Comparative Study of Tribological Properties of Polyphenylene Sulfide (PPS), Polyethersulfone (PES), and Polysulfone (PSU)

The tribological properties of polyphenylene sulfide (PPS), polyethersulfone (PES) and polysulfone (PSU), which have similar molecular structures, were investigated using an end-face contact tribometer and a reciprocating tribometer. The thermomechanical behavior of the polymers was analyzed using dynamic mechanical analysis (DMA). PPS exhibited a maximum friction coefficient with increasing load and sliding speed, while the friction coefficients of PES and PSU decreased only slightly. The wear rate of PPS was much lower than that of PES and PSU under high loads and speeds. It is suggested that the main factors influencing the friction and wear properties of the neat polymers are their condensed state and heat resistance. Amorphous PES and PSU showed liquid-like behavior and very low friction when the frictional surface was in the molten-flow state. The macromolecular crystals of crystallizable PPS give it some solid-like behavior and load-carrying capacity; hence PPS exhibited lower wear than PES and PSU.     

Effect of Alkyl Side Chain Length on Relaxation Behaviors in Poly(n-alkyl Acrylates) and Poly(n-alkyl Methacrylates)

Dynamic mechanical analysis (DMA) is used to investigate the effect of alkyl side chain length on the relaxation behavior of poly(n-alkyl acrylates) (PnAA) and poly(n-alkyl methacrylates) (PnAMA) above the glass transition temperature (T_g). Master curves and shift factors (log a_T) were obtained using the time–temperature superposition (TTS) principle. The log a_T curves of PnAA and PnAMA exhibit a dynamic crossover from one Vogel–Fulcher–Tammann–Hesse (VFTH) equation to another above T_g. The corresponding temperature was designated as the dynamic crossover temperature (T_c). It is found that T_c/T_g and the apparent activation energy (E_g) increases, e whereas the fragility index (m) decreases with increasing alkyl side chain length. Further analysis shows that m ∝ T_g, E_g∝ , and E_g∝ m² for both PnAA and PnAMA.     

Synthesis and magnetic properties of Co1−xZnxFe2O4+γ nanoparticles as materials for magnetic fluid hyperthermia

Nanoparticles of the single spinel phase Co_1−xZn_xFe₂O_4+γ of mean size 3-23 nm, as determined by X-ray diffraction analysis, were synthesized by the co-precipitation method followed by a temperature treatment. Magnetic studies carried out in the range of 4.5-550 K revealed gradual transition from ferrimagnetic to superparamagnetic to paramagnetic behaviour depending on the composition and particle size. The observed behaviour indicates a broad distribution of volume sizes of the nanoparticles. Particular importance can be ascribed to the composition of x=0.6 where the observed transition temperature to the paramagnetic state at 310-334 K suggests applicability of this material for magnetic fluid hyperthermia in a self-controlled regime.     

Limit theorems in financial market models

Invariance principle states that a scaled simple random walk converges to the standard Brownian motion.In this article, we present a discrete time stochastic process, which reflects a microstructure of market dynamics, and prove a convergence to a scaling limit process with a drift term and a jump term. These terms are derived from a macroscopic condition on volumes traded in some time intervals. The mathematical tools for obtaining our results are Dobrushin-Hryniv theory and the method of cluster expansion developed in mathematical studies of statistical mechanics.     

A FT-IR and V-UV Spectroscopic Study of Nickel-Containing Hydrotalcite-Like Compounds, [Ni1−xAlx(OH)2](CO3)x/2.nH2O

Hydrotalcite-like compounds containing Ni(II) and Al(III) cations and with different Ni/Al ratios in the brucite layers have been prepared and studied using FT-IR and V-UV/DR spectroscopies. It has been found that the local environment of the Ni(II) cations is the same in all cases, occupying octahedral holes, but the orientation of the interlayer carbonate anions changes with the Ni/Al ratio.     

