The Mutual Conversion of CO2 and CO in Dielectric Barrier Discharge (DBD)

Non-equilibrium plasma, which was engendered by dielectric barrier discharge (DBD) was used to analyze the mutual conversion between CO₂ and CO. The results showed that the conversion ratio of CO increased monotonously with the increasing voltage. But CO₂ was not so. Its conversion ratio reached maximum when the voltage was 3600 V in Ar system. It also showed that the existence of water molecules was more advanageous for the conversion of CO to CO₂ in Air system than in oxygen system, and the conversion ratio could reach 75.8% when the relative humidity was 100%. We also discussed the energy yield and energy efficiency, and the result was that high voltage and high concentration of reactant was disadvantageous for energy utilization.     

固载Ru基催化剂上二氧化碳加氢合成甲酸Ⅱ反应条件对催化剂性能的影响

The synthesis of formic acid from carbon dioxide and hydrogen using a silica immobilized ruthenium catalyst as precursor has been studied in different reaction conditions. The results revealed that the TOF （turn over frequency） of HCOOH achieved 1481.5 h^-1 on immobilized ruthenium catalyst near the critical pressure point of CO2 with H2 pressure of 4.0 MPa, reaction temperature of 80℃ and PPh3/Ru molar ratio of 6：1. The reaction activity of immobilized catalyst was higher than that of homogeneous catalyst, and the immobilized catalyst also offered the practical advantages such as easy separation and reuse.     

New approaches in radical carbonylation chemistry: fluorous applications and designed tandem processes by species-hybridization with anions and transition metal species

New approaches in radical carbonylation chemistry are described. We have successfully integrated tin mediated radical carbonylation chemistry into modern fluorous applications and separation techniques. We revealed that radical carbonylation reactions can be performed using fluorous tin mediators, such as fluorous tin hydride and fluorous allyltin reagents. Fine tuning of the reaction conditions resulted in a good efficiency equivalent to conventional tin mediators. The tedious procedure of removing organotin byproducts can be circumvented through the use of fluorous/organic liquid-liquid extraction or fluorous liquid-solid phase extraction with fluorous reverse phase silica (FRPS). Also described are newly developed tandem carbonylation reactions that are based on species hybridization approaches. Using a radical/anionic hybrid system based on zinc-induced one-electron reduction, we achieved a three-component coupling reaction consisting of 4-alkenyl iodides, carbon monoxide, and electron-deficient alkenes. We observed two types of annulations processes, namely [4 + 1](radical)/[3 + 2](anionic) and [5 + 1](radical)/[3 + 2](anionic), which lead to the production of bicyclo[3.3.0]octanols and bicyclo[3.2.1]octanols, respectively. We found a radical/palladium hybrid system to be useful in the construction of new cyclic systems that incorporate two or three molecules of carbon monoxide.     

Mesoscopic structure and properties of liquid crystalline mesophase pitch and its transformation into carbon fiber

The history and present state of the art in the chemistry of mesophase pitch, which is an important precursor for carbon fiber and other high-performance industrial carbons, are reviewed relative to their structural properties. The structural concepts in both microscopic and macroscopic views are summarized in terms of the sp(2) carbon hexagonal plane as a basic unit common to graphitic materials, its planar stacking in clusters, and cluster assembly into microdomains and domains, the latter of which reflect the isochromatic unit of optical anisotropy. Such a series of structural units is described in a semiquantitative manner corresponding to the same units of graphitic materials, although the size and stacking height of the hexagonal planes (graphitic sheets) are very different. Mesophase pitch is a liquid crystal material whose basic structural concepts are maintained in the temperature range of 250 to 350 degrees C. The melt flow and thermal properties are related to its micro- and mesoscopic structure. The structure of mesophase-pitch-based carbon fiber of high tensile strength, modulus, and thermal conductivity has been formed through spinning, and has inherited the same structural concepts of mesophase pitch. Stabilization settles the structure in successive heat treatments up to 3000 degrees C. Carbonization and graphitization enable growth of the hexagonal planes and their stacking into units of graphite. Such growth is governed and controlled by the alignment of micro- and mesoscopic structures in the mesophase pitch, which define the derived carbon materials as nanostructural materials. Their properties are controlled by the nanoscopic units that are expected to behave as nanomaterials when appropriately isolated or handled.     

