Synthesis and application as polymer electrolyte of hyperbranched polyether made by cationic ring‐opening polymerization of 3‐{2‐[2‐(2‐hydroxyethoxy)ethoxy]ethoxymethyl}‐3′‐methyl‐oxetane

A novel cyclic ether monomer 3‐{2‐[2‐(2‐hydroxyethoxy)ethoxy]ethoxy‐methyl}‐3′‐methyloxetane (HEMO) was prepared from the reaction of 3‐hydroxymethyl‐3′‐methyloxetane tosylate with triethylene glycol. The corresponding hyperbranched polyether (PHEMO) was synthesized using BF₃·Et₂O as initiator through cationic ring‐opening polymerization. The evidence from ¹H and ¹³C NMR analyses revealed that the hyperbranched structure is constructed by the competition between two chain propagation mechanisms, i.e. active chain end and activated monomer mechanism. The terminal structure of PHEMO with a cyclic fragment was definitely detected by MALDI‐TOF measurement. A DSC test implied that the resulting polyether has excellent segment motion performance potentially beneficial for the ion transport of polymer electrolytes. Moreover, a TGA assay showed that this hyperbranched polymer possesses high thermostability as compared to its liquid counterpart. The ion conductivity was measured to reach 5.6 × 10^?5 S/cm at room temperature and 6.3 × 10^?4 S/cm at 80 °C after doped with LiTFSI at a ratio of Li:O = 0.05, presenting the promise to meet the practical requirement of lithium ion batteries for polymer electrolytes. © 2006 Wiley Periodicals, Inc. J Polym Sci Part A: Polym Chem 44: 3650–3665, 2006     

Synthesis of copolymers containing a spiro orthocarbonate moiety and evaluation of the volume change during their cationic crosslinking

Spiro orthocarbonate (SOC) monomers having either an exomethylene group {3,3‐dimethyl‐9‐methylene‐1,5,7,11‐tetraoxaspiro[5.5]undecane (ExoSOC)} or an allyl group {9‐allyl‐3,3‐dimethyl‐1,5,7,11‐tetraoxaspiro[5.5]undecane (AllylSOC)} were radically copolymerized with vinyl monomers at several feed ratios to obtain the corresponding copolymers having SOC moieties in the side chain. The obtained copolymers were crosslinked via the double ring‐opening polymerization of the SOC moieties by a treatment with boron trifluoride etherate. The volume changes during the crosslinking of the copolymers were evaluated by density measurements with a gas pycnometer. As the SOC moiety composition increased, the volume shrinkage during the crosslinking was suppressed, and that finally changed into volume expansion. The volume changes during the crosslinking of the copolymers from AllylSOC were slightly larger than those of the copolymers from ExoSOC. The higher volume expansions in the crosslinking of AllylSOC‐based copolymers were ascribable to the lower steric hindrance around the SOC moieties. © 2006 Wiley Periodicals, Inc. J Polym Sci Part A: Polym Chem 44: 7040–7053, 2006     

Synthesis and polymerization of a new nitrogen‐containing bis‐ortho‐diynylarene monomer

This study focuses on the preparation, characterization, and optical properties of new bis(3,4‐diphenylethynylphenyl)phenylamine. This is the first nitrogen‐containing bis‐ortho‐diynylarene (BODA) monomer having a nitrogen atom as the spacer group. BODA monomers are usually prepared from common bisphenols, thereby providing great synthetic versatility and the opportunity to develop a wide array of novel polyarylene thermosets by varying the aromatic spacer group. The new bis(3,4‐bisphenylethynylphenyl)phenylamine was synthesized in five steps. This compound emits an intense blue color (λ = 438 nm) upon irradiation by UV light and may be suitable for use as an emitting layer in electroluminescent devices. Bis‐(3,4‐bisphenylethynylphenyl)phenylamine and its polymer have photoluminescence quantum yields 34 and 38%, respectively, and long excited‐state lifetimes of 3.2 and 3.6 ns, respectively. The structure of the monomer and its polymer were characterized using spectroscopic techniques including Ultraviolet–visible Spectrophotometer, Photoluminescence Spectrophotometer, Fourier Transform infrared spectroscopy, and Gel Permeation Chromatography. The polymerizations were studied by Differential Scanning Calorimeter. The amount of weight loss and the thermostability of the nitrogen‐containing polymer were determined from thermogravimetric analysis. The electrical conductivity of neat HCl‐doped BODA‐derived polymer film was measured according to the standard four‐point probe technique. © 2006 Wiley Periodicals, Inc. J Polym Sci Part A: Polym Chem 44: 6988–6996, 2006     

