凝胶型聚合物电解质的电导率与温度的关系

凝胶型聚合物电解质的电导率与温度的关系孙晓光，林云青，齐力，景遐斌，王佛松（中国科学院长春应用化学研究所长春１３００２２）关键词凝胶电解质，离子电导率，活化能无定形聚合物电解质电导与温度的依赖关系一般可用Ｖｏｇｅｌ－Ｔａｍｍａｎ－Ｆｕｌｃｈｅｒｃ（Ｖ...     

聚丙烯酰胺固定化糖化酶特性的研究

本研究以丙烯酰胺单体通过反向悬浮聚合技术合成聚丙烯酰胺作为载体材料，采用包埋—交联法固定化葡萄糖淀粉酶，并对其特性进行了研究．结果表明，该固定化酶最适pH值为5．0，最适温度为55～58℃，而且具有较好的贮存稳定性和操作稳定性，8个月后该固定化酶的残余活力仍保持在94％左右，可重复使用43批次，此固定化酶酶活回收率达到56％．实验表明丙烯酰胺悬浮聚合固定化糖化酶的方法是简便可行的．     

三组分(NiO、La2O3、SiO2)负载型加氢催化剂中La2O3的作用

用X射线衍射分析、FT-IR、小角X光散射等方法研究了浸渍法制备的NiO/SiO_2和NiO/(La_2O_3+SiO_2)样品中组分之间的相互作用。La_2O_3在SiO_2上可形成近乎密置单层的分散。在负载了La_2O_3的SiO_2上,NiO的分散程度比在SiO_2上有明显提高,也更容易被还原,而且还原后所得金属镍粒子的平均粒度降低,小粒子所占百分比提高。这些结果表明,NiO/(La_2O_3+SiO_2)比NiO/SiO_2样品具有更高的加氢还原硝基普鲁卡因为胺基普鲁卡因的活性,与Ni/(La_2O_3+SiO_2)比Ni/SiO_2活性高的情形相一致。     

Microporous, fast response cellulose ether hydrogel prepared by freeze-drying

A simple and effective method of preparing fast-response gels is developed. The freeze-drying and subsequent rehydration of thermosensitive gels alters the microstructural properties of the gels in a way that leads to rapid shrinking rates. Microporous hydroxypropyl cellulose (HPC) gels were created by this method to investigate the influence of the process on the swelling and shrinking kinetics of the gels in response to temperature changes. Micropores of different size ranges were produced by freezing gels with different amounts of water at −20 °C. Water content was the key factor to control the microporosity and the shrinking rates of gels. After the freezing treatment, an effective diffusion coefficient for shrinking could be determined by fitting Fick's law to the data (5.2 × 10⁻⁴ cm²/s). This was an increase of two orders of magnitude over that of the untreated, non-porous gel (6.0 × 10⁻⁶ cm²/s). The magnitude of the shrinking coefficient indicates that the shrinking rate of the microporous gel is probably limited by the convective flow, as unsteady flow through porous media follows the same differential equation as Fick's law, but with much greater transport coefficients, as observed here. Physically, the shrinking rate may be determined by the level of interconnected-cells in a microporous structure present at the beginning of shrinking process because the convection through the interconnected-cells is estimated to be much slower than the polymer network diffusion rate of the struts of micropores (0.1–3.0 μm) as well as heat transfer.     

聚丙烯酰胺凝胶结构非均匀性的动态光散射研究

利用动态光散射技术研究了聚丙烯酰胺 (PAAm)凝胶结构的非均匀性 ,分析了PAAm凝胶结构非均匀性的形成原因及凝胶动态光散射的数据处理方法和分析结果的物理意义 .研究结果表明 ,PAAm凝胶中含有动态相关长度 (LC)不同的两相 ,其中 ,LC 为 10～ 2 0nm的区域是聚合物稀疏相 ,LC 为 85nm左右的区域是聚合物密集相 ,两相的不均匀分布形成了PAAm凝胶结构的非均匀性 .分析表明 ,PAAm凝胶存在两相主要是由于单体和交联剂的溶解度存在差异所致 .随交联度增大 ,PAAm凝胶结构的非均匀性显著增强     

