无烟煤结构的高分辨电镜研究

镜质组不仅是煤结构变化最具规律性，也是影响煤质的主要微成分。用点分辨率为２．１Ａ的高分辨电镜对几种不同煤化程度的无烟煤大分子结构进行了研究。结果表明：电镜图像直接表征了无烟煤分子的非均匀性孔隙结构。京西煤分子方向化程度强，主要以芳层平行堆或有序化前结构为主；晋城煤方向化程度弱，主要以粒状嵌晶结构为主。高分辨电镜技术是研究煤分子结构和煤化作用实质的有效方法。     

Degradation-fragmentation of marine plastic waste and their environmental implications: A critical review

This review critically evaluates the plastic accumulation challenges and their environmental (primarily) and human (secondarily) impacts. It also emphasizes on their degradation and fragmentation phenomena under marine conditions. In addition, it takes into account the leachability of the various chemical substances (additives) embedded in plastic products to improve their polymeric properties and extend their life. Regardless of their effectiveness in enhancing the polymeric function of plastic products, these additives can potentially contaminate air, soil, food, and water. Several findings have shown that, regardless of their types and sizes, plastics can be degraded and/or fragmented under marine conditions. Therefore, the estimation of fragmentation and degradation rates via a reliable developed model is required to better understand the marine environmental status. The main parameter, which is responsible for initiating the fragmentation of plastics, is sunlight/UV radiation. Yet, UV- radiation alone is not enough to fragment some plastic polymer types under marine conditions, additional factors are needed such as mechanical abrasion. It should be also mentioned that most current studies on plastic degradation and fragmentation centered on the primary stages of degradation. Thus, further studies are needed to better understand these phenomena and to identify their fate and environmental effects.     

Selective detection of Fe(III) ions in aqueous solution with a 1,8-diacridylnaphthalene-derived fluorosensor

The syn-isomer of 1,8-bis(4,4′-diisopropyl-9,9′-diacridyl)naphthalene, 1, has been prepared by two consecutive Pd(PPh₃)₄-catalyzed Stille cross-coupling steps. This highly congested sensor undergoes Fe(III)-selective fluorescence quenching in water/acetonitrile even in the presence of excess of other metal ions.     

Clean-up and analysis of carbazole and acridine type polycyclic aromatic nitrogen heterocyclics in complex sample matrices

A HPLC method for the analysis of polycyclic aromatic nitrogen heterocyclics (PANHs) in complex sample matrices is presented. It isolated and separated carbazole and acridine type PANHs with an absolute recovery of between 79–98%. Open column chromatography is used as an initial step to isolate a PANH fraction. By applying normal-phase liquid chromatography using a dimethylaminopropyl silica stationary phase and utilising back-flush technique it was possible to separate the PANH fraction into two fractions containing acridine type and carbazole type PANHs, respectively. The method applied on a sample of solvent refined coal heavy distillate (SRC II HD). A number of 3–5 ring acridines and carbazoles were identified with GC–electron impact MS and quantified with GC–nitrogen–phosphorous detection. Polycyclic aromatic hydrocarbons (PAHs) were determined in the SRC II HD sample by automated on-line clean-up and analysis of the obtained PAH fraction with coupled LC–GC–flame ionization detection. There was no overlap between the PANH and the PAH fractions with this method, and carbazoles and acridines were efficiently separated.     

