ZnO-SnO_2透明导电薄膜的制备及性能研究

采用二步成胶工艺制备ZnO-SnO_2透明导电薄膜,应用X射线衍射、原子力显微镜、紫外-可见分光光度计、薄膜分析仪及四探针仪等对薄膜的结构、表面微观形貌、透过率和导电性能进行表征.结果表明,锌锡摩尔比为9/12,退火温度为500 ℃时,薄膜的透过率达90%,电阻率为3.15×10~(-3) Ω·cm.与其它工艺相比,二步成胶工艺所制备出的ZnO-SnO_2透明导电薄膜性能优异.     

激光击穿光谱技术监测固土过程中阳离子交换

为了实时探测离子土固化剂(ISS)在固土过程中的阳离子交换量(CEC),采用激光击穿光谱技术(LIBS),对ISS处理后的土壤溶液中的K、Ca、Na、Mg、Al、Si这6种离子含量进行探测。分别对由不同配比(1∶100、1∶200和1∶300)的ISS处理过的高岭土、膨胀土、红粘土等5种标准土壤进行了研究,结果表明:同一土壤中的各种离子随ISS配比的变化趋势各不相同;不同土壤与ISS作用的效果各不相同;ISS的配比并非越高越好。这些工作为ISS固化机理的研究提供实验依据,而利用激光击穿光谱技术进行探测的方式为ISS固化机理的研究提供了新的思路。     

Measurements of NO2 mixing ratios with topographic target light scattering-differential optical absorption spectroscopy system and comparisons to point monitoring technique

A topographic target light scattering-differential optical absorption spectroscopy(ToTaL-DOAS) system is developed for measuring average concentrations along a known optical path and studying surface-near distributions of atmospheric trace gases.The telescope of the ToTaL-DOAS system points to targets which are located at known distances from the measurement device and illuminated by sunlight.Average concentrations with high spatial resolution can be retrieved by receiving sunlight reflected from the targets.A filed measurement of NO2 concentration is performed with the ToTaL-DOAS system in Shijiazhuang in the autumn of 2011.The measurement data are compared with concentrations measured by the point monitoring technique at the same site.The results show that the ToTaL-DOAS system is sensitive to the variation of NO2 concentrations along the optical path.     

Multipeak fitting analysis of Raman spectra on DLCH film

The hydrogenated diamond‐like carbon (DLCH) film with 1‐µm thickness is deposited by direct hydrocarbon gas ion beam method on silicon wafer and annealed at 400 °C. Detailed Raman spectra feature are fitted from nine sets of different peak fitting functions, including Gaussian, Lorentzian and Breit‐Wigner‐Fano (BWF) functions. These fitting results obtained from a two‐peak combination show some specific variances on the G peak position, FWHM_G and I_D/I_G ratio for as‐deposited and as‐annealed DLCH films. The most popular two‐peak fitting method with full Gaussian function tends to exhibit a higher ratio of the G peak position shift and higher I_D/I_G ratio than others fitting methods, the drastic difference among the most popular G (G) & G (D) and B (G) & L (D) schemes also have brought out in I_D/I_G ratio. However, for a more complex four‐peak Gaussian function fitting Raman spectra, the I_D/I_G ratio is close to that of a two‐peak fitting function with a mixture functions of BWF (G) and L (D). Furthermore, a series of systematic peak fitting procedures and comparisons of Raman spectra have been discussed in this study. Copyright © 2009 John Wiley & Sons, Ltd.     

Spectral indices to assess the carotenoid/chlorophyll ratio from adaxial and abaxial leaf reflectance

The ratio between the carotenoid and chlorophyll concentrations can indicate the physiology and phenology of plants. Most of the vegetation indices related to the ratio between the carotenoid and chlorophyll contents only consider the reflectance from the adaxial leaf surface. In this study, it was found that the leaf reflectance from the abaxial surface is lower than that of the adaxial surface in the visible wavelength region. On the contrary, the reflectance is higher on the adaxial surface in the near-infrared wavelength region. The difference ratio index resulted in the best correlation with the carotenoid/chlorophyll ratio and was the most robust among all the spectral indices studied when the spectral information on the adaxial and abaxial surfaces was pooled. The result indicated that this index can accurately estimate the carotenoid/chlorophyll ratio because of the insensitivity to the differences between adaxial and abaxial leaf surfaces.     

