光电传感器在战场侦察车上的应用与发展

通过对国内外战场侦察车光电传感器资料及实物的查阅和调研，并通过总结几十年的工作和设计经验，论述了战场侦察车上光电传感器在未来数字化战争中的作用和地位。对国外传感器系统在侦察车上的应用状况进行了分析，着重对各种传感器进行分析与比较，并对多光谱技术、多传感器的图像融合技术以及桅杆的应用和要求提出看法。最后对我国光电传感器在战场侦察车上的应用与发展提出了建议。     

On the dynamic electromechanical loading of dielectric elastomer membranes

Dielectric elastomer actuators (DEAs) have received considerable attention recently due to large voltage-induced strains, which can be over 100%. Previously, a large deformation quasi-static model that describes the out-of-plane deformations of clamped diaphragms was derived. The numerical model results compare well with quasi-static experimental results for the same configuration. With relevance to dynamic applications, the time-varying response of initially planar dielectric elastomer membranes configured for out-of-plane deformations has not been reported until now. In this paper, an experimental investigation and analysis of the dynamic response of a dielectric elastomer membrane is reported. The experiments were conducted with prestretched DEAs fabricated from 0.5 mm thick polyacrylate films and carbon grease electrodes. The experiments covered the electromechanical spectrum by investigating membrane response due to (i) a time-varying voltage input and (ii) a time-varying pressure input, resulting in a combined electromechanical loading state in both cases. For the time-varying voltage experiments, the membrane had a prestretch of three and was passively inflated to various predetermined states, and then actuated. The pole strains incurred during the inflation were as high as 25.6%, corresponding to slightly less than a hemispherical state. On actuation, the membrane would inflate further, causing a maximum additional strain of 9.5%. For the time-varying pressure experiments, the prestretched membrane was inflated and deflated mechanically while a constant voltage was applied. The membrane was cycled between various predetermined inflation states, the largest of which was nearly hemispherical, which with an applied constant voltage of 3 kV corresponded to a maximum polar strain of 28%. The results from these experiments reveal that the response of the membrane is a departure from the classical dynamic response of continuum membrane structures. The dynamic response of the membrane is that of a damped system with specific deformation shapes reminiscent of the classical membrane mode shapes but without same-phase oscillation, that is to say all parts of the system do not pass through the equilibrium configuration at the same time. Of particular interest is the ability to excite these deformations through a varying electrical load at constant mechanical pressure.     

Weak noncovalent Si···F?C interactions stabilized fluoroalkylated rod-like polysilanes as ultrasensitive chemosensors

Noncovalent interactions, such as hydrogen bonding, metal coordination, and π-π stacking, are increasingly being utilized to develop well-ordered and self-organized supramolecular materials. Recently, new types of nonclassical weak interactions, such as C H···π, C H···F C, and C H···O, have been exploited in stabilizing the specific conformations of molecules and molecular assemblies in the solid state. These noncovalent interactions play an important role in materials comprised of polymer chains, because cooperative effects from a large number of weak interactions can lead to drastic changes in its conformation, several properties, and functionalities. The programmed design of synthetic helical polymer with well-defined molecular conformation has been the main subject in modern polymer science and engineering. Silicon-catenated polysilane is an ideal helical silicon quantum wire and polymers with unique photophysical properties. The present review highlights the spectroscopic evidences for through-space weak Si···F C interaction in poly(methyl-3,3,3-trifluoropropylsilane) ( 1 ) in noncoordinating and coordinating solvents by means of NMR (²⁹Si and ¹⁹F) and IR spectroscopies, and viscometric measurement. It was found that 1 is applicable for chemosensors with an extremely high sensitivity and selectivity toward fluoride ions in tetrahydrofuran (THF) and with high sensitivity for nitroaromatic compounds, detected by a decrease in the photoluminescence intensity in THF and in thin solid film. © 2006 Wiley Periodicals, Inc. J Polym Sci Part A: Polym Chem 44: 5060–5075, 2006     

Growth of oxide thin films for optical gas sensor applications

Tungsten trioxide and titanium dioxide thin films were synthesised by pulsed laser deposition. We used for irradiations of oxide targets an UV KrF* (λ = 248 nm, τ_FWHM ≅ 20 ns, ν = 2 Hz) excimer laser source, at 2 J/cm² incident fluence value. The experiments were performed in low oxygen pressure. The (0 0 1) SiO₂ substrates were heated during the thin film deposition process at temperature values within the 300-500 °C range. The structure and crystalline status of the obtained oxide thin films were investigated by high resolution transmission electron microscopy. Our analyses show that the films are composed by nanoparticles with average diameters from a few to a few tens of nm. Moreover, the films deposited at substrate temperatures higher than 300 °C are crystalline. The tungsten trioxide films consist of a mixture of triclinic and monoclinic phases, while the titanium dioxide films structure corresponds to the tetragonal anatase phase. The oxide films average transmittance in the visible-infrared spectral range is higher than 80%, which makes them suitable for sensor applications.     