Isotope dilution determination of polycyclic aromatic hydrocarbons in olive pomace oil by gas chromatography-mass spectrometry

A gas chromatographic (GC) method with mass spectrometry detection (MS) for the determination of eight polycyclic aromatic hydrocarbons (PAHs) in olive pomace oil has been developed. The oil was diluted with n-pentane and extracted by liquid-liquid partition with dimethyl sulphoxide (DMSO). After water addition and back-extraction with cyclohexane, a thin-layer chromatography on silica gel was performed as a further purification step. The PAHs spot was scraped off from the plate and the final extract was concentrated and analysed by GC-MS in full scan mode. The eight PAHs under investigation were determined in the presence of the corresponding labelled compounds added as internal standards to the sample at the beginning of the analytical process. The identified PAHs were then quantified by the isotope dilution methodology assuring the compensation of the concentration of each analyte for any variation in the sample preparation. The method precision was satisfactory with relative standard deviation (R.S.D.) values in the range 3.6-12.7% for all PAHs. The average recovery rates ranged from 69.0 to 97.5%. Accuracy was also calculated for benzo[k]fluoranthene, benzo[a]pyrene, indeno[1,2,3-cd]pyrene and benzo[ghi]perylene by analysing a certified reference material (CRM 458, coconut oil) with adequate results. All response curves exhibited a linear fit from 0.1 to 10 microg ml(-1) and the determination coefficients R2 were better than 0.9942. The limits of detection (0.1-0.4 microg kg(-1)) were acceptable when compared with the maximum permitted limit of 2 microg kg(-1) for each of the eight considered PAHs and 5 microg kg(-1) for the sum of the eight PAHs established by the Italian legislation. Measurement uncertainty was finally calculated identifying and quantifying the uncertainty components of the analytical process. The relative expanded uncertainties (Uc), expressed as percent values were in the range 8.5-11.4% thus appropriate for residues quantification in the range of concentrations considered in the present study.     

Synthesis of tert-butyl-substituted poly (ether ketone) by nickel-catalyzed coupling polymerization of aromatic dichloride

tert-Butyl substituted poly (aryl ether ketone)s with relatively high molecular weights were prepared by the Ni-catalyzed polymerization of tert-butyl substituted aromatic dichlorides containing ether ketone unit. These polymers were amorphous and soluble in common organic solvents, such as THF, dichloromethane, and chloroform. De-tert-butylation of the polymer by the treatment of trifluoromethanesulfonic acid in the presence of toluene proceeded smoothly and produced crystalline poly (aryl ether ketone). © 1994 John Wiley & Sons, Inc.     

Particle-size distribution of polycyclic aromatic hydrocarbons in urban air in southern Spain

The size distribution of polycyclic aromatic hydrocarbons (PAH) was determined for airborne particles from a large city with high vehicular traffic. The analytical method was optimised and validated using NIST standard reference material (SRM 1649a Urban Dust). The 16 priority PAH listed in the US-EPA were Soxhlet-extracted from filtered particulate matter and then fractionated using on-column chromatography. The aromatic fraction was quantified by gas chromatography-mass spectrometry. Real samples of particles collected in Seville (Spain) were analysed using the validated method. Values for the total concentration of PAH in the air, as well as the concentrations of each PAH in six particle-size ranges were obtained. Values of the PAH in TSP, PM₁₀, PM_2.5 and PM₁ were assessed.     

Determination of polycyclic aromatic hydrocarbons in water samples using high-performance liquid chromatography with amperometric detection

The determination of polycyclic aromatic hydrocarbons (PAHs) using high-performance liquid chromatography (HPLC) with UV and fluorescence detection has been well established. Although most of the PAHs can be detected by these methods, some environmentally important polyaromatic compounds, such as acenaphthylene, do not show fluorescence and can only be determined by UV detection at higher concentrations. A sensitive and selective determination of acenaphthylene, acenaphthene and the six PAHs listed in the TVO, the German drinking water standard, is also possible by amperometric detection following HPLC separation. The method was applied to the determination of PAHs in different water samples after solid-phase extraction (SPE). The efficiency of the amperometric determination was found to be superior to UV detection (λ = 300 nm).     

用近红外光谱仪快速测定调和汽油中芳烃、烯烃的含量

介绍了带有CCD检测器的近红光普仪在调和汽油分析中的应用，并与标准测定方法测定的数据对比，验证了近红外光谱法测定汽油性质的可靠性，同时表明该方法具有分析速度快，重现性好等特点。