时滞反馈控制下三维节能减排系统的稳定性分析

考虑三维节能减排系统,施加时滞反馈控制,建立反馈控制下的节能减排系统,求解平衡点,分析系统稳定性,得到出现Hopf分支的条件.利用中心流形定理和Poincare规范型方法讨论Hopf分支的性质,给定参数进行数值模拟,验证理论结果的有效性.     

Measurement of carbonyls in exhaust gases of light-duty vehicles in China using pentafluorophenyl hydrazine derivatisation and GC/MS analysis

A method for determining carbonyl emissions from motor vehicles was developed in which exhaust gases from test vehicles running on a dynamometer are directly collected in 6-L Teflon bags and then introduced into pentafluorophenyl hydrazine -coated adsorbent tubes for derivatisation and subsequent analysis of generated derivatives by GC/MS. Twenty gasoline and LPG light-duty vehicles were sampled at a vehicle inspection station in Guangzhou, China, by running test vehicles over a transient testing cycle and analysed for carbonyls. Results show that the method can achieve a detection limit of 8–28 ng m^?3 for individual carbonyls with a relative standard deviation of 14.5%. Twenty-four carbonyls were identified in the gasoline vehicle exhaust gases and their total concentration was 19.2 mg m^?3. For the LPG vehicles, 20 carbonyls were found in the exhaust gases with a total concentration of 4.71 mg m^?3. Based on the results, carbonyl emission factors for the gasoline and LPG vehicles were estimated to be 25.0 and 7.36 mg km^?1, respectively.     

Emissions and deposit properties from combustion of wood pellet with magnesium additives

This work studies the amount of gaseous and particle emissions and deposits on heat exchanger surfaces in a boiler firedwith commercially available pellets and with pellets primed with magnesium oxide and magnesium hydroxide.The combustionexperiments were performed on a residential boiler of 20 kW.Substrates placed in the heat exchanger was analysed with SEM-EDX-mapping to evaluate the chemical composition of the deposits.The results show that particle emissions(PM 2.5)using the additivesincreased by about 50%and the mass of the deposits in the flue gas heat exchanger(excluding loose fly ash)increased by about25%compared to the combustion of pellets without additives.The amount of additives was found to be eight times higher than theamount of the main alkali metals potassium(K)and sodium(Na)which leads to the assumption that the additives were overdosedand therefore caused the problems reported.The SEM analysis of the substrates placed in the flue gas heat exchanger indicate that thedeposits of sodium(Na),potassium(K),chlorine(Cl)and sulphur(S)decrease using the additives.If this was due to theexpected chemical reactions or due to the loose fly ash covering the substrates after the test,could not be determined in this study.     

Polymorphism dependent triplet-involved emissions of a pure organic luminogen

Polymorphism has been frequently used in tuning the singlet emissions of pure organic dyes. The modulation of triplet-involved emissions, particularly room temperature phosphorescence(RTP),however, is scarcely reported. Herein, polymorphism is reported to tune the triplet-involved emissions of 2 CZBZL, a newly designed pure organic luminogen consisting of twisted benzil and two planar carbazole moieties. Other than the conventional modulation through changing molecular conformation and packing, vibration can also finely tune the triplet-involved emissions. Besides prompt fluorescence(PF),polymorph B with relatively extended conformation emits thermally activated delayed fluorescence(TADF), whereas the others(A, C–E) with similarly more twisted conformations generate predominant RTP or simultaneous DF and RTP. These results demonstrate the fascinating chance to regulate the tripletinvolved emissions through controlling conformation and vibration.     

多色量子点表面等离子体耦合荧光发射性质

以巯基小分子为配体水相合成CdTe量子点, 通过调节回流时间调控其粒径大小. 由于量子点的宽谱激发特性, 在蓝光(473 nm)或绿光(532 nm)条件下, 纳米金属薄膜表面不同发射波长的CdTe量子点均可被激发而与金属表面等离子体发生耦合相互作用, 从而在棱镜一侧发出高度定向的偏振荧光, 其荧光特性与样品厚度密切相关. 表面等离子体耦合荧光发射法(SPCE)具有波长分辨性质, 不同颜色的量子点在不同角度定向发射, 发射波长越长, 角度越小. 720 nm和630 nm量子点的自由空间发射荧光光谱呈现交叠, 然而, 基于SPCE的波长分辨性质, 我们通过改变检测角度避开光谱重叠, 在棱镜一侧的43o和51o处分别得到了两种量子点的SPCE荧光单峰. 量子点是SPCE在多通路、高通量检测应用中荧光物种的理想选择.     

Development of a Method for Determination of Volatile Organic Compounds (C6-C9) by Thermal Desorption-Gas Chromatography. Application to Urban and Rural Atmospheres.

ABSTRACT

An analytical method for the determination of 15 Volatile Organic Compounds (VOC): benzene, n-heptane, toluene, n-octane, chlorobenzene, ethylbenzene, m-xylene, o-xylene, p-xylene, isopropylbenzene, n-propylbenzene, n-decane, 1,4-dichlorobenzene, 1,3-dichlorobenzene and 1,2-dichlorobenzene, by thermal desorption coupled with gas chromatography (GC) was proposed. The flame ionisation detector (FID) and mass spectrometry (MS) detector were used. The variables that have an influence on the desorption process (time, inert gas flow and temperature) were studied, obtaining detection limit ranges from 15 to 120 pg (GC-FID), 3.8 to 32 pg (GC-MS, SIM mode) and 15 to 300 pg (GC-MS, SCAN mode). In order to detect possible VOC urban sources, samples were taken from 6 points in A Coruña (N.W. Spain) to analyse. Sampling time and flow rate were 30 minutes and 50 mL/min respectively. VOC profile and their total concentrations can be considered as typical of an urban area. Other samples were also obtained from a nearly rural zone to determine the influence of these VOC sources.     