互通多孔碳/二氧化锰纳米复合材料的原位水热合成及电化学性能

以互通多孔碳（IPC）为载体，水热条件下在碳表面原位反应生成纳米结构的二氧化锰（MnO₂），制备互通多孔碳/二氧化锰纳米（IPC/MnO₂）复合电极材料. 采用扫描电镜（SEM），透射电镜（TEM），X射线衍射（XRD），热重分析（TGA）对其结构进行表征；采用循环伏安法、恒流充放电和交流阻抗对其电化学性能进行研究. 结果表明：生成的MnO₂均匀地负载在碳的表面，形成多层次结构，并且随着温度的升高IPC表面负载的MnO₂由纳米颗粒变为纳米片状结构；MnO₂纳米片具有典型的K-Birnessite 型晶体结构；复合物中MnO₂的含量约为34%（w）. 在100 ℃制备的IPC/MnO₂复合材料在三电极系统中最高比电容达到了411 F·g^-1；随着反应温度的升高,比容量先增长后基本保持不变. 以IPC/MnO₂为正极，活性炭（AC）为负极，1 mol·L^-1 Na₂SO₄溶液为电解液组装成IPC/MnO₂//AC 混合超级电容器，发现IPC/MnO₂电极的电容器其电位窗口从1 V扩展到1.8 V，容量可达86F·g^-1，且表现出良好的电容特性和大电流放电性能.     

Coating Carbon Nanotubes with Europium Oxide

Carbon nanotubes (CNTS) coating with europium oxide by a simple method is reported in this letter for the first time. The CNTS were refluxed in a solution of nitric acid containing europium nitrate, and the pH value was subsequently ajusted with ammonia solution. At last, the mixture was filtered and annealed. The TEM micrograph showed that the CNTS were covered with a uniform thin layer with thickness of about 15 nm. The XRD results revealed that the CNTS were coated with europium oxide.     

Probing in vitro digestion at oil–water interfaces

Interfacial layers have been widely applied to study the formation and stability of emulsion-based systems. However, the application of isolated interfaces to address digestibility of emulsions is often limited because of the complexity of experimental methods and results. This review summarizes the latest developments in analytical methods and literature data on effects of digestion on interfacial layers. Particular emphasis is given to understand the changes on interfacial magnitudes during oral, gastric, and duodenal digestion, either applied separately or sequentially. Limitations of interfacial aspects and key factors that influence emulsion microstructure in bulk and lipid digestion are identified. Understanding the behavior of interfacial layers upon gastrointestinal digestion promotes an accurate tracking of the physiological fate of emulsions.     

Solvent extraction of sodium picrate with 15-crown-5 into carbon tetrachloride. The determination of the dimer-formation constant of a crown ether-univalent metal salt 1∶1∶1 complex

The theory is derived to determine the dimer-formation constant,K ₂, of a crown ethermetal salt 111 complex in organic solvents of low dielectric constant by solvent extraction. The theoretical predictions are verified experimentally by extraction of sodium picrate (NaA) with 15-crown-5 (15C5) into carbon tetrachloride. All the experiments were conducted at 25°C. The logK ₂ value of the Na(15C5)A complex in carbon tetrachloride has been determined to be 4.05±0.11. Moreover, the partition constant of the complex is calculated.     

Adsorption of Pd, Ni, and Cu ions on anode-oxidized carbon fiber materials

The anodic oxidation of the carbon felt Carbonetcalon results in the formation of surface defects which serve as centers of strong adsorption of Pd^II, Ni^II, and Cu^II ions. The electrochemical reduction of adsorbed ions makes it possible to obtain metallic catalysts, which undergo multiple redox cycles without loss of metal. The catalysts are characterized by high dispersity of the reduced phase, high adsorption capacity with respect to hydrogen, and 100% selectivity in hydrogenation of acetophenone. Translated fromIzvestiya Akademii Nauk. Seriya Khimicheskaya, No. 1, pp. 81–85, January 1997     

碳纳米管电极超大容量离子电容器交流阻抗特性

采用碳纳米管作为超大容量离子电容器的电极材料,应用交流阻抗频谱法,研究了超大容量离子电容器的频率响应特性.结果表明,用碳纳米管块作电极,超大容量离子电容器在频率250 mHz以下出现“电荷饱和”；而用活性炭块作电极, 超大容量离子电容器在频率为100 mHz时仍未出现“电荷饱和”,这说明碳纳米管电极超大容量离子电容器的频率响应特性优于活性炭电极超大容量离子电容器的频率响应特性.上述两类超大容量离子电容器的阻抗谱中均出现倾角约为45°的直线段,其相位角均远小于理想电容器的相位角90°.