Nanoparticle enabled thermal control of ions in liquid crystals

Typically, ionic species in thermotropic liquid crystals are nearly fully ionised. Therefore, the concentration of mobile ions practically does not depend on the temperature. Interestingly, the same liquid crystals doped with nanoparticles exhibit totally different behaviour. The concentration of mobile ions become temperature dependent. This paper reports the effects of the temperature on the concentration of ions in liquid crystal nanocolloids. Liquid crystals doped with both 100% pure and contaminated nanoparticles are considered. Regardless the ionic purity of nanodopants, the concentration of mobile ions in liquid crystal nanocolloids increases towards the saturation as their temperature goes up. The magnitude of this saturation level equals the initial concentration of ions in liquid crystals doped with 100% pure nanoparticles. The temperature induced release of ions by contaminated nanoparticles in liquid crystals increases the above-mentioned saturation level. While the dispersion of 100% pure nanoparticles in liquid crystals leads to the temperature-dependent purification only, the use of contaminated nanoparticles results in the temperature-driven switching between the purification and contamination regimes enabling thermal control of ions.     

Residue behaviour and safety evaluation of fenaminstrobin in peanut field ecosystems

A rapid, sensitive, and selective method using a quick, easy, cheap, effective, rugged, and safe procedure in combination with high-performance liquid chromatography and tandem mass spectrometry was developed for the analysis of fenaminstrobin in peanut and soil. The average recoveries in all samples fall within 88.1%–10%, having relative standard deviations of 2.5%–14%. The limits of quantitation of fenaminstrobin in peanut shell, peanut kernels, peanut plant, and soil were 0.005, 0.004, 0.01, and 0.002 mg kg^?1, respectively. The field trial results show that the half-lives of fenaminstrobin in peanut plant and soil are 1.3–10 and 5.5–20 days, respectively. Residues in peanut kernels were found to be present at <0.004 mg kg^?1 levels, based on good agricultural practices recommended by the manufacturer. The risk posed by fenaminstrobin exposure at the recommended dosage is negligible to humans, depending on the risk quotient.     

Life cycle assessment and sustainability analysis of products, materials and technologies. Toward a scientific framework for sustainability life cycle analysis

There are many approaches to study the environmental and sustainability aspects of production and consumption. Some of these reside at the level of concepts, e.g., industrial ecology, design for environment, and cleaner production. Other approaches are based on the use of quantitative models, e.g., life cycle assessment, material flow accounting and strategic environmental assessment. This paper focuses on the development of a framework that is able to incorporate different models for environmental analysis, with the option of a broader scope that also includes economic and social aspects, thus covering the three pillars of sustainability. This framework builds on the ISO-framework for life cycle assessment, but takes a broader view, and allows us to move from micro questions on specific products, via meso questions on life styles up to macro questions in which the entire societal structure is part of the analysis.     

Radiochemical characterization of spring waters in Balaton Upland, Hungary, estimation of radiation dose to members of public

Hungary is rich in spring waters. A survey studying the naturally occurring alpha emitter radionuclides in 30 frequently visited and regularly consumed spring waters was conducted out in the Balaton Upland region of Hungary.²²⁶Ra, ²²⁴Ra, ²³⁴U, ²³⁸U and ²¹⁰Po activity concentrations were determined by using alpha spectrometry after separation from matrix elements. Average concentration (mBq L^{− 1}) of ²²⁶Ra, ²²⁴Ra, ²³⁴U, ²³⁸U and ²¹⁰Po in the spring waters is varied from 2.1 to 601, from < 1.1 to 65.4, from 3.9 to 741.9, from < 0.44 to 274.3 and from 2 to 15.2 respectively. In most cases radioactive disequilibrium was observed between uranium and radium isotopes. The doses for the analyzed samples of spring water are in the range 3.59–166.73 μSv y^{− 1} with an average 18.2 μSv y^{− 1} .This is well below the 100 μSv y^{− 1} reference level of the committed effective dose recommended by WHO. Only one water sample had a dose higher than 100 μSv y^{− 1}, mainly due to the contribution from radium (²²⁶Ra, ²²⁴Ra) and ²¹⁰Po isotopes. This study provides important information for consumers and authorities about their internal radiological exposure risk from spring water intake.     

New method for determination of trihalomethanes in exhaled breath: Applications to swimming pool and bath environments

A method for the estimation of the human intake of trihalomethanes (THMs), namely chloroform, bromodichloromethane, dibromochloromethane and bromoform, during showering and bathing is reported. The method is based on the determination of these compounds in exhaled breath that is collected by solid adsorption on Tenax using a device specifically designed for this purpose. Instrumental measurements were performed by automatic thermal desorption coupled to gas chromatography with electron capture detection. THMs in exhaled breath samples were determined during showering and swimming pool attendance. The levels of these compounds in indoor air and water were also determined as reference for interpretation of the exhaled breath results. The THM concentrations in exhaled breath of the volunteers measured before the exposure experiments showed a close correspondence with the THMs levels in indoor air where the sampler was located. Limits of detection in exhaled breath were dependent on THM analytes and experimental sites. They ranged between 170 and 710 ng m⁻³ in the swimming pool studies and between 97 and 460 ng m⁻³ in the showering studies. Application of this method to THMs determination during showering and swimming pool activities revealed statistically significant increases in THMs concentrations when comparing exhaled breath before and after exposure.     

