光谱复杂的稀土基体中稀土杂质ICP光谱测定的一些问题

ICP激发光源以其独特的功能使ICP/AES技术在稀土分析中的应用日益广泛,在一定程度上取代了经典的直流电弧光谱法,但应指出,由于常规雾化器的低雾化效率(≤5％)和试样的高倍稀释,ICP/AES技术的实际检测能力的改善并不明显,本文用ICP光谱法测定了     

氯化钠在球形纳米氧化铈形成过程中的作用

以水合碳酸铈为原料, 以氯化钠作为助磨剂和阻聚剂, 采用机械活化法制备了球形纳米氧化铈, 用XRD法研究了水合碳酸铈与氯化钠质量比、球磨时间、煅烧温度对CeO2粉体晶粒度的影响, 用TEM对最终产物粒子进行形貌观察. 结果表明: 在碳酸铈的球磨过程及其随后的煅烧过程中, 氯化钠的存在起到了很好的助磨和阻聚作用, 所得CeO2为类球形粒子, 分散性较好, 晶粒度约为30～50 nm.     

Effect of Ba and Bi doping on the synthesis and sintering of Ge-based apatite phases

Recently, high oxide ion conduction has been observed in the apatite-type systems La_9.33+x(Si/Ge)₆O_26+x/2, with conductivities approaching and even exceeding that of yttria-stabilized zirconia. The Ge-based phases have been reported to suffer from Ge loss and undergo irreversible structural changes on sintering at the high temperatures required to obtain dense pellets. In this paper we discuss doping studies (Ba, Bi for La) aimed at stabilizing the hexagonal apatite lattice to high temperature, and/or lowering the synthesis and sintering temperatures. The results show that doping with Ba helps to stabilize the hexagonal lattice at high temperatures, although Ge loss appears to still be a problem. Conductivity data show that, as previously reported for the Si-based systems, non-stoichiometry in the form of cation vacancies and/or oxygen excess is required to achieve high oxide ion conduction in these Ge-based systems. Neutron diffraction structural data for the fully stoichiometric phase La₈Ba₂Ge₆O₂₆ shows that the channel oxygen atoms show little anisotropy in their thermal displacement parameters, consistent with the low oxide ion conductivity of this phase. Bi doping is shown to lower the synthesis and sintering temperatures, although the presence of Bi means that these samples are not stable at high temperatures under reducing conditions.Presented at the OSSEP Workshop Ionic and Mixed Conductors: Methods and Processes, Aveiro, Portugal, April 10–12, 2003     

2-三氰基乙烯基蒽及其旋转异构体的量子化学研究

用量子化学从头算方法 ,在RHF/STO - 3G水平上 ,对 2_三氰基乙烯基蒽 (2_TCVA)分子进行了理论计算 ,优化得到了它的平衡几何构型 ,并计算了它的谐振动频率 .结果表明 :2_TCVA存在两种旋转异构体 :2_TCVA(1)和 2_TCVA(2 ) ,2_TCVA(2 )的总能量比 2_TCVA(1)的略高 .在PM3/CIS水平上计算了它们的电子光谱 ,得到了由基态到各激发态的垂直跃迁能和相应的振子强度 .研究表明 :2_TCVA(1)和 2_TCVA(2 )的强度最大的吸收波长分别为 2 4 9.72nm和 2 89.4 1nm ,2_TCVA(2 )的强度最大的吸收波长比 2_TCVA(1)的要长 .计算结果与实验结果符合得较好     

Improved accuracy of quantitative XPS analysis using predetermined spectrometer transmission functions with UNIFIT 2004

The accuracy of quantitative XPS analysis can be improved using predetermined transmission functions. Two different calibration methods are used for estimating the transmission function T(E) of a photoelectron spectrometer, applying a survey spectra approach (SSA) and a quantified peak‐area approach (QPA) to minimize the quantification error. For the SSA method, Au, Ag and Cu spectra measured with the Metrology Spectrometer II have been used. The new QPA method was built up from Au 4f, Au 4d, Au 4p_3/2, Ag 3d, Ag 3p_3/2, Cu 3p, Cu 2p_3/2, Ge 3p and Ge 2p_3/2 standard peak areas, applying adequate ionization cross‐sections and mean free path lengths for different pass energies (10 and 50 eV), lens modes (large area, large area XL, small area 150) and x‐ray sources (Al/Mg Twin and Al Mono). In the energy range 200–1500 eV a transmission function T(E) = a₀ + b₁E (where a₀, b₁ and b₂ are variable parameters) was found to give an appropriate approximation for eight tested spectrometer settings, implementing the largest changes in the case of pass energy variations. Determination and application of the transmission functions were integrated in the XPS analysis software (UNIFIT 2004) and tested by means of an Ni90Cr10 alloy. The results demonstrate the practicability of the SSA and QPA methods, giving decreased errors of <8% in comparison with errors up to 38% obtained using Wagner's sensitivity factors. Copyright © 2005 John Wiley & Sons, Ltd.     

