有机高分子与聚合硫酸铁的复配特性

研究了水溶性有机高分子(OP)与聚合硫酸铁(PFS)的复配特点,从分子结构和溶剂化角度探讨了OP在PFS中的稳定机制,并采用FT-IR、SEM和X射线衍射探讨了OP与PFS的相互作用.结果表明:具有吡咯环结构的聚二甲基二烯丙基氯化铵、聚二乙基二烯丙基氯化铵和聚乙烯吡咯烷酮能与PFS复配,且具有较好的稳定性;OP与PFS形成了互相融合的复合体系,主要与PFS中Fe4.67(SO4)6(OH)2.20H2O物相发生相互作用.     

硫酸铜含量对硫酸铜与丁腈橡胶之间配位交联反应的影响

利用丁腈橡胶(NBR)的可配位侧基——腈基(—CN)与金属盐硫酸铜(CuSO4)的铜离子(Cu2+)之间的配位反应制备了一种配位交联CuSO4/NBR.影响该配位交联反应的因素众多,如热压温度、热压时间、增塑剂等等,考察了CuSO4含量对其的影响.通过X射线光电子能谱(XPS)、动态力学分析(DMA)、差示扫描量热分析(DSC)等手段对CuSO4与NBR之间的配位交联反应进行了分析,并对所得配位交联的CuSO4/NBR进行了交联密度及力学性能的测试.结果发现,随CuSO4含量的不断增加,CuSO4与NBR的配位交联程度逐渐增强,且所得配位交联CuSO4/NBR显示出从典型橡胶到韧性塑料再到脆性塑料的力学转变特性.另外,通过扫描电子显微镜(SEM)及X射线能谱仪(EDX)对材料的微观结构进行了分析,发现CuSO4在聚合物基体中不仅充当交联剂的角色,而且还起着增强填料的作用.     

Studies on the Hydrogen Bonding Network Structures of Amino-konjacglucomannan-zinc Chelate

Amino-Konjacglucomannan(NH2-KGM) was prepared through the reaction of ammonium hydroxide with KGM by ultrasonic. The influence of amount of ammonium hydroxide, concentration of KGM and ultrasonic time on the extent of amination was studied. Then, NH2-KGM and zinc sulfate were used as materials for the preparation of NH2-KGM-Zn complex. The results indicated that the extent of amination increases with increasing the ammonium hydroxide. The optimum concentration of KGM and ultrasonic time are 0.3% and 75 min respectively. IR showed KGM is successfully aminated and NH2-KGM forms stable complex with zinc(Ⅱ). The hydrogen bonding network structures of NH2-KGM-Zn are more stable and the key linking points of hydrogen bonding network are at the OH(6) and O(3) positions of mannose and OH(2) of glucose and O(3) of mannose on the KGM ring. It is more favorable for NH2-KGM-Zn to form intermolecular hydrogen bonds between KGM.     

微分脉冲伏安法测定硫酸锌溶液中铊

研究了微分脉冲伏安法测定复杂硫酸锌溶液体系中的铊。讨论了伏安图的形成、测定底液和pH值的选择。结果表明:在醋酸介质(pH=4.5±0.2)中,加入适量EDTA、聚乙二醇6000和抗坏血酸的测定体系,采用微分脉冲伏安法可直接测定铊。方法检出限为1.0×10-8g/L,千倍浓度的8种阳离子共存或单独存在时均不干扰测定。方法用于湿法炼锌中上清、一段净化后液、二段净化后液、电积新液、电积废液中铊的测定,相对标准偏差RSD分别为1.6%,2.5%,3.3%,8.3%,4.9%,铊加标回收率为98.4%～102.2%。方法灵敏、简单、快速,用来测定湿法炼锌各阶段硫酸锌溶液中的铊,结果满意。     

超声波辅助液相合成六次甲基四胺络铜的研究

以五水硫酸铜和六次甲基四胺(HMTA)为原料,在超声波作用下采用液相合成法合成六次甲基四胺络铜。探讨原料配比、超声波辐射功率、辐射时间和反应温度对产物收率的影响。实验证明,合成六次甲基四胺络铜较适宜的条件为:五水硫酸铜/六次甲基四胺物质的量比1∶2.0,超声波辐射功率160 W,辐射时间60min,反应温度50℃,在此条件下产物收率可达65.2%,比传统的液相法(收率36%)高出近30%。     

