Comparative study of the instrumental couplings of high performance liquid chromatography with microwave-assisted digestion hydride generation atomic fluorescence spectrometry and inductively coupled plasma mass spectrometry for chiral speciation of selenomethionine in breast and formula milk

A comparison of chiral separation and analysis of selenomethionine in breast and formula milk, using high performance liquid chromatography (HPLC) on a glycopeptide teicoplanin-based chiral stationary phase (Chirobiotic T), coupled to atomic fluorescence spectrometry (AFS) and inductively coupled plasma (ICP) MS detectors has been performed. The coupling HPLC-microwave-assisted digestion hydride generation requires on-line post-column analytes treatment, and a severe sample clean-up for fat and proteins elimination using centrifugation and ultrafiltration. Underivatized -selenomethionine enantiomers were completely resolved in 10 min using unbuffered water mobile phase at 1 ml min⁻¹ flow. Good selectivity and sensitivities (detection limits 3.1 and 3.5 ng ml⁻¹ as Se for - and -selenomethionine, respectively) were obtained, and method robustness and simplicity, together to the low cost of AFS detector, makes it suitable for infant milk routine analysis. HPLC–ICP-MS coupling exhibits very low detection limits (0.9 ng ml⁻¹, as Se) for each -selenomethionine enantiomers, but the method suffers from matrix influence, that produces a poor S/N ratio and low reliability.

The methods were applied to breast and formula milk samples with recoveries of 80% of the total selenium presence, which is attributable to the existence of other unknown species. -Selenomethionine was the only isomer present in breast milk, but a 30% of -selenomethionine was also detected in formula milk.     

On-line hyphenation of capillary electrophoresis with flame-heated furnace atomic absorption spectrometry for trace mercury speciation

Capillary electrophoresis (CE) was directly interfaced to flame-heated furnace atomic absorption spectrometry (FHF-AAS) via a laboratory-made thermospray interface for nanoliter trace element speciation. The CE-FHF-AAS interface integrated the superiorities of stable CE separation, complete sample introduction, and continuous vaporization for AAS detection without the need of extra external heat sources and any post-column derivation steps. To demonstrate the usefulness of the developed hybrid technique for speciation analysis, three environmentally significant and toxic forms of methylmercury (MeHg), phenylmercury (PhHg), and inorganic mercury (Hg(II)) were taken as model analytes. Baseline separation of the three mercury species was achieved by CE in a 60 cm long x 75 microm inner diameter fused-silica capillary at 20 kV and using a mixture of 100 mM boric acid and 10% v/v methanol (pH 8.30) as running electrolyte. The precision (relative standard deviation, RSD, n = 7) of migration time, peak area and peak height for the mercury species at 500 microg x L(-1) (as Hg) level were in the range of 0.9-1.2%, 1.5-1.9%, and 1.4-2.0%, respectively. The detection limit (S/N = 3) of three mercury species was 3.0 +/- 0.15 pg (as Hg), corresponding to 50.8 +/- 2.4 microg x L(-1) (as Hg) for 60 nL sample injection, which was almost independent on specific mercury species. The developed hybrid technique was successfully applied to the speciation analysis of mercury in a certified reference material (DORM-2, dogfish muscle).     

Preparation of trout liver microsomes for iron speciation in P-450 enzymes by AE–FPLC with ICP–(ORS)MS detection

Cytochromes P-450 are members of a superfamily of hemoproteins involved in the oxidative metabolism of various physiological and xenobiotic compounds in eukaryotes and prokaryotes. The multiplicity of this group of enzymes has been widely studied by chromatographic techniques, mainly high-performance liquid chromatography (HPLC). Because these enzymes are membrane-bound proteins, sample preparation for chromatographic separation of P-450 enzymes requires a solubilization step. The sample-preparation procedures are critical, because detergents affect not only the efficiency of protein solubilization but also their further chromatographic resolution. Trout liver microsomes have been taken here as a model sample to investigate iron speciation in cytochrome P-450. Trouts were treated intraperitoneally with -naphthoflavone, a potent inducer of some P-450 enzymes, and a microsomal suspension containing 7.4±0.1 nmol mL^–1 P-450 enzymes was obtained by ultracentrifugation. Lubrol PX was selected as detergent for solubilization, resulting in about 90% solubilization recovery. The solubilized cytochromes P-450 were further separated by AE–FPLC, with UV detection, or coupled to ICP–MS with an octapole reaction system, ICP–(ORS)MS (monitoring Fe signals at masses 54, 56, and 57). A sampling procedure and chromatographic conditions are developed and were successfully applied to iron speciation in trout liver P-450 enzymes. ICP–(ORS)MS detection of P-450 enzymes is Fe-specific and so will give accurate information on the prosthetic group of the protein, which can constitute an advantageous alternative to classical methods for detection of these hemoproteins.     

