Cr（Ⅲ）—5—Br—PADAP—Triton X—100析相光度法测定微量铬的研究

研究Cr(Ⅲ)-5-Br-PADAP-Triton X-100析相显色体系,建立测定微量铬的析相光度法。在pH 4.5乙酸-乙酸钠介质中,Cr(Ⅲ)、5-Br-PADAP、Triton X-100加热形成的配合物,于95℃恒温浴中析相1h,即被Triton X-100相完全富集,最大吸收峰为593nm,铬含量在0～10μg/5ml服从比耳定律,以硫脲、锰-EDTA、柠檬酸钠、氟化钾为掩蔽剂,测定水样中微量铬,获得满意结果。     

Thermal Properties of Hot-Stage Extrudates of Itraconazole and Eudragit E100. Phase separation and polymorphism

Solid dispersions of itraconazole and eudragit E100 were prepared by hot-stage extrusion. Analysis of the physical structure revealed the existence of different phases, depending on the manufacturing condition. Extrudates prepared at 453 K existed as a molecular dispersion of itraconazole in eudragit E100 when the drug concentration did not exceed ca. 13% mass/mass. At higher concentrations, a second phase consisting of pure glassy itraconazole emerged. In other dispersions prepared at 413 K, the second phase consisted of pure crystalline itraconazole. The difference can be attributed to the relation of the process-temperature to the melting point. Heating of both dispersions induced cold crystallization. Extrudates prepared at 453 K showed comparable behavior before and after milling, with the exception that unmilled dispersions with a drug load of ≥60% mass/mass recrystallized upon heating into a polymorphic modification of itraconazole (T _m=431 K). Upon further heating the polymorph recrystallized to the stable crystalline form (T _m=441 K). This revised version was published online in August 2006 with corrections to the Cover Date.     

微波辐照增强原煤磁分离脱硫机理探讨

采用~(57)Fe穆斯堡尔谱学方法,研究微波-磁分离法脱硫机理及微波辐照深度对脱硫率的影响。结果表明,微波选择性介质加热,可以激励煤中顺磁性黄铁矿FeS_2热解,使其转化为非化学计量的磁黄铁矿Fe_(1-x)S(0相似文献   

卡尔曼滤波析相光度法同时测定锰铁铜锌镉的研究——5-Br-PADAP—Triton X-100体系

运用卡尔曼滤波递推法,以2-(5-溴-2-吡啶偶氮)—5-二乙氨基苯酚(5-Br-PADAP)为显色剂,建立了同时测定锰、铁、铜、锌、镉析相光度法.在pH9.0硼酸-氢氧化钠介质中,胶束溶液在95℃加热1h,配合物被Triton X-100相完全富集,最大吸收峰分别为锰566nm、铁556nm、铜560nm、锌562nm、镉557nm,工作曲线范围除镉为0～8μg/5ml外,其余均为0～10μg/5ml.应用于大米中锰铁铜锌镉的同时测定,结果满意.     

Crystal Structure Analysis of Tetras[L-tris(ethylenediamine) cobalt(Ⅲ)] tris[hexacyanoruthenate(Ⅱ)]

1 INTRODUCTION The tris(ethylenediamine) cobalt (Ⅲ) complex in which there are L and D configurations is one of the very interest cations due to the chirality among research complexes and the characterization of reaction on the ion-pair charge-transfer transitions. It has been mentioned in a lot of examples on the chirality and the structure, such as [L-Co(en)3]- [?Co(edta)]2Cl?0H2O[1], [(+)DCo(en)3]Cl3稨2O[2], [(+)-Co(en)3?-)-Cr(en)3]Cl?.1H2O[3], [()-Co(en)3] (SCN)3[4], [(+)D…     

Modification of HPTLC-plates by in situ chemical bonding with non-polar and polar organosilanes

A method has been developed for the preparation of modified silica plates for high performance thin-layer chromatography (HPTLC). Some typical organosilanes were thus allowed to react in situ with the silica of Merck HPTLC-plates. This method was found to be highly reproducible, simple and cheap. Non-polar plates were prepared and compared with commercial plates from Merck, Whatman and Macherey-Nagel. Modification with cyanodecyltrichlorosilane resulted in plates that showed good coverage, efficiency and low residual silica activity. Silica modified with a multifunctional silane has different properties in different organic solvents. It will appear to be non-polar in a polar solvent and vice versa. New advantageous separation systems are thus made feasible by the presence of cyano groups on the plate. The utility of modified thin-layer plates is demonstrated by the separation of some homologues of p-hydroxybenzoic acid esters and of some polycyclic aromatic hydrocarbons.     

