Synthesis of Spherical Titanium Dioxide Particles by Homogeneous Precipitation in Acetone Solution

Titania powders were synthesized by thermal hydrolysis of titanium tetrachloride in a mixed solvent was studied. The dielectric constant was tuned by regulating the acetone/water volume ratio (R/H ratio) and temperature of the solvent. Hydroxypropyl cellulose (HPC) was used as a steric dispersant. The synthesis were carried out at R/H ratios of 0–4, temperatures of 70–90°C, TiCl₄ concentrations of 0.05–0.2 M, HPC concentrations of 0–5 × 10^–3 g/cm³, and synthesis times of 15–60 min. The TiO₂ particles obtained at an R/H ratio of 0, i.e., pure water system, were fine and agglomerated. In contrast, the TiO₂ particles prepared at an R/H ratio of 3 were uniform and spherical. The TiO₂ particle size increased with increasing TiCl₄ concentration. The synthesis temperature did not influence the particle size, but greatly influenced the morphologyof the TiO₂. Adding HPC to the solution yielded more uniform and spherical particles. In addition, the synthesis time should be longer than 30 min to obtain the most uniform and spherical particles. The dielectric constant of the acetone-water mixed solvent at 28 gave the most uniform and spherical TiO₂ particles. The powders prepared at the condition of 0.1 M TiCl₄, R/H ratio of 3, HPC concentration of 0.001 g/cm³, temperature of 70°C, and synthesis time of 1 h exhibited the most uniform and spherical morphology. The as-synthesized powder was anatase and retained the phase below 400°C. It transformed to the rutile phase after calcination at 700°C.     

17O NMR Investigation of Chemical Homogeneity in Hybrid Systems

¹⁷O NMR experiments using enriched water were performed to followthe hydrolysis-condensation process of dimethyldiethoxysilanetetraethoxysilane and a 1/1 mixture of dimethyldiethoxysilane andtetraethoxysilane (H₂O/OEt = 0.5; pH = 2). The spectrarecorded over several hours time period were simulated to followquantitatively the variations of residual water, hydroxyl groups(Si–¹⁷ H) and oxo bridges (Si–¹⁷ –Si). Presence of a resonance signal due oxo bridges between di- andtetrafunctional Si units clearly demonstrates that co-condensationreactions occur to a large extent between the two alkoxides, and that thesebonds are stable during the aging period.     

Disproportionation of 6,8-Dialkyl-3-thia-2,4,6,8-tetraazabicyclo[3,3,0]octan-7-one 3,3-Dioxides under Conditions of Acid Hydrolysis and Acetylation

Acid hydrolysis and acetylation of 6,8-dialkyl-3-thia-2,4,6,8-tetraazabicyclo[3,3,0]octan-7-one 3,3-dioxides have been studied. 6,8-Dialkyl-3-thia-2,4,6,8-tetraazabicyclo[3,3,0]octan-7-one 3,3-dioxides disproportionate to 4,4'-sulfonyldiiminobis(1,3-dialkylimidazolidin-2-ones) and sulfamide when treated with acid at pH 1 or with acetyl chloride. The kinetics of the disproportionation have been studied.     

Hydrolysis of (CH3)3Sn+ in Various Salt Media

The hydrolysis of trimethyltin(IV) has been studied by potentiometry (H⁺ -glass electrode) and calorimetry in various salt media (NaNO₃, NaCl, KCl, Na₂SO₄, and NaNO₃—NaCl mixtures). The effect of ionic strength on the hydrolysis constants is accounted for by a simple Debye–Hückel type equation and by Pitzer equations. The results allow us to obtain H for hydrolysis and the temperature dependence of the Pitzer parameters. The resulting coefficients can be used to examine the speciation of (CH₃)₃Sn⁺ in multicomponent electrolyte solutions, such as natural waters, over a wide range of temperature and ionic strength.     

Solubilization of lanthanide ions by cyclodextrins in basic aqueous solutions

Cyclodextrins form complexes with lanthanide ions in basic aqueous solutions. This complex formation in basic solution dramatically enhances the solubility of lanthanide ions, which are otherwise insoluble due to the formation of hydroxide gels. Solutions of the -cyclodextrin-Ce³⁺ complex effectively hydrolyze 2-deoxyadenosine-5-monophosphate to 2-deoxyadenosine.     

