Synthesis,characterization, and thermal studies of cardanol-based polyphosphate esters

Polyphosphate esters were synthesized from derivatives of cardanol phosphorodichloridateates and dihydric phenols by interfacial polycondensation using a phase transfer catalyst. The polymers were characterized by IR, ¹H-, ¹³C-, and ³¹P-NMR spectroscopy, and GPC. The thermal stability and thermal degradation kinetics of the polymers were determined by thermogravimetry. The flammability of the polymers was evaluated by limiting oxygen index values. © 1993 John Wiley & Sons, Inc.     

2，2＇－偶氮二异丁酸二甲酯的合成及其热分解反应的研究

本文研究了２，２＇－偶氮二异丁酸二甲酯的合成及其在甲苯、二甲苯中的热分解反应动力学，得到了其热分解反应速度常数与反应温度的关系式：Ｋ＿ｄ＝１．６３×１００￣（－１４）ｅｘｐ（－１２３．３ＫＪ／ＲＴ）２，２＇－偶氮二异丁酸二甲酯作为苯乙烯自由基聚合的引发剂，其单体转化率随引发剂用量的增加而增高，产物分子量则随之下降；引发剂用量在５％以上时，可得到分子量低于１０￣３的含有酯基端基的聚合物。     

Thermal and other properties of complexes of Mn(II), Co(II) and Ni(II) with 2,2'-bipyridine and trichloroacetates

Complexes of the general formulae Mn(2-bpy)₂(CCl₃COO)₂, Co(2-bpy)₂(CCl₃COO)₂·H₂O and Ni(2-bpy)₂(CCl₃COO)₂·2H₂O (where: 2-bpy=2,2'-bipyridine) have been prepared and characterized by VIS and IR spectroscopy, conductivity and magnetic measurements. The thermal properties of complexes in the solid state were studied under non-isothermal conditions in air atmosphere. During heating the complexes decompose via different intermediate products to the oxides Mn₃O₄, CoO and NiO. A coupled TG-MS system was used to detection the principal volatile products of thermal decomposition and fragmentation processes of obtained compounds. The principal volatile products of thermal decomposition of complexes are: H₂O⁺, CO₂ ⁺, Cl₂ ⁺ and other. This revised version was published online in August 2006 with corrections to the Cover Date.     

Difference in Conversions Between Dimethyl Sulfide and Methanethiol in a Cold Plasma Environment

This study compared the conversion of two malodorous substances, dimethyl sulfide (CH₃SCH₃, DMS) and methanethiol (CH₃SH) in a cold plasma reactor. The DMS and CH₃SH were successfully destroyed at room temperature. DMS decomposed less than CH₃SH at the same conditions. In oxygen-free condition, CS₂ and hydrocarbons were the major products, while SO₂ and CO_x were main compounds in oxygen-rich environments. The DMS/Ar plasma yielded more hydrocarbons and less CS₂ than that of CH₃SH/Ar plasma. In the CH₃SH/O₂/Ar plasma, rapid formation of SO and CO resulted in the yields much more amounts of SO₂ and CO₂ than those in the DMS/O₂/Ar plasma; and remained only a trace of total hydrocarbons, CH₂O, CH₃OH, CS₂, and OCS. The major differences between the reaction mechanisms of DMS and CH₃SH were also proposed and discussed.     

Syntheses,molecular structures,and thermal decomposition of cyclopentadienyldicarbonylmanganese chalcogenide derivatives

Transmetallation of the dichalcogenide complexes [CpMn(CO)₂]₂(-X₂) (X = S or Se) with M(CO)₅(thf) (M = Cr or W) afforded new heterometallic complexes CpMn(CO)₂(-Se₂)Cr(CO)₅, CpMn(CO)₂(-Se₂)[Cr(CO)₅]₂, CpMn(CO)₂(-X₂)[W(CO)₅]₂ (X = S or Se), and CpMn(CO)₂(-Se₂)[Cr(CO)₅][W(CO)₅]. According to the X-ray diffraction data, their molecular structures contain the cyclic MnX₂ fragments coordinated by one or two M(CO)₅ groups via the X atoms. Study of thermal decomposition of the manganese complexes with different Mn : M : X ratios (M = Cr, W; X = S, Se, Te) by differential scanning calorimetry (DSC) and thermogravimetry demonstrated that this process took place at rather low temperatures (100—400 °C) and was accompanied by complete elimination of the CO groups followed by elimination of the Cp groups. At any metal to chalcogen ratio, the resulting inorganic chalcogenides contained no impurities of metal oxides and carbides.     

