微波合成铝掺杂钻酸锂材料及性能研究

以LiOH·H2O，Al2O3和Co3O4为原料，微波加热合成Li离子电池正极材料LiAlxCo（1-x）O2．通过XRD测试表征了不同Al加入量时合成产物的晶体结构，确定当x≤0．4时，产物为单一相层状结构．计算了不同x时LiAlxCo（1-x）O2的晶胞参数，随着x的增大，a值减小，c值增大．对合成LiAlxCo（1-x）O2样品进行DSC—TGA测试，结果表明，当x不同时，合成样品的热稳定性不同．SEM测试表明，合成晶体粒度较均匀，粒径在5μm左右．电化学测试表明，LiAl0.2Co0.8O2的电化学性能最好，首次循环放电容量为127mAh／g，多次循环容量损失率小于LiCoO2．     

Shot noise sets the limit of quantification in electrochemical measurements

Detection of single molecules, particles, and rapid redox events is a challenge of electrochemical investigations and requires either an amplification strategy or significant averaging for the electrochemical current to exceed the noise level. We consider the minimum number of electrons required to reach the limit of quantification in these electrochemical measurements. A survey of the literature indicates that the state-of-the-art limit in current detection for different types of measurements (e.g. voltammetry, single-molecule redox cycling, ion channel recordings of single molecules, metal nanoparticle collision, and phase nucleation) is independent of the nature of the measurement and increases linearly with reciprocal response time, Δt^?1, over ～5 orders of magnitude (from ～10 to ～10⁶ s^?1). We demonstrate that the practical limit of quantification requires cumulative measurement of ～2100 electrons during Δt and is determined by statistics of counting electrons, that is, the shot noise in the current.     

Thermodynamics of molecular interactions in ethyl iodide+toluene mixtures

The excess Gibb's free energy of mixing, G^E, for ethyl iodide+toluene at 25°C have been obtained from the measured vapor pressuure data. The H^E and G^E values for ethyl iodide+toluene are positive throughout the ethyl iodide concentration range and G^E>H^E. The results have been analyzed in terms of Flory and ideal associated model theory of nonelectrolyte solutions. It has been observed that the ideal associated model approach which assumes the presence of AN and A₂B molecular species describes well (within±10 J-mol^–1 in the worst case) the general dependence of H^E on X_A (mole fraction of ethyl iodide) over the whole composition range for ethyl iodide+toluene mixtures. The equilibrium constants for A+A AB and 2A+BA₂B reactions along with the enthalpies of formation of AB and A₂B molecular species have been calculated.     

Effect of hydrogen bonding of solvent on the thermodynamic stability of cadmium ethylenediamine complexes

Changes in the stability of the cadmium(ii) ethylenediamine complexes in mixed water—DMSO solvents were studied by pH-metry and calorimetry. Complex cations [Cd(en)]²⁺, [Cd(en)₂]²⁺, and [Cd(en)₃]²⁺ are formed in aqueous solutions, and the [Cd(en)₄]²⁺ complex with a partially dentate ligand is stable in DMSO. An increase in the DMSO content in a solvent increases the stability of the complexes. The maximum increase in logK is observed for coordinatively saturated compounds. The thermodynamics of complexation is discussed from the viewpoint of solvation approach. Principal differences in the influence of aqueous-alcohol and aqueous-aprotic solvents on the stability of the metal amino complexes were revealed. Protolytic solvents exert a destabilizing effect on the multiligand complexes, because the coordination sphere is involved in H bonding.     

Thermodynamics of the conversion of aqueous glucose to fructose

The thermodynamics of the conversion of aqueous glucose to fructose has been investigated using both heat conduction microcalorimetry and high pressure liquid chromatography (HPLC). The reaction was carried out in both aqueous Tris/HCl buffer and in aqueous phosphate buffer in the pH range 7–8 using the enzyme glucose isomerase and the cofactors CoCl₂ and MgSO₄. The temperature range over which this reaction was investigated was 298.15–358.15 K. We have found that the enthalpy of reaction is independent of pH over the range investigated. A combined analysis of both the HPLC and microcalorimetric data leads to the following results at 298 15 K:ΔG° = 349 ± 53 J mol^-1, ΔH° = 2.78 ± 0.20 kJ mol^-1, and ΔC _p ^° = 76 ± 30 J mol^-1 K^-1. The stated uncertainties are based upon an analysis of both the random and systematic errors inherent in the measurements. Comparisons are made with literature data. The percent conversion of glucose to fructose has been calculated for the temperature range 300–373.15 K.     