Interferences in ultratrace speciation of organolead and organotin by gas chromatography with atomic spectrometric detection

Interferences in trace and ultratrace speciation analysis of organotin and organolead compounds in various samples by gas chromatography coupled with atomic absorption spectrometry (AAS) and/or microwave induced plasma atomic emission spectrometry (MIP AES) are investigated. Particular attention is given to the effects of matrix co-extractives and reagents impurities introduced during sample preparation. Their influence on the detection limits is discussed in terms of baseline noise level, blank value, formation of artefacts and signal suppression. Loss of column resolution during the analysis of some matrices is observed.     

Speciation analysis of chromium by separation on a 5-palmitoyl oxine-functionalized XAD-2 resin and spectrophotometric determination with diphenylcarbazide

The method developed in this work for the separation and preconcentration of Cr(III) is based on its retention by an Amberlite XAD-2 copolymer resin functionalized with 5-palmitoyl-8-hydroxyquinoline (oxine), abbreviated XAD-POx, with the ligand covalently bound to the copolymer. Cr(III) sorption was quantitative within the pH range 4.5–7.0 and Cr(VI) was not retained. The Cr(III) held by the resin column was eluted with a hot solution of H₂O₂ in pH9.0 aqueous NH₃–NH₄Cl buffer, and Cr oxidized to CrO₄^2– was rejected by the chelating cation-exchanger column. Any Cr(VI) originally present with Cr(III) could be reduced with an acidic solution of H₂O₂, and retained by the column yielding total Cr results, Cr(VI) being determined from the difference. The resin showed a maximal preconcentration factor of 60 for Cr(III), the LOD and LOQ being 9.3 and 30.1 nmol L^–1, respectively. The developed preconcentration-speciation analysis was finished with a diphenylcarbazide (DPC) spectrophotometric procedure suitable for conventional laboratories. The resin showed excellent salt tolerance, enabling Cr analysis in seawater, and was stable over extended use. All the interferents of this procedure that normally occur in an electroplating effluent, a blended coal CRM, and a standard steel sample could be removed by the recommended procedure, by use of partial and total selectivity at the adsorption and desorption stages, respectively, enabling preconcentration and colorimetric determination of chromium in various complex matrices.     

ELECTROCHEMICAL POLYMERIZATION OF ANILINE IN PHOSPHORIC ACID AND THE PROPERTIES OF POLYANILINE

The behavior of the electrochemical polymerization of aniline in a weak acid, phosphoric acid, is very similar to that in strong acids, i.e. its polymerization rate increases quickly with the electrolysis time. The FTIR spectra of polyaniline samples synthesized in phosphoric acid indicate that the counter ion H2PO4^- is present in both the oxidized form and the reduced form of polyaniline. The counter ion plays an important role in adjusting the pH value at the electrode surface of polyaniline during the oxidation and reduction processes. As a result, a pair of redox peaks still appear in cyclic voltammograms of polyaniline in a solution of sodium sulfate of pH 5.5 and in a solution of NaH2PO4 of pH 7.0,respectively, at low potential scan rate; and the color of polyaniline film also changes with applied potential at pH 7.0. Thus,the pH region for the electrochemical activity and the electrochromism of polyaniline is extended to pH 5.5 for a solution of sodium sulfate and to pH 7.0 for a solution of NaH2PO4. The conductivity of polyaniline is 3.3 S cm^-1, depending on the concentration of phosphoric acid used in the stage of polymerization of aniline. The result of elemental analysis of polyaniline is presented here.     

