基于低功耗双边沿D触发器的任意进制异步计数器设计

从D触发器激励表入手，分别给出了采用单边沿D触发器和双边沿D触发器的2^n进制异步加法计数器、减法计数器的设计方法．在此基础上，采用逻辑函数修改技术，通过实例讨论了基于单边沿D触发器和双边沿D触发器的异步任意进制计数器的设计．该设计方法方便，快速，具有一定的实用意义．     

Microwave synthesis of magnetic Fe3O4 nanoparticles used as a precursor of nanocomposites and ferrofluids

Methods to synthesize magnetic Fe₃O₄ nanoparticles and to modify the surface of particles are presented in the present investigation. Fe₃O₄ magnetic nanoparticles were prepared by the co-precipitation of Fe³⁺ and Fe²⁺, NH₃·H₂O was used as the precipitating agent to adjust the pH value, and the aging of Fe₃O₄ magnetic nanoparticles was accelerated by microwave (MW) irradiation. The obtained Fe₃O₄ magnetic nanoparticles were characterized by Fourier transform infrared spectroscopy (FT-IR), transmission electron microscopy (TEM), X-ray powder diffraction (XRD) and vibrating sample magnetometer (VSM). The average size of Fe₃O₄ crystallites was found to be around 8–9 nm. Thereafter, the surface of Fe₃O₄ magnetic nanoparticles was modified by stearic acid. The resultant sample was characterized by FT-IR, scanning electron microscopy (SEM), XRD, lipophilic degree (LD) and sedimentation test. The FT-IR results indicated that a covalent bond was formed by chemical reaction between the hydroxyl groups on the surface of Fe₃O₄ nanoparticles and carboxyl groups of stearic acid, which changed the polarity of Fe₃O₄ nanoparticles. The dispersion of Fe₃O₄ in organic solvent was greatly improved. Effects of reaction time, reaction temperature and concentration of stearic acid on particle surface modification were investigated. In addition, Fe₃O₄/polystyrene (PS) nanocomposite was synthesized by adding surface modified Fe₃O₄ magnetic nanoparticles into styrene monomer, followed by the radical polymerization. The obtained nanocomposite was tested by thermogravimetry (TG), differential scanning calorimetry (DSC) and XRD. Results revealed that the thermal stability of PS was not significantly changed after adding Fe₃O₄ nanoparticles. The Fe₃O₄ magnetic fluid was characterized using UV–vis spectrophotometer, Gouy magnetic balance and laser particle-size analyzer. The testing results showed that the magnetic fluid had excellent stability, and had susceptibility of 4.46×10⁻⁸ and saturated magnetization of 6.56 emu/g. In addition, the mean size d (0.99) of magnetic Fe₃O₄ nanoparticles in the fluid was 36.19 nm.     

纳米颗粒悬浮液池内泡状沸腾的实验研究

本文对纳米颗粒悬浮液在平壁面上池内沸腾进行了实验研究。实验用的纳米粒子为26 nm的铁粉和13 nm的三氧化二铝纳米粉末,基液为去离子水。分别配成体积浓度为0．1％, 1％和2％的悬浮液。实验结果表明,纳米悬浮颗粒对液体沸腾换热过程的影响会随着纳米颗粒性质,颗粒浓度及热流密度大小的不同而出现不同的效果;加入纳米颗粒后, 对基液沸腾换热的影响存在着两个相反的作用机制,它们分别为:纳米颗粒增强了液体内部的热量迁移能力(热物性的影响)和改变了加热面的表面结构特性(加热面特性的影响)。     

Classical, phenomenological analysis of the kinetics of reactions at the gas-exposed surface of mixed ionic electronic conductors

The kinetics of reactions occurring at the gas-exposed surfaces of charged mixed ionic electronic conductors (MIECs) are examined from theoretical first principles. Analysis based on the classical electrochemical potential-transition state theory model reveals that the nature of the reactions is electrochemical in general. However, the influence of the surface potential on the reaction rate is opposite for adsorption and incorporation reactions. Two-dimensional finite volume models of an MIEC as working electrode in a half-cell configuration are presented. The results for a simple, two-step reduction process show that the effect of the surface potential on the rate of reactions is minimal for incorporation-limited reactions but more influential for adsorption-limited reactions. An erratum to this article is available at .     