电化学方法获得具有表面增强拉曼活性镍电极的研究

利用纯电化学手段获得了具有较强表面增强拉曼活性的镍电极, 改进了原有的镍电极表面预处理方法. 结果表明, 在0.5 mol/L的NaClO4溶液中, 结合电化学阶跃技术和循环伏安技术, 可以得到合适的粗糙镍电极; 同时, 还得到了探针分子吡啶在该粗糙镍电极表面随电极电位变化的表面增强拉曼光谱(SERS), 此时谱峰强度获得了极大的增强; 还研究了粗糙镍电极的扫描电子显微镜(SEM)图像, 并估算出其SERS增强因子约为104, 此结果比以前的镍电极表面粗糙方法所能达到的增强因子高一个数量级.     

Complexation of aluminate anion by bis-tris in aqueous media at 25–50°C

Gibbsite, Al(OH)₃, solubility studies in aqueous NaCl solutions at pH 9 demonstrate that the aluminate anion forms a strong complex with the neutral Bis-tris molecule 2,2-Bis(hydroxymethyl)-2,2,2-nitrilotriethanol, at low temperatures. The logarithm of the molal concentration quotient for the reaction

Vanadium Doped Sol-Gel TiO2 Coatings

A study of the experimental conditions required to obtain vanadium doped sol-gel TiO2 coatings is presented. Tetraethyl orthotitanate was employed as the TiO2 source and VCl3, VOSO4 · H2O and VOSO4 dissolved H2SO4 where employed as vanadium sources.Dip coating has been used to produce coatings on silicon wafers, spectral carbon electrodes and titanium electrodes. Both supported and unsupported films have been studied by UV-Vis spectra, IR spectroscopy and X-ray diffraction (XRD). The measurements have been made on samples as prepared and treated thermally at temperatures between 100°C and 300°C. The thermal treatment temperatures have been established from DTA/TGA measurements.The vanadium doped sol-gel TiO2 coatings have been tested as sensors for redox potential measurements in electrochemical processes. The influence of both the thickness of films and the nature of substrate has been investigated.     

ZnO纳米线的电化学制备研究

High-quality ZnO nanowires have been synthesized at relatively low temperature via one-step electrochemical anodization technique. In this method, Zn sheet acted as the anode and Pb sheet served as the counter electrode, and the complex solution of HF-C₂H₅OH-H₂O was used as electrolyte. ZnO nanowires were characterized by Field Emission Scanning Electron Microscopy (FE-SEM), Transmission Electron Microscopy (TEM) and Selected Area Electron Diffraction (SAED) and X-ray Diffraction (XRD). The results show that the nanowires were wurtzite crystalline ZnO, and the ZnO nanowires with the diameters of 70 nm and 30～40 nm were obtained by adjusting preparation conditions, respectively.     

超高交联吸附树脂吸附对硝基苯乙酮的热力学研究

比较两种超高交联聚苯乙烯吸附树脂NJ-8、AM-1与Amberlite XAD-4(以下简称XAD-4)对对硝基苯乙酮的静态吸附行为，根据吸附等温线研究了吸附热力学性质．在298～318K和研究的浓度范围内，NJ-8，AM-1、XAD-4对对硝基苯乙酮的吸附平衡数据符合Freundlich吸附等温方程．结果表明：吸附为放热过程，适当降低温度有利于吸附．计算了对硝基苯乙酮在NJ-8，AM-1、XAD-4树脂上的吸附焓变、自由能变，吸附熵变．对吸附行为作了合理的解释。