过氧化2－乙基己酸叔丁酯（OT）和0．01％的过氧化苯甲酸特丁酯（CP）代替过氧化二苯甲酰（BPO作引发剂，或者加入0．02％的链转移剂十二烷基硫醇，均能够在一定程度上改善共聚物珠粒的结构均匀性，提高其合成的离子交换树脂的磨后圆球率和抗渗透性能。     

新型Ni—Pd/碳化树脂催化剂的制备及在微量测定有机氧元素中的应用

本文报道一种新型Ni—Pd／碳化树脂催化剂的制备方法，用该法制备的催化剂具有高金属分散度和高机械强度，用于库仑法微量测定有机氧元素取得满意结果。文中对Ni和Pd颗粒在催化剂上表面形貌和分布、催化活性等作了初步探讨。