硫酸钠对胰岛素淀粉样纤维化及其细胞毒性的作用

超过20种人类疾病与蛋白质或者多肽淀粉样纤维化密切相关,探究影响蛋白质的结构稳定性及其淀粉样纤维化的环境条件具有重要意义.本文采用牛胰岛素作为模型蛋白质,研究了Na2SO4对蛋白质淀粉样纤维化的作用.实验结果表明,不同浓度的Na2SO4对胰岛素淀粉样纤维化过程具有不同的影响,低浓度条件下可促进纤维化,较高浓度可明显抑制淀粉样纤维的形成,更高的浓度则使胰岛素形成非纤维状聚集体.ANS荧光分析结果表明,所有浓度的Na2SO4均可减小胰岛素聚集体的表面疏水性,并导致聚集体对细胞膜的损害作用降低.Na2SO4的上述作用可能与其改变蛋白质分子间的静电作用力及溶剂效应有关.     

一株硫酸盐型厌氧氨氧化菌的分离和鉴定

以硫酸盐为电子受体、氨为电子供体的反应称为硫酸盐型厌氧氨氧化,这是一个新的生物反应.迄今为止,虽已证明硫酸盐型厌氧氨氧化的存在,但并未获得进行该反应的微生物.本课题组从长期稳定运行的厌氧脱氮除硫反应器污泥中,分离获得了一株硫酸盐型厌氧氨氧化菌.形态观察、生理试验和16SrDNA序列比对表明,该菌株可归入Bacillus benzoevorans.以Biolog板检测发现,该菌株可利用多种碳源,基质多样性明显.其最适代谢pH为8.5,最适代谢温度为30℃.研究证明,该菌株可在无氧条件下,同时去除氨氮和硫酸盐,具有硫酸盐型厌氧氨氧化活性.这一发现为硫酸盐型厌氧氨氧化的确认提供了生物学证据,为新型生物脱氮除硫工艺的研发打下了基础,为微生物学增加了新的内容,为地球氮素和硫素循环提供了新的认识.     

糖苷基季铵盐与十二烷基硫酸钠复配性能的研究

研究了糖苷基季铵盐(CAPG)与十二烷基硫酸钠(K12)复配体系的稳定性、表面活性、泡沫性能和润湿性能.结果表明:CAPG与K12复配体系的稳定性好,并表现出很好的协同增效作用.当n(CAPG)∶ (K12)等于0.1∶ 1,0.3∶ 1,0.5∶ 1时,复配体系的临界胶束浓度(cmc)分别为0.081 mmol/L,0.065 mmol/L,0.054 mmol/L,大大低于单一组分的cmc,临界胶束浓度时的表面张力(γcmc)比单一组分略低,起泡力和泡沫稳定性均好于单一组分,润湿力比K12略低,但比CAPG好得多.     

CAN引发S—DMDAAC—AM接枝共聚的研究

以硝酸铈铵(CAN)为引发剂,以淀粉(S)、二甲基二烯丙基氯化铵(DMDAAC)和丙烯酰胺(AM)为原料,通过反相乳液聚合,合成接枝共聚物。研究了加料顺序、引发剂浓度、单体与淀粉配比、油水体积比、乳化剂用量等因素对产品性能的影响。并用IR和1H-NMR对接枝产物进行了分析表征。     

Three useful bromimetric methods for the determination of salbutamol sulfate

Three different methods developed for the determination of salbutamol sulfate (SBS), in pure drug form and in dosage forms, are discussed. The methods are based on the oxidation–bromination reaction of the drug by bromine generated in-situ by the interaction of bromate with bromide in acid medium. In titrimetry the drug is titrated directly with bromate in the presence of a large excess of bromide and in sulfuric acid medium using methyl red as indicator. Spectrophotometry is based on addition of a measured excess of bromate–bromide mixture to the sample solution in sulfuric acid medium followed by the estimation of surplus bromine by reacting it with a definite amount of methyl orange dye and measuring the absorbance at 510 nm. The amount of bromate reacting corresponds to the sample content. The kinetic method depends on the linear relationship between the concentration of the drug and time for oxidation and bromination as indicated by the bleaching of the methyl orange acid colour by the bromine generated in situ. Titrimetry is applicable in the 2–20 mg range. In spectrophotometry, Beer's law is obeyed in the 0.5–5.0 g mL^–1 range whereas concentrations in the 5.0–25.0 g mL^–1 range can be determined by the kinetic method. The effect of common excipients and additives in tablets is discussed. The procedures have been successfully applied to dosage forms; the results agree well with those obtained by use of a reference method. The methods can be used to determine SBS at mg or g levels.