活性炭纤维改性对ACF-SPME技术分析多环芳烃的影响

活性炭纤维经改性剂浸渍,水蒸气高温活化后,增大了其对水中多环芳烃的选择性和吸附量,提高了检出限。活性炭纤维活化的最佳条件:在45%磷酸中浸渍6 h,水蒸气中活化30 min,活化温度为500℃。与未改性炭纤维相比,改性后的炭纤维经固相微萃取技术与气相色谱联用测定16种多环芳烃(PAHs),检出限由0.5~50μg/L降至0.01~0.5μg/L,加标回收率由46%~112%增至74%~124%。方法的灵敏度和准确性得到明显的改善,提高了该技术的实际应用价值。     

Determination of 16 polycyclic aromatic hydrocarbons in environmental water samples by solid-phase extraction using multi-walled carbon nanotubes as adsorbent coupled with gas chromatography–mass spectrometry

A solid-phase extraction (SPE) using multi-walled carbon nanotubes (MWCNTs) as adsorbent coupled with gas chromatography–mass spectrometry (GC–MS) method was developed for the determination of 16 polycyclic aromatic hydrocarbons (PAHs) in environmental water samples. Several condition parameters, such as extraction adsorbents, elution solvents and volumes, and sample loading flow rate and volume were optimized to obtain high SPE recoveries and extraction efficiency. 150 mg MWCNTs as sorbent presented high extraction efficiency of 16 PAHs due to the large specific surface area and high adsorption capacity of MWCNTs compared with the commercial C18 column (250 mg/2 mL). The calibration curves of 16 PAHs extracted were linear in the range of 20–5000 ng L⁻¹, with the correlation coefficients (r²) between 0.9848 and 0.9991. The method attained good precisions (relative standard deviation, RSD) from 1.2% to 12.1% for standard PAHs aqueous solutions; method recoveries ranged in 76.0–125.5%, 74.5–127.0%, and 70.0–122.0% for real spiked samples from river water, tap water and seawater, respectively. Limits of detection (LODs, S/N = 3) of the method were determined from 2.0 to 8.5 ng L⁻¹. The optimized method was successfully applied to the determination of 16 PAHs in real environmental water samples.     

抗硫性芳烃加氢催化剂研究进展

因环保立法限制,芳烃加氢日益受到重视.本文简述了芳烃加氢的热力学及动力学行为,归纳总结了不同的抗硫性芳烃加氢催化剂类型及其加氢机理.鉴于硫中毒对过渡金属催化剂性质的复杂影响,对过渡金属催化剂的硫中毒做了较为详尽的阐述.     

手性羰基铁体系催化酮的不对称氢转移氢化

手性羰基铁络合物很少被用于芳香酮的不对称氢转移氢化.利用不同的羰基铁络合物与手性双胺双膦配体现场络合,形成手性胺膦铁催化体系.考察了它们对多种芳香酮的不对称氢转移催化氢化性能.结果表明,三核的手性胺膦铁簇合物是催化芳香酮不对称氢转移氢化的较好体系.当用三核的铁簇合物[Et₃NH]⁺[HFe₃(CO)₁₁]^-体系催化1,1-二苯基丙酮的氢化时,最高可获得98%的对映选择性.通过现场红外光谱测定,揣测羰基铁簇合物Fe₃(CO)₁₂在催化反应过程中保持三核的簇合物的簇骼不变.     

超声波辐射下β-吲哚衍生物的合成

在超声波下以吲哚、芳香醛、丙二酸亚异丙酯为原料一锅法合成了β-吲哚衍生物——5-[(3-吲哚基)．芳甲基]-2,2-二甲基-1,3-二氧六环4,6-二酮,其结构经IR和1H NMR确认。     

Reaction of 4,4′-dimethyldiphenyl ether with phosphorus trichloride in the presence of anhydrous aluminum chloride

The reaction of 4,4-dimethyldiphenyl ether with phosphorus trichloride in the presence of anhydrous aluminum chloride was studied. This reaction affords 2,8-dimethyl-10H-10⁵-phenoxaphosphine 10-oxide as virtually the only product. In air, the latter in an alkaline solution is quantitatively transformed into 10-hydroxy-2,8-dimethyl-10H-10⁵-phenoxaphosphine 10-oxide.__________Published in Russian in Izvestiya Akademii Nauk. Seriya Khimicheskaya, No. 12, pp. 2762–2765, December, 2004.     

Automated high-capacity sorption probe for extraction of organic compounds in aqueous samples followed by gas chromatographic analysis

An automated high-capacity sorption device for GC analysis of ultra trace components has been developed. The scope of the presented technique was to combine the simplicity of solid-phase microextraction (SPME) with the high extraction efficiency of the stir bar sorptive extraction technology. Sorptive extractions of water samples were performed using polydimethylsiloxane (PDMS) rubber tubing (120 microl) mounted onto a glass rod. The sampling procedure was carried out by a robotic autoinjector. Since the setup is fully automated, unattended and precise time-controlled extraction of samples is possible and makes quantitation with non-equilibrium extractions feasible. The sorption probes are easy to exchange, which facilitates off-line/in-field sampling. The system was evaluated with a test mixture of 44 environmentally hazardous compounds. Detection limits were found to be in the sub-ppt region. The performance of the system was demonstrated with the analysis of polycyclic aromatic hydrocarbons in urban snow.     

Gas chromatographic-mass spectrometric determination of polycyclic aromatic hydrocarbons formed during the pyrolysis of phenylalanine

The formation of polycyclic aromatic hydrocarbons (PAHs) during pyrolysis process of phenylalanine had been studied. Ten PAHs, including fluorene, phenanthrene, anthracene, fluoranthene, pyrene, benzo[a]anthracene, chrysene, benzo[k]fluoranthene, benzo[e]pyrene, and benzo[a]pyrene were analyzed by gas chromatography-mass spectrometry using selective ion monitoring mode. This technique offers the capability to analyze trace amounts of PAHs in phenylalanine pyrolyzates. The pyrolysis was carried out in a micro-furnace with quartz furnace liner. The injection was conducted with glass pelletizer syringe to avoid metal contamination. Qualitative results were obtained at 900 degrees C and quantitative analysis of 10 PAHs was done for 700 and 900 degrees C.