面向氢能源、燃料电池和二氧化碳减排的制氢途径的选择

对氢气的多种制造途径加以探讨,也涉及到氢能的利用、燃料电池以及二氧化碳的减排。需要指出的是氢气并非能源,而只是能量的载体。 所以氢能的发展首先需要制造氢气。对于以化石燃料为基础的制氢过程,如煤的气化和天然气重整,需要开发更经济和环境友好的新过程,在这些新过程中要同时考虑二氧化碳的有效收集和利用问题。对于煤和生物质,在此提出了一种值得进一步深入研究的富一氧化碳气化制氢的概念。对于以氢为原料的质子交换膜燃料电池系统,必须严格控制制备的氢气中的一氧化碳和硫化氢;对于以烃类为原料的固体氧化物燃料电池,制备的合成气中的硫也需严格控制。然而,传统的脱硫方法并不适宜于这种用于燃料电池的极高深度的氢气和合成气的脱硫。氢能和燃料电池的发展是与控制二氧化碳排放紧密相关的。     

Air pollution from traffic emissions in Oporto, Portugal: Health and environmental implications

Air pollution represents a serious risk not only to environment and human health, but also to historical heritage. In this study, air pollution of the Oporto Metropolitan Area and its main impacts were characterized. The results showed that levels of CO, PM₁₀ and SO₂ have been continuously decreasing in the respective metropolitan area while levels of NO_x and NO₂ have not changed significantly. Traffic emissions were the main source of the determined polycyclic aromatic hydrocarbons (PAHs; 16 PAHs considered by U.S. EPA as priority pollutants, dibenzo[a,l]pyrene and benzo[j]fluoranthene) in air of the respective metropolitan area. The mean concentration of 18 PAHs in air was 69.9 ± 39.7 ng m⁻³ with 3-4 rings PAHs accounting for 75% of the total Σ_PAHs. The health risk analysis of PAHs in air showed that the estimated values of lifetime lung cancer risks considerably exceeded the health-based guideline level. Analytical results also confirm that historical monuments in urban areas act as passive repositories for air pollutants present in the surrounding atmosphere. FTIR and EDX analyses showed that gypsum was the most important constituent of black crusts of the characterized historical monument Monastery of Serra do Pilar classified as “UNESCO World Cultural Heritage”. In black crusts, 4-6 rings compounds accounted approximately for 85% of Σ_PAHs. The diagnostic ratios confirmed that traffic emissions were the major source of PAHs in black crusts; PAH composition profiles were very similar for crusts and PM₁₀ and PM_2.5.     

Linking electromagnetic precursors with earthquake dynamics: An approach based on nonextensive fragment and self-affine asperity models

Understanding the earthquake (EQ) preparation process in terms of precursory electromagnetic (EM) emissions has been an evolving field of multi-disciplinary research. EM emissions in a wide frequency spectrum ranging from kHz to MHz are produced by opening cracks, which can be considered as precursors of general fracture. An important feature, observed on both laboratory and geophysical scale, is that the MHz radiation systematically precedes the kHz one. Yet, the link between an individual EM precursor and a distinctive stage of the EQ preparation comprises a crucial open question. A recently proposed two-stage model on preseismic EM activity suggests that the MHz EM emission is due to the fracture of the highly heterogeneous system that surrounds the fault. The finally emerged kHz EM emission is rooted in the final stage of EQ generation, namely, the fracture of entities sustaining the system. In this work we try to further penetrate and elucidate the link of the precursory kHz EM activity with the last stage of EQ generation building on two theoretical models for EQ dynamics. First, the self-affine model states that an EQ is due to the slipping of two rough and rigid fractional Brownian profiles, one over the other, when there is an intersection between them. Second, the fragment-asperity model, rooted in a nonextensive Tsallis framework starting from first principles, consists of two rough profiles interacting via fragments filling the gap. In the latter approach, the mechanism of triggering EQ is established through the interaction of the irregularities of the fault planes and the fragments between them. This paper shows that these models of EQ dynamics can be linked with the detected kHz EM emission. In this framework of analysis of preseismic EM activity, we identify sufficient criteria that offer the possibility to discriminate whether a seismic shock is sourced in the fracture of fragments filling the gap between the rough profiles or in the fracture of “teeth” distributed across the fractional Brownian profiles that sustain the system.     

发动机采用柴油／甲醇组合燃烧的性能研究

分别在增压和自然吸气式高速直喷柴油机上采用柴油/甲醇组合燃烧方式进行研究.试验结果表明,采用组合燃烧后发动机和纯柴油燃烧发动机相比,尾气中NOx和碳烟排放显著减少,消耗燃料的比能耗降低,组合燃烧用燃料的使用经济性优予原机;仅未燃碳氢和一氧化碳较原机有所增加,但是由于排气温度高于催化转换器起燃温度,可以通过催化转换器将其转化.