破乳剂对复合驱乳状液的破乳机理研究

针对模拟采出液和三元复合驱矿场采出液,研究了破乳剂对复合体系界面张力和膜强度的影响.破乳剂浓度增加,二元复合体系界面张力降低,而三元复合体系界面张力升高.破乳剂分子部分顶替乳化剂分子并显著降低了界面膜强度.     

Atomic force microscopy of Au deposition from aqueous HF onto Si(111)

Non-contact atomic force microscopy (AFM) was employed following emersion to examine Au nanoclusters deposited from aqueous mixtures of HF and 10⁻⁴ M KAu(CN)₂ onto Si(111). As the HF concentration is increased, the growth rates both parallel and perpendicular to the substrate of the approximately oblate Au hemispheroids increase. AFM images were obtained for times at which previously reported in situ second harmonic generation signals from the interface reach a maximum. At the time when the second harmonic enhancement is maximized during deposition from 0.500 (5.00) M HF, the Au nanoclusters have an average diameter of 94 (109) nm and an average height of 3.6 (9.5) nm. These cluster diameters can be understood qualitatively by the shift of the plasmon resonance due to depolarization as the cluster size increases, causing the resonant second harmonic enhancement at 532 nm to pass through a maximum at cluster diameters in the range 90–110 nm.     

表面科学研究回顾与21世纪发展展望

表面与界面是材料物理、化学性质发生空间突变的二维区域,材料的许多重要物理、化学过程首先发生在表面,同时材料的很多破坏和失效也首先起源于表面和界面。因此,表面是材料与外部环境直接发生联系的窗口,从研究材料表面界面的各种物理化学过程入手最终可以达到改善材料性能的目的。过去１０年中,材料表面科学在促进材料科学基础研究、推动新材料新技术发展中发挥了关键作用。世纪之交乃至下一世纪,表面科学将面临新的挑战和机     

Flow and fracture of rocks under general triaxial compression

Recent laboratory studies of the flow and fracture of rocks under general triaxial compression are reviewed. New developments in laboratory techniques have made it possible to measure three principal stresses and strains under general triaxial stress states, in which all three principal stresses are different.Strength and ductility of isotropic rocks are markedly affected not only by the least compression ₃, but also by the intermediate compression ₂, although these two effects are rather additional in strength, but opposite in ductility. The experimental results show that dilatancy is highly anisotropic under the general triaxial stress states.Deformational properties of anisotropic rocks have been also measured under the general triaxial compression. In this case, the effect of the intermediate compression markedly depends on the orientations of the weak planes.     

Unsymmetrical bending problems for the annular and circular thin plates under various supporting conditions (I)

In this paper we consider the nonlinear and unsymmetrical bendings of annular and circular thin plates under various supports. The uniformly valid asymptotic solutions have been derived by means of the perturbation method presented in [7].     

On-line monitoring of all-acrylic emulsion polymerization reactors by Raman spectroscopy

Fourier Transform Raman spectroscopy was used as an on-line sensor in order to monitor high solids content (50 wt%) n-BA/MMA emulsion copolymerization reactions. Due to the similarity of the chemical structure of the monomers, no separate bands could be detected for each monomer, and therefore a multivariate calibration technique was required (Partial Least Squares Regression, PLSR). Using experimental data from several semi-batch reactions independent PLSR models were built for the solids content, cumulative copolymer composition and unreacted amounts of n-BA and MMA. Those models were experimentally validated by monitoring reactions not used for calibration. It is demonstrated that FT-Raman spectroscopy can be successfully applied to on-line monitor emulsion polymerization reactors. This technique also shows a high potential for process control purposes because independent information about several molecular properties can be obtained from a single apparatus.     

Analysis of particle formation under monomer-starved conditions in emulsion polymerization reactors

An important characteristic of monomer-starved nucleation in semibatch reactors is that the rate of growth of particles is controlled by the rate of monomer addition. The reduced rate of growth of particles prolongs the nucleation interval by slowing down the rate of emulsifier micelle depletion and forms a larger number of particles (N_p). Model calculations show how N_p varies with the formulation parameters as the monomer-flooded nucleation shifts into monomer-starved one. Particle formation in the intermediate conversion of interval III of the styrene batch emulsion polymerization also showed an enhancement because of a low rate of growth of newly formed particles. However, at a higher conversion, the rate of particle formation decreased significantly. Modeling results show that the reduction in the rate of particle formation at high conversions could not be simply explained by existing theories which rely on the decrease in monomer concentration in the aqueous phase as a means to explain the decrease in the rate of radical capture.     

Inorganic,polymeric and hybrid colloidal carriers with multi-layer reactive shell

Main experimental approaches for obtaining polymer, inorganic and hybrid colloidal particles as well as the tailored functionalization of their surface by oligoperoxide surfactants (OPS) and metal complexes (OMC) on their basis are discussed in the paper. The methods proposed enable to combine the stage of the formation of colloidal polymer, siliceous, metal and metal-oxide particles with the stage of their surface modification by functional surface-active oligoperoxides, which are sorbed irreversibly. Novel functional particles are studied by chemical, colloidal-chemical, rheological methods and scanning electronic microscopy. The occurrence of metal and metal oxide particle formation in distinct zones correlates well with the particle size distribution. The availability of reactive ditertiary peroxidic fragments on the particle surface as a result of OPS or OMC sorption causes their reliable protection, hydrophobity and ability to form free radicals and participate in elementary stages of radical processes.     

Tailoring the Flow Properties of Soft Colloidal Dispersions

Summary: The dynamics and the non-linear rheology of concentrated dispersions of soft particles are shown to exhibit generic properties. They display both solid-like and liquid-like properties depending on the applied stress. Below the yield point, dispersions exhibit history-dependent phenomena that have all the hallmarks of ageing in glasses. The close-packed disordered structures of the dispersions lie at the heart of this behaviour. Other properties such as the propensity of pastes to slip on solid surfaces appear to be governed by specific contact interactions between the squeezed particles.     

轴向间隙对动 /静相干叶排内部非定常特性的影响

本文采用文献［3,4］所发展的滑移界面技术,求解了不同轴向间隙时某一透平级内的非定常流场, 发现轴向间隙由0.152倍栅距变化到0.533倍栅距时,监测点速度u的相对振幅由26.27%下降为7.94%; 速度v的相对振幅由21.34%下降到7.3%。计算结果表明轴向间隙的增大将使动/静叶排间的相互干扰作用减弱,从而使其内部非定常流动特性减小,为设计工作提供了参考依据