Synthesis and cationic photopolymerization of new fluorinated,polyfunctional propenyl ether oligomers

New fluorinated, polyfunctional propenyl ether functionalized resins were synthesized, and their behavior in cationic photopolymerization was investigated. The photopolymerization proceeded efficiently with a high double‐bond conversion (>90%), giving rise to UV‐cured coatings characterized by low glass‐transition temperatures (?33 °C ≤ glass‐transition temperature ≤ ?15 °C) and hydrophobic surface properties. A fluorinated additive was also employed as a reactive additive in the cationic photopolymerization of trimethylolpropane tripropenyl ether, increasing the double‐bond conversion, polymer network flexibility, thermal stability, and surface hydrophobicity. © 2006 Wiley Periodicals, Inc. J Polym Sci Part A: Polym Chem 44: 6943–6951, 2006     

Radiation induced synthesis and swelling characterization of thermo-responsive N-isopropylacrylamide-co-ionic hydrogels

Two-component thermo-responsive hydrogels poly(N-isopropylacrylamide)-co-vinylbenzyltrimethylammonium chloride (NIPA-co-VBT) and poly(N-isopropylacrylamide)-co-p-sodium styrene sulphonate (NIPA-co-SSS) were prepared by using high energy gamma radiation. The gels were characterized by Fourier transformed infrared spectroscopy (FTIR), scanning electron microscopy (SEM) and sol-gel analysis. The presence of ionic monomers in NIPA leads to lower gel content. Introduction of ionic components in the matrix enhanced swelling extent but caused slower volume transition. The swelling studies in alcohol indicated that swelling extent was function of polarity of the swelling medium and all gels followed the order water > methanol > ethanol > iso-propanol. In mixed co-solvents (water-alcohol), they exhibit complex reentrant behavior. The co-polymer gels containing VBT swelled faster and to higher extent than those containing SSS. The dynamic swelling studies indicated that diffusion of water in PNIPA gel shifts from Fickian for PNIPA to anomalous for NIPA-co-ionic gels also the mean swelling time (MST) decreases for gels containing ionic monomers.     

亚麻等麻类纤维与乙烯基类单体接枝共聚反应的研究进展

近年来,乙烯基类单体与亚麻、大麻、苧麻等麻类纤维的接枝共聚反应已得到关注。本文着重总结接枝的引发方法,包括:1.辐射引发接枝;2.光引发接枝;3.Ce(Ⅳ)离子引发接枝;4.锰盐引发接枝;5.V(Ⅴ)离子引发接枝;6.Fenton's 试剂(Fe~(2+)-H_2O_2)引发接枝;7.过硫酸盐氧化还原引发体系接枝。上述各类引发体系及接枝纤维的结构与性能表征均在本文中作了述评。     

多官能单体TMPTA在LDPE表面光接枝聚合研究

以二苯甲酮(BP)为光引发剂、丙酮和水的混合物为溶剂,研究了室温下多官能单体三羟甲基丙烷三丙烯酸酯(TMPTA)在低密度聚乙烯(LDPE)表面的光接枝聚合(λ>300nm).研究表明,多官能单体的接枝速率较快,接枝聚合易产生交联结构,聚合后仍残留双键;延长聚合反应时间、增加单体用量有利于单体接枝转化率的提高;随引发剂用量增加,单体接枝转化率出现一峰值;在研究范围内,混合溶剂中水含量增加可使单体接枝转化率明显提高.扫描电镜观察到接枝膜表面形成了许多小球,表面粗糙度增加,疏水性提高.     

