免疫亲和柱净化/柱前衍生化-高效液相色谱荧光检测法测定粮谷中的T-2毒素

建立了免疫亲和柱净化/柱前衍生化-高效液相色谱荧光检测器测定粮谷中T-2毒素含量的方法。样品经甲醇-水(体积比为80∶20)混合溶剂提取,通过免疫亲和柱(IAC)净化,以氰酸蒽(1-AN)为衍生化试剂、4-二甲基氨基吡啶(DMAP)为催化剂进行衍生,以ZORBAX Eclipse XDB-C18 柱为分离柱,乙腈-水(体积比为80∶20)为流动相进行高效液相色谱分离及荧光检测，荧光检测的激发波长为381 nm，发射波长为470 nm。T-2毒素的质量浓度为0.01~1.5 mg/L时与峰高呈良好的线性,相关系数为0.9985。在0.01~1.5 μg/g添加水平下，回收率为79.7%~94.5%,相对标准偏差小于7%；检出限（S/N＝3）为0.01 μg/g。该方法净化效果好,灵敏度高,操作简便快速。     

Indirect UV detection of carbohydrates in capillary zone electrophoresis

Summary A new system for the rapid and sensitive analysis of underivatized carbohydrates has been established using capillary zone electrophoresis with indirect UV detection. At an applied potential of 28 kV, sugars and sugar acids could be separated by the combined effects of electroendosmosis and electrophoresis within 20 minutes in a fused silica capillary of 50 m internal diameter and an effective length of 100 cm using 6mM sorbic acid, pH 12.1, as both carrier electrolytie and chromophore. The alkaline pH ensured ionization of the sugars and, hence, their detection by means of charge displacement. Furthermore, the chosen concentration of sorbic acid allowed the smallest fractional change in the background signal to be measured. While the electrophoretic mobilities of the sugars were found to increase within a pH range of 11.9 to 12.3, those of the sugar acids were not affected. Due to the increasing competition of hydroxide ions in the displacement of the chromophore with rising pH, a significant loss of sensitivity is observed at pH values higher than 12.1 and this pH was found to provide sufficient resolution, optimum sensitivity, and a acceptably short analysis time. Under these conditions, a lower detection limit of 2 pmol was obtained for glucose.     

BRCA1 mutation screening using restriction endonuclease fingerprinting-single-strand conformation polymorphism in an automated capillary electrophoresis system

Efficient mutation scanning techniques are needed for the rapid detection of novel disease-associated mutations and rare-sequence variants of putative importance. The large size of the breast cancer 1 gene (BRCA1) and the many mutations found throughout its entire coding sequence make screening for mutations in this gene particularly challenging. We have developed a method for screening exon 11 of the BRCA1 gene based on restriction enzyme digestion of fluorescence-labeled polymerase chain reaction (PCR) products followed by single-strand conformation polymorphism (SSCP) using an automated capillary electrophoresis system, denoted capillary restriction endonuclease fingerprinting (REF)-SSCP electrophoresis. Using this strategy on a control set of samples, we were able to detect 17 of 18 known sequence alterations. The method was then applied to screen 73 Norwegian females with family histories of breast and/or ovarian cancer. A total of 172 sequence alterations were detected, including substitutions, insertions, and deletions. One novel substitution of unknown function was identified. Sequencing of all samples negative in the capillary REF-SSCP system gave no additional mutations confirming the high sensitivity of the described methodology. Capillary REF-SSCP electrophoresis appeared as a technically convenient technique, requiring amplification of fewer PCR fragments than traditional SSCP. The novel strategy allows high-throughput mutation scanning without radioactive labeling and polyacrylamide gel electrophoresis (PAGE).     

Contactless Conductivity Detection in Capillary Electrophoresis: A Review

The popularity of contactless conductivity detection in capillary electrophoresis has been growing steadily over the last few years. Improvements have been made in the design of the detector in order to facilitate its handling, to allow easy incorporation into available instruments or to achieve higher sensitivity. The understanding of its fundamental working principles has been advanced and the detection approach has also been transferred to lab‐on‐chip devices. The range of applications has been extended greatly from the initial work on small inorganic ions to include organic species and biomolecules. Concurrent determination of cations and anions by dual injection from opposite ends has been demonstrated as well as sample introduction by using flow‐injection systems for easy automation of the process.     

Single-molecule fluorescence detection in microfluidic channels—the Holy Grail in μTAS?

Both single-molecule detection (SMD) methods and miniaturization technologies have developed very rapidly over the last ten years. By merging these two techniques, it may be possible to achieve the optimal requirements for the analysis and manipulation of samples on a single molecule scale. While miniaturized structures and channels provide the interface required to handle small particles and molecules, SMD permits the discovery, localization, counting and identification of compounds. Widespread applications, across various bioscience/analytical science fields, such as DNA-analysis, cytometry and drug screening, are envisaged. In this review, the unique benefits of single fluorescent molecule detection in microfluidic channels are presented. Recent and possible future applications are discussed.Dedicated to the memory of Wilhelm Fresenius     

Capillary electrophoresis with end-column amperometric detection of urinary 8-hydroxy-2'-deoxyguanosine

Urinary 8-hydroxy-2'-deoxyguanosine (8OHdG) is an excellent marker of oxidative DNA damage. Until now, urinary 8OHdG has been measured by high-performance liquid chromatography with electrochemical detection. A simple and sensitive method for the analysis of urinary 8OHdG by capillary electrophoresis with end-column amperometric detection has been developed in our laboratory. A single-step solid-phase extraction procedure was optimized and used for extracting 8OHdG from human urine. To improve the sensitivity of this method, a new focusing technique based on a dynamic pH junction was used. The limit of detection was 20 nM (signal-to-noise ratio S/N = 3), the linear range was 50 nM-10 microM, and the correlation coefficient was better than 0.999. The relative standard deviation (RSD) was found to be 0.57% for migration time, and 4.79% for peak current. To show the usefulness of the method, the urinary concentration of 8OHdG in nine healthy persons and ten cancer patients was determined. The urinary concentration of 8OHdG in cancer patients was significantly higher than that in healthy persons.     