3D打印贝壳仿生复合材料的拉伸力学行为

采用硬质和软质双组分材料,通过调控两种基体材料的装配夹角,采用光固化3D打印技术制备了不同装配方式的仿贝壳珍珠层复合材料,开展了准静态拉伸实验,结合扫描电镜观察,分析了其拉伸力学性能、断裂及能量耗散机理。研究结果表明,保持胞元边长不变,随着面内装配角度增加,仿贝壳珍珠层复合材料的强度呈线性增加趋势,断裂应变呈线性减小的趋势;随着面外装配角度增大,断裂应变呈线性减小趋势,而强度在面外装配角小于45°时呈增强趋势,超过45°时趋于稳定;面外装配角度为45°时,材料的强度达到最大值。试样在断裂前主要通过硬质材料的拔出、软/硬相界面处微裂纹的生成及微裂纹在扩展过程中的合并和偏转等方式耗散能量。     

基于改进格林元的压裂水平井动态分析方法

以建立高效的动态分析方法为出发点,以边单元作为求解点,改进传统的格林元方法,减少未知数和求解矩阵维度;并提出基于改进格林元的加密网格加密方法,保证考虑复杂裂缝网络的压裂水平井动态模拟的早期精度.退化模型与半解析解、数值模拟结果进行对比,验证本文基于加密网格的改进格林元方法的准确性和动态分析的高效性.最后进行动态响应的敏感性分析,结果表明：①格林元方法是一种高精度的动态模拟方法,将求解节点设置在网格的边上可以提高压裂水平井动态模拟的速度;②改进格林元方法的加密基于叠加原理,不需要通过插值近似,其求解精度高.在相同加密网格条件下,基于本文改进格林元方法的加密效果比有限差分加密效果更佳;③复杂裂缝导流能力、改造区渗透率提高倍数、改造区大小等参数对压裂水平井动态特征影响较大,在动态分析和参数反演时,应着重考虑这些因素的影响.     

Electric field induced non-linear multisubband electron mobility in V-shaped asymmetric double quantum well structure

ABSTRACT

We study the effect of the external electric field F_ext on the low-temperature electron mobility μ in an asymmetrically doped Al_xGa_1-xAs based V-shaped double quantum well (VDQW) structure. We show that nonlinearity of µ occurs under double subband occupancy on account of intersubband effects. The field F_ext alters the VDQW potential leading to transfer of subband wave functions between the wells, which affects the scattering potentials and hence μ. In the VDQW structure, due to the alloy channel layer, the alloy disorder (Al-) scattering happens to be significant along with the ionised impurity (Imp-) scattering. The non-linear behaviour of μ is because of μ^Imp, while the overall magnitude of μ is mostly due to μ^Al. The increase of difference in the doping concentrations of the outer barriers increases the nonlinearity of μ. The oscillatory character of μ is amended by varying the width of the well and barrier and also the height of the VDQW. Our results can be used to study VDQW based nanoscale field effect transistor structures.     

Fano profile in a novel double cavity optomechanical system with harmonically bound mirrors

We investigate a double cavity optomechanical system generating single and double Fano resonance (multi-Fano). By altering a single parameter, the tunnelling rate g of the middle mirror, we are able to switch between single and double Fano line shapes. The first spectral line shape is stronger in the case of multi-Fano than in the case of single Fano. Also the behaviour of the steady state value of the displacement of the middle mirror, with respect to g, heavily influences the behaviour of double Fano lines in our scheme. This tunability along with using a single pump and signal/probe laser has an added advantage in situations where only low power consumption is available.     

Study of Sm-doped ZnO samples sintered in a nitrogen atmosphere and deposited on n-Si(1 0 0) by evaporation technique

The samarium doping zinc oxide (Zn_1-xSm_xO) with (x=0.0, 0.04, 0.05 and 0.17) polycrystalline thin films have been deposited on n-Si(1 0 0) substrate using thermal evaporation technique. Ceramic targets for deposition were prepared by the standard solid-state reaction method and sintered in nitrogen atmospheres. X-ray diffraction and scanning electron microscopy analyses show that the bulk and films features reveal wurtzite crystal structure with a preferential (1 0 1) crystallographic orientation and grows as hexagonal shape grains. According to the results of the Hall effect measurements, all the films show p-type conductivity, possibly a result of nitrogen incorporation into the Sm-doped ZnO samples. Magnetic measurements show that ferromagnetic behavior depends on the Sm³⁺ concentration. For a film with lower Sm₂O₃ contents (x=0.04), a phenomenon of paramagnetism has been observed. While, with further increase of Sm³⁺ contents (x=0.05) the ferromagnetic behavior has been observed at room temperature. However, at higher doping content of Sm³⁺, the ferromagnetic behavior was suppressed. The decrease of ferromagnetism with increasing doping concentration demonstrates that ferromagnetism observed at room temperature is an intrinsic property of Zn_1-xSm_xO films.