余热驱动的传热强化吸附制冰机实验研究

以活性炭-甲醇为工质对,搭建单床吸附制冰机。采用某种粘结剂与活性炭混合。制作具有良好传热性能的固化活性炭块。吸附床即由此种炭块和带铜肋片的传热管组成。本文针对渔船制冰工况(冷量温度控制在零下7℃)对制冰机进行了模拟试验。系统的性能参数如下:COP为0.07,SCP为11W/kg活性炭。     

等离子体-吸附SO2转化机理研究

本文对SO2在等离子体和分子筛吸附联合作用下的转化现象进行了研究,开展了实验、模型建立、机理研究和理论计算等工作。研究表明,二者共同作用下可有效的将SO2转化,等离子体在转化反应中起着决定性的作用,其主要反应为OH SO2→HOSO2。理论计算和实验数据基本吻合。     

Electrical and chemical characteristics of nano-meter gold encapsulated in mesoporous and microporous channels and cages of FSM-16 and Y zeolites

The dc and ac conductivities as well as the dielectric constant () were measured for different zeolites encapsulated gold (AuCl₃) samples at different temperatures (300-500 K) and various frequencies (5 kHz-1 MHz). The conductivity was found to change in the order Au/FSM-27>Au/NaY>Au/FSM-47. Sorbed water contained inside zeolites assists greatly the proton mobility (zeolite protons) and the ion mobility (Na⁺ and Au⁺) and hence enhance the electric conduction in the temperature range 300-373 K. Raising the temperature over 373 K induces dehydration effect that assists the metallic gold formation and thus a dramatic loss in conductivity was revealed. The conduction mechanism was expected to be partially ionic and partially electronic. The IR study showed that the exposure of Au zeolites to CO gas produced a characteristic band of Au⁺-CO at 2180 cm⁻¹ that tends to decrease with temperatures and even vanishes at 376 K in favor of Au⁰-CO at 2128 cm⁻¹. Similarly, a phase transition at 338 K, that occurs in the range 300-376 K, was confirmed by DTA to further emphasize the temperature regions of either Au⁺ cations (338 K) or Au⁰ (376 K) formation.     

金属原子修饰石墨烯体系催化性能的理论研究

采用基于密度泛函理论的第一性原理方法研究了单个CO 和O2气体分子在金属原子修饰石墨烯表面的吸附和反应过程. 结果表明: 空位缺陷结构的石墨烯能够提高金属原子的稳定性, 金属原子掺杂的石墨烯体系能够调控气体分子的吸附特性. 通入混合的CO和O2作为反应气体, 石墨烯表面容易被吸附性更强的O2分子占据, 进而防止催化剂的CO 中毒. 此外, 对比分析两种催化机理(Langmuir-Hinshelwood和Eley-Rideal)对CO氧化反应的影响. 与其它金属原子相比, Al原子掺杂的石墨烯体系具有极低的反应势垒(< 0.4 eV), 更有助于CO氧化反应的迅速进行.     

铝和银在铱（111）宽范围吸附的稳定性、原子构型及电子特性研究

利用第一性原理密度泛函理论研究了铝和银在铱的111面的宽范围吸附特性。基于密度泛函理论计算了覆盖度在0.11ML到2.00ML的结构稳定性、原子构型及平均结合能。对于铝原子在铱111面的吸附,最稳定的结构是铝原子覆盖度为0.5ML位于密堆六方空位（hcp-hollow）,相应的结合能为-4.68eV;对于亚层铝原子的吸附,最稳定结构是铝原子覆盖度为1.00ML时位于octahedral位置,相应的结合能为-5.28eV。对于覆盖度为2.00ML的满覆盖度混合结构的表层及亚层吸附,最稳定结构是Al位于六方密堆及八方密堆位置,相应的结合能为-4.70eV。这意味着当铝原子以满覆盖度吸附在铱的111面上时,趋向于在铱的111面的亚层形成化学键,而非吸附于表层。相比于铝吸附在铱111面,银的吸附特性呈现出很大的不同,面心位置更为稳定,在覆盖度为0.25ML时其结合能为3.89eV,略微高出密堆六方位置处3.88eV的结合能。     

Real-time monitoring of SiO2/Si(1 1 1) interlayer etching by Brewster-angle reflectometry

A transitory etching regime after SiO₂ dissolution and before bulk Si(1 1 1) etching in neutral NH₄F solutions was monitored by in situ Brewster-angle reflectometry (BAR). An observed intermediate increase of the BAR reflectance signal is attributed to a fast dissolution of a stressed/strained interlayer beneath the SiO₂/Si(1 1 1) interface. Similar effects were observed on thin thermal oxides (18.2 nm), grown on float zone silicon, as well as on ultra-thin native oxides (1.2 nm) on Czochralsky silicon. Native oxide covered samples showed an increased surface roughness in the course of interlayer dissolution while the surface is progressively covered with compounds of fluorinated silicon. The etch rate, determined by atomic force microscopy (AFM) and compared to the etch rate of bulk silicon, is increased by a factor of four. In the limit of extended etching, the known low etch rates for silicon in 40% NH₄F are observed. Structural and chemical properties of the interfacial layer were analyzed by synchrotron radiation photoelectron spectroscopy (SRPES) which confirmed the presence of Si^3+/4+ valence states throughout the interlayer and by near open-circuit potential (N-OCP) dark current measurements. As a result, oxide etch rates in NH₄F in the pH-range 7–8 as well as the silicon interlayer depth can be assessed by in situ BAR.     