Electrochemical Oxidation of Compounds Containing 1,4-Dihydropyridine and Pyridinium Rings — Analogs of Gene Transfection Agents

A study was carried out on the electrochemical oxidation of 1,4-dihydropyridines, found as substituents in pyridinium salts, which are strong electron acceptors. The potentials for their oxidation in acetonitrile were determined. NMR spectroscopy was used to find the relative acidity of the N–H and C–H protons and the oxidation potentials were determined for the anionic products of the ionization of the N–H bond in dihydropyridine. The only product of the preparative electrolysis, in contrast to chemical oxidation, is the corresponding pyridine, namely, the oxidized dihydropyridine form.     

毛细管电泳安培检测扑热息痛及其水解物

研究了各种电化学预处理条件下碳纤维电极对扑热息痛及水解物的电化学行为。确定该体系最佳预处理条件为０．２Ｖ电位下阳极化１ｍｉｎ，再于－２．０Ｖ下阴极化１０ｓ。预处理后的碳纤维伏安响应得到明显提高。运用最佳条件并在支持电解中加入添加剂后，扑热息痛及其水解物在毛细管电泳上获得很好的分离和检测。其中扑热息痛的检测下限为２．７８ｐｇ；对氨基酚为１．８４ｐｇ。     

基于硫化镉纳米团簇标记DNA电化学传感的研究

合成了表面具有自由羧基的硫化镉纳米团簇，以乙基-（3-二甲基丙基）碳二 亚胺盐酸盐为偶联活化剂，将其标记于人工合成的5'端氨基修饰的寡聚核苷酸片段 上，制备成CdS纳米团簇标记DNA探针，该寡聚核苷酸片段与大肠杆菌肠毒素基因相 关。在一定的条件下，使基与固定晨玻碳电极表面的待测DNA序列进行杂交反应， 利用阳极溶出示差脉冲伏安法（ASDPV）间接测定Cd的量，实现对互补、非互补 DNA片段的识别和电化学检测，从而对大肠杆菌肠毒素基因片段识别和检测。     

溶液酸度和反应温度对CaMoO4薄膜电化学制备的影响

本工作研究了恒电流电化学技术制备CaMoO₄薄膜工艺中，溶液酸度和反应温度对薄膜形成的影响。结果表明，酸度会影响薄膜的生长时间和光致发光特性，在较低酸度沉积薄膜时，容易造成薄膜的团簇生长和不确定相的形成；适当升高反应温度会加快晶粒的生长、提高薄膜的纯度、增加薄膜发射光谱的相对强度。在CaMoO₄薄膜电化学制备工艺中，溶液pH值控制在12.0附近和反应温度控制在60 ℃的左右比较好。     

Study of migration of active components of phosphorescent oxygen sensors for food packaging applications

A study of migration of the active components of oxygen sensors into food is presented. Six types of sensors, based on different oxygen sensitive dyes (two metalloporphyrins and one ruthenium dye), polymers (polystyrene and polysulfone) and support materials, were exposed to a number of standard ‘food simulants’ recommended by FDA/EU guidelines and then assayed for migration or sensor components and changes in oxygen calibration. Both metalloporphyrin sensor dyes leached only in olive oil and in 95% ethanol (used as a positive control), at maximum levels of 19.22 μg/dm² for PtOEPK and 113.96 μg/dm² for PtTFPP. The RuDPP dye showed maximum leaching in 95% ethanol (25.19 μg/dm²) while also migrating in an acidic aqueous simulant. Planar supports such as polyester tended to enhance the stability of the sensor. Migration of the styrene monomer from the polystyrene encapsulation medium was concluded to be low enough to be insignificant. Migration of sensor components was shown to correlate with the changes in sensor response to oxygen. Based on these results, sensor combinations were ranked on the basis of their resistance to leaching and their general stability, safety and suitability for use on a large scale in packaged foods and related food applications was proven.     

电化学超级电容器电极材料的研究进展

回顾了电化学超级电容器电极材料的研究进展，并对不同电极材料的储能原理和性能特点进行了简要的阐述。参考文献29篇。