Specific surface of two hydrated cements differing in strength

Specific surface, S, of CSH-gel particles of disordered layered structure, was studied by water sorption/retention in two cement pastes differing in strength, i.e. C-33 (weaker) and C-43 (stronger), w/c=0.4. Hydration time in liquid phase was t _h=1 and 6 months, followed by hydration in water vapour either on increasing stepwise the relative humidity, RH=0.5→0.95→1.0 (WS) or on its lowering in an inverse order (WR). Specific surface was estimated from evaporable (sorbed) water content, EV (110°C), assuming a bi- and three-molecular sorbed water layer at RH=0.5 or 0.95, respectively (WS). On WR it was three- and three- to four-molecular (50 to 75%), respectively, causing a hysteresis of sorption isotherm. At RH=0.5 the S increased with cement strength from 146 m² g^-1 (C-33, 1 m) to 166 m² g^-1 (C-43, 1 m) and with hydration time to 163 (C-33, 6 m) and to 204 m² g^-1 (C-43, 6 m). At RH=1.0 (and 0.95), higher S-value were measured but these differences were smaller: S amounted to 190-200 m² g^-1 in C-33 (1 and 6 m) and 198-210 m² g-1 in C-43 (1 and 6 m). Thus no collapse occurred on air drying of paste C-43 (6 m). This revised version was published online in July 2006 with corrections to the Cover Date.     

Modification of Non-Hydrolytic Sol-Gel Derived Alumina by Solvent Treatments

The effect of wetting non-hydrolytic derived alumina xerogels with water and organic solvents in the 20–70°C range on the alumina's properties was investigated. Wetting with organic solvents does not affect the alumina. However, contact with water was found to change the sharp crystallization at 800°C to a continuous crystallization starting at 450°C. Water treatment for a day at room temperature (RT) followed by second calcination decreased the surface area by 10%. This decrease in surface area is less pronounced with increasing wetting periods. On the other hand water treatment at 50–70°C followed by a second calcination resulted in a surface area increase of up to 15%. Upon water treatment the total pore volume has decreased from 0.65 (cm³/gr) to 0.48 (cm³/gr) and the average pore size decreased from 6.8 nm to 4.1 nm. The Cl content was found to be uneffected by the water treatment, remaining at 2.5% wt. Wetting with water at elevated temperature (70°C) accelerated the morphological changes, eliminating the crystallization peak at 800°C in one hour. A dissolution-reprecipitation mechanism is suggested to explain the results. In addition, Mass-Spectroscopy of the effluent gas during heat treatment revealed the emission of CO₂ and water upon phase transition into -Al₂O₃, at 1150–1300°C.     

Yeast cell microfiltration: Flux enhancement in baffled and pulsatile flow systems

The filtration performance of yeast cell harvesting was greatly improved by using an oscillatory flow mixing technique in both tubular and flat sheet membrane systems; flux increases of several fold were achieved. The effects of various operating parameters such as frequency, amplitude and ratio of net forward flow rate to oscillatory flow rate were investigated. A simple alternative to the dual head pump, which involved the use of solenoid valves for producing flow reversal, was developed. The flux was significantly increased using this new operating mode. As the only increase of power consumption was from inertia loss due to change of flow direction the additional power consumption is minimal.     

Effects of medium and chemical modification on thermal characteristics of Β-lactoglobulin

The thermal properties of -lactoglobulin (-LG) were studied by differential scanning calorimetry (DSC) under different medium conditions.pH, neutral salts, protein perturbants, and polyols all affected the DSC characteristics of -LG. Acylation with fatty acids also changed the thermal properties, particularly peak width at half-height. The results suggest that the structural stability of -LG is controlled by non-covalent forces, particularly electrostatic and hydrophobic interactions. Disulfide bonds did not contribute to the thermal response of -LG. Fatty N-acyl-amino acids caused marked increases in thermal stability and decreases in denaturation enthalpy, and additional peaks were observed in the presence of some palmitoyl derivatives.Contribution No. 2310, Centre for Food and Animal Research.We thank D. Raymond for her excellent technical assistance.     

（H2O）^＋n（n=1,2）的几何结构优化和振动光谱分析

采用Ｈａｒｔｒｅｅ－Ｆｏｃｋ和ＭＰ２方法在多种水平下优化了（Ｈ２Ｏ）＾＋ｎ（ｎ ＝１，２）的几何结构，并进行了振动光谱分析。结果表明：对（Ｈ２Ｏ）＾＋采用ＭＰ２／６－３１１＋＋Ｇ（ｄ，ｐ）可得出最满意的结论。     

Ternary surface complexes by theE(%)-pH curve method

A new method for the study of ternary surface complexes at liquid-solid interface, theE(%) -pH curve method, was proposed. Four types ofE(%)-pH curves, namely, phenomenon of left-right shifts of S-shaped curve, V-shaped curve, monodirection shift curve and X-shaped curve, were discovered. Correspondingly, apart from type (I) ternary surface complex and type (II) ternary surface complex , a new type of ternary surface complex was discovered. Project supported by the National Natural Science Foundation of China and the Fund of Doctoral Degree’s Spot.     

