泡沫铅对VRLA电池负极活性物质结构及性能影响

0引言随着36V/42V汽车电源系统的提出,新一轮汽车用电池的竞争不断加剧。从目前情况看,铅酸电池由于具有成本低廉,使用可靠,原材料来源丰富,铅回收率可高达98%等优点,因此成为电动车电源最实际的选择之一[1]。但作为电动车用电池,需要克服其比能量低、充电接受能力差和负极硫酸盐化等缺点。为此各国科学家开展了大量的研究工作。最近报道用铸造多孔体作为敞口铅酸电池的集流体,它的比表面积为14cm2·cm-3,正极活性物质利用率上升到50%,远高于传统的铸造板栅[2]。在铅酸电池集流体研究领域里另一个重大进步,就是以R V C(R etic-ulated V i…     

A microcalorimetric study of the association of hexacyanoferrate(II) ions with calcium and magnesium ions in aqueous solution

Using flow microcalorimetry, the ion association reaction M²⁺(aq)+Fe(CN) ₆ ^4– (aq)=MFe(CN) ₆ ^2– (aq) (M=Ca, Mg) has been studied at 25°C over the ionic strength range 0.02 to 0.08 mol-dm^–3. Analyses of the data to obtain H^o, the enthalpy change at infinite dilution, are described. The value obtained for H^o is sensitive to the kind of functions used to correct for non-ideal behavior.     

Microheterogeneity in aqueous-organic solutions: Heat capacities,volumes and expansibilities of some alcohols,aminoalcohol and tertiary amines in water

The heat capacities per unit volume and the densities of aqueous solutions of 2-propanol, neopentanol, tert-amylalcohol, 2-amino-2-methylpropanol, triethylamine and diethylmethylamine were measured, in many cases as a function of temperature, over the whole mole fraction or solubility range. Apparent and partial molal heat capacities, volumes and expansibilities were derived. The concentration dependence of these functions suggest the existence of transitions in some of these systems, in the water-rich region, qualitatively similar to micellization. The large relaxation contribution observed with some of the thermodynamic functions of hydrophobic alcohols and amines suggests a reinforcement of hydrophobic hydration due to strong hydrogen-bonding interactions of the polar groups with water.     

pH,Definition and measurement at high temperatures

In this review paper, the NBS scale and its limitations are briefly discussed. The magnitude of liquid junction potentials and some calculated values are presented. The use of a molality scale for hydrogen electrode concentration cells at high temperatures is described, and results from measurements on ionization equilibria are summarized. Use of this scale is also recommended for certain circumstances with cells without liquid junction. As an alternative activity scale, use of the Pitzer ion-interaction treatment for ions is recommended for special cases. Finally, reference data are presented for _±HCl in HCl(aq) to 350°C and (HCl+NaCl)(aq) to 200°C that were derived by use of the Pitzer ion-interaction treatment.Presented at the Second International Symposium on Chemistry in High Temperature Water, Provo, UT, August 1991.     

Thermodynamic properties of organic compounds in aqueous solution. II. Apparent molal heat capacities of piperidines,morpholines, and piperazines

Apparent molal heat capacities of some piperidine, morpholine, and piperazine derivatives in aqueous solution have been determined by adiabatic calorimetry in the temperature range 20–55°C and in the molality range 0.2–1m. Comparison of experimental values with those calculated through group contributions, found for monofunctional compounds, indicates strong interactions between the hydrophilic centers. An interpretation is given of the possible mechanism of this interaction. Also, values of ΔC _p for the addition reaction of proton to nitrogen centers of mono- and bifunctional organic compounds are examined.     

Effect of Ba and Bi doping on the synthesis and sintering of Ge-based apatite phases

Recently, high oxide ion conduction has been observed in the apatite-type systems La_9.33+x(Si/Ge)₆O_26+x/2, with conductivities approaching and even exceeding that of yttria-stabilized zirconia. The Ge-based phases have been reported to suffer from Ge loss and undergo irreversible structural changes on sintering at the high temperatures required to obtain dense pellets. In this paper we discuss doping studies (Ba, Bi for La) aimed at stabilizing the hexagonal apatite lattice to high temperature, and/or lowering the synthesis and sintering temperatures. The results show that doping with Ba helps to stabilize the hexagonal lattice at high temperatures, although Ge loss appears to still be a problem. Conductivity data show that, as previously reported for the Si-based systems, non-stoichiometry in the form of cation vacancies and/or oxygen excess is required to achieve high oxide ion conduction in these Ge-based systems. Neutron diffraction structural data for the fully stoichiometric phase La₈Ba₂Ge₆O₂₆ shows that the channel oxygen atoms show little anisotropy in their thermal displacement parameters, consistent with the low oxide ion conductivity of this phase. Bi doping is shown to lower the synthesis and sintering temperatures, although the presence of Bi means that these samples are not stable at high temperatures under reducing conditions.Presented at the OSSEP Workshop Ionic and Mixed Conductors: Methods and Processes, Aveiro, Portugal, April 10–12, 2003     