Synthesis of new hydrolyzable polyurethanes from L‐gulonic acid‐derived diols and diisocyanates

New polyurethanes with lactone groups in the pendants and main chains were synthesized by the polyaddition of two kinds of L ‐gulonolactone‐derived diols (2,3‐O‐isopropylidene‐L ‐gulono‐1,4‐lactone and 5,6‐O‐isopropylidene‐L ‐gulono‐1,4‐lactone) with hexamethylene diisocyanate and methyl (S)‐2,6‐diisocyanatohexanoate and by the subsequent deprotection of isopropylidene groups. They were hydrolyzed more quickly than the polyurethane derived from methyl β‐D ‐glucofuranosidurono‐6,3‐lactone in a phosphate buffer solution, the pH value of which was 8.0, at 27 °C. © 2002 Wiley Periodicals, Inc. J Polym Sci Part A: Polym Chem 40: 4158–4166, 2002     

可见光照射下丙炔光催化水解反应的研究 Ⅱ．钒离子对二氧化钛催化性能的影响

 研究了几种不同粒径的TiO2在CH3CCH和H2O的光催化反应中的催化活性．结果表明,利用离子注入法可以拓展纳米TiO2催化剂的光吸收区域,使其吸收带向可见光方向偏移,且偏移程度随着TiO2粒径的增大而增大;特别是注入V离子使TiO2催化剂在可见光区域具有光催化活性．V离子注入后,TiO2催化剂在紫外区域的光催化活性没有下降,但在可见光区域的光催化活性有所提高．在五种光催化剂中,具有中等粒径大小的P－25注入V离子后表现出最高的光催化活性．在太阳光直接照射下,这些光催化剂也具有较高的催化活性．     

N- and O-Alkylation of 3-indolylcyclopropylacetic acid derivatives

2,2-Dimethyl-3-(2-methyl-3-indolyl)cyclopropylacetic acid, its amide and esters, and the corresponding alcohol, viz., the product of ester reduction by LiAlH₄, were synthesized. The chemoselectivity of N- and O-alkylation of these compounds was studied. Selective monoalkylation at the nitrogen atom of the heterocycle, O-alkylation to the side chain, or dialkylation at both nucleophilic sites can be carried out under conditions of phase-transfer catalysis. The N-acylation at the indole fragment of nitrile of this acid occurs only under the Vilsmeier—Haak formylation conditions.     

Kinetic studies of the urease-catalyzed hydrolysis of urea in a buffer-free system

The kinetics of urea hydrolysis catalyzed by urease, mainly in the absence of buffers by use of the self-buffer effect of the products, was investigated. The effect of pH, temperature, and concentration of enzyme, substrate, product, salt ions, and buffers on the kinetic behavior of urease was examined. A kinetic model of a modified Michaelis-Menten form, incorporating substrate and product inhibition, pH dependence, and temperature effect, was developed to describe the reaction rate. Experimental data indicated that urease in a buffer-free solution was less susceptible to the inhibition of substrate product. The Michaelis constant keeps almost constant with the variation of pH and temperature, and increases with the addition of buffers and salts. The data also suggested that the noncompetitive pattern of the product inhibition, which is not significantly affected by temperature, increases gently with increasing pH. A Monod form rate expression was proposed to analyze the pH effect on the maximum rate. The proposed kinetic model was also examined by the long-time experiments in which pH, substrate, and product concentration varied obviously during the reaction course.     

Nanostructured pure gamma-Fe2O3 via forced precipitation in an organic solvent

Pure maghemite, gamma-Fe(2)O(3), was prepared as ultra fine particles in the nanometer-sized range via the forced precipitation method in an organic solvent. The precipitation of iron(III) ions, from iron(III) chloride in 2-propanol led selectively to highly dispersed particles of ferrihydrite, which upon treatment with temperatures higher than 200 degrees C under dynamic vacuum resulted in high-surface-area particles of gamma-Fe(2)O(3). Precipitation in water also led to ferrihydrite, but the final product, after heating at 300 degrees C, contained a mixture of gamma-Fe(2)O(3) and alpha-Fe(2)O(3) (hematite). The precipitation from iron(III) nitrate in water resulted in goethite which was converted to hematite upon heating. On the other hand, the final product in 2-propanol was a mixture of maghemite and hematite. The products were characterized by FTIR, TGA, XRD, and gas sorption analysis. Nitrogen gas adsorption studies for the pure gamma-Fe(2)O(3) samples revealed mesoporous particles with high surface areas in the range of 70-120 m(2) g(-1) after heat treatment at 300 degrees C. The gamma-Fe(2)O(3) particles retained their gamma-phase as well as their mesoporous structure at relatively high temperatures, as high as 400 degrees C.