Elastic moduli and structure of low density polyethylene

Summary Low density polyethylene film is drawn at room temperature four times the original length and subjected to thermal annealing at 60, 80, and 100 °C keeping the film length constant. Long spacing measured by SAXS increased with increasing temperature of annealing; the increase of the long spacing is presumed to be due to the decrease of the number of micelles through relaxation during the annealing. Simultaneous measurement of the changes of the long spacing and the film length by stretching is carried out and stress-extension curves are obtained. The values of the initial moduli of the long spacingE ₁ and the film lengthY are very near to each other. Elastic modulus of the crystal latticeE _c is known to be 235 GN/m² and that of the amorphous regionE _a is found to be 0.15 GN/m². When higher stress is applied than in the case of the initial modulus, the percentage of extension of film is much greater than that of the long spacing. The discrepancy is explained by the increase of the number of micelles through stress crystallization.Dedicated to Professor Dr. K. Ueberreiter on the occasion of his 70th birthday.     

Sulfate Ions in Titania Polymorphs

Sol-gel titania was sulfated by using sulfuric acid as hydrolysis catalyst, or by impregnating with ammonium sulfate fresh samples prepared with nitric acid or ammonium hydroxide as hydrolysis catalyst. Samples were characterized with X-ray powder diffraction, infrared spectroscopy, thermogravimetry and atomic absorption spectroscopy. Sulfate ions were found anchored to brookite and anatase phases, because they have short O—O atomic bond lengths slightly larger than the largest O—O bond length of sulfate ion. Since the shortest O—O atomic bond in anatase is smaller than the one in brookite, the sulfate ions are then less deformed when they are anchored to anatase, and consequently more stable. Therefore when the sample temperature is raised, the brookite with sulfate ions was transformed mainly to anatase and not into rutile, which is the most probably transformation when these ions are not involved. Sulfate ions also hindered anatase and brookite crystallite growing and stabilized the crystalline structure of anatase. When the sulfate ions are lost the crystalline anatase phase is transformed into rutile, leaving a large number of vacancies that favored atom diffusion and consequently the growing of rutile crystallites. The crystalline evolution of the samples as a function of the annealing temperature is almost independent of the sulfating method.     

Molecular Dipole Moment and Interaction Dipole Moment in 2-N-Substituted Amino-3(or 5)-methyl-4-nitropyridines and Their N-Oxides

The dipole moments of 2-alkylaminoand 2-alkylnitramino-3(or 5)-methyl-4-nitropyridines and their N-oxides have been measured, as well as calculated, using vectorial summation of the group moments and by ab initio method. The estimated interaction dipole moments, _int, have been discussed in terms of the electronic and steric effects and intramolecular hydrogen bonding. Introduction of the NHCH₃ group to position 2 in 4-nitropyridine strengthens the conjugation between the nitro group and ring nitrogen. The lack of such strengthening in 4-nitropyridine-N-oxides is explained as being due to formation of intramolecular hydrogen bond between the N-oxide group and the hydrogen of alkylamino group. Introduction of the nitramino group does not lead to marked modification of the charge distribution in a molecule. This fact may be explained by much weaker electron-donating ability of this group in comparison with the alkylamino group.     

The aromatic diboracyclopropenyl (diboriranyl) anion; CB2H3 −: An ab initio study

The most stable structure of CB₂H₃ ^–, as established computationally, is the aromatic diboracyclopropenyl (diboriranyl) anion (5), while open-chainC _2v, isomer H₂BCBH (7) is only 3 kcal/mol higher in energy at the QCISD(T)/6-311 +G^**//MP2/6-31+G^*+ZPE (HF/6-31 +G^*). The 47-kcal/mol barrier between cyclic,5, and open-chain,7, structures suggests that both of them may be observed. The aromatic stabilization energy of the diboriranyl anion (18 kcal/mol) is half the value in the isoelectronic cyclopropenium ion, C₃H₃ ⁺. The computed, by IGLO method (5a), and experimental (6a) chemical shifts,(¹³C) and(¹¹B), agree within 4 ppm range. The theoretical vibrational frequencies of the most stable isomers,5 and7, are presented for experimental verification of these species.     

Kinetics, selectivity, and mechanism of the reactions of arenes with adamantyl carbocations in sulfuric acid

Data on the kinetics, selectivity, kinetic isotope effect, and the effect of the acidity of the medium on the rate of the reactions of benzene and alkylbenzenes in sulfuric acid (59–78 wt.% H₂SO₄) solutions of 1-adamantanol at 30 °C indicate that the direct reagents are the adamantyl carbocations (Ad⁺) that alkylate the arenes. The ortho positions of the benzene ring are not accessible on account of steric hindrances. The rate of attack by the Ad⁺ cation on the accessible para and meta positions of the ring is controlled by the formation of a σ complex. __________ Translated from Teoreticheskaya i éksperimental’naya Khimiya, Vol. 42, No. 1, pp. 14–18, January–February, 2006.     

Structural Efficiency and Microstructural Modeling of Wet Gels and Aerogels

We present a microstructural model of aerogels that includes the effect of particle necks, tortuosity and dangling ends on the scaling of elastic moduli with density. Relative neck radii can be determined for sintering series of silica aerogels and for Resorcinol Formaldehyde (RF) aerogels produced with different catalyst concentrations. The density of elastically ineffective dangling ends and the tortuosity can be estimated using information from thermal conductivity and elastic modulus measurements in silica aerogels. Typical values for the load bearing mass range from >50% for high density and heat treated aerogels to <10% of the total mass for low density wet-gels.     

Aging effect on the mechanical properties of hybrid gels

Sol-gel derived unsupported films and thin rods have been obtained from co-hydrolysis of triethoxysilane and methyldiethoxysilane. The materials are flexible, dense and transparent. Films and rods have been aged for different periods of time in air at room temperature. The elastic modulus has been measured by means of tensile or flexural tests. Measurements showed an increase of elastic modulus with aging time and showed different values for films and rods. The observed evolution of mechanical properties has been related to a corresponding structural modification as highlighted mainly by MAS-NMR studies. Analyses pointed out the crucial role of condensation processes and showed that the stiffness increase arises from the formation of relatively few bonds which link and constrain pre-existing mobile network regions.     

Influence of the Coordination of Donor Solvent Molecules to 1,4,7,10-Tetramethyl-1,4,7,10- tetraazacyclododecanenickel(II) and Analogous Nickel(II) Complexes on Their Steric Factors

Coordination equilibrium constants (K _NiS) of some donor solvent molecules to 1,4,7,10-tetramethyl-1,4,7,10-tetraazacyclododecanenickel(II) ([Ni(Me₄[12]aneN₄)]²⁺) were determined in nitrobenzene (a noncoordinating bulk solvent). The first (K _NiS1) and second stepwise coordination equilibrium constants (K _NiS2) for 1,4,7,10-tetraazacyclododecanenickel(II) ([Ni([12]aneN₄)]²⁺), 1,4,8,11-tetraazac yclotetradecane- nickel(II) ([Ni([14] aneN₄)]²⁺), 1,4,8,11-tetrathiacyclotetra-decanenickel(II) ([Ni([14]aneS₄)]²⁺) were also reinvestigated. The K _NiS values for [Ni(Me₄[12]aneN₄)]²⁺ were compared to those of [Ni([12]aneN₄)]²⁺, (1R,4S, 8R,11S)-1,4,8,11-tetramethyl-1,4,8,11-tetraazacyclotetradecanenickel(II) (R,S,R,S-[Ni(Me₄[14]aneN₄)]²⁺), R,R,S,S-[Ni(Me₄[14]aneN₄)]²⁺, [Ni([14]aneN₄)]²⁺, and [Ni([14]aneS₄)]²⁺. Coordination of pyridine (Py), N,N,N′,N′-tetramethylurea (TMU), and N,N-dimethylacetamide (DMA) to [Ni(Me₄[12]aneN₄)]²⁺ was observed, although these donor solvent molecules did not coordinate to R,S,R,S-[Ni(Me₄[14]aneN₄)]²⁺. The K _NiS values for Py, TMU, and DMA are 7.9, 2.8, and 9.0 dm³⋅mol⁻¹, respectively. Some hydrogen-bonding waters were coordinated to R,S,R,S-[Ni(Me₄[14]aneN₄)]²⁺, but such waters did not coordinate to [Ni(Me₄[12] aneN₄)]²⁺. Also, the K _NiS2 values were larger than the corresponding K _NiS1 values for [Ni([14]aneS₄)]²⁺. Furthermore, the K _NiS1 values for [Ni([12]aneN₄)]²⁺ were the largest among these nickel(II) complex cations. The K _NiS, K _NiS1, and K _NiS2 values are discussed in terms of properties of the donor solvents and steric strains of these nickel(II) complex cations.     

Peculiarities of the effect of the electronic nature of substituents on the basic properties of aliphatic amines

Changes in the hybrid state of atomic orbitals of nitrogen and p-character of LEP, which occur under the effect of saturated hydrocarbon radicals and polar substituents in aliphatic amines, differ substantially. Therefore, the effect of the both substituents on the basicity constants of amines cannot be described by the single formal type of interaction. The anomalous changes in the basicity in the series of primary, secondary, and tertiary alkylamines, which are discussed in the literature, and the correlations pK _BH+ = f(*) and G _B = f(*) are, in fact, imaginary, because the alkyl radicals at the N atom do not manifest the electron-donor properties.     

取代基对氮和氧自由基稳定性影响的理论研究

用MNDO方法，全构型优化，研究了15个氮自由基4-RC6H4NH，和15个氧自由基4-RC6H4O（R＝－H；－OCH3，－Cl，－F，－CN，－COCH3，－NO2，－CH3，－CF3，－SCH3，－C6H5，－Nh2，－BH2，－PH2，－SiH3）的稳定化能．结果表明：－NH2，－CH3，－OCH3，－F基团对自由基起稳定化作用，－CF3，－NO2；－CN，－COCH3，－BH2基团对自由基起去稳定化作用．苯基对氧自由基有较大的稳定化作用，而对氮自由基的稳定性影响较小．－SCH3，－PH2，－SiH3，－Cl基团表现弱的去稳定化作用．计算和实验结果基本相符．