Radiation induced polymerization of vinyl monomers and their application for preparation of wood-polymer composites

Polymerizing effects of high energy radiation has been found suitable for preparation of wood-polymer composites. In the present work after evaluating polymer products that have been obtained by irradiation method, wood-polymer composites have been prepared by in situ polymerization of vinyl acetate, acrylic acid and acrylic acid/styrene mixture using two samples of Iranian hardwoods, Beech and Hornbeam. These woods and their composites have been tested for their physical and mechanical properties. The results have shown that chemical bonding between polymer and the cell wall component lead to better strength properties in the composites.     

Solid-State polymerization of the binary mixture of methacrylate and liquid-crystalline compound by electron beam

Solid-state polymerization of a binary mixture of nonliquid-crystalline monomer and liquidcrystalline compound was carried out using electron beam. The monomers were benzoic acid containing 4-[ω-(meth)acryloyloxyalkyloxy] benzoic acids, in which the alkylene spacer was ethylene, hexamethylene, or undecamethylene. The conversion yield of monomer to polymer to a large extent increased with increasing content of a liquid-crystalline compound with a terminal carboxylic group, such as 4-n-alkyloxybenzoic acid, while the addition of a liquid-crystalline compound without terminal carboxylic group did not affect polymerization of the monomer. Phase diagrams of the mixture of monomer and liquid-crystalline compound were examined using cross-polarizing microscopy and differential scanning calorimetry (DSC). All mixtures of monomer and 4-n-alkyloxybenzoic acid or liquid-crystalline compound without terminal carboxylic group showed liquid-crystallinity in a broad composition range. It was concluded that liquid-crystalline compounds with terminal carboxylic acid may form hydrogen bondings with methacrylate or acrylate monomer having terminal carboxylic acid which enhance polymerizability of the mixture. The stereoregularity of polymers determined by NMR depended on increasing irradiation dose and temperature rather than the content of the added liquid-crystalline 4-n-decanoxybenzoic acid.     

Preparation of Micron-size Functional Fluorescent Microspheres

As a kind of special functional microspheres, fluorescent polymer microspheres could be used in cell label and separation, blood flow assay, flow cytometer marking, chemical reaction assay,and in analyst of the transform and diffusion of particles in soil 1. However, one of the most important applications of fluorescent microspheres is in the high-throughput screening of drugs (HTS) 2. Through affinity interaction, radioactive ligands (latent drugs) are bound to fluorescent microspheres covered by receptor, and luminescence is produced by radioactivity, so ligands can be assayed and screened.In this study, we developed a technique for preparing micron-size fluorescent microspheres with different functional groups. The methods included the synthesis of micron-size polystyrene microspheres through the dispersion polymerization of styrene in different media such as ethanol,ethanol-water, and isopropanol; the functional polystyrene microspheres were prepared by introduction of functional monomers into the reaction system of styrene; the functional fluorescent microspheres were obtained by the way of dying functional microspheres in the fluorescent material's ethanol solvent.The average diameter of microspheres was in the range of 1～10 μm, and the distribution was normal distribution. The functional groups included -OH, -CHO, -COOH, -CONH2, and SO3H. The absorbing spectrum and exciting spectrum were tested, the results showed that the maximal absorbance of fluorescent microsphere was near 306.5 nm, and its maximal excitation was near 362 nm. The excitation spectrum of fluorescent material (DPO) and fluorescent microspheres were shown in figure 1, and it indicated that the developed fluorescent microspheres showed the same excitation behavior like DPO, which related to the fluorescent microspheres had stable luminescence property.