微合金钢中稀土对沉淀相和性能的影响

在Nb(Ti,V）微合金钢中，主要沉淀相分别为Nb(C,N),(Nb,Ti)(C,N)和V（C，N）。稀土降低沉淀相完全溶解的温度，增大奥氏体中沉淀相析出的孕育期，降低析出速率，抑制奥氏体中沉淀相的析出，在铁素体相区，稀土提高沉淀相的析出速率和数量，促进沉淀相的析出，其中稀土对铌沉淀相析出的作用影响最强。锻态钢中，稀土有促进细化球化析出相的作用，随稀土含量增加，沉淀相析出数量增加，但过量稀土，促进作用又减弱，稀土在保持微合金钢强度的情况下，显著改善其冲击韧性，尤其是低温韧性，微合金钢中添加适量稀土可获得更佳的综合性能。     

钙钛矿型CaSiO_3解压缩和重压缩过程的分子动力学模拟

用分子动力学模拟方法 (MD)研究了 3 0 0K时钙钛矿型CaSiO3 ,从高压到负压的解压缩过程 .MD模拟获得的P V关系与实验数据相近 ,与已报道的MD模拟数据基本一致 ,所得体积模量也在实验数据分布范围内 .减压缩和重压缩的MD模拟数据与实验结果相似 .钙钛矿型CaSiO3 解压缩成非晶态时 ,存在两个结构破坏阶段 :破坏硅氧八面体和破坏钙氧二十面体 .当钙氧二十面体被破坏后 ,重压缩不能得到钙钛矿型结构 .只要钙氧二十面体未被破坏 ,重压缩可恢复钙钛矿型结构 .本研究得到的结果尚未见相关报道 .由MD模拟数据计算了CaSiO3 系统的红外光谱 ,分析这些数据可知钙钛矿型CaSiO3 解压缩非晶化是一个二阶软模相变 .研究表明钙钛矿型CaSiO3 结构存在一个等容的亚稳极限 ,其解压缩非晶化是一个受动力学控制的亚稳状态 .     

掺杂稀土元素对细晶BaTiO_3系统耐压及介电性能的影响

研究了稀土元素Ho2O3和Er2O3掺杂BaTiO3基瓷料,其在BaTiO3系晶粒中可抑制晶粒生长,使晶粒尺寸变小,体密度增高,呈现细晶效应,ε峰在整个温区范围内弥散,提高室温下介电常数,减小容量变化率。本系统中三价稀土氧化物Ho2O3和Er2O3等物质同时加入到BaTiO3陶瓷中后,稀土氧化物没有全部进入晶格内部发生取代,其中的一部分与其他添加剂形成一些非铁电相,提高耐压;另一部分留在晶界处,成为晶粒抑制剂,使得晶粒细小,瓷体致密,提高陶瓷的耐压。     

铈杂多配离子-水滑石超分子层柱材料ZnAl-Ce(PMoV)2的插层组装、表征及催化性能

以十四酸根阴离子柱撑Zn-Al水滑石Zn0.77Al0.22(OH)2.0.22C13H27COO.0.81 H2O(记为ZnAl-14A)为预撑前体,在水溶液中用离子交换法将以2∶17缺位杂多酸根离子(P2Mo16VO61)11-记为(P Mo V)为配体的稀土杂多配阴离子Ce(P2Mo16VO61)219-(记为Ce(PMoV)2)插层组装到水滑石层板间,合成了一种具有大的层间距(3.37 nm)的超分子插层材料Zn0.77Al0.23(OH)2.0.0105[Ce(P1.9Mo15.7V1.1O61)2].0.011C13H27COO.0.83H2O(记为ZnAl-Ce(PMoV)2)。用ICP,IR,XRD和DTA对产物的组成和结构进行了表征。结果表明,该产物中Ce(PMoV)2配阴离子沿其长轴垂直于层板的方向分布于水滑石层间;产物具有规整的层状结构和热稳定性;产物对乙酸与正丁醇的酯化反应,二甘醇的脱水-环化反应和H2O2氧化环己烷的反应有良好的催化性能,且易于回收重复使用。