Nd(OTf)3-catalyzed intramolecular-intermolecular cascade cyclization reaction: An access to phenanthro[9,10-b]furan derivatives

An intramolecular-intermolecular cascade cyclization reaction via multi metal-carbene intermediates has been developed. This reaction uses catalytic amount of Nd(OTf)₃, which actives both alkyne and aldehyde moieties. This protocol provides a novel strategy for the synthesis of phenanthro[9,10-b]furans.     

Er^3＋：Y2O3透明陶瓷制备及发光性质研究

以Y2O3为基质材料,掺杂不同含量的Er3 ,采用共沉淀法制备出性能良好的Er3 :Y2O3纳米粉,并将粉体在1 700℃和真空度为1×10-3Pa下烧结8 h得到Er3 :Y2O3透明陶瓷.用X射线衍射仪(D/MAX-RB)、透射电子显微镜(EM420)、自动记录分光光度计(DMR-22)、荧光分析仪(F-4500)和发射波长为980 nm的半导体激光器分别对样品的结构、形貌和发光性能进行了研究.结果表明:Er3 完全固溶于Y2O3的立方晶格中,Er3 :Y2O3粉体大小均匀,近似球形,尺寸约40～60 nm左右.Er3 :Y2O3透明陶瓷相对密度为99.8%,在长波长范围内其透光率超过60%,在波长为980 nm的激光下有两个上转换发光带,其中绿色发光中心波长位于562 nm,红色发光中心波长位于660 nm,分别对应4S3/2/2H11/2→4I15/2和4F9/2→4I15/2的跃迁;随着铒浓度的提高颜色从绿色向红色转变,Er3 的掺杂浓度不宜超过2%,超过这个范围,对材料发光强度的增强作用反而很小.     

LD泵浦Cr4+∶YAG被动调Q锁模Nd∶Gd0.42Y0.58VO4激光器

理论和实验研究了LD泵浦Nd∶Gd0.42Y0.58VO4/Cr4+∶YAG被动调Q锁模激光器.在分析Cr4+∶YAG晶体能级结构和调Q锁模物理过程的基础上,通过数值模拟给出了Cr4+∶YAG调Q锁模的参量要求,然后进行了实验验证.实验中Cr4+∶YAG的初始透过率T0分别为86.3%、95%,输出镜的透过率T分别为10%、20%,在其他条件不变的情况下构成四种不同的组合,均实现了激光器的调Q锁模运转.实验结果表明,降低Cr4+∶YAG的初始透过率T0或提高输出镜透过率T有利于获得较好的锁模效果,与理论分析一致.     

荧光材料Y_2O_3:Eu变温拉曼光谱分析

本文用显微拉曼谱仪在波长为785 nm的激光激发下,对Y2O3:Eu陶瓷在温度83-473 K间进行了系统的变温拉曼实验研究。实验发现Y2O3:Eu的一些振动模在低温下没有出现,只有当温度达到一定值之后才可以被观察到,分析表明这是由于温度变化引起的简并振动模式分裂。此外,Y2O3:Eu的拉曼峰位、半高全峰宽(FWHM)也是温度的非线性函数,且不同的拉曼峰遵循不同的函数关系,本文分析这是由于晶格的各向异性导致的。     

Calculated coupling constants 1J(X–Y) and 1K(X–Y), and fundamental relationships among the reduced coupling constants for molecules HmX–YHn,with X,Y ═ 1H, 7Li, 9Be, 11B, 13C, 15N, 17O, 19F, 31P, 33S,and 35Cl

Equation-of-motion coupled-cluster singles and doubles (EOM-CCSD) calculations have been performed to determine coupling constants ¹J(X–Y) for 65 molecules H_mX–YH_n, with X,Y ═ ¹H, ⁷Li, ⁹Be, ¹¹B, ¹³C, ¹⁵N, ¹⁷O, ¹⁹F, ³¹P, ³³S, and ³⁵Cl. The computed ¹J(X–Y) values are in good agreement with available experimental data. The reduced coupling constants ¹K(X–Y) have been derived from ¹J(X–Y) by removing the dependence on the magnetogyric ratios of X and Y. Patterns are found for the reduced coupling constants on a ¹K(X–Y) surface that are related to the positions of X and Y in the periodic table.     