Electron beam induced modification of poly(ethylene terephthalate) films

Electron beam processing of poly(ethylene terephthalate) (PET) films is found to promote significant changes in the melting heat, intrinsic viscosity and polymer film-liquid (water, isooctane and toluene) boundary surface tension. These properties are featured with several maximums depending on the absorbed dose and correlating with the modification of PET surface functionality. Studies using adsorption of acid-base indicators and IR-spectroscopy revealed that the increase of PET surface hydrophilicity is determined by the oxidation of methylene and methyne groups. Electron beam treatment of PET films on the surface of N-vinylpyrrolidone aqueous solution provided graft copolymerization with this comonomer at optimum process parameters (energy 700 keV, current 1 mA, absorbed dose 50 kGy).     

Ag纳米颗粒的光吸收和透射电镜研究

用硼氢化钠作还原剂,制备出两种相对稳定的含银纳米颗粒的水溶胶,用透射电镜（TEM）和光学吸收谱对这些颗粒进行了表征.当被还原的银离子较少时,所形成的银纳米颗粒较小,吸收峰呈现二极等离子体共振吸收峰.当被还原的银离子较多时,银纳米颗粒尺寸变大,并出现二极和四极共振吸收峰.在Ag纳米颗粒形成后,对其溶液稀释,发现其峰形保持不变,而峰位会出现红移,最大红移量可达到10 nm.透射电镜研究表明,低浓度溶胶中的Ag纳米颗粒尺寸较为均匀,平均直径12 nm.高浓度溶胶中的纳米颗粒尺寸呈双尺寸分布特点,少量颗粒直径小于14 nm,大部分颗粒直径大于20 nm.     

用力敏传感器测量乙醇水溶液的表面张力系数与浓度的关系

用硅压阻式力敏传感器测量了纯水、乙醇的表面张力系数，并测量了不同浓度的乙醇水溶液的表面张力系数，得到了乙醇水溶液的表面张力系数随浓度的变化曲线．     

用板式电势差计测量电池的电动势和内阻实验的改进

分析了在“用板式电势差计测量电池的电动势和内阻”实验中 ,由于待测干电池的电动势和内阻在实验过程中均不为恒定值而引起的误差 ,依据电化学理论和电阻构成解释了实验现象 ,并给出了实验改进方案 .     

Vassiliev invariants for braids on surfaces

We show that Vassiliev invariants separate braids on a closed oriented surface, and we exhibit a universal Vassiliev invariant for these braids in terms of chord diagrams labeled by elements of the fundamental group of the surface.

     

Depth profile analysis of polyimide film treated by potassium hydroxide

The structural change in the depth direction of a polyimide (UPILEX‐S) film treated in alkaline solution, which was a representative surface treatment used to form a seed layer for plating and to improve the adhesive strength, was analyzed by means of micro Fourier transform infrared attenuated total reflection (FTIR‐ATR) line analysis with gradient shaving preparation. The polyimide film was treated with KOH. The imide ring opened through the alkaline treatment, and the amide structure and carboxylic acid salt were formed. The attainment depth of this structural change was almost proportional to the treatment time, and it reached about 8 μm after a 30‐min treatment. The degree of structural change through the alkaline treatment was almost constant after it reached a considerably degraded stage, and the chemically changed region penetrated into the inner part of the film from the surface. An intermediate layer before the final degraded stage appeared in the treated layer, and its thickness increased with the treatment time. The region that was changed chemically by the alkaline treatment progressed to the inner part simultaneously and continuously as the treatment time increased. The combined use of gradient shaving preparation and micro FTIR‐ATR line analysis was found to be extremely effective for the depth profiling of organic materials. © 2003 Wiley Periodicals, Inc. J Polym Sci Part B: Polym Phys 41: 2071–2078, 2003