Quantitative analysis of perchlorate in extracts of whole fish homogenates by ion chromatography: comparison of suppressed conductivity detection and electrospray ionization mass spectrometry

The perchlorate anion (ClO ₄ ^– ) is an anthropogenic contaminant of increasing concern in water supplies, and has been shown to disrupt thyroid activity. Most perchlorate analyses are currently carried out by ion chromatography (IC) with suppressed conductivity detection (SCD). While this procedure has been demonstrated to provide acceptable performance for analysis of water samples, the determination of perchlorate in high-conductivity aqueous extracts of plant or animal material is not readily accomplished by IC-SCD unless lengthy cleanup protocols are applied. With the addition of electrospray ionization mass spectrometry (ESI-MS) to IC, it was hypothesized that the interference imposed by various ionic species could be significantly reduced without the need for purification; however, the analysis of perchlorate in relatively unpurified extracts of biologically derived homogenates by IC-ESI-MS has not previously been described in the literature. The research presented here represents a comparison of the capabilities of IC-SCD and IC-ESI-MS to detect perchlorate in reagent water and in crude extracts of perchlorate-exposed fish (threespine stickleback, Gasterosteus aculeatus). ESI-MS was found to compare favorably to SCD for the detection of perchlorate in deionized water, and to exceed SCD performance in perchlorate analysis of fish-derived extracts.     

An In Situ Copper Plated Boron‐Doped Diamond Microelectrode Array for the Sensitive Electrochemical Detection of Nitrate

The first example of using a copper microelectrode array for use in electroanalysis is explored and exemplified with the electroanalytical quantification of nitrate. The analytical approach is based upon the in situ deposition of copper at a boron‐doped diamond (BDD) microelectrode array. The immobilized copper layer is electrocatalytic for nitrate reduction and exhibits an analytically useful range from 1.2 to 124 μM with a marked selectivity for nitrate ion over nitrate, with a limit of detection of 0.76 μM. The analytical applicability was examined through standard addition determinations of nitrate in drinking and river water samples.     

Application of Nafion／Cobalt Hexacyanoferrate Chemically Modified Electrodes for the Determination of Electroinactive Cations by Ion Chromatography

Ｉｎｔｒｏｄｕｃｔｉｏｎ　　Ｉｏｎｃｈｒｏｍａｔｏｇｒａｐｈｙ (ＩＣ)ｈａｓｂｅｅｎｒｅｃｏｇｎｉｚｅｄａｓａｕｓｅｆｕｌｍｅｔｈｏｄｆｏｒｔｈｅｓｅｐａｒａｔｉｏｎｏｆｉｎｏｒｇａｎｉｃａｎｉｏｎｓａｎｄｃａｔｉｏｎｓｓｉｎｃｅｉｔｓｉｎｔｒｏｄｕｃｔｉｏｎｂｙＳｍａｌｌｅｔａｌ .ｉｎ 1975 .1ＡｓｉｇｎｉｆｉｃａｎｔｔｒｅｎｄｉｎｔｈｅｄｅｖｅｌｏｐｍｅｎｔｏｆＩＣｍｅｔｈｏｄｉｓｓｅａｒｃｈｆｏｒｓｅｎｓｉｔｉｖｅａｎｄｕｎｉｖｅｒｓａｌｄｅｔｅｃｔｉｏｎｍｅｔｈｏｄｓ .Ｔｈｅｍａｉｎｄｅｔ…     

On-line LC-GC-AED and LC-GC-MS – multidimensional methods for the analysis of PAC in fuels,combustion emissions and atmospheric samples

The composition and concentration of polycyclic aromatic compounds (PAC) in fuels. Theier combustion products and in the atmosphere remains a topic of considerable interest. Despite the wealth of literature on the identification of PAC, speciation at low concentrations remains difficult due to instrument limitation and the complexity of fuel and environmental samples. Consequently on line sample preparation procedures (SPE, SFE, LC, etc.) are becomeing an increasingly important step in the analysis procedure particularly where sample clean-up and fractionation are essential for improving analytical resolution. In this study a normal phase high pressure analytical resolution. In this study a normal phase high pressure liquid chromatography-gas chromatography (LC-GC) system has been developed to provide quantitative analysis of samples, as diverse as coal liquids, petroleum fuels, diesel exhaust particulates, and urban air particulates. Separation and identification of parent and alkylated PAH, hetercycline nitro-and oxy-PAC can be achieved by direct coupling to an atomic emission detector and a bech top mass spectrometer. For both systems the primary LC separation combined with the large sample volume transferred to GC vastly improves detection limits. Furthermore the complimentary nature of the two detectors used enables the positive indentification of many unknowns.