土壤砷含量高光谱估算模型研究

以实验室内测取的土壤反射光谱为研究对象,利用PLSR方法建立反射光谱与土壤As含量之间的模型,通过交叉验证、估算检验建模精度,探讨利用反射光谱估算士壤As含量的可行性.通过比较不同光谱预处理方法、不同光谱分辨率和不同OM含量条件下建模、验证和估算结果.表明,MSC方法可以有效去除散射的影响而取得较好的结果(估算R2=0...     

Role of cleaning methods on bond quality of Ti coated glass/imidex system

Thin film materials are widely used in the fabrication of semiconductor microelectronic devices. In thin film deposition, cleanliness of substrate surface have become critically important as over 50% of yield losses in integrated circuit fabrication are caused by microcontamination [1]. There are many wafer cleaning techniques. The most successful approach for silicon wafer cleaning technique is RCA clean [2]. But for glass substrate it is still not known which procedure of cleaning is the best. This paper provides an understanding of the right way of glass wafer cleaning method, with a focus towards identifying good bond strength. Two wafer cleaning techniques have been used for cleaning glass substrates in the context of laser micro-joining of dissimilar substrates. First cleaning procedure involves two steps, first cleaning in acetone solution and then in DI water solution. After each step dried with N₂. Second cleaning procedure involves four steps, first cleaning with 1% Alconox solution, second in DI water, third in acetone solution and finally in a methanol solution and dried with N₂ after each step. Deposition of Ti thin film on top of these two types of substrate using DC magnetron sputtering method also showed better adhesion of Ti film on glass for the second type of cleaning method. Scanning electron microscopy (SEM) analyses of the lap shear tested failed surfaces for these two kinds of samples revealed strong bond for samples prepared by second cleaning method compared to first cleaning method. Characterization of these two sets of samples using X-ray photoelectron spectroscopy (XPS) has shown excellent contamination removal for the second cleaning method. This modification is believed to be due to reduction of carbon contamination.     

基于证据推理的混合型多指标群组决策方法

针对决策方案的属性值为语言评价等级和区间灰数的灰色多指标群组决策问题,提出一种基于证据推理的灰色多指标群组决策方法.首先,根据语言评价信息的概率分布和效用值等价原理确定定性指标和定量指标的信用结构,进而得到群体等级信用结构决策矩阵,然后,依据证据推理方法,对群组评价信息进行合成,求出各方案在各等级的信任度,最后,利用期望方差排序方法确定整个方案集的排序.具体算例表明方法合理有效.     

Quality assessment of Cortex Phellodendri by high‐performance liquid chromatography coupled with electrospray ionization mass spectrometry

A simple method based on liquid chromatography coupled with diode array detection and electrospray ionization mass spectrometry (LC‐DAD‐ESI‐MS) was developed for the quality assessment of Cortex Phellodendri (CP), which was mainly derived from two species of Phellodendron chinense Schneid and Phellodendron amurense Rupr. Total 41 compounds, including 14 phenols, 24 alkaloids and three liminoidal triterpenes were identified or tentatively characterized from the 75% methanol extract of CP samples by online ESI‐MSⁿ fragmentation and UV spectra analysis. Among them, two phenols and six alkaloids were simultaneously quantified using HPLC‐DAD method. The validated HPLC‐DAD method showed a good linearity, precision, repeatability and accuracy for the quantification of eight marker compounds. Furthermore, the plausible fragmentation pathway of the representative compounds were proposed in the present study. The differences of the chemical constituents content and the comprehensive HPLC profiles between the two CP species using LC‐DAD‐ESI‐MS method are reported for the first time, indicating that the CP drugs from different resources should be used separately in the clinic. Copyright © 2009 John Wiley & Sons, Ltd.     

Chromatographic determination,decline dynamic and risk assessment of sulfoxaflor in Asian pear and oriental melon

The dissipation pattern of sulfoxaflor in Asian pear cultivated in an open field conditions and in oriental melon grown under plastic house conditions was each studied in two different locations. Residues in field‐treated samples were determined using liquid chromatography coupled with an ultraviolet detector and confirmed by liquid chromatography–tandem mass spectrometry. A calibration curve for sulfoxaflor was linear over the concentration range 0.1–5.0 mg/L, with a coefficient of determination of 0.9999. The limits of detection and quantification (LOQ) were 0.007 and 0.02 mg/kg, respectively. Recoveries at three fortification levels (LOQ, 10 × LOQ and maximum residue limit) ranged from 70.5 to 86.2%, with a relative standard deviation ≤5.8%. The dissipation half‐lives were 10.8 and 7.9 days in pear and 5.4 and 5.9 days in oriental melon, at sites 1 and 2, respectively. Based on a pre‐harvest residue limit curve, it was predicted that, if the residues at 10 days before harvest in Asian pear are <0.54/0.61 mg/kg and those in oriental melon are <1.43/1.26 mg/kg, then the residue level will be below the maximum residue limit at harvest. Risk assessment at zero days showed a percentage acceptable daily intake of 10.80% in Asian pear and 1.77 and 1.55% in oriental melon, for sites 1 and 2, respectively. These values indicate that the fruits are safe for consumption.