Hydrolysis of (CH3)3Sn+ in Various Salt Media

The hydrolysis of trimethyltin(IV) has been studied by potentiometry (H⁺ -glass electrode) and calorimetry in various salt media (NaNO₃, NaCl, KCl, Na₂SO₄, and NaNO₃—NaCl mixtures). The effect of ionic strength on the hydrolysis constants is accounted for by a simple Debye–Hückel type equation and by Pitzer equations. The results allow us to obtain H for hydrolysis and the temperature dependence of the Pitzer parameters. The resulting coefficients can be used to examine the speciation of (CH₃)₃Sn⁺ in multicomponent electrolyte solutions, such as natural waters, over a wide range of temperature and ionic strength.     

Analysis of microgram amounts of particulate material by simultaneous multiwavelength AES

A unique simultaneous emission spectrograph is utilized to perform qualitative and quantitative analysis on trace quantities of solid particulates. The atomic emission spectroscopic system consists of a direct current plasma source and an echelle spectrograph with a charge injection device detector, enabling the system to simultaneously measure the wavelength range from 220 nm to 520 nm with 0.02 nm resolution at 300 nm. Monitoring all wavelengths simultaneously allows the qualitative and quantitative determination of most major and minor constituent in a trace quantity of sample with little prior knowledge about the sample. The ability to perform qualitative and quantitative analysis on particulates is demonstrated by evaluating NBS certified coal fly ash, as well as a sample taken from the respirator air filter at an acute care unit in a hospital.Presented in part at the 1989 European Winter Conference on Plasma Spectrochemistry, Reutte, Austria     

Structural analysis of 2,6-[bis(alkyloxy)methyl]-phenyltin derivatives using electrospray ionization mass spectrometry

Electrospray ionization (ESI) mass spectrometry was applied to the structural analysis of 23 2,6-[bis(alkyloxy)methyl]phenyltin(IV) derivatives. The mass spectra were measured in both polarity modes and multistage tandem mass spectrometric (MS(n)) measurements were performed on the ion trap analyser for positively charged tin-containing ions. The sum of complementary ions observed in the positive-ion mode (i.e. [M-R(3)](+) ion) and in the negative-ion mode (i.e. [R(3)](-) ion) permits molecular mass determination in spite of the fact that the molecular adducts were often missing even in the first-order mass spectra. The subsequent fragmentation of [M-R(3)](+) ions studied by MS(n) and the correlation of observed fragment ions with the expected structures of synthesized organotin(IV) compounds allowed us to understand the fragmentation behaviour and the mechanism of the ion formation for studied compounds. The typical neutral losses are alkenes, alcohols and aldehydes. The fragmentation pattern of one selected compound was supported by MS(n) measurements of an isotopically labelled analogue to confirm unusual ion-molecule reactions of some fragment ions with water in the ion trap.     

Speciation of arsenic in ground water samples: A comparative study of CE-UV, HG-AAS and LC-ICP-MS

The performance of capillary electrophoresis-ultraviolet detector (CE-UV), hydride generation-atomic absorption spectrometry (HG-AAS) and liquid chromatography-inductively coupled plasma mass spectrometry (LC-ICP-MS) have been compared for the speciation of arsenic (As) in groundwater samples. Two inorganic As species, arsenite (As^III), arsenate (As^V) and one organo species dimethyl arsenic acid (DMA) were mainly considered for this study as these are known to be predominant in water. Under optimal analytical conditions, limits of detection (LD) ranging from 0.10 (As^III, AsT) to 0.19 (DMA) μg/l for HG-AAS, 100 (As^III, DMA) to 500 (As^V) μg/l for CE-UV and 0.1 (DMA, MMA) to 0.2 (As^III, As^V) μg/l for LC-ICP-MS, allowed the determination of the above three species present in these samples. Results obtained by all the three methods are well correlated (r² = 0.996*** for total As) with the precision of <5% R.S.D. except CE-UV. The effect of interfering ions (e.g. Fe²⁺, Fe³⁺, SO₄²⁻ and Cl⁻) commonly found in ground water on separation and estimation of As species were studied and corrected for. Spike recovery was tested and found to be 80-110% at 0.5 μg/l As standard except CE-UV where only 50% of the analyte was recovered. Comparison of these results shows that LC-ICP-MS is the best choice for routine analysis of As species in ground water samples.