萃取催化动力学分析法测定痕量钯

本文研究了在ｐＨ３．Ｏ的缓冲溶液中，利用邻菲罗嘛活化Ｐｄ（Ⅱ）催化水中溶解氧氧化二苯硫腙褪色的指示反应，建立了测定痕量钯的萃取催化动力学分析方法。方法的灵敏度为３．３×１０￣（－９）ｇ／ｍＬ，线性范围为７．５×１０￣（－９）～４．０×１０￣（－７）Ｇ／ｍＬ。用于钯催化剂中钯的测定，获得了满意的结果。     

Amberlite XAD-2键合双硫腙螯合树脂现场预富集测定水中痕量铅

以Amberlite XAD-2树脂与双硫腙通过N N基键合的形式合成了一种新型螯合树脂(XAD-H2DZ),采用IR和TGA技术对其特性进行了表征,并将其应用于微柱现场在线采样(MFS)新技术中,实现了环境水样中痕量铅的在线原位预富集和实验室中流动注射-火焰原子吸收(FI-FAAS)系统的联机测定。当采样体积为10和50 mL时,其富集因子分别为78和384倍;检出限(3σ)分别为0.32和0.079μg/L;相对标准偏差(n=7)分别为2.0%和1.9%。对环境水样标准物质(GBW 08608)、海水中微量元素标准物质(GBW(E)080040)和实际样品(大连老虎滩区域海水以及南湖水)中铅进行分析,均获得了满意的结果。     

A Coated Piezoelectric Crystal Sensor for the Determination of 2, 4-Toluene Diisocyanate in Air

Abstract

2, 4-toluene diisocyanate (TDI) in air was detected and determined by a piezoelectric quartz crystal sensor coated with tetrakis(hydroxyethyl)ethylenediamine (THEED)/dithizone(diphenylthiocarbazone) solution (l:3v/v in acetone). The response curve is linear over the concentration range 3–24 ppb of TDI. The sensor can be used for more than 2 months without loss in sensitivity and presented good reversibility and reproducibility. Of the different possible interferents tested, only SO₂ caused a frequency change.     

Simultaneous determination of copper,mercury and lead by first-order derivative spectrophotometry using dithizone as reagent

A first-order derivative spectrophotometric method has been developed for the simultaneous determination of copper, mercury and lead at g/L levels using dithizone as reagent. The procedure involves the simultaneous extraction of these elements by dithizone in chloroform from weakly alkaline solutions. Linear calibration curves were obtained in the ranges 0.5–10 (Cu), 1–10 (Hg) and 1–10 (Pb) g present in 40 ml of aqueous phase with detection limits of 5 g/L (Cu) and 20 g/L (Hg and Pb). The R.S.D.s for 100 g/L of copper, mercury and lead were 2.5, 2.6 and 3.1% respectively, for 5 determinations. The method is applicable for the determination of copper and lead in marine sediment samples with good precision and accuracy.     

Equilibrium and Kinetic Aspects of Hg(II) Extraction from Natural Waters with Diphenylthiocarbazone

A diphenylthiocarbazone (dithizone) based liquid-liquid extraction method of general utility is proposed for small-scale Hg(II) extraction from natural waters. The quantitative aspects related to the extraction are studied in terms of distribution of mercury dithizonate in carbon tetrachloride-water system at 293 K (20±1°C). Various distribution constants related to the reagent and the complex formed are evaluated. The equilibrium and kinetic studies of extraction and complex formation are analytically based on atomic absorption and colorimetric methods. Local natural waters were subjected to the proposed method for Hg(II) removal. The method is found to be capable of removing above 98% mercury in a single-step extraction under the conditions evaluated in terms of matrix pH, equilibration time and amount of reagent.     

双硫腙—CPC与铜显色反应的研究和应用

双硫腙——ＣＰＣ与铜显色反应的研究和应用余协瑜罗姿容吴德岚（重庆钢铁高等专科学校应用化学系重庆６３００５０）关键词分光光度法铜双硫腙氯化十六烷基吡啶中图分类号Ｏ６５７．３２双硫腙应用于铜的测定早有报导［１］，但需用ＣＣｌ４萃取。本文研究了ＣＰＣ对铜（...     

Application of a new nanoporous sorbent for extraction and pre-concentration of lead and copper ions

The authors describe a method for the trace determination of copper (II) and lead (II) in water and fish samples using solid-phase extraction via siliceous mesocellular foam functionalised by dithizone. Siliceous mesocellular was functionalised with dithizone, and the resulting sorbent was characterised by scanning electron microscopy, surface area analysis, thermogravimetric/differential thermal analysis and FTIR. Following solid-phase extraction of target ions by the sorbent, copper and lead ions were quantified by flame atomic absorption spectrometry. Factors affecting the sorption and desorption of target ions by the sorbent were evaluated and optimised. The calibration plot is linear in the 1 – 500 μg L^?1 copper (II) and 3–700 μg L^?1 lead (II) concentration range. The relative recovery efficiency in real sample analysis is in the range from 96 to 102%, and precision varies between 1.7 and 2.8%. It is should be noted that the limits of detection for the copper and lead analysis were 0.8 and 1.6 μg L^?1, respectively. Also, the adsorption capacities for copper and lead ions were 120 and 160 mg g^?1, respectively. The obtained pre-concentration factor for the lead and copper ions by the proposed solid-phase extraction was 75. The method was successfully applied to the determination of low levels of copper (II) and lead (II) in tap, Caspian sea, Persian gulf and lake water and also their detection in fish samples.     

双硫腙后处理诱导的钙钛矿膜二次结晶和钝化

有机-无机杂化钙钛矿较低的缺陷形成能和表面的悬挂键会导致其薄膜中产生铅缺陷.这些深能级缺陷会直接引起载流子的非辐射复合,导致有机-无机杂化钙钛矿光伏器件的界面接触和载流子传输效率变差,最终降低了器件的综合性能.采用双硫腙作为钙钛矿薄膜表面的二次结晶诱导剂和铅缺陷钝化剂,通过对钙钛矿膜进行后处理的方法实现对钙钛矿薄膜的形...     

Disposable Screen-Printed Electrodes (Spe) Mercury-Free for Lead Detection

ABSTRACT

Strategies to modify screen-printed electrodes (SPE) for lead determination are reported. Dithizone was mixed with graphite ink to obtain a modified screen-printed strip to detect ppb levels of lead(II) (detection limit 12 μg/l) using square wave anodic stripping voltammetry (SWASV). In addition, screen-printed electrodes were also modified by casting a few μl of a Nafion® solution onto the working electrode surface. In this case, ppb levels of lead were detected (detection limit 15 μg/1), using potentiometric stripping analysis (PSA). The addition of an ionophore to Nafion® polymer was also investigated, but this did not yield a significant improvement.     

UV–Vis Spectrophotometric Determination of Mercury Based on Room Temperature Ionic Liquids Enhanced Hollow-Fiber Liquid-Phase Microextraction

A novel method based on the enhancement effect of room temperature ionic liquids for hollow-fiber liquid-phase microextraction trace amounts of mercury combined with UV–Vis spectrophotometry for the determination of Hg was developed. The addition of room temperature ionic liquids led to 6.0 times improvement in the determination of mercury. Under optimized conditions, an enrichment factor of 120 could be obtained, and the detection limit for Hg was 0.2 ng mL^?1. The relative standard deviations for five replicate determinations of 20 ng mL^?1 Hg(II) was 5.4%. The proposed method was successfully applied to certified reference materials and environmental water samples with satisfactory results for the determination of Hg.