催化裂化USY／ZnO／Al2O3脱硫添加剂的高温水热失活

 对USY／ZnO／Al2O3汽油催化裂化脱硫添加剂经高温水热老化处理前后的脱硫性能进行了考察，发现老化后添加剂的脱硫性能大幅度下降．采用XRD和IR等技术对USY／ZnO／Al2O3添加剂在高温和高温水热条件下失活的原因进行了研究．结果表明，在高温下，ZnO可与USY沸石中的铝发生固相反应生成ZnAl2O4尖晶石，从而造成USY晶体结构崩塌，转变成无定形状态．在ZnO含量较高的条件下，ZnO可继续与USY晶体结构崩塌后生成的无定形的硅和铝的氧化物反应，生成Zn2SiO4硅锌矿和ZnAl2O4尖晶石结构．这一方面使添加剂失去了可形成硫化物吸附中心的ZnO，另一方面破坏了硫化物的裂化活性组分USY，从而造成添加剂脱硫性能下降甚至失去脱硫活性．ZnO对USY的破坏作用主要与温度有关．在USY／ZnO／Al2O3体系中，ZnO被ZnO与Al2O3之间形成的锌铝尖晶石膜固定并与USY隔离，单纯的高温条件对添加剂的破坏不显著，而水蒸气可以促进ZnO的移动，有利于ZnO与USY的接触，因此在高温和有水蒸气存 在的条件下添加剂的结构易遭到破坏．     

Synthesis and Crystal Structure of a Zinc(II) Complex Salt with the Schiff Base of Picolinaldehyde N-oxide and Semicarbazone

1 INTRODUCTION The donor properties of pyridine N-oxide and its substituted derivatives to form metal complexes have been widely investigated[1～3]. The resulting comple- xes were used as drugs[4] and catalysts[5]. So far, there have been a few reports on the synthesis of Schiff base derived from picolinaldehyde N-oxide with se- micarbazone (PNOS Scheme 1) and its metal com- plexes. And crystal structures of the complexes of PNOS with Au(III)[6], Pd(II)[7] and Cu(II)[8] were re- …     

Conductance in homomorphous solvents: Tetrabutylammonium salts and alkali picrates in butyrolactone-sulfolane mixtures

Conductance measurements are reported for LiPi, NaPi, KPi, RbPi, CsPi, Bu₄NPi, Bu₄NBr, Bu₄NClO₄, Bu₄NNO₃, and Bu₄NBBu₄ at 25°C in -butyrolactone-sulfolane mixtures. In these mixtures of solvents that are practically homomorphous, isodielectic and with comparable dipole moments, the ion pair association and ionic mobilities of large ions conform to the expectations of the primitive model. Electrolytes containing lithium or sodium ions show anomalies indicating that other factors besides shape, dipole moment, and polarizability of the solvent molecules are involved in the association and transport processes of these ions.     

Study on the electroreduction of In(III) ions at gold from acidic bromide solutions by the rotating ring-disc electrode technique

The mechanism of the indium electrodeposition on gold from acidic KBr solutions has been investigated by means of the rotating ring-disc electrode technique. The measurements showed that the overall electrode reaction In(III) + 3 e In consists of two successive charge transfer steps, i.e. In(III) + 2 e In(I) and In(I) + e In, with soluble monovalent indium as an intermediate. The current efficiency for In(I) generation under steady-state conditions is 100% in the case of low disc current densities. The disproportionation of In(I) in the bulk of solution occurs in slightly acidified solutions,pH=2, in addition to the In(I) electrochemical reduction. Based on the ring current transients, it was established that the two-electron transfer step is preceded by the formation of a thin passive film of indium metal.

---

Untersuchung der elektrochemischen Reduktion von In(III)-Ionen an Gold in sauren Bromidlösungen mit der rotierenden Ring-Scheiben-Elektrode

Zusammenfassung Mit Hilfe der rotierenden Ring-Scheiben-Elektrode wurde der Mechanismus der kathodischen Abscheidung von Indium auf Gold in sauren KBr-Lösungen untersucht. Aus den Messungen folgt, daß die Bruttoreaktion In(III) + 3e In über zwei aufeinanderfolgende Durchtrittsreaktionen, In(III) + 2 e In(I) und In(I) + e In, mit löslichem einwertigem Indium als Zwischenprodukt abläuft. Bei kleinen Stromdichten werden die In(I)-Ionen mit 100%iger Stromausbeute erzeugt. In schwächer sauren Lösungen (pH=2) konnte außer der elektrochemischen Reduktion von In(I) zusätzlich dessen Disproportionierung innerhalb der Lösung ermittelt werden. Auf Grund der Ringstrom-Zeit-Kurven wurde auch festgestellt, daß die Bildung von einer dünnen In-Metallschicht, die ein passives Verhalten aufweist, dem Zweielektronenübergang vorangegangen ist.