Theory of noise in a kilo-Hz cascaded high-energy Yb-doped nanosecond pulsed fiber amplifier

A theoretical analysis of noise in a high-power cascaded fiber amplifier is presented. Unlike the noise theory in low power communication, the noise of a high power system is redefined as the leaked output energy between pulses with coherent beat noise uncounted. This definition is more appropriate for high power usage in which the pulse energy receives more attention than the pulse shape integrity. Then the low power pre-amplifying stages are considered as linear amplification and analyzed by linear theory. In the high-power amplification stages, the inversion is assumed to recover linearly in the time interval between pulses. The time shape of the output pulse is different from that of the input signal because of different gains at the front and back ends of the pulse. Then, a criterion is provided to distinguish the nonlinear and linear amplifications based on the signal-to-noise ratio （SNR） analysis. Then, an experiment that shows that the output SNR actually drops off in nonlinear amplification is performed. The change in the noise factor can be well evaluated by pulse shape distortion.     

Direct numerical simulation methods of hypersonic flat-plate boundary layer in thermally perfect gas

High-temperature effects alter the physical and transport properties of air such as vibrational excitation in a thermally perfect gas,and this factor should be considered in order to compute the flow field correctly.Herein,for the thermally perfect gas,a simple method of direct numerical simulation on flat-plat boundary layer is put forward,using the equivalent specific heat ratio instead of constant specific heat ratio in the N-S equations and flux splitting form of a calorically perfect gas.The results calculated by the new method are consistent with that by solving the N-S equations of a thermally perfect gas directly.The mean flow has the similarity,and consistent to the corresponding Blasius solution,which confirms that satisfactory results can be obtained basing on the Blasius solution as the mean flow directly in stability analysis.The amplitude growth curve of small disturbance is introduced at the inlet by using direct numerical simulation,which is consistent with that obtained by linear stability theory.It verified that the equation established and the simulation method is correct.     

分数阶傅里叶变换结合高峰均比抑制算法对CO-OFDM系统的影响分析

针对相干光正交频分复用系统中出现的高峰值平均功率比问题,提出分数阶傅里叶变换与高峰值平均功率比抑制算法相结合的方法.计算表明:随着分数阶傅里叶变换阶数的减小,信号的峰值平均功率比逐渐降低;与抑制算法结合后可进一步降低系统的峰值平均功率比,并解决抑制算法影响系统性能的问题.从结合的兼容性、抑制高峰值平均功率比效果及改善引入抑制算法后对系统的负面影响三方面进行仿真分析,结果表明:采用选择性映射算法与分数阶傅里叶变换结合后,旋转因子同为4时,峰值平均功率比高于6.6dB的概率较单一选择性映射算法低104;选取高峰值平均功率比抑制情况相近时,结合算法的时间复杂度比单一选择性映射算法降低了8倍;采用限幅算法与分数阶傅里叶变换结合的仿真情况也较单一限幅算法有很大提高,表明该算法结合的兼容性良好.     

基于压扩变换的60GHz正交频分复用光载无线通信系统实验研究

提出并实验研究了在60GHz正交频分复用(OFDM)-光载无线通信(ROF)系统中采用压扩变换技术降低OFDM信号峰值平均功率比(PAPR),并提高系统的接收灵敏度。实验结果表明,携带基于压扩变换的2.5Gb/s60GHz的OFDM-ROF信号经标准单模光纤传输50km后,在无色散补偿和误码率为10-3的条件下,当入纤功率为12dBm时,系统接收灵敏度提高约2.3dB,并且当互补累积分布函数(CCDF)为10-4时,OFDM信号的PAPR下降约3dB。     

电子白板系统中参数标定方法的研究

为了避开复杂繁琐的摄像机标定过程,提出了一种基于CCD摄像机的电子白板系统参数标定新方法,实现了开机自动标定系统参数的功能。采用Harris角点检测算法成功提取了参考点的像素坐标,并直接运用射影变换交比不变性,推导出白板边框图像像素距离与实际物理距离的映射关系式,进而获得了摄像机的光心坐标。简要分析影响系统标定精度的因素,并设计出减小标定误差的方案,最后搭建实验平台标定系统参数。实验结果表明:该标定方法实现简单,应用方便,且对于单位长度为1 cm的标定块而言,标定误差小于0.04 cm。