Phase Separation in Sol-Gel System Containing Mixture of 3- and 4-Functional Alkoxysilanes

The phase separation behavior of gelling systems containing the mixture of 3-functional and 4-functional alkoxysilanes has been investigated. The relation between the starting composition and resultant macroporous morphology was examined using tetramethoxysilane (TMOS) and vinyltrimethoxysilane (VTMS) as starting alkoxysilanes, formamide (FA) as an additive, under an acidic condition. Up to TMOS:VTMS molar ratio of 0.5:0.5, the phase relation remained almost unchanged from that of pure TMOS system which exhibits morphology with well-defined co-continuous macropores in a very limited concentration region. On the VTMS-rich side typically TMOS:VTMS = 0.2:0.8, however, the co-continuous macroporous morphology was obtained in a broader composition range than those of either pure TMOS or VTMS system. A dome-like pseudo binary region was obtained with the two-phase region extending toward FA-rich direction. The domain size and pore volume of the gels with macroporous morphology could be controlled by alkoxide:water ratio and total solvent fraction, respectively.     

铀-2-(3,5-二溴-2-吡啶偶氮)-5-二乙氨基苯酚-Triton X-100析相体系的研究及应用

本文研究了铀-2-(3,5-二溴-2-吡啶偶氨)-5-二乙氨基苯酚(3,5-diBr-PADAP)-Triton X-100析相光度体系,建立了矿石中微量铀的测定方法,在pH 7.5三乙醇胺-盐酸介质中,将胶束溶液在 95±1℃加热 1h.络合物即被Triton X-100相完全富集.络合物最大吸收峰位于565nm.摩尔吸光系数为1.02×10～5L·mol～(-1)·cm～(-1),铀含量在0～12μg/5mL服从比耳定律.采用TBP萃淋树脂分离干扰离子,测定矿石中微量铀,结果满意.     

Stereogenicity/Astereogenicity as Global/Local Permutation-Group Symmetry and Relevant Concepts for Restructuring Stereochemistry

Molecules of ligancy 4 that have been derived from an allene, an ethylene, a tetrahedral, and a square-planar skeleton have been investigated to show that their symmetries are dually and distinctly controlled by point groups and permutation groups. Insomuch as the point-group symmetry was exhibited to control the chirality/achirality of a molecule, sphericity in a molecule, and enantiomeric relationship between molecules [S. Fujita, J. Am. Chem. Soc. 112 (1990) 3390], the permutation-group symmetry has been now clarified to control the stereogenicity of a molecule, tropicity in a molecule, and diastereomeric relationship between molecules. To characterize permutation groups, proper and improper permutations have been defined by comparing proper and improper rotations. Thereby, such permutation groups are classified into stereogenic and astereogenic ones. After a coset representation (CR) of a permutation group has been ascribed to an orbit (equivalence class), the tropicity of the orbit has been defined in term of the global stereogenicity and the local stereogenicity of the CR. As a result, the conventional stereogenicity has now been replaced by the concept local stereogenicity of the present investigation. The terms homotropic, enantiotropic, and hemitropic are coined and used to characterize prostereogenicity. Thus, a molecule is defined as being prostereogenic if it has at least one enantiotropic orbit. Since this definition has been found to be parallel with the definition of prochirality, relevant concepts have been discussed with respect to the parallelism between stereogenicity and chirality in order to restructure the theoretical foundation of stereochemistry and stereoisomerism. The derivation of the skeletons has been characterized by desymmetrization due to the subduction of CRs. The Cahn–Ingold–Prelog (CIP) system has been discussed from the permutational point of view to show that it specifies diastereomeric relationships only. The apparent specification of enantiomeric relationships by the CIP system has been shown to stem from the fact that diastereomeric relationships and enantiomeric ones overlap occasionally in case of tetrahedral molecules.     

Selective ordering of surfactant modified gold nanoparticles in a diblock copolymer

Ordered aggregation of thiol-passivated Au nanoparticles in a diblock copolymer polystyrene-b-poly(methyl methacrylate) has been observed. The morphology of the diblock copolymer/Au-nanocomposite was dependent on the composition of the thiol modifier. For the thiol modifier that does not preferentially interact with one of the blocks, a perpendicular (relative to the substrate) lamellar morphology is maintained. However, for a thiol with a surfactant structure similar to one of the blocks, we observed a parallel lamellar morphology and speculate that the nanoparticles have localized at the microdomain interface. These conclusions are based on transmission electron microscopy, angle-dependent X-ray photoelectron microscopy and tensiometry. These results are consistent with theoretical predictions on the hybrid systems composed of block copolymers and nanoparticles.