Salen Supported Molecular Borosilicates

Various Salen ligands (Salen( ^t Bu)H₂=N, N-ethylenebis(3,5-di-tertbutyl(2-hydroxy)benzylidenimine) were used to prepare borosilyl and -O bridged borosilyl compounds having the formula, L{B(OSiMe₃)₂}₂ (L=Salen( ^t Bu) (1), Salpen( ^t Bu) (2), Salben( ^t Bu) (3), Salhen( ^t Bu) (4) and L(BOSiMe₃)₂(-O) (L=Salen( ^t Bu) (5) and Salben( ^t Bu) (6)). In the case of 5 and 6 the formation of the B–O–B linkage takes precedence over the formation of a B–O–Si linkage. All of the compounds were characterized by Mp, elemental analysis, ¹H and ¹¹B NMR, IR, MS and in the case of 1, 2, and6 by X-ray crystallography.     

Polyaniline-coated silica gel

Silica gel microspheres 7 and 15 μm in diameter were coated with an overlayer of polyaniline camphorsulfonate or hydrochloride during the oxidative polymerization of aniline. Coated silica gel and polyaniline precipitate were separated using a difference in sedimentation rate. In an alternative approach, the microspheres were modified with polyaniline in the presence of 35 nm colloidal silica. This technique prevented the macroscopic precipitation of polyaniline. Coatings of neat, 3-aminopropyl- and octadecyl-modified silica gel with polyaniline hydrochloride were compared. The surface composition of coated microspheres was characterized by X-ray photoelectron spectroscopy. Potential applications of particles in electrorheology, organic catalysis, and in modeling of conductivity behavior in composites are demonstrated.     

Structural and Adsorptive Characteristics of Pyrocarbon/Silica Gel Si-60

Pyrocarbon/silica gel adsorbents (carbosils, CS) with mesoporous Si-60 (Merck, granule size 0.2–0.5 mm) modified by pyrolysis of CH₂Cl₂ at 823 K and reaction time from 0.5 to 6 h and then hydrothermally treated at 473 K for 6 h were studied by means of TEM, adsorption and ¹H NMR methods. Changes in the structural and adsorptive characteristics of hybrid adsorbents before and after hydrothermal treatment, which depend on pyrocarbon content (C _C), were analyzed on the basis of TEM micrographs and p-nitrophenol and nitrogen adsorption isotherms treated using a constrained regularization method. Interfacial water layers in aqueous suspension of CS were investigated by means of ¹H NMR with freezing-out of bulk water at T < 273 K showing nonlinear changes in the Gibbs free energy of interfacial water with increasing C _C because of nonlinear dependence of the structural characteristics of pyrocarbon deposits and CS as a whole on C _C.     

Two-dimensional separations and behaviour of alkaloids of various polarities on unmodified silica gel in polar and very polar neutral or acidic mobile phases

Summary New separation procedures for alkaloids of similar polarity and structure or of very different polarity and structure, based upon two-dimensional thin-layer chromatography on unmodified silica gel under mild conditions are described. Separation factors and separation mechanisms based on the structure of the bases and mobile phase composition are discussed for some examples of very efficient procedures.Proportions in solvent mixtures are v/v except where otherwise indicated.     

Structure formation in heavy metal oxyhydrates at low rates of gel formation

Oxyhydrate gels have a hydrophilic surface, due to which they undergo destruction and secondary polymerization in aqueous media. Prolonged storage in aqueous solution gives rise to regions with selfsimilar helical ordering in gels. Structuring of this kind is also observed when synthesis is conducted under conditions that provide low gelation rates. Electromagnetic UV and visible radiation is another means to change the gel structure; it makes the oligomer species pass into the excited state, due to which one of the directions of structuring becomes dominant. This work summarizes the results of computer simulation of gel agglomerates. For oxyhydrate systems, helical ordering was found to be one of the local energy minima. The units of a macrohelix can lie at various angles relative to one another, and they can change, after absorption of energy, the helix pitch and the order of elements in the helix.