Separation of fluorescent 1,N6 ethenoderivatives of diadenosine polyphosphates and their enzymatic degradation products by reversed-phase high-performance liquid chromatography

Summary The retention, selectivity and elution order of fluorescent 1,N⁶-etheno derivatives of diadenosine polyphosphates and their enzymatic degradation products on octadecyl and phenyl-bonded silica columns have been studied as a function of mobile phase pH, ionic strength and organic modifier content. Good separations of the compounds of interest were achieved using mobile phases of around 0.1M potassium phosphate buffers at neutral pH containing approximately 10% methanol or 4% acetonitrile for C₁₈ columns and 5% methanol or 1.5% acetonitrile for phenyl columns. The data obtained were used to establish isocratic assays for diadenosine polyphosphate cleaving activities from chromaffin cells using Di(1,N⁶-ethenoadenosine) polyphosphates as fluorogenic substrate analogues followed by fluorescence detection.     

5-Hydroxytryptamino-induced calcium sparks in cultured rat stomach fundus smooth muscle cells

With the imaging fluorescence probe of Ca2+ (fluo-3) and a laser scanning confocal micro-scope, the spontaneous localized calcium release event was first discovered in resting rat cardiac myocytes by Cheng[1] in 1993. A mathematical simulation is developed with computer in order to reveal the effect, which is immediately suggested that these events are likely to reflect the local-ized release of Ca2+ from a small cluster of ryanodine-sensitive Ca2+ release channels in sar-coplasmic reticulum …     

La0.8Sr0.2Ga0.8Mg0.2O2.8的电化学性质及其在SOFC中的应用

采用凝胶浇注法制备具有较高氧离子电导率的固体电解质La0.8Sr0.2Ga0.8Mg0.2O2.8粉料.X射线衍射结果表明,于1400℃焙烧后即形成了钙钛矿结构,无杂相存在.探讨了粉料压制坯体的致密化和导电性能在1450℃下与烧结时间的关系,发现烧结时间为18h时其相对密度达98.3%,而在24h的情况下,样品具有最佳的氧离子导电性.采用Ni-Ce0.8Gd0.2O1.9作为阳极,La0.8Sr0.2Ga0.6Ni0.4O2.7作为阴极,组装了平板型固体氧化物燃料电池(SOFC).阳极和阴极分别通入含3%H2O的氢气和空气,750℃时的开路电压为1.04V,最大输出功率密度(P)达252mW/cm2(U=0.48V,J=525mA/cm2).     

Effect of polarization on the electrode behavior and microstructure of (La,Sr)MnO<Subscript>3</Subscript> electrodes of solid oxide fuel cells

The electrode behavior and microstructure of freshly prepared (La_0.8Sr_0.2)_0.9MnO₃ (LSM) electrodes were investigated under various polarization conditions. The original, large agglomerates in freshly prepared LSM electrodes were broken down into sphere-shaped grains when exposed to cathodic or anodic current passage of 200 mA cm^–2 at 800 °C in air for 3 h. Microstructural changes under cathodic polarization could be related to the pronounced diffusion and migration of oxygen vacancies and Mn ions on the LSM surface and lattice expansion, while lattice shrinkage under oxidation conditions most likely contributes to the structural changes under anodic polarization. Such morphological changes were irreversible and were found to be beneficial to the performance of freshly prepared LSM electrodes. Freshly prepared LSM electrodes behaved very differently with respect to the cathodic and anodic current passage treatment.     

Biofuel cell anode based on the Gluconobacter oxydans bacteria cells and 2,6-dichlorophenolindophenol as an electron transport mediator

A basic scheme of the use of the Gluconobacter oxydans bacteria cells as a biocatalyst at an anode of a biofuel cell with air-based cathode is raised up. The anode and cathode of the cell are made of graphite; 2,6-dichlorophenolindophenol serves as an electron transport mediator; and glucose is the substrate to be oxidized. The open-circuit voltage is 55 mV, for the bacteria cell, the mediator, and glucose concentrations of 3 mg/ml (raw weight), 34 mM, and 10 mM, respectively. The voltage and current of the biofuel cell loaded with an external resistance of 10 kohm are 5.6 mV and 0.56 mA. The cell’s internal resistance is 88 kohm.     