微氧化烧结制备掺杂Y2O3的SiC陶瓷及含镉模拟废水处理

采用了微氧化烧结制备了不同Y₂O₃质量分数（0%、2%、4%、6%）的多孔SiC陶瓷，通过对陶瓷的晶体结构、微观形貌、物理性能和Cd²⁺的去除率测试发现：添加了Y₂O₃的SiC陶瓷出现了较多的第二相Y₂SiO₇、Y₅Si₃C_0.5，随着Y₂O₃的质量分数增加逐渐升高，主相的衍射峰的强度有降低。扫描电子显微镜测试发现，SiC陶瓷的尺寸在2.5 μm，Y₂O₃引入后，SiC陶瓷的晶粒尺寸降低，高温烧结时液相的含量增加，熔体粘度降低，晶粒结合更加紧密，Y₂O₃的引入提高了多孔陶瓷的体积密度，Y₂O₃质量分数为6%SiC的体积密度最大为2.21 g/cm³。热导率随着Y₂O₃质量分数的增加呈现出先升高后降低的趋势。金属Cd²⁺的过滤测试表明：随着Y₂O₃质量分数增加，Cd²⁺的残留质量浓度、膜通量和去除率先降低后升高，当掺杂质量分数为4%时，Cd²⁺残留质量浓度最低为0.042 mg/L，膜通量达到了最大值572 L/（m²·h），去除率最大为99.95%，相比未掺质量分数杂体系的去除率提高了0.14%。随着溶液pH值的逐渐增大，金属Cd²⁺的残留质量浓度逐渐降低、去除率逐渐升高，pH≥9时最终均趋于稳定。综合来看，多孔SiC陶瓷的助烧剂Y₂O₃最佳掺量为4%。     

On the linearity of ω-primality in numerical monoids

In an atomic, cancellative, commutative monoid, the ω-value measures how far an element is from being prime. In numerical monoids, we show that this invariant exhibits eventual quasilinearity (i.e., periodic linearity). We apply this result to describe the asymptotic behavior of the ω-function for a general numerical monoid and give an explicit formula when the monoid has embedding dimension 2.     

Dynamics of partially obstructed breakup of bubbles in microfluidic Y‐junctions

For revealing the dynamics of partially obstructed breakup of bubbles in microfluidic Y‐junctions, the combination of dimensionless power‐law and geometric model was applied to study the effects of capillary number, bubble length, and channel angle on the bubble rupture process. In the squeezing process, the gas‐liquid interface curve follows the parabolic model. For the evolution of the bubble neck during breakup, the increase of the bubble length, the channel angle, and the capillary number leads to the decrease of the focus distance α. The chord m increases with the increase of the capillary number and the decrease of the bubble length, and it would reach the maximum value when the channel angle is 90°. In the fast pinch‐off stage during bubble breakup, the bubble's neck curve no longer conforms to the parabolic model so the focus and chord no longer exist. For the evolution of the bubble head during breakup, the value of γ approaches 1 with the increase of the capillary number and the bubble length, and with the close of the channel angle to 90°. It is found that the quadrilateral model can be applied for the partially obstructed rupture of bubbles in the symmetrical microfluidic Y‐junction.     

Characterisation of atomic-scale defects in ODS ferritic alloys by positron annihilation

The vacancy-type defects and their local chemical environment in different ODS alloys produced in the USA (14YWT), China (K5) and Russia (ODS EP-450) are studied. The Angular Correlation of Annihilation Radiation (ACAR), which is one of the positron annihilation spectroscopy method, was used. It was shown that in all alloys, except 14YWT, the dominant type of positron traps are vacancy-like defects, localised in matrix or associated with dislocations and/or interfaces of the incoherent particles. In the case of 14YWT alloy, which contains Y–Ti–O nanoclusters of a high density, the positrons confine and annihilate at O-vacancy pairs or complexes within nanoclusters. It is testified by enhanced electron density in annihilation sites and neighbourhood of Ti and Y atoms. These results, obtained by the ACAR method, indicate that the vacancies play an essential role in the formation of nanoclusters in ODS 14YWT alloy as it was theoretical predicted by first-principle calculations.