Sensitive Adsorption Stripping Voltammetric Determination of Reserpine by a Glassy Carbon Electrode Modified with Multi-Wall Carbon Nanotubes

Adsorption stripping voltammetry, a very sensitive electroanalytical method, was employed to determine reserpine, a kind of anti-hypertensive drug. In 0.1M phosphate buffer with a pH of 6.0, reserpine was accumulated at a multi-wall carbon nanotubes (MWNT)-modified glassy carbon electrode (GCE) surface under the condition of open-circuit. In the following anodic sweep from 0.20 to 1.00V, reserpine, adsorbed at the MWNT-modified GCE surface, was oxidized and yielded a sensitive oxidation peak at 0.64V. Due to its unique structure and extraordinary properties, MWNT shows a ten times higher accumulation efficiency toward reserpine, compared with a bare GCE. Hence, the amount of reserpine at the MWNT-modified GCE surface increases significantly, and finally the oxidation peak current improves greatly. The experimental conditions, such as supporting electrolyte, pH value, the amount of MWNT-DHP suspension, accumulation time and scan rate, were optimized for the measurement of reserpine, and a sensitive electroanalytical method was proposed for reserpine determination. The oxidation peak current varies linearly with the concentration of reserpine over the range of 2×10^–8 to 1×10^–5M, and the detection limit is 7.5×10^–9M after 4min open-circuit accumulation. The relative standard deviation at 1×10^–6M reserpine was about 4.7% (n=7), indicating excellent reproducibility. This new method was successfully demonstrated with reserpine injections and tablets.     

Cyclic Voltammograms of Ferrocene on Multi‐Walled Carbon Nanotubes (MWCNTs)‐Modified Edge Plane Pyrolytic Graphite (EPPG) Electrode in Room Temperature Ionic Liquids (RTILs) of 1‐Ethyl‐3‐Methylimidazolium Tetrafluoroborate (EMIBF4)

In this work, the electrochemical behavior of ferrocene (Fc) was investigated by cyclic voltammetry (CV) in room temperature ionic liquids (RTILs) of 1‐ethyl‐3‐methylimidazolium tetrafluoroborate (EMIBF₄) on glass carbon (GC), edge plane pyrolytic graphite (EPPG) and multi‐walled carbon nanotube (MWCNTs)‐modified EPPG electrodes, respectively. The results demonstrated that on GC electrode, pairs of well‐defined reversible peaks were observed, while for the electrode of EPPG, the peak potential separation (ΔE_p) is obviously larger than the theoretical value of 59 mV, hinting that the electrode of EPPG is distinguished from the commonly used electrode, consistent with the previous proposition that EPPG has many “defects”. To obtain an improved electrochemical response, multi‐walled carbon nanotubes (MWCNTs) were modified on the electrode of EPPG; the increased peak current and promoted peak potential separation not only proved the existence of “defects” in MWCNTs, but also supported that “creating active points” on an electrode is the main contribution of MWCNTs. Initiating the electrochemical research of Fc on the MWCNTs‐modified EPPG electrode in RTILs and verifying the presence of “defects” on both EPPG and MWCNTs using cyclic voltammograms (CVs) of Fc obtained in RTILs of EMIBF₄, is the main contribution of this preliminary work.     

Fluoride and lead adsorption on carbon nanotubes

The properties and applications of CNT have been studied extensively since Iijima discovered them in 1991[1,2]. They have exceptional mechanical properties and unique electrical property, highly chemical stability and large specific surface area. Thus far, they have widely potential applications in many fields. They can be used as reinforcing materials in composites[3], field emissions[4], hydrogen storage[5], nanoelectronic components[6], catalyst supports[7], adsorption material and so on.…     

The binding of single-stranded DNA and PNA to single-walled carbon nanotubes probed by flow linear dichroism

The binding of single-stranded DNAs and a neutral DNA analogue (peptide nucleic acid, PNA) to single-walled carbon nanotubes in solution phase has been probed by absorbance spectroscopy and linear dichroism. The nanotubes are solubilised by aqueous sodium dodecyl sulfate, in which the nucleic acids also dissolve. The linear dichroism (LD) of the nanotubes, when subtracted from that due to the nanotubes/nucleic acid samples, gives the LD of the bound nucleic acid. The binding of the single-stranded DNA to the single-walled nanotubes is quite different from that previously observed for double-stranded DNA. It is likely that the nucleic acid bases lie flat on the nanotube surface with the backbone wrapping round the nanotube at an oblique angle in the region of 45 degrees . The net effect is like beads on a string. The base orientation with the single-stranded PNA is inverted with respect to that of the single-stranded DNA, as shown by their oppositely signed LD signals.     