Novel polycationic biocides: Synthesis and antibacterial activity of polymeric phosphonium salts

Various polymeric phosphonium salts and the corresponding low-molecular-weight model compounds were prepared and their antibacterial activities against Staphylococcus aureus and Escherichia coli were explored by the viable cell counting method in sterile distilled water. Antibacterial activity of the polymers was found to be higher than that of the corresponding model compounds, particularly against S. aureus. Furthermore, the polymeric phosphonium salt exhibited a higher activity by 2 orders of magnitude than the polymeric quaternary ammonium salt with the same structure except the cationic part. Compounds with the longest alkyl chain (octyl) studied were found to exhibit particularly high activity, and this finding may be ascribed to the contribution of the increased hydrophobicity of the compounds to the cidal activity. © 1993 John Wiley & Sons, Inc.     

Influence of the cathodic polarization on the stability of Ti surface in concentrated KOH solutions

The stability of spontaneous thin layers and thin layers formed upon cathodical polarization of Ti in KOH solutions have been studied by potentiostatic and ellipsometric methods. At open circuit potential (OCP) the strongly adherent films, whose thickness depends on the concentration of the KOH solution, were formed. During the cathodic polarization the transformation of these films to weakly adsorbed precipitated layers on the electrode surface was observed. Comparing the theoretically computed curves with the experimental Ψ vs Δ loci measured ellipsometrically, the complex indices of refraction and the thickness of the generated films, from 3.6 to 60 nm in 1 M KOH and from 36 to 105 nm in 5 M KOH (adherent to the electrode surface), were determined. At OCP the rate of film growth increases with increasing the concentration of KOH solution. Cathodic polarizations change the chemical composition and retard the rate of film growth. Based on the ellipsometric and electrochemical data the chemical compositions of the formed films consisted of TiO₂, Ti₂O₃, TiO₂·H₂O, Ti(OH)₃ and TiOOH·nH₂O.     

Role of the surface heterogeneity in adsorption of hydrogen ions on metal oxides: theory and simulations

In this article we study the effect of energetic heterogeneity of a crystalline surface on the adsorption of hydrogen ions (protons) from the liquid phase. In particular, we examine the influence of the shape of the adsorption energy distribution on the equilibrium isotherms of hydrogen ions. To that purpose, a few popular distribution functions, including rectangular, exponential, and asymmetric Gaussian are considered. Additionally, multimodal distribution functions, which may correspond to the adsorption on different crystal planes of the oxide, are also used. Lateral interactions between adsorbed charges are modeled using the potential function proposed by Borkovec et al., which accounts also for polarization of the liquid medium. The results presented here are obtained using both Monte Carlo (MC) simulations and theoretical calculations involving Mean Field Approximation (MFA). They indicate that increased energetic heterogeneity of the adsorbing surface may, in general, considerably change the behavior of the adsorption isotherms, regardless of the assumed distribution function. It is also shown that the predictions of the proposed theory are consistent with the data obtained from the MC simulations.     

Oxidation kinetics of timahdit and tarfaya moroccan oil shales

Organic matter evolution and kinetics of combustion of Tarfaya and Timahdit oil shales have been examined by thermogravimetry (TG) and by differential thermal analysis (DTA). An agreement is observed between both techniques where it was found that combustion of organic matter occurs in two steps. Kissinger's method applied on experimental results gives an activation energy of the same magnitude for the first step of both oil shales (103 kJ mol^–1) whereas the second is 148 kJ mol^–1 for Timahdit and 118 kJ mol^–1 for Tarfaya.The changes in specific surface area during thermal combustion of Timahdit and Tarfaya oil shales have been studied by thermogravimetric gas sorption balance and correlated with experimental results obtained on TG/DTA in air. For Timahdit oil shale oxidation products, specific surface areas calculated from nitrogen adsorption data shows a slight increase during the temperature domain of 280 to 430°C and after this temperature, they increase sharply. However, data obtained with Tarfaya oil shales shows a significant increase at the temperature of maximum oxidation of the first stage of combustion of organic matter.This revised version was published online in November 2005 with corrections to the Cover Date.