Thermal decomposition of copper(II) and zinc carbonate hydroxides by means of TG-MS

Summary For the quantitative analyses of evolved CO₂and H₂O during the thermal decomposition of solids, calibration curves, i.e. the amounts of evolved gases vs. the corresponding peak areas of mass chromatograms measured by TG-MS, were plotted as referenced by the reaction stoichiometry of the thermal decomposition of sodium hydrogencarbonate NaHCO₃. The accuracy and reliability of the quantitative analyses of the evolved CO₂and H₂O based on the calibration curves were evaluated by applying the calibration curves to the mass chromatograms for the thermal decompositions of copper(II) and zinc carbonate hydroxides. It was indicated from the observed ratio of evolved CO₂and H₂O that the compositions of copper(II) and zinc carbonate hydroxides examined in this study correspond to mineral malachite, Cu₂CO₃(OH)₂, and hydrozincate, Zn₅(CO₃)₂(OH)₆, respectively. Reliability of the present analytical procedure was confirmed by the fairly good agreement of the mass fraction of the evolved gases calculated from the analytical values with the total mass-loss during the thermal decompositions measured by TG.     

Experimental evidence of structural transition from fcc to bulk bcc in nanophase metal clusters of (Fe)n, (Cr)n, (Mo)n and (W)n produced by CO2 laser multiphoton decomposition of metal carbonyls

We have produced nanophase metal clusters, (Fe)_n, (Cr)_n, (Mo)_n and (W)_n, by multiphoton decomposition of the corresponding metal carbonyls with a 10.6 μm CO₂ laser in the presence of Ar and SF₆. The size distribution was narrow and the average diameter was 6, 3.5, 2 and 1 nm for Fe, Cr, Mo and W clusters, respectively. The structure was found to be bcc for both Fe and Cr clusters, fcc for Mo clusters, and amorphous for W clusters (note that all the bulk metals have bcc structure). Considering the cluster sizes (9630, 1870, 230 and 30 for Fe, Cr, Mo and W clusters, respectively) estimated from their average diameters, it is likely that there exists a structural transition from fcc to bulk bcc with increasing cluster size in these metal clusters.     

Thermal behaviour of anhydrous, dihydrate and (2/1) ethanol forms of 1-O-α- -glucopyranosyl- -mannitol

The melting points of anhydrous 1-O-α- -glucopyranosyl- -mannitol, 1-O-α- -glucopyranosyl- -mannitol dihydrate and a new compound, 1-O-α- -glucopyranosyl- -mannitol-ethanol (2/1) were determined using differential scanning calorimetry. The melting onset values were 169.2 (3), 104.3 (18) and 158.7 (9), respectively, and the melting peak values were 171.4 (5), 107.9 (15) and 160.1 (6), respectively. 1-O-α- -glucopyranosyl- -mannitol dihydrate and 1-O-α- -glucopyranosyl- -mannitol-ethanol (2/1) decompose to anhydrous form when heated at slow heating rates.According to TG-FTIR measurements, 1-O-α- -glucopyranosyl- -mannitol-ethanol (2/1) lost its ethanol in the 110–190°C range, and 1-O-α- -glucopyranosyl- -mannitol dihydrate lost its crystal water in the 60–210°C range. After removal of ethanol and crystal water, both decomposed in air totally as carbohydrates usually do, forming lower hydrocarbons with OH-groups, CO₂ and H₂O.     

Interaction of Mo(CO)6 and its derivative fragments with the Cu(001) surface: Influence on the decomposition process

A theoretical study on the adsorption and decomposition of molybdenum carbonyl on the copper (001) surface is reported. The adsorption structures and energies of Mo(CO)_n molecules (n = 1 … 6) are computed systematically using density functional theory with Van der Waals corrections. By analyzing the energies of the various conformations, the main factors that determine the stable adsorption geometry are identified. Insight into the thermodynamics of decomposition is gained by calculating the reaction energy for dissociation of Mo(CO)_n into Mo(CO)_n?1 and CO. In the gas phase, this reaction is highly endothermic for all n. On the Cu surface, however, removal of the first CO group (n = 6) becomes strongly exothermic. The subsequent dissociation steps (n < 6), are endothermic even on the surface, but the reaction energies are much reduced. Dissociation is found energetically more favorable than desorption in all cases. The results clearly show that molybdenum carbonyl decomposition is strongly facilitated by the presence of the Cu surface. © 2014 Wiley Periodicals, Inc.