Preparation and Characterization of Activated Carbon from Microwave and Conventional Heated Almond Shells Using Phosphoric Acid Activation

Activated carbon production from almond shells using phosphoric acid activation agent was achieved by applying both conventional heating and microwave heating in succession. The morphology and surface properties of activated carbon were studied using thermogravimetric and differential gravimetric analysis, Fourier-transform infrared spectroscopy, scanning electron microscopy, and Brunauer–Emmett–Teller analysis. A surface area of 1128 m²/g was achieved by optimizing the microwave power (500?W), microwave application time (15?minutes), conventional heating time (45?minutes), conventional heating temperature (500?°C), and the phosphoric acid:sample ratio (0.7:1). An adsorption capacity of methylene blue of 148?mg/g and an iodine value of 791?mg/g was obtained for the prepared activated carbon.     

General Formation of Macro-/Mesoporous Nanoshells from Interfacial Assembly of Irregular Mesostructured Nanounits

Mesoporous core–shell nanostructures with controllable ultra-large open channels in their nanoshells are of great interest. However, soft template-directed cooperative assembly to mesoporous nanoshells with highly accessible pores larger than 30 nm, or even above 50 nm into macroporous range, remains a significant challenge. Herein we report a general approach for precisely tailored coating of hierarchically macro-/mesoporous polymer and carbon shells, possessing highly accessible radial channels with extremely wide pore size distribution from ca. 10 nm to ca. 200 nm, on diverse functional materials. This strategy creates opportunities to tailor the interfacial assembly of irregular mesostructured nanounits on core materials and generate various core–shell nanomaterials with controllable pore architectures. The obtained Fe,N-doped macro-/mesoporous carbon nanoshells show enhanced electrochemical performance for the oxygen reduction reaction in alkaline condition.     

Direct Intermediate Regulation Enabled by Sulfur Containers in Working Lithium–Sulfur Batteries

Polysulfide intermediates (PSs), the liquid-phase species of active materials in lithium–sulfur (Li-S) batteries, connect the electrochemical reactions between insulative solid sulfur and lithium sulfide and are key to full exertion of the high-energy-density Li-S system. Herein, the concept of sulfur container additives is proposed for the direct modification on the PSs species. By reversible storage and release of the sulfur species, the container molecule converts small PSs into large organosulfur species. The prototype di(tri)sulfide-polyethylene glycol sulfur container is highly efficient in the reversible PS transformation to multiply affect electrochemical behaviors of sulfur cathodes in terms of liquid-species clustering, reaction kinetics, and solid deposition. The stability and capacity of Li-S cells was thereby enhanced. The sulfur container is a strategy to directly modify PSs, enlightening the precise regulation on Li-S batteries and multi-phase electrochemical systems.     

Revealing and comparing different excited-state intramolecular proton transfer processes for 3-(4-dimethylamino-phenyl)-1-(4-fluoro-2-hydroxy-phenyl)-propenone and 3-(4-dimethylamino-phenyl)-1-(4-fluoro-2-hydroxy-phenyl)-3-hydroxy-propenon

Two novel 2′-hydroxychalcone derivatives (i.e., M1 and M2) are explored in this work. We mainly focus on investigating the effects of photoexcitation on hydrogen bonds and on the excited-state intramolecular proton transfer (ESIPT) process. On the basis of calculations of electrostatic potential surface and intramolecular interactions, we verify the formation of hydrogen bond O1 H2···O3 in both S₀ and S₁ states. Exploring the ultraviolet–visible spectra in the liquid phase, our simulated results reappear in the experimental phenomenon. Analyzing molecular geometry and infrared stretching vibrational spectra, we confirm O1 H2···O3 is strengthened for both M1 and M2 in the S₁ state. We further confirm that charge redistribution facilitates ESIPT tendency. Constructing potential energy curves, we find the ultrafast ESIPT behavior for M1, which is because of the deficiency of side hydroxyl moiety comparing with M2. This work makes a reasonable affiliation of the ESIPT mechanism for M1 and M2. We wish this paper could facilitate understanding these two novel systems and promote their applications.     