Theoretical investigation of CO adsorption on TM-doped (MgO)12 (TM = Ni, Pd, Pt) nanotubes

CO adsorption on TM-doped magnesia nanotubes (TM = Ni, Pd and Pt) have been studied by using density functional theory. Our calculation results show that CO favors adsorption on TM-doped magnesia nanotubes in the form of C atom bonding with TM atom. Fukui indices analysis clearly exhibits that doping of impurity TM atom allows for a noticeably enhancement of nucleophilic reactivity ability of magnesia nanotube. The adsorption energies demonstrate that CO molecule is more strongly bound on the 3-fold TM atoms than the 4-fold TM atoms. This finding is well confirmed by TM-C bond length, charge transfer and C-O vibrational frequency. The high adsorption energy of 2.55 eV is found when CO adsorbs on 3-fold Pt in Pt-doped magnesia nanotubes, implying the kind of the doping TM atom has a significant influence on the chemical reactivity.     

Electrocatalytic reduction of alkyl iodides in tetrahydrofuran at silver electrodes

Recent interest in the electrocatalytic activity of silver towards the reduction of alkyl iodides has led us to investigate whether the effect is observed in tetrahydrofuran (THF) at room temperature. Using platinum electrodes in THF for the reduction of alkyl halides at 298 K has been hampered by the solvent window, which ‘obscures’ the voltammetric signals of interest. In order to overcome these problems, voltammetry has been performed at low temperature and was shown to extend the voltammetric window, leading to accurate electrochemical analyses and even novel changes in mechanism(s) of the reactive species following electron‐transfer (ET). Herein, it is shown that for a primary and tertiary alkyl iodide in THF, electroreduction at silver leads to a significant shift in the reduction potential to more positive values compared to platinum. In addition, following reduction, a characteristic series of oxidation peaks are observed and are shown to be due to the specific activity of iodide ions towards silver following reductive cleavage of the parent alkyl iodide. This characteristic feature is not observed with other halide ions: bromide and chloride. Preparative electrolyses at controlled‐potential have suggested that the reduction of the above alkyl iodides is a one‐electron concerted process. The ‘free’ iodide ions act as a monitor of reaction progression, and the carbon‐centred radical either dimerises and/or abstracts a hydrogen atom from the electrolyte/solvent; 1‐iodoadamantane giving percentage yields of 58% adamantane and 39% 1,1'‐biadamantane, the primary alkyl iodide, prepared in‐house, giving 67% R‐H and 25% R‐R. Copyright © 2007 John Wiley & Sons, Ltd.     

Heat of adsorption and density distribution in slit pores with defective walls: GCMC simulation studies and comparison with experimental data

The adsorption behavior (capacity, density distribution and packing density) and the isosteric heat versus loading in a slit pore whose walls contain defective graphene layers are investigated in this paper. The defective wall is characterized by the extent and size of the defect. Simulation results obtained with the Grand Canonical Monte Carlo method reveal complex patterns of isosteric heat, and this complex behavior is a result of the interplay between three factors: (i) the surface heterogeneity (solid-fluid interaction, sites with varying degree of affinity), (ii) fluid-fluid interaction and (iii) the overlapping of potentials exerted by the two defective walls. We illustrate this with argon adsorption in pores of various sizes, and results obtained from the simulation agree qualitatively with the experimental data at 77 K on Saran microporous S600H and micro-mesoporous S84 charcoals of Beebe et al. [R.A. Beebe, B. Millard, J. Cynarski, J. Am. Chem. Soc. 75 (1953) 839]. The S600H was found to contain pores predominantly in the neighborhood of 7 Å with 30% of defect and a defective size of 2.84 Å. This is consistent with the argument made by Beebe et al. that this sample is a microporous solid and most pores can accommodate only one layer. The other sample, S84, has larger pores than S600H, and it is found that it has a wider pore size distribution and the pore width is centered at about 12 Å.     

接枝聚合物对小分子的选择性吸附研究

文章应用密度泛函理论研究接枝于壁面的方阱链对二元小分子混合物的选择性吸附特性. 系统的Helmholtz剩余自由能泛函被表示为硬球排斥和方阱吸引两部分贡献之和,分别由硬球链流体状态方程和变阱宽方阱链流体状态方程的简单加权密度近似来进行计算. 用此理论方法,分别考察了接枝聚合物的结构性质,以及不同温度下接枝分子层对二元方阱流体的选择性吸附性能. 结果表明:分子刷厚度随接枝密度线性增长而随温度非线性增加,并且在高温下趋于饱和;在较低温度下,接枝聚合物刷能表现出很好的选择性吸附能力,当聚合物刷被加热到高于饱和温度时,该能力将大幅度地减弱. 关键词： 密度泛函理论 接枝聚合物 选择性吸附 方阱链