A Systematic Evaluation of Polyurethane as a Conformal Coating for the Inhibition of Corrosion on Electronic Components

The corrosion of printed circuit boards can be effectively prevented with a polyurethane conformal coating. In this study, the protective performance of PU coating was investigated systematically through electrochemical measurements and simulated exposure/immersion tests. Some fungi tests were also included. All experimental results show that a polyurethane coating effectively inhibits corrosion on printed circuit boards. The optimal thickness of the coating film should be about 60 μm. Long-term exposure tests showed that this coating material could preserve the reliability of the investigated printed circuit boards for more than 400 days in a 90% relative humidity environment at 25°C.     

Uncertainty of the Thermal Conductivity Measurement Using the Transient Hot Wire Method

This work deals with uncertainty analysis of the thermal conductivity measurement using the transient hot wire method. The characterization is made from a sample of low-density, polyethylene BRALEN SA 200-22. The utilized experimental data are obtained from the test measurements performed on the air at room temperature. The sources of measurement errors are analyzed and the uncertainty of the measured value of the thermal conductivity is evaluated. The analysis shows that in the present case the uncertainty of the thermal conductivity measurement is about ±3.3% for 68% confidence level.This revised version was published online in November 2005 with corrections to the Cover Date.     

New far infrared laser lines obtained by optically pumping13CD3OD

We have obtained laser action on 34 far infrared lines for the first time in fully deuterated methyl alcohol with the¹³C isotope (¹³CD₃OD), and we have measured the frequency of 13 lines. The molecule was pumped by a cw CO₂ laser. We have measured the wavelength, the relative polarization, the relative intensity of most lines, the frequency, and the CO₂ pump frequency offset of the strongest lines. The new lines are distributed in the wavelength region from 75.27 m to 464.7 m.Supported in part by a joint grant with the U.S. National Science Foundation grant # INT 80-19014 and the Brazilian Conselho Nacional de Pesquisas (CNPq).     

磷脂水解与胆固醇型胆结石时的可能生成机理

用胆酸盐-磷脂-胆固醇-水体系模拟胆汗的化学行为。在体系中发现，磷脂可 以发生降解形成脂肪酸。而在胆汗中，磷脂在增溶固醇的过程中起到了十分重要的 作用。依此，我们提出磷脂的水解可能与胆固醇型胆结石的生成有密切关系。     

Lecithin/propanol-based microemulsions used as media for a cholesterol oxidase-catalyzed reaction

Reverse micelles, Winsor III and IV systems were examined as reaction media for the enzymatic conversion of cholesterol to cholestenone by cholesterol oxidase at 298.2 K. The micelles and the microemulsions, stabilized by soybean lecithin and ethanol or 1-propanol as cosolvent, were characterized with respect to phase behavior and distribution of 1-propanol between the phases of the Winsor III systems. The used oils were dodecane, tetradecane, and hexadecane. The Winsor IV systems and the surfactant-rich phase in the Winsor III systems exhibit bicontinuous structures. The reaction yield for the enzymatic conversion performed in a Winsor IV system was much higher than in a Winsor III system or in reverse micelles.     

采用Seemann－Bohlin准聚焦X射线衍射仪测量薄膜厚度的误差理论分析

本文从理论上分析了衍射强度比偏差Δ（Ｉ／Ｉ∞）和衍射峰位偏差Δ２θ对Ｓｅｅｍａｎｎ－Ｂｏｈｌｉｎ准聚焦Ｘ射线衍射仪测量表面单层薄膜厚度误差的影响。分析结果表明，降低Δ（Ｉ／Ｉ∞）可提高膜厚的测量精度，在Δ（Ｉ／Ｉ∞）－定的情况下，按μρｔ［Ｓｉｎ（－１）γ＋Ｓｉｎ（－１）（２θ－γ）］＝１选择靶辐射和衍射晶面可使由Δ（Ｉ／Ｉ∞）导致的膜厚测量误差具有极小值；选择高角度衍射线有助于减小试样离焦引起的衍射峰位偏差，亦可降低因衍射角测量偏差导致的膜厚测量误差，当衍射线处于薄膜的法向２θ＝γ＋π／２时，角度项误差（Δｔ／ｔ）（２θ）完全消除。     

气相色谱质谱法快速测定人血浆中克仑特罗

血浆样品经0.01mol·L-1盐酸和无水乙醇浸取,在碱性条件下用氯仿萃取,GG-MS-选择离子测量法测定,外标法定量。在选定的色谱条件下,盐酸克仑特罗的检出限为0.05ng,线性范围为0.1-100ng,方法的平均回收率为95.6％,RSD小于6.82％(n=6)。该法毋需衍生化,基质无干扰,简便可靠,适用于生物材料中克仑特罗的快速分析。     

一种新的库仑微水滴定仪的设计方法

在传统微库仑滴定仪原理的基础上，利用８７５１单片机和微机，采用对电解电流时间调制的方法以及测量精度为准则判断滴定终点，从而大大地提高了仪器的测量精度和重复性。