A Procedure for Transforming Impedance Spectra for the Determination of Mechanism of Electrochemical Reactions

Transformation of impedance spectra into relaxation time spectra (RTS) is used for determining contributions of individual processes of the oxygen electroreduction reaction (OER) to the polarization resistance of the electrochemical cell. The transformation technique involves the solution of the convolution equation found with the aid of a modified Van Cittert iteration algorithm checked on model impedance spectra. The technique, when used to analyze impedance spectra of electrochemical cells air|Pt|YSZ|YSZ + Pt|air, shows that the conversion of a globular structure of the YSZ + Pt cermet layer to a columnar one is accompanied by a change of peak amplitudes in RTS. The revealed RTS dynamics when heated to 750°C is compared with peculiarities of individual processes in OER.     

碳纳米管添加剂对质子交换膜燃料电池低铂载量膜电极性能的影响研究

以碳纳米管（CNT）作为低铂载量膜电极（CCM）催化层（0.1 mg_Pt·cm^-2）添加剂，研究了CNT的添加方式对催化层微观结构以及膜电极性能的影响.结果表明，与常规低铂载量催化层相比，在其表面喷涂一层CNT或将CNT均匀分散到Pt/C催化层中均有利于提升低铂载量膜电极的输出性能，在70℃和100%相对湿度条件下最高输出功率比常规低铂载量膜电极的0.522 W·cm^-2分别提升了22.4%和60.0%，并且均匀分散添加方式优于分层添加方式.其原因在于分层添加CNT后改善了低铂催化层和气体扩散层之间的接触界面，降低了催化层与扩散层间的接触电阻，而均匀分散添加方式除了可降低界面接触电阻外，还显著改善了低铂催化层中的气体传输，大幅提升了Pt催化剂的利用效率，使得膜电极电化学反应电阻明显降低.进一步对均匀分散添加方式中CNT的载量进行优化，表明CNT添加量为37.5 μg·cm^-2时电池输出性能最佳，70℃和100%相对湿度条件下的最大输出功率达到0.91 W·cm^-2.本研究工作表明，将CNT均匀分散添加到催化层中是一种有效提升低铂载量膜电极性能的方法.     

Production of α-keto acids Part I. Immobilized cells ofTrigonopsis variabilis containing D-amino acid oxidase

Whole cells ofTrigonopsis variabilis were immobilized by entrapment in Ca²⁺-alginate and used for the production of α-keto acids from the corresponding D-amino acids. The D-amino acid oxidase within the immobilized cells has a broad substrate specificity. Hydrogen peroxide formed in the enzymatic reaction was efficiently hydrolyzed by manganese oxide co-immobilized with the cells. The amino acid oxidase activity was assayed with a new method based on reversed-phase HPLC. Oxygen requirements, bead size, concentration of cells in the beads, flow rate, and other factors were investigated in a “ trickle-bed ” reactor.     

Artificial red cells with crosslinked hemoglobin membranes

Artificial cells containing concentrated hemoglobin (Hb) solution were prepared by interfacial polymerization of Hb with glutaraldehyde (GA) in liquid membrane capsules (LMC). A solution containing 30% of Hb was emulsified in mineral oil as red cell-size microdroplets, and this emulsion was dispersed in an aqueous phase containing glutaraldehyde to form LMC. The LMC were semipermeable templates that held the microdroplets of Hb in suspension while GA diffused through the oil to the microdroplet surfaces. The GA crosslinked Hb at the surface of each microdroplet to form an artificial red-cell membrane encapsulating Hb solution. A water-soluble surfactant was used to eject the cells from the LMC and suspend them in saline. Several surfactants were evaluated. Cell size was controlled by agitation speed during preparation of the original emulsion. Cells of 2.52 = ±1.69 μm were prepared. The encapsulated Hb retained capacity to bind and release O₂. The cells had aP ₅₀ of 8.9 torr (1200 Pa) and a capacity of 0.55 cc O₂/g of total Hb, indicating that the crosslinked portion of the Hb did not contribute to O₂ transport.