含气率对PTS时压力容器内流动与传热的影响

本文对反应堆压力容器紧急安注时的流动与传热特性在1/10的模型上进行了流动可视化、局部传热系数以及混合函数的试验研究。针对三个热冲击敏感区域的部分测点,比较了环腔流速为0.5m/s、安注流速为1～30 m/s时不同含气率对下降环腔内流动与传热特性的影响,得出并分析了不同测点传热系数、混合函数的变化规律。研究结果表明:随着含气率增大,安注流体与环腔流体的混合增强;下降环腔内的含气率对小安注流速时的流动与传热影响显著,而对大安注流速时影响较小。     

双掺(Tm3+,Tb3+)LiYF4激光器1.5 μm波长激光阈值分析

由速率方程推出了双掺（Tm^3 ,Tb^3 ）离子准四能级系统的激光阈值解析式，讨论了Tm^3 和Tb^3 离子之间的相互作用。分析了1.5μm波长附近的激光阈值和Tm^3 、Tb^3 离子的掺杂原子数分数及晶体长度的关系。结果表明，对于对应Tm^3 离子^3H4→^3F4跃迁的约1.5μm波长的激光，激活离子Tm^3 的掺杂原子数分数过大时，交叉弛豫作用将使系统阈值迅速增加。Tb^3 离子的加入，一方面能抽空激光下能级，起到降低阈值的作用；另一方面亦减少了激光上能级的寿命，使阈值升高。故Tb^3 离子有最佳掺杂原子数分数。对于Tm原子数分数为y=0.01的Tm:LiYF4晶体，Tb^3 离子的最佳掺杂原子数分数为0.002左右，同时表明，激光阈值与晶体长度有关。最佳晶体长度与Tm^3 、Tb^3 离子的掺杂原子数分数以及晶体的衍射损耗和吸收损耗有关。     

Thermal gradient induced sidebranching in directional solidification

The polycrystalline perovskitelike manganese oxides La_1-xA_xMnO (A = Na, and K, ) have been fabricated by sol-gel technique. For all the compositions explored in this work, the average manganese oxidation state is practically constant, at for A = Na, and for A = K, respectively. A close relationship is confirmed to hold between the Curie temperature (T_c) and the bond distance of Mn-O. Results of magnetic measurements show that these materials can be utilized as suitable candidates for magnetic refrigerants with wide applied temperature span, for their significant entropy change and the easily tuned Curie temperature. Received: 12 September 1997 / Revised: 18 December 1997 / Accepted: 21 January 1998     

Spectrophotometric analysis, thermal analysis and gravimetric determination of some metal ions with oxime and Schiff's base derivatives of N-furoylphenylhydroxylamine

The oxime and Schiff's base of N-furoylphenylhydroxylamine form complexes with Co²⁺, Cu²⁺, Zn²⁺ and Fe³⁺. These complexes were studied by means of the UV — Vis. spectra of nujol mulls, electron spin resonance (ESR) spectra and magnetic susceptibility to determine their stereochemistry. The complexes were characterized via elemental analyses, molar conductivities and thermogravimetric analyses. Organic reagents were used for the gravimetric determination of Co²⁺, Cu²⁺ and Fe³⁺ through the precipitation of their complexes. The compounds were also used for separation of a binary mixture of Cu²⁺ and Cu²⁺. Interferences were studied.     

Studies on basicity of alkali metal catron exchanged β and X zeolites by pyrrole-IR spectroscopy

The strength of basic sites has been measured by pyrrole-IR on alkali metal cation exchanged β and X zeolites, as well as NaOH loaded Naβ. The influence of cation type and the structure of zeolites on their basicity has been studied. The acidic and basic properties of the samples were investigated by NH3-TPD and isopropanol reaction. It was shown that the strength of basic sites on samples could be characterized by the shift of vNH band in the pyrrole-IR spectra. The framework oxygen charges were calculated from the Sanderson electronegativity. The changes in basic properties with various alkali metal cation are consistent with the changes of local oxygen charges of the zeolite framework.