Simultaneous Determination of Aromatic Amines by Liquid Chromatography Coupled with Carbon Nanotubes/Poly (3-methylthiophene) Modified Dual-Electrode

Liquid chromatography with amperometric detection (LC-AD) is developed and applied to simultaneously determine five aromatic amines. In the LC-AD, a new carbon nanotubes/poly(3-methylthiophene) modified dual-electrode is fabricated and then used as the working electrode. It is found that this chemically modified electrode (CME) exhibits efficiently electrocatalytic oxidation for aromatic amines with relatively high sensitivity, stability and long-life. Thus, lower detection in LC-AD can be achieved, which are 4.0 × 10^–8 mol L^–1 for aniline, 1.6 ×10^–7 mol L^–1 for 4-nitroaniline, 1.0 × 10^–7 mol L^–1 for 4-chloroaniline, 1.5 × 10^–7 mol L^–1 for 1-naphthylamine, 1.7 × 10^–7 mol L^–1 for 2-bromoaniline. The recoveries of the five analytes are also determined, which range between 0.95 and 1.05 for drinking water, 0.86 and 1.10 for the LiWa River water.     

基于定向纳米碳管气体放电的气敏传感器研究

介绍了一种基于定向纳米碳管的气敏传感器,以生长定向纳米碳管的氧化铝模板作为阳极,铝板作为阴极,利用纳米碳管的尖端发射效应,在较低的电压下使气体产生放电现象。通过对纳米碳管在气体中击穿电压和放电电流的测量,实现对气体的定性定量检测。同时纳米碳管气敏传感器还具有体积小、灵敏度高、稳定性好、响应速度快、在常温常压下即可进行检测等优点,具有较好的应用前景。     

纳米碳管电极上氧的电催化还原

以聚四氟乙烯为粘结剂制成了多壁纳米碳管（MWNT）电极.采用恒电位阶跃法和循环伏安法研究了MWNT电极在碱性溶液中的电化学行为，并对碱性溶液中溶解氧在该电极上的电化学还原行为进行了研究.实验结果表明： MWNT电极具有比石墨电极更高的孔隙率和电化学表面积；MWNT电极上O2还原成的反应为准可逆过程；在5～50 mV•s－1的扫描速率范围内，阴极峰电流与扫描速度成线性关系，表明MWNT电极上O2还原成的反应受吸附控制；对碱性溶液中的氧还原反应， MWNT比石墨具有更高的催化活性.     

Optical and Bioelectrochemical Characterization of Water‐Miscible Ionic Liquids Based Composites of Multiwalled Carbon Nanotubes

Acidic treated multiwalled carbon nanotubes (AMWNTs) were ground with water‐miscible room temperature ionic liquids, 1‐butyl‐3‐methylimidazolium tetrafluoroborate ([bmim]BF₄), and resulted in AMWNTs‐[bmim]BF₄ composite. Its electrical‐ionic conductivity and optical properties were compared with the other two types of carbon materials‐[bmim]BF₄ composites: pyrolytic graphite powder (PGP), pristine multiwalled carbon nanotubes (PMWNTs), through the ac impedance technology and Raman spectroscopy. The impedance data show that AMWNTs‐[bmim]BF₄ composite exhibits the highest conductivity. Raman spectra study exhibits that the [bmim]BF₄ can form gel with PMWNTs and AMWNTs but only form a viscous liquid with PGP. AMWNTs‐[bmim]BF₄ gel modified GC electrode was applied in direct electrochemistry of heme proteins (Hb and HRP) and it catalysis to the reduction of H₂O₂ was investigated.     

Determination of Phenolic Compounds Based on Co‐Immobilization of Methylene Blue and HRP on Multi‐Wall Carbon Nanotubes

This work evaluated an amperometric biosensor based on multi‐wall carbon nanotubes (MWCNT), chemically modified with methylene blue (Met) and horseradish peroxidase (HRP), for detection of phenolic compounds. The dependences of the biosensor response due to the enzyme immobilization procedure, HRP amounts, pH and working potential were investigated. The amperometric response for catechol using the proposed biosensor showed a very wide linear response range (1 to 150 μmol L^?1), good sensitivity (50 nA cm^?2 μmol^?1 L), excellent operational stability (after 300 determinations the response remained at 97%) and very good storage stability (lifetime>3 months). Based on all these characteristics, it is possible to affirm that the material is promising for phenol detection due to its good electrochemical response and enzyme stabilization. The biosensor response for various phenolic compounds was investigated.     

GO-SWCNT Buckypapers as an Enhanced Technology for Water Decontamination from Lead

Water decontamination is an important challenge resulting from the incorrect disposal of heavy metal waste into the environment. Among the different available techniques (e.g., filtration, coagulation, precipitation, and ion-exchange), adsorption is considered the cheapest and most effective procedure for the removal of water pollutants. In the last years, several materials have been tested for the removal of heavy metals from water, including metal-organic frameworks (MOFs), single-walled carbon nanotubes (SWCNTs), and graphene oxide (GO). Nevertheless, their powder consistency, which makes the recovery and reuse after adsorption difficult, is the main drawback for these materials. More recently, SWCNT buckypapers (SWCNT BPs) have been proposed as self-standing porous membranes for filtration and adsorption processes. In this paper, the adsorption capacity and selectivity of Pb²⁺ (both from neat solutions and in the presence of other interferents) by SWCNT BPs were evaluated as a function of the increasing amount of GO used in their preparation (GO-SWCNT buckypapers). The highest adsorption capacity, 479 ± 25 mg g⁻¹, achieved for GO-SWCNT buckypapers with 75 wt.% of graphene oxide confirmed the effective application of such materials